• Journal of the Korean Society for Heat Treatment
• /
• v.24 no.1
• /
• pp.23-30
• /
• 2011

This study was carried out to investigate the effect of aging treatment on the mechanical properties and damping capacity of 12Cr heat resistant steel with ferrite phase. While hardness values in ferrite phase was not changed, that in martensite phase was dramatically dropped in early stage of aging treatment and then gradually decreased with increase of aging time. As aging treatment was carried out, the precipitation was not detected in ferrite phase, while carbides were precipitated in martensite phase. With increasing the aging time, tensile strength eventually decreased while impact toughness increased rapidly in the early stage of aging and then gradually increased. Besides, it was confirmed that damping capacity was not changed in the early stage of aging and then gradually increased with increase of aging time.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.16 no.5
• /
• pp.415-429
• /
• 2011

In this study, a single-phase quasi Z-source AC-AC converters with a series connection of the output terminals is proposed. The proposed system has configuration that the input terminals of two quasi Z-source AC-AC converters are connected in parallel and its output terminals are connected in series. The out of phase mode and in phase mode of the proposed system are presented. To verify the validity of the proposed converter, a DSP controlled hardware was made and PSIM simulation was executed. As a result, controlling the duty ratio of the converter, the desired buck-boost output voltages could be generated. For each modes, as compared with the single converter operation, the proposed converter could enhance the efficiency and input power factor according to different loads. Also, in case of the out of phase mode under the constant load, the efficiency and input power factor of the proposed system are increased 10[%], 35[%] respectively in compared with the single converter. And, the output voltage is constantly controlled in dynamic state in case while the load is suddenly changed.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2006.06a
• /
• pp.269-270
• /
• 2006

A finite difference lattice Boltzmann model which allows us to simulate gas-liquid two-phase flows with large density difference, for instance, 800 times for air and water is considered. Two-particle model is used and the density difference is introduced by changing the acceleration according to the fluid density. Numerical measurement of surface tension agrees well with theoretical predictions. Simulations of two-phase phenomenon for phase-transition is carried out, showing applicability of the model for two-phase flows. The two-dimensional cavitating flow around a board set up in the fluid way is also simulated. As a result, it was confirmed that the FDLB method with two-particle model was effective in numerical simulation of cavitating flow and the bubble periodically grew up at the low pressure area behind the board, in which the fluid condition was influenced by the cavitation number.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.5 no.1
• /
• pp.17-22
• /
• 2000

The separation of tryptophan enantiomers was carried out with medium-pressure liquid chromatography using BSA (bovine serum albumin)-bonded silica as a chiral stationary phase. The influence of various experimental factors such as pH and ionic strength of mobile phase, separation temperature, and the presence of organic additives on the resolution was studied. In order to expand this system to preparative scale, the loadability of sample and the stability of stationary phase for repeated use were also examined. The separation of tryptophan enantiomers was successful with this system. The data indicated that a higher separation factor (a) was obtained at a higher pH and lower temperature and ionic strength in mobile phase. Addition of organic additives (acetonitrile and 2-propanol) in mobile phase contributed to reduce the retention time of L-tryptophan. About $30\%$ of the separation factor was reduced after 80 days of repeated use.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.1013-1018
• /
• 2016

In this paper, three kinds of the inverter topologies for the variable speed drive of 2-phase induction motor are compared and analyzed. The 2-phase inverters are classified into 2-leg, 3-leg, and 4-leg types depending on the number of power switching devices. And they use the output voltage vectors of the different forms according to the inverter topologies. Based on the comparative analyzed results, the effective values of output voltage have been defined by the linear modulation range. Therefore, the motor design guideline is proposed in order to decide a rated voltage of 2-phase induction motor according to the inverter topologies. Also, the computer simulations are carried out to verify the output voltage and current characteristics of each inverter topology.

• The Korean Journal of Zoology
• /
• v.37 no.3
• /
• pp.318-323
• /
• 1994

The association of replication origins/termini with nuclear matrix during S phase was investigated by DNase digestion of halo structures in synchronized mouse LPI-1 cells. The binding of parental DNA to nuclear matrix was constant throughout S phase. When nuclear matrix was isolated from the cells pulse-labeled with 3H-thvmidine at various stases of S phase, total 3H-labels associated with nuclear matrix were specifically higher at So, Sa and Ss stages than other stases of S phase, suggesting that the newly synthesized DNAs at those stages are not excluded out of nuclear matrix. Similar patterns were obsenred from the pulse-chase experiments, in which cells were pulse-labeled at each stage of S phase and further incubated for 1 hr. These results suggest that the replication origins and termini are fixed at the nuclear matrix, and that the nuclear matrix binding fractions of DNA at 3C-pause may contain a large population of replication origins and termination sites.

• Journal of environmental and Sanitary engineering
• /
• v.18 no.2
• /
• pp.87-93
• /
• 2003

This study carried out to recommend adaptable technologies and countermeasures for performance improvement of Wet Scrubber(WS) in industrial waste incinerator. When not using the Activated Carbon(AC), the removal efficiency of dust and HCl is 73%, 92%. And particulate phase and gaseous phase dioxins removal efficiency was evaluated up to 31% and 12%. In this case, dioxins enrichment was not revealed in WS. When using the AC mixing with scrubbing water, the case of 1,000ppm, removal efficiency of particulate phase dioxins was about 51%, and gaseous phase dioxins was about 96%. The case of 2,000ppm, removal efficiency of particulate phase dioxins was about 55%, and gaseous phase dioxins was about 97%. And the case of 3,500ppm, the removal efficiency of particulate phase dioxins was about 35%, and gaseous phase dioxins was about 96% respectively. By this study, using the AC was more useful to remove the gaseous phase dioxins, and needed to use proper concentration of the AC, that in case of 3,500ppm, the particulate phase dioxins removal efficiency was more lower than other cases.

• Asian Pacific Journal of Cancer Prevention
• /
• v.16 no.3
• /
• pp.1225-1233
• /
• 2015

This study aims to clarify the psychosocial reactions of female patients with gynecological cancer undergoing chemotherapy and in the process of suffering from alopecia and to examine their nursing support. The target group comprised female patients who had received two or more cycles of chemotherapy, were suffering from alopecia, and were aged 30-65. Data were collected from semi-structured interviews, conducted from the time the patients were informed by their doctors that they might experience alopecia due to chemotherapy to the time they actually experienced alopecia and until they were able to accept the change. Inductive qualitative analysis was employed to close in on the subjective experiences of the cancer patients. The results showed the existence of six phases in the psychosocial reactions in the process of alopecia: phase one was the reaction after the doctor's explanation; phase two was the reaction when the hair starts to fall out; phase three was the reaction when the hair starts to intensely fall out; phase four was the reaction when the hair has completely fallen out; phase five was the reaction to behavior for coping with alopecia; and phase six was the reaction to change in interpersonal human relationships. The results also made it clear that there are five types of reaction patterns as follows: 1) treatment priority interpersonal relationship maintenance type; 2) alopecia agitated interpersonal relationship maintenance type; 3) alopecia agitated interpersonal relationship reduction type; 4) alopecia denial interpersonal relationship reduction type; and 5) alopecia denial treatment interruption type. It is important to find out which of the five types the patients belong to early during treatment and provide support so that nursing intervention that suits each individual can be practiced. The purpose of this study is to make clear the process in which patients receiving chemotherapy come to accept alopecia and to examine evidence-based nursing care on patients with strong mental distress from alopecia.

• Korean Journal of Materials Research
• /
• v.26 no.4
• /
• pp.200-206
• /
• 2016

This study was carried out to investigate the effect of W substitution on the precipitation behavior of ${\chi}$ and ${\sigma}$ phases in super duplex stainless steel. The ${\chi}$ phase was precipitated at the interface of ferrite / austenite phases and inside the ferrite phase at the initial stage of aging. With an increase in the aging time, the volume fraction of the ${\chi}$ phase increased, and then decreased with the transformation from the ${\chi}$ phase to the ${\sigma}$ phase. The ${\sigma}$ phase was precipitated later than the ${\chi}$ phase, and the volume fraction of x phase increased with the increase in the aging time. The ferrite phase was decomposed into the new austenite (${\gamma}2$) and ${\sigma}$ phases by aging treatment. The decomposition of the ferrite phase into the ${\gamma}2$ and ${\sigma}$ phases was retarded by W substitution for Mo. The volume fraction of the ${\chi}$ phase increased and that of the ${\sigma}$ phase decreased due to W substitution. The ${\chi}$ and ${\sigma}$ phases were intermetallic compounds, which had lower nickel concentration, and higher chromium, molybdenum, and tungsten concentrations. The ${\chi}$ phase has higher molybdenum and tungsten concentrations than those of the ${\sigma}$ phase. The amounts of chromium and nickel in the ${\chi}$ and ${\sigma}$ phases did not change, but these phases have higher concentrations of molybdenum and tungsten due to W substitution for Mo.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.23 no.1
• /
• pp.55-70
• /
• 2019

The phase properties of ground acceleration records from Mw 5.5~6.5 earthquakes are analyzed. The interrelationships between phase properties and significant durations, as well as PGA, are clarified through both of theoretical and empirical approaches. The probabilistic characteristics of phase information is also discussed based on previous studies and it is shown that circular normal distribution is the most appropriate probability distribution for the phase angle and phase difference. Whereas those variates can be modeled by Gaussian random variables. From the survey results on the frequency dependency of the phase statistics, a simple model is introduced, which is possible to express the frequency dependency of phase information. It is also shown that the significant duration can be controlled by appropriately chosen standard deviation of phase difference for 4~8Hz frequency band and additional consideration of phase scattering in higher frequency band through a series of Monte Carlo simulations. The source of phase scattering effect is also pointed out and discussed.