• Journal of electromagnetic engineering and science
• /
• v.6 no.1
• /
• pp.24-29
• /
• 2006

In this paper, we analyzed new two-branch polarization diversity at the receiving end of a mobile link which a transmitter emits circularly polarized wave. To analyze the correlation coefficient considered by XPD(Cross Polarization Discrimination) between the two received signals, a simple theoretical model of circular polarization diversity is adopted and experimental measurements are also conducted. From both theoretical and measurement results, it can be seen that the proposed circular polarization diversity scheme is more effective than that of the conventional linear polarization diversity.

• Proceedings of the KIEE Conference
• /
• 2005.11c
• /
• pp.80-82
• /
• 2005

Lightning surge damages of low voltage equipments in building are increasing due to increase in electrical and communication networks in the information-oriented society. And electrical circuits with semiconductor are very weak against lightning surge. To achieve effective method of surge protection on low voltage lines, there are needs for the relationship between propagation aspects of lightning surge and arrangement of indoor wire. This paper describes the experimental study on the relationship between them. This result may be raw data for establishment of surge protection system.

• Journal of the Korean Professional Engineers Association
• /
• v.44 no.5
• /
• pp.42-47
• /
• 2011

Currently, wireless communication environment in high-rise buildings are limited in the basement and ground floor facilities are not in common use do not part, in case of disaster is difficult for efficient repression. In this paper, wireless communication facilities on the ground floor of the skyscraper by building infrastructure, wireless communications is proposed to eliminate shadows. That the presence of various wireless communication systems, wireless communication system proposed by this paper, TPS laying coaxial cable seals leak, and the propagation shades in place by installing indoor antenna is the solution to eliminate shadows. The wireless communications solutions reveal the advantages and features, a method of constructing the proposed design.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.790-795
• /
• 2004

The characteristics of refrigerator noise recorded in anechoic chamber was investigated in condition of a the real living room and a kitchen. To predict the noise propagation in an apartment unit, room acoustic simulation software was used. It was found that the noise level in the real living room was $4\sim8dB$ higher than in the anechoic chamber. When a noise barrier and absorption materials were used on the rear wall and floor, the noise level reduced up to $3\sim4dB$. In addition, when the subjective evaluation of auralized refrigerator noise was undertaken using headphone, it was revealed that 21dB (A) is the allowable sound pressure level of 95% satisfaction.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.10
• /
• pp.1821-1827
• /
• 2007

In this paper, an analytic transfer channel modeling function by impulse signal propagation effects in indoor power-line network are analysed. The modeled channel parameters of power line channel including background noise is applied to the OFDM system and we analysis BER for QPSK and 16-QAM modulation signals with simulation. By the representation of gain for OFDM modulation, we can estimate the characteristic parameters of OFDM in Broadband power line communication.

• The KIPS Transactions:PartC
• /
• v.17C no.3
• /
• pp.251-258
• /
• 2010

In an indoor localization method taking the lateration-based approach, the location of a target is estimated with the location of anchor points (APs) and the approximated distances between the target and APs using received signal strength (RSS) measurements. The accuracy of distance estimation affects the localization accuracy of a lateration-based method. Since a radio propagation environment varies randomly in time and space, the highest RSSs do not necessarily give the best estimation of the distances between a target and APs. Thus, all APs hearing a target have been used for localization. However, the accuracy of a lateration-based method degrades if more APs beyond a certain threshold are used because the area of polygon with the APs increases. In this paper, we focus on reducing the size of the polygon to further increase the localization accuracy. We use the centroid of the polygon as a reference point to estimate the relative location of a target in the polygon. Once the relative location is estimated, only the APs which are closest to the target are used for localization to reduce the area of the polygon with the APs. We validate the proposed method by implementing an indoor localization system and evaluating the accuracy of the proposed method in the various experimental environments.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.9
• /
• pp.868-882
• /
• 2009

In this paper, channel model and wireless link performance analysis for the short-range wireless communication system applications in the terahertz frequency which is currently interested in many countries will be described. In order to realize high data rates above 10 Gbps, the more wide bandwidths will be required than the currently available bandwidths of millimeter-wave frequencies, therefore, the carrier frequencies will be pushed to THz range to obtain larger bandwidths. From the THz atmospheric propagation characteristics based on ITU-R P.676-7, the available bandwidths were calculated to be 68, 48 and 45 GHz at the center frequencies of 220, 300 and 350 GHz, respectively. With these larger bandwidths, it was shown from the simulation that higher data rate above 10 Gbps can be achieved using lower order modulation schemes which have spectral efficiency of below 1. The indoor propagation delay spread characteristics were analyzed using a simplified PDP model with respect to building materials. The RMS delay spread was calculated to be 9.23 ns in a room size of $6\;m(L){\times}5\;m(W){\times}2.5\;m(H)$ for the concrete plaster with TE polarization, which is a similar result of below 10 ns from the Ray-Tracing simulation in the reference paper. The indoor wireless link performance analysis results showed that receiver sensitivity was $-56{\sim}-46\;dBm$ over bandwidth of $5{\sim}50\;GHz$ and antenna gain was calculated to be $26.6{\sim}31.6\;dBi$ at link distance of 10m under the BPSK modulation scheme. The maximum achievable data rates were estimated to be 30, 16 and 12 Gbps at the carrier frequencies of 220, 300 and 350 GHz, respectively, under the A WGN and LOS conditions, where it was assumed that the output power of the transmitter is -15 dBm and link distance of 1 m with BER of $10^{-12}$. If the output power of transmitter is increased, the more higher data rate can be achieved than the above results.

• Journal of Bio-Environment Control
• /
• v.20 no.4
• /
• pp.346-351
• /
• 2011

This research was done to identify the mass propagation method in winter daphne (Daphne odora Thunb) using its softwood cuttings and to investigate its plant characters established at different light and soil conditions as an indoor plant. Cuttings from winter daphne were taken and grown in different treatment consisted of rooting media (perlite, vermiculite, perlite + vermiculite (1 : 1) and commercial horticulture media soil), indole butyric acid (IBA) hormone concentrations (0, 100, 500, 1000 ppm and Rootone) and date of cutting. Transplants were grown at different light intensities (100, 1000, 2500 lux and control) and growing media. Results showed that cuttings grown in perlite + vermiculite (1 : 1) gave higher percentage (100%) rooting. Cuttings treated with Rootone and IBA 100 ppm showed good rooting growth and cutting taken in June, 25 gave the highest rooting (96.7%). The best plant growth obtained at 1000 lux (56~60 ${\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$) followed by 2500 lux (125~130 ${\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$) and scoria mixed with commercial horticulture media soil showed better growth of transplants.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.6 no.1
• /
• pp.41-50
• /
• 2003

The feasibility as floricultural crops and water garden plant materials of Korean native water plants was investigated. Propagation type, growing and flowering time were observed for development as water garden, interior aquarium plant and water purification materials. Flowering time of the water plant was 7 species in May, 28 species in June, 49 species in July, 55 species in August, 47 species in September, and 17 species in October. Beautiful flowering water plants were Nymphaeaceae, Nymphoides peltata, Nymphoides indica, Monochoria korsakowii, Iris pseudacorus, Iris laevigata, and etc. Ornamental leafy water plants were Ceratopteris thalictroides, Ludwigia ovalis, Myriophyllum verticillatim, Limnophila sessiliflora, Blyxa aubertii, Blyxa echinosperma, Vallisneria asiatica, Hydrilla verticillata and Eleocharis acicularis etc. Isoetes japonica, Isoetes coreana and Isoetes sinensis were propagated by spore. Blyxa aubertii, Blyxa echinosperma, Myriophyllum verticillatim, Nuphar japonicum, Nelumbo nucifera, Ottelia alismoides, Sagittaria aginashi, Trapa japonica, and Trapa natans were propagated by seed. Persicaria amphibia, Ceratophyllum demersum (hornwort), Myriophyllum verticillatim, Myriophyllum spicatum, Oenanthe javanica, Potamogeton crispus, Hydrilla verticillata and Acorus calamus were propagated by division. And Vallisneria asiatica, Hydrilla verticillata and Phragmites japonica were propagated by runner. Ceratophyllum demersum (hornwort), Myriophyllum verticillatim, Myriophyllum spicatum, Limnophila sessilifera were propagated by adventitious bud. Ceratopteris thalictroides was propagated by leaf cutting. The 35 genera, 68 species of water plants were available for horticultural use. The 45 species such as Iris laevigata, Eleocharis acicularis, Menyanthes trifoliata, Nymphaea minima, Nuphar pumilum, Nymphoides coreana, Nymphoides peltata, Nymphoides indica, Nymphaea tetragona (water lily), and Typha latifolia could be use for water garden plant. The 21 species such as Limnophila sessilifera, Vallisneria asiatica, Ceratophyllum demersum and Hydrilla verticillata available for indoor aquarium. The 19 species such as Ottelia alismoides, Oenanthe javanica, Limnophila sessilifera and Blyxa echinosperma could be culture in container. The 27 species such as Trapa japonica, Trapa incisa, Phramites commuris (reed), Phragmites japonica, and Zizania latifolia were usable for water purification plant materials.

• Fire Science and Engineering
• /
• v.27 no.6
• /
• pp.89-96
• /
• 2013

The purpose of this study is to check the fire origin and cause of the fire by observing the shape of the flame propagation in air-conditioner indoor unit through the fire tests. We supposed that the flame is spread from the surroundings to the top of the air-conditioner and ignited on top of the air-conditioner with n-heptane. And then repeated this experiment twice under the same conditions. After the ignition, refrigerant filled in air-conditioner and lubricating oil exploded with large explosion and flame having high temperature and pressure belched out rapidly due to bursting refrigerant pipe linked air-conditioner between 734 seconds and 559 seconds. After result of checking the combustion residue we found that almost all of that was lost except a part of the evaporator, motor and metal. The position of short-circuit traces of wiring for the air-conditioner ignited itself is similar to that of fire damage by external flame. Therefore, we verified that it is not certain to determine the ignition cause and point by only the shape of the combustion residues.