• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.04a
• /
• pp.198-201
• /
• 2001

In-situ flushing의 적용에 따른 농도 저감이 생물학적 분해에 미치는 영향을 알아보기 위하여, 초기농도 13mg/kg dry soil과 3mg/kg dry soil인 토양을 생물학적으로 처리한 결과 제거효율은 각각 86% 및 81%였으며, 두 가지 토양 모두 24시간 이후에는 미생물에 의한 작용이 크지 않은 것으로 나타났다. 이것은 토양상에서 용액상으로의 미생물에 의한 작용이 크지 않은 것으로 나타났다. 이것은 토양상에서 용액상으로의 물질전이 속도가 율속 단계로 작용하고 있기 때문이라 생각된다. 토양에 잔류하는 계면활성제가 생물학적 분해에 미치는 영향을 본 결과, 잔류하는 계면활성제에 의해 물질전이 속도가 향상되어 생분해가 지속적으로 일어났으며 초기농도 3mg/kg dry soil인 경우 120시간이 경과한 후 89%의 제거효율을 나타내었다. 계면활성제와 보조용매가 동시에 잔류하는 경우에는 계면활성제에 대한 순응기간이 보다 길어지는 것을 알 수 있었으며, 메탄올과 에탄올의 경우 각각 84%의 제거효율을 나타내었다.

• Journal of Soil and Groundwater Environment
• /
• v.18 no.6
• /
• pp.38-47
• /
• 2013

This study was performed to identify the optimal operating conditions and to evaluate the xylene removal efficiency, applying in-situ soil flushing with the low concentrated solution of 'Tween 80' at the xylene contaminated site. The pilot scale test site ($5m{\times}5m{\times}3m$), was mainly composed of 'sandy loam', with the average hydraulic conductivity of $9.1{\times}10^{-4}cm\;s^{-1}$. The average xylene concentration of the site was 42.1 mg $kg^{-1}$, which was more than 2.5 times higher than Korea soil pollution warning limit (15 mg $kg^{-1}$). For the soil flushing, 7,800 L of 0.1~0.2% surfactant solution was injected into three injection wells at the average injection time of 9 hr $d^{-1}$ for 10 days, followed by the additional only groundwater injection of 6,000 L. The same amount of the effluent solution was extracted from three extraction wells. From the analysis for xylene concentration of all effluent at 3 extraction wells, total 166 g of xylene was removed by in-situ surfactant flushing. Even though the residual xylene concentrations of 7 soil sampling locations in the test site were different due to the soil heterogeneity, from the comparison of xylene concentration at 7 locations before/after the feasibility test, 53.9% of the initial xylene in the site was removed from three extraction wells (mainly Ext-N and Ext-M well). The results showed that the in-situ soil flushing by using low concentrated 'Tween 80' solution had a great potential to remediate the xylene contaminated site.

• Journal of Korean Society on Water Environment
• /
• v.22 no.5
• /
• pp.824-830
• /
• 2006

Several tests were conducted to optimize the design parameters of ln-situ soil flushing processes for diesel contaminated soil. According to the batch extraction test for three anionic surfactants evaluation, Calgonit limiting bubble occurrence was selected for its higher oil cleaning efficiency. After optimum surfactant selection, there were many sets of column flushing test. Over 70% of BTEX was removed in this surfactant dose with 400% of soil volume. In the case of no surfactant addition flushing in column, so called "blank flushing test", BTEX removal rate was 64%. But when we reused the effluent for the cleaning solution, the removal rate was decreased to 46.9%. This result showed reabsorption of oil occurred on the soil. With the addition of Calgonit solution to the diesel contaminated column, BTEX was removed up to 98.9% during the first flushing and 99.4% for the second recirculation flushing. In microcosm tests, diesel contaminated soils were cleaned by both surfactant flushing and biological activities. In anoxic condition, nitrate was used as an electron acceptor while the surfactant and the oil were used an electron donor. BTEX removal efficiency could be achieved up to 80% by biological degradation.

• Journal of Soil and Groundwater Environment
• /
• v.6 no.2
• /
• pp.39-47
• /
• 2001

According to a series of batch-scale washing tests, SDS+$POE_5$ and $POE_5$+$POE_14$ were determined for the applicable mixed surfactants. Because SDS+$POE_5$ showed slightly negative effects on the microbes in the toxicity tests, $POE_5$+$POE_14$((1:1) 1%) was chosen for this study. In the in-situ flushing experiments, the removal rate of endosulfan was 67% for the injection rate of 1.5L/min/$\textrm{km}^2$. And when methanol and ethanol were added as cosolvent, 75% and 81% removal efficiencies were achieved, respectively. In the tests of bioremediation after the application of in-situ flushing, the removal rates of contaminated soils having 13mg/kg dry soil and 3mg/kg dry soil as initial concentrations were 86% and 81%, respectively. There were no significant degradation after 24 hours. The major rate-limiting factor for the biodegradation of endosulfan might be the mass transfer from soil phase to liquid phase after 24 hours. With the addition of surfactant, 89% removal was achieved after 120 hours. Because the surfactant improved the mass transfer rate, the biodegradation of endosulfan was enhanced. When surfactant and cosolvent were added together, the adaptation period of microorganisms to the surfactant became longer and the removal rates were 84% and 83% for methanol and ethanol, respectively.

• Journal of Korea Soil Environment Society
• /
• v.1 no.2
• /
• pp.61-72
• /
• 1996

A series of batch and lab-scale continuous tests were conducted to optimize the design parameters for the full-scale in-situ soil flushing experiments. The cleaning abilities of the surfactant solutions of Tween 80, Triton X-100 and SDS were compared for the soil artificially contaminated by hydrophobic organic contaminants: n-dodecane, naphthalene and anthracene. Tween 80 and Triton X-100 were shown to be efficient for n-dodecane. SDS and Tween 80 were shown to be efficient for naphthalene and anthracene. At the end of each column test, the sorbed amount of surfactant to soil was also measured. Tween 80 was found to be the least adsorbed surfactant to soil. The flushing ability at flowrate of 7 ml/min, was hampered comparing to flowrate of 3 and 5 ml/min. Initial pH of the soil did not significantly affect the flushing efficiencies. Tween 80 was determined as the most harmless surfactant for the Gram(+) and Gram(-) bacteria.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.04a
• /
• pp.418-421
• /
• 2003

Surfactant enhanced in-situ soil flushing was peformed to remediate the soil and groundwater at an oil contaminated site, and the effluent solution was treated by the chemical treatment process including DAF(Dissolved Air Flotation). A section from the contaminated site(4.5m$\times$4.5m$\times$6.0m) was selected for the research, which was composed of heterogeneous sandy and silt-sandy soils with average Hydraulic conductivity of 2.0$\times$10$^{-4}$ cm/sec. Two percent of sorbitan monooleate(POE 20) and 0.07% of iso-prophyl alcohol were mixed for the surfactant solution and 3 pore volumes of surfactant solution were injected to remove oil from the contaminant section. Four injection wells and two extraction wells were built in the section to flush surfactant solution. Water samples taken from extraction wells and the storage tank were analyzed by GC(gas-chromatography) for TPH concentration with different time. Five pore volumes of solution were extracted while TPH concentration in soil and groundwater at the section were below the Waste Water Discharge Limit(WWDL). Total 18.5kg of oil (TPH) was removed from the section. The concentration of heavy metals in the effluent solution also increased with the increase of TPH concentration, suggesting that the surfactant enhanced in-situ flushing be available to remove not only oil but heavy metals from contaminated sites. Results suggest that in-situ soil flushing and chemical treatment process including DAF could be a successful process to remediate contaminated sites distributed in Korea.

• Journal of Soil and Groundwater Environment
• /
• v.7 no.4
• /
• pp.77-86
• /
• 2002

Surfactant enhanced in-situ soil flushing was performed to remediate the soil and groundwater at an oil contaminated site, where had been used as a military vehicle repair area for 40 years. A section from the contaminated site (4.5 m $\times$ 4.5 m $\times$ 6.0 m) was selected for the research, which was composed of heterogeneous sandy and silt-sandy soils with average $K_d$ of 2.0$\times$$10^{-4}$cm/sec. Two percent of sorbitan monooleate (POE 20) and 0.07% of iso-prophyl alcohol were mixed for the surfactant solution and 3 pore volumes of surfactant solution were injected to remove oil from the contaminated section. Four injection wells and two extraction wells were built in the section to flush surfactant solution. Water samples taken from extraction wells and the storage tank were analyzed on a gas-chromatography (GC) for TPH concentration in the effluent with different time. Five pore volumes of solution were extracted while TPH concentration in soil and groundwater at the section were below the Waste Water Discharge Limit (WWDL). The effluent TPH concentration from wells with only water flushing was below 10 ppm. However, the effluent concentration using surfactant solution flushing increased to 1751 ppm, which was more than 170 times compared with the concentration with only water flushing. Total 18.5 kg of oil (TPH) was removed from the soil and groundwater at the section. The concentration of heavy metals in the effluent solution also increased with the increase of TPH concentration, suggesting that the surfactant enhanced in-situ flushing be available to remove not only oil but heavy metals from contaminated sites. The removal efficiency of surfactant enhanced in-situ flushing was investigated at the real contaminated site in Korea. Results suggest that in-situ soil flushing could be a successful process to remediate contaminated sites distributed in Korea.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.12 no.2
• /
• pp.82-90
• /
• 2004

This study was conducted to evaluate in situ soil flushing and coagulation for naphtalenes-contaminated soil remediation. Mixed-surfactant of 1% POE12 and 1% SDS (1 : 1 by volume basis) was used as a flushing solution. When 5 pore volumes of mixed -surfactant were added to soil column, the flushing efficiencies of 2-methylnaphtalene and 1,5-dimethylnaphtalene with about 1,500 mg/kg(dry soil) were approximately 80% and 60% respectively. In adding 13 pore volumes of mixed-surfactant, the flushing efficiencies of 2-methylnaphtalene and 1,5-dimethylnaphtalene were 90% and 82%. However, considering in situ soil flushing with distilled water, about 42% and 71% were flushed for 2-methylnaphtalene and 1,5-dimethylnaphtalene by surfactant-only. For about 10,000 mg/kg(dry soil) diesel-contaminated soil, 40% and 70% of TPH were flushed-out in 5 pore volumes and 13 pore volumes addition. However, for naphtalenes in diesel TPH, 90% of flushing efficiency was discovered in adding only 5 pore volumes of flushing solution. There was not discovered significant difference among coagulation efficiencies of 6 kinds of polymers, and the coagulation efficiencies were near 50%.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.04a
• /
• pp.13-17
• /
• 2002

Ultrasonic waves have several mechanical, chemical, and biological effects on a saturated soil medium. Their mechanical effects, popularly known as cavitation. Cavitation is the rapid and repeated formation, and resulting implosion, of imcrobubbles in a liquid, resulting in the propagation of microscopic shock waves. In a soil-liquid system, their mechanical effects generate high differntial fluid-particle velocities and microscopic shock waves. The velocity perturbations are capable of dislodging oil in the system by overcoming the forces binding oil to sand particles. In this study, a series of laboratory experiments involving the simple flushing and ultrasonic flushing were carried out. An increase in permeability and oil removal rate were observed in ultrasonic flushing tests. Some practical implications of these results are discussed in terms of technical feasibility of in situ implementation of ultrasonics.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.04a
• /
• pp.183-185
• /
• 2004

In this study, the combined electrokinetic and ultrasonic remediation technique, ultrasonically enhanced electrokinetic technique, was studied for the removal of heavy metal and organic substance in contaminated soils. The electrokinetic technique has been applied to remove mainly the heavy metal and the ultrasonic technique has been to remove mainly organic substance in contaminated soil. The laboratory soil flushing tests combined electrokinetic and ultrasonic technique were conducted using specially designed and fabricated devices to determine the effect of these both techniques. A series of laboratory experiments involving the simple, electrokinetic, ultrasonic, and electrokinetic & ultrasonic flushing test were carried out. A soil admixed with sand and kaolin was used as a test specimen, and Pb and ethylene glycol were used as contaminants of heavy metal and organic substance. An increase in out flow, permeability and contaminant removal rate was observed in electrokinetic and ultrasonic flushing tests. Some practical implications of these results are discussed in terms of technical feasibility of in situ implementation of electrokinetic ultrasonic remediation technique.