• Journal of the Korea institute for structural maintenance and inspection
• /
• v.8 no.3
• /
• pp.169-176
• /
• 2004

The Mechanistic model, considering expansion stress, coefficient of diffusion etc. to time, is applied to predict the deterioration of concrete structures of the nuclear power plant(NPP) due to sulfate attack. Mix design for the test was three kinds of specified compressive strength 385, 280 and $210kgf/cm^2$ which are used to construct NPPs and cement was type I and V. The immersion test was performed with 10% $Na_2SO_4$ solution to cement type and strength for a year. The coefficient of diffusion on each concrete mix is calculated based on the results of immersion test, and it is used for predicting the sulfate attack of the concrete structures of NPP. The coefficient of diffusion of the target concrete ranged $0.5763{\sim}3.9002{\times}10^{-12}m^2/sec.$, and the sulfate attack rate of concrete structures of the NPP was predicted as 0.1~7.1 mm/year.

• Journal of Power System Engineering
• /
• v.9 no.1
• /
• pp.50-56
• /
• 2005

The corrosion experiment was performed for 120 hours on the specimens in the natural seawater tank with four steps of the loaded torsional stress. The surface corrosion pattern of SCM440 area was showed global corrosion and narrow pitting, that was cause by galvanic corrosion between friction welded IN713LC and SCM440. But corrosion does not proceeded from IN713LC area. Initially, the average relative electrode potential and corrosion current were decreased suddenly, by and large, it was stabilized gradually tend to decreasing with the elapse of the immersion time. The corrosion rate was decreased by increasing the load stress, but 200 MPa specimen was showed most large value.

• Proceedings of the Korean Society for Emotion and Sensibility Conference
• /
• 2001.11a
• /
• pp.169-172
• /
• 2001

There are many people who suffer from simulation sickness when immersing in virtual reality. In this study, we analyzed two photoplethysmogram(PPG) parameters - a second derivative parameter and power spectral density ratios - in order to relate PPG parameters with simulation sickness. 36 young, healthy subjects were participated in the experiment, and each subject was equipped with a PPG electrode during his or her immersion. Simulation sickness section was defined as a 7 - second section which starts from the point where a subject reported simulation sickness, and normal section as a same-length section where no physical stimuli was presented to him or her. We compared the PPG parameters of the simulation sickness sections with the normal sections, - d/a ratio is believed to have lower value during vasodilation and higher value during vasoconstriction, however, we could not find much difference in the parameter between normal and simulation sickness sections. We also compared 1 to 10Hz power spectral density ratios in normal sections with in simulation sickness section, and found that 6 density ratios among them have different value. Therefore, the density ratios might be utilized as parameters to detect simulation sickness of subjects.

• The Journal of the Korea Contents Association
• /
• v.21 no.3
• /
• pp.205-216
• /
• 2021

This study aims to discuss ways needed to prepare their careers through relations between the personal internal factors perceived by college students in the process of career preparation and the external factors they experience during college life. To this end, the study conducted not only a questionnaire survey of 927 students at K University in Seoul but also hierarchical multiple regression analysis, independent two sample t-test, and one-way ANOVA (analysis of variance). The study set career preparation as a dependent variable, presented research models in four steps, and the explanatory power of each model was statistically significant. According to the findings of the study, both Model 1 and Model 2, gender had a significant impact on career preparation. Also, when self-directedness was added to Model 2, self-directedness had a greater impact on career preparation than gender did. When satisfaction with extracurricular activities was added to Model 3, this factor turned out to be helpful for career preparation. When college immersion, or a sense of belonging to college, was added to Model 4, the higher the sense of belonging students perceived, the more helpful they felt it for their career preparations. This study is expected to be helpful in preparing a policy to support college students' career preparation by grasping the relations between the personal characteristics of college students and career-related activities and college immersion they experience during college life.

• Journal of Korea Entertainment Industry Association
• /
• v.13 no.2
• /
• pp.101-110
• /
• 2019

Filmic spaces are not only a core expressive factors that can embody both internal and external meanings of films, but also play an important role for initiating dramatic context in terms of narratives. They establish visible environment in which provocative incidents occur and characters' behaviors are induced, include characters' psychology or emotional meanings of narratives and provoke tensions through symbolic meanings and the implicit function of surface background. This paper, therefore, analyzes the film, , by focusing on the dramatic function of narrative space. This film provides insights and thoughts through deep philosophical reflection, by escaping from the convention of such a genre, through deep philosophical reflection, by escaping from the convention of such a genre, though it belongs seemingly to the crime thriller genre using Mexico's drug cartel as it main material. In the film, narrative spaces are responsible for emotions invoking dramatic tensions beyond provocative incidents and the elaborately planned and controlled mise-en-scene absorbed audiences' attention by organizing ultimate suspense. In conclusion, flow and dramatic lingering imagery of this film might be achieved by power of scenes rather than plot factors. This study thus explained the correlation between narrative spaces and dramatic immersion, by analyzing spaces appearing in and visualized construction. It is hoped that this will further extends the pattern of researches on dramatic immersion, which have been primarily focused on plots and characters.

• Corrosion Science and Technology
• /
• v.4 no.6
• /
• pp.242-249
• /
• 2005

A lot of parts in FGD (Flue Gas Desulfurization) systems of fossil-fuel power plants show the environments in which are highly changeable and extremely acidic corrosive medium according to time and locations, e.g. in duct works, coolers and re-heaters etc. These conditions are formed when system materials are immersed in fluid that flows on them or when exhausted gas is condensed into thin layered acidic medium to contact materials of the system walls and roofs. These environments make troublesome corrosion and air pollution problems that are occurred from the leakage of the condensed solution. To cathodically protect the metallic structures in extremely acidic fluid, the properties of the protective coatings on the metal surface were very important, and epoxy Novolac coating was applied in this work. On the base of acid immersion tests, hot sulfuric acid decreased the hardness of the coatings and reduced greatly the content of $Na_2O$, $Al_2O_3$, and $SiO_2$ among the main components of the coating. A special kind of CP(Cathodic Protection) system has been developed and tested in a real scale of the FGD facility. Applied coating for this CP system was peeled off and cracked in some parts of the facility. However, the exposed metal surface to extremely acidic fluid by the failure of the coatings was successfully protected by the new CP system.

• Korean Journal of Materials Research
• /
• v.9 no.2
• /
• pp.217-225
• /
• 1999

The effect on the pitting corrosion resistance of laser welding and surface treatment developed as a repair method of stream generator tubing material that was a major component of primary system at nuclear power plant was observed. Some heat-treated Alloy 600 tubing materials used at domestic nuclear power plants were laser-surface observed. Some heat-treated Alloy 600 tubing materials used at domestic nuclear power plants were laser-surface melted and the microstructural characteristics were examined. The pitting corrosion resistance was examined through Ep(pitting potential) and degree of pit generation by means of the electrochemical tests and the immersion tests respectively. The pit formation characteristics were investigated through microstructural changes and the pit initiation site and pit morphology. The test results showed that the pitting corrosion resistances was increased in the order of the followings; sensitized Alloy 600, solution annealed alloy600, and laser surface melted Alloy 600. Pits were initiated preferably at Ti-containing inclusions and their surroundings in all tested specimens and it is believed that higher pitting resistance of laser-surface treated Alloy 600 was caused by fine, homogeneous distribution of non-soluble inclusions, the disappearance of grain boundary, and the formation of dense, stable oxide film. The major element of corrosion products filled in the pit was Cr. On the other hand, Fe was enriched in the deposit formed on the pit.

• Nuclear Engineering and Technology
• /
• v.53 no.7
• /
• pp.2261-2267
• /
• 2021

This paper evaluates the efficacy of magnesium potassium phosphate cements (MKPCs) as waste forms for the solidification of radioactive concrete powder wastes produced by the decommissioning of nuclear power plants. MKPC specimens that contained up to 50 wt% of simulated concrete powder wastes (SCPWs) were evaluated. We measured the porosity and compressive strength of the MKPC specimens, observing them using scanning electron microscopy and X-ray diffraction. The addition of SCPWs reduced the porosity and increased the compressive strength of the MKPC specimens. Struvite-K crystals were well-synthesized, and no additional crystal phase was formed. After thermal cycling and after immersion, MKPC specimens with 50 wt% SCPWs satisfied the waste-acceptance criteria (WAC) for compressive strength. Semi-dynamic leaching tests were performed using the ANS 16.1 method; the leachability indices of Cs, Co, and Sr were 11.45, 17.63, and 15.66, respectively, which also satisfy the WAC. Thus, MKPCs can provide stable matrices to immobilize radioactive concrete wastes generated by the decommissioning of nuclear power plants.

• Transactions of the Society of Information Storage Systems
• /
• v.4 no.1
• /
• pp.1-5
• /
• 2008

Super-resolution near-field structure (super-RENS) technology and solid immersion lens (SIL) based near-field (NF) technology have been expected as promising approaches to increase data capacity or areal density of optical disc. Super-RENS technology has been studied until now using mainly numerical aperture (NA) of 0.85 far-field optical system and possibility of tangential data density increment have been presented. NF technology has been studied with NA over 1 and presented demonstration of removable performance. To achieve much higher density, approach to increase NA of super-RENS by NF technology (Near-Field Super-Resolution, NFSR) can be a candidate and we think this technology would be advantageous compared to wavelength reduction or much higher NA increment of NF technology or much smaller effective optical spot size reduction of far-field super-resolution technology. In this paper we present readout result of ROM media having monotone pits using NF optical system with wavelength of 405nm and NA of 1.84 surface type SIL. GeSbTe material was used for super resolution active layer and pit length is 37.5nm which is shorter than resolution limit 55nm. We present the feasibility of NFSR technology by confirming the CNR threshold according to readout power (Pr) and CNR 33dB over threshold Pr.

• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.2
• /
• pp.84.1-84.1
• /
• 2013

We present a python-based data reduction pipeline for the Immersion GRating INfrared Spectrograph (IGRINS). IGRINS covers the complete H- and K-bands in a single exposure with a spectral resolving power of greater than 40,000. IGRINS is designed to be compatible with telescopes of diameters ranging from 2.7-m (the Harlan J. Smith telescope at McDonald Observatory) to 8-10m. Commissioning and initial operation will be on the 2.7-m telescope from late 2013. The pipeline package is a part of the IGRINS software and designed to be compatible with other package that maneuvers the spectrograph during the observation. This package provides high-quality spectra with minimal human intervention and the processes of order extraction, distortion correction, and wavelength calibration can be automatically carried out using the predefined functions (e.g. echellogram mapping and 2D transform). Since the IGRINS is a prototype of the Giant Magellan Telescope Near-Infrared Spectrometer (GMTNIRS), this pipeline will be extended to the GMTNIRS software.