• 한국지구과학회지
• /
• 제26권8호
• /
• pp.800-808
• /
• 2005

광주광역시 향등지역에서 화강암의 풍화에 따른 토양단면의 지화학적 특성을 파악하기 위하여 11개의 시료를 화학분석 하였다. 모암에서부터 풍화암까지 주성분원소 중 Si, Ca, Na, Mg, P, Mn은 감소하고 Ti, Fe, K는 증가하는 경향을 보인다. 미량성분원소의 경우 Rb, Sr, Pb, Ba은 증가하는 경향을 보이며, As, Co늘 감소하는 경향을 보인다. 또한 Zn, Cr, Ni등은 부분적으로 집적된 경향을 보이나 전체적으로는 모암과 풍화토에서 거의 비슷한 함량을 갖는다. 희토류원소는 전체적으로 상부로 갈수록 증가하는데 경희토류원소(LREE)는 풍화초기에 기반암에서 용탈되어 풍화암(saprock)에서 집적되지만, 중희토류원소(HREE)의 경우는 상대적으로 집적되지 못하여 풍화초기에 약간 감소하는 경향을 나타낸다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집 Vol.17
• /
• pp.226-229
• /
• 2004

A stoichiometric mixture of evaporating materials for $CuAlSe_2$ single crystal thin films was prepared from horizontal electric furnace. To obtain the single crystal thin films, $CuAlSe_2$ mixed crystal was deposited on thoroughly etched semi-insulating GaAs(100) substrate by the hot wall epitaxy (HWE) system. The source and substrate temperatures were $680^{\circ}C$ and $410^{\circ}C$, respectively. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction (DCXD). The carrier density and mobility of $CuAlSe_2$ single crystal thin films measured with Hall effect by van der Pauw method are $9.24{\times}10^{16}\;cm^{-3}$ and $295\;cm^2/V{\cdot}s$ at 293 K, respectively. The temperature dependence of the energy band gap of the $CuAlSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)\;=\;2.8382\;eV\;-\;(8.68{\times}10^{-4}\;eV/K)T^2/(T+155K)$. The crystal field and the spin-orbit splitting energies for the valence band of the $CuAlSe_2$ have been estimated to be 0.2026 eV and 0.2165 eV at 10K, respectively, by means of the photocurrent spectra and the Hopfield quasicubic model. These results indicate that the splitting of the ${\Delta}so$ definitely exists in the ${\Gamma}_5$ states of the valence band of the $CuAlSe_2$. The three photocurrent peaks observed at 10K are ascribed to the $A_1-$, $B_1-$, and $C_1$-exciton peaks for n = 1.

• 한국재료학회지
• /
• 제30권4호
• /
• pp.204-210
• /
• 2020

ZnO thin films are of considerable interest because they can be customized by various coating technologies to have high electrical conductivity and high visible light transmittance. Therefore, ZnO thin films can be applied to various optoelectronic device applications such as transparent conducting thin films, solar cells and displays. In this study, ZnO rod and thin films are fabricated using aqueous chemical bath deposition (CBD), which is a low-cost method at low temperatures, and environmentally friendly. To investigate the structural, electrical and optical properties of ZnO for the presence of citrate ion, which can significantly affect crystal form of ZnO, various amounts of the citrate ion are added to the aqueous CBD ZnO reaction bath. As a result, ZnO crystals show a nanorod form without citrate, but a continuous thin film when citrate is above a certain concentration. In addition, as the citrate concentration increases, the electrical conductivity of the ZnO thin films increases, and is almost unchanged above a certain citrate concentration. Cu(In,Ga)Se₂ (CIGS) solar cell substrates are used to evaluate whether aqueous CBD ZnO thin films can be applicable to real devices. The performance of aqueous CBD ZnO thin films shows performance similar to that of a sputter-deposited ZnO:Al thin film as top transparent electrodes of CIGS solar cells.

• 대한한방소아과학회지
• /
• 제29권4호
• /
• pp.29-38
• /
• 2015

Objectives We aimed to identify the effectiveness of photobiomodulation using low level laser therapy (LLLT), light emitting diode (LED) and others on the growth of the length of the growth plate by reviewing literatures. Methods We searched literatures using PubMed, Science Direct, CINAHL, Korea Traditional Knowledge Portal (KTKP), Oriental Medicine Advanced Searching Integrated System (OASIS), China Knowledge Resource Integrated Database (CNKI), Japan Science and Technology Information Aggregator, Electronic (J STAGE), and Japan National Institute of Informatics Scholarly and Academic Information Navigator (CiNii) using the keywords "Growth plate" "Epiphyseal growth" "Epiphyseal plate" and "Laser", "light emitting diode (LED)", "near-infrared light", and "photobiomodulation". Search range included only original article which provided English abstract were selected. The search strategy contained no language limitation. Results A total 556 studies were found. Then, 551 were excluded by scanning titles and abstracts and finally 5 articles were selected. Five articles were RCTs using rodents. Two of the 5 articles used InGaAlP Laser (630-685 nm), and the other 3 articles used GaAlAs Laser (780, 820, and 870 nm) to investigated the effects of LLLT on the growth of the length of the epiphyseal cartilage and the number of chondrocytes and thickness of each zone of the epiphyseal cartilage. Two articles concluded that LLLT had a beneficial effect on the longitudinal growth of the growth plate. In growth of the epiphyseal plate, there were no significant differences in others. Conclusions It is might that LLLT influenced on the growth of epiphyseal plate by positive affect. However, further rigorous RCTs are warranted.

• 한국세라믹학회지
• /
• 제48권4호
• /
• pp.328-333
• /
• 2011

The influence of Al-doped ZnO (AZO) thin films degraded under high temperature and damp heat on the performance deterioration of Cu(In,Ga)$Se_2$ (CIGS) solar cells was investigated. CIGS solar cells with AZO/CdS/CIGS/Mo structure were prepared on glass substrate and exposed to high temperature ($85^{\circ}C$) and damp heat ($85^{\circ}C$/85% RH) for 1000 h. As-prepared CIGS solar cells had 64.91% in fill factor (FF) and 12.04% in conversion efficiency. After exposed to high temperature, CIGS solar cell had 59.14% in FF and 9.78% in efficiency, while after exposed to damp heat, it had 54.00% in FF and 8.78% in efficiency. AZO thin films in the deteriorated CIGS solar cells showed increases in resistivity up to 3.1 times and 4.4 times compared to their initial resistivity after 1000 h of high temperature and damp heat exposure, respectively. These results can be explained by the decreases in carrier concentration and mobility due to diffusion or adsorption of oxygen and moisture in AZO thin films. It can be inferred that decreases in FF and conversion efficiency were caused by an increase in series resistance, which resulted from an increase in resistivity of AZO thin films degraded under high temperature and damp heat.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2006년도 하계종합학술대회
• /
• pp.609-610
• /
• 2006

A 77GHz MMIC transceiver module consisting of a power amplifier, a low noise amplifier, a drive amplifier, a frequency doubler and a down-mixer has been developed for automotive forward-looking radar sensor. The MMIC chip set was fabricated using $0.15{\mu}m$ gate-length InGaAs/InAlAs/GaAs mHEMT process based on 4-inch substrate. The power amplifier demonstrated a measured small signal gain of over 20dB from $76{\sim}77GHz$ with 15.5dBm output power. The chip size is $2mm{\times}2mm$. The low noise amplifier achieved a gain of 20dB in a band between $76{\sim}77\;GHz$ with an output power of 10dBm. The chip size is $2.2mm{\times}2mm$. The driver amplifier exhibited a gain of 23dB over a $76{\sim}77\;GHz$ band with an output power of 13dBm. The chip size is $2.1mm{\times}2mm$. The frequency doubler achieved an output power of -16dBm at 76.5GHz with a conversion gain of -16dB for an input power of 10dBm and a 38.25GHz input frequency. The chip size is $1.2mm{\times}1.2mm$. The down-mixer demonstrated a measured conversion gain of over -9dB. The chip size is $1.3mm{\times}1.9mm$. The transceiver module achieved an output power of 10dBm in a band between $76{\sim}77GHz$ with a receiver P1dB of -28dBm. The module size is $8{\times}9.5{\times}2.4mm^3$. This MMIC transceiver module is suitable for the 77GHz automotive radar systems and related applications in W-band.

• 전자공학회논문지A
• /
• 제30A권4호
• /
• pp.28-39
• /
• 1993

In the international BISDN used satellite, the laser that has large BW has to be used as a carrier for transmitting a lot of visual, vocal, and data information. Interoptical satellite communication has now developed in theoretical and practical aspects. But the optical communication, between satellite and earth station, is hindered by atmospheric absorption, scattering, and turbulence. In this paper, it was supposed that 1Gbps information was transmitted by binary FSK and 50mW AlGaAs semiconductor laser was used as a optical source in the satellite communication link between geosynchronous orbit satellite and earth station. We analyzed the BER and the entire diameter of the noncoherently combined optical heterodyne receiver as el evation angle, and determined the number of the optical heterodyne rece ivers, which is necessary for the BER of the receiver to be less than 10$^{-9}$ by computer simulation under the clear weather condition. It is shown that the BER and the number of the optical heterodyne receivers decrease as the elevation angle increases. In the region used the same number of the optical heterodyne receivers, it is shown that the entire diameter of the receiver increases but the BER decreases as the elevation angle increases.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2007년도 제32회 학술대회 초록집
• /
• pp.116-116
• /
• 2007

• Journal of Oral Medicine and Pain
• /
• 제21권1호
• /
• pp.25-36
• /
• 1996

To investigate the effect of low level laser therapy, the author selected 37 dental students with tender points in both masseters and trapeziuses, also measured maximum comportable opening(MCO), Numerical analog scale(NAS) and pressure pain threshold (PPT). 20 subjects were assigned randomly and were treated with GaAlAs diode laser after ultrasound. The other 17 subjects were treated with ultrasound and laser without irradiation. All the subjects were treated after 2 and 4 day respectively and were examined again after 6 days. And the obtained results were as follows : 1. The MCO of irradiated group increased more significantly after treatment than non-irradiated group. 2. The NAS of irradiated group decreased more significantly after treatment than non-irradiated group. 3. The PPT or irradiated group increased more significantly after treatment than non-irradiated group.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.1
• /
• pp.282-285
• /
• 2003

Single crystal $CuAlSe_2$ layers were grown on thoroughly etched semi-insulating GaAs(100) substrate at $410\;^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating $CuAlSe_2$ source at $680\;^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction (DCXD). The carrier density and mobility of single crystal $CuAlSe_2$ thin films measured with Hall effect by van der Pauw method are $9.24{\times}10^{16}\;cm^{-3}\;and\;295\;cm^2/V{\cdot}s$ at 293 K, respectively. The temperature dependence of the energy band gap of the $CuAlSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)\;=\;2.8382\;eV\;-\;(8.68\;{\times}\;10^{-4}eV/K)T^2/(T\;+\;155\;K)$. The crystal field and the spin-orbit splitting energies for the valence band of the $CuAlSe_2$ have been estimated to be 0.2026 eV and 0.2165 eV at 10 K, respectively, by means of the photocurrent spectra and the Hopfield quasicubic model. These results indicate that the splitting of the $\Delta$so definitely exists in the ${\Gamma}_5$ states of the valence band of the $CuAlSe_2$. The three photocurrent peaks observed at 10 K are ascribed to the $A_1-$, $B_1-$, and $C_1$-exciton peaks for n = 1.