• Journal of ILASS-Korea
• /
• v.28 no.1
• /
• pp.10-15
• /
• 2023

Recently, various types of towels and dishcloth dryer products are being widely distributed in Korea. Evaluation methods for water absorption properties of various fabrics have been developed, and there are many studies using them. This study newly intended that whether it is possible to obtain data that can quantitatively analyze the water absorption characteristics of various fabrics, to show the correlation between the water absorption height and the amount of water (water holdup) absorbed, and to experimentally suggest the applicability to evaluate the drying capacity of towel dryer using IR camera. Through these experiments, it was confirmed that quantitative data on the water absorption height of various fabrics can be measured using an IR camera and can be clearly applied to the performance evaluation of actual products.

• Journal of the Korean Ceramic Society
• /
• v.25 no.1
• /
• pp.1-6
• /
• 1988

The IR edge absorption of the important pure components of ZrF4-based glasses, including two previously uncharacterized components(ZrF4 and AlF3), has been measured. Values of the glass IR edge absorption coefficients have been calculated from these results, assuming additivity, and are compared with experimental glass absorption coefficients. The calculated ${\alpha}$ values are about a factor of two lower than the experimental values for ZrF4-based glasses, and the ZrF4 makes the largest contribution to the calculated ${\alpha}$ value.

• Journal of the Korean Ceramic Society
• /
• v.31 no.2
• /
• pp.201-205
• /
• 1994

Glasses being prepared, measurements and investigations of glass transition temperature and IR edge optical absorption have been performed for the compositions of 56ZrF4-14BaF2-6LaF3-4AlF3-(20-x)NaF-xLiF. Values for transition temperature of these glasses decrease in proportion to increasing LiF mol%(x) in the range of 0

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.62 no.12
• /
• pp.1725-1729
• /
• 2013

In this paper, the modeling and simulation of infrared absorption in an infrared absorbing structure with the cascaded transmission line model were carried out. Each layer in the infrared absorbing structure can be modeled as a characteristic impedance of the cascaded transmission line model. The simulation results show that the cavity thickness to get a maximum absorption should be less than a quarter wavelength, which is somewhat different from prevalent thickness. It can be assured that the sheet resistance of an absorbing layer to get a maximum absorption is $377{\Omega}/{\square}$, that the thickness of the absorbing layer dose not affect the spectral characteristics of absorption. It is also shown that the thickness of the active layer is not critical to the IR absorption. It can also be assured that the validation of this modeling is proved in comparison with the previous results from similar absorbing structures.

• Journal of the Korean Ceramic Society
• /
• v.22 no.3
• /
• pp.29-34
• /
• 1985

The IR spectra of he heavy metal fluoride glasses showed peaks at $1, 400cm^{-1}$ or $1, 100cm^{-1}$ due to metal oxyfluoride impurities. The intensity of this band and hence the oxide impurity content of the glass could be reduced considerably by the use of reactive atmosphere melting under $CCl_4$ In comparison with the fundamental IR absorption band of heavy metal oxides the oxide impurity bands observed in the heavy metal fluoride glasses are multiphonon bands due to a 2-phonon absorption process. The envelope of the a vs. v curve beyond thue fundamental region shows the exponential fall off of a with increasing v-typical of intrinsic multiphonon absorption. In the multiphonon region the amount of structure is intermediate between that observed for covalent solids and that for ionic solids.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.16 no.1
• /
• pp.25-31
• /
• 2006

Many amethysts of different origins such as South America, Aftrica, and Asia were compared. According to ICP-AES analysis, the colorizing elements were Fe, Cr, Cu, and Co. Amethysts from South America showed higher concentrations of the elements. UV- VIS analysis showed that both natural and synthetic amethysts were characterized by the higher absorption at 350 nm and 550 nm wavelength. The natural amethysts had lower permeability than that of the synthetic amethysts. According to FT-IR analysis, the synthetic amethysts were distinguished from the natural amethysts in that they had a typical absorption band of $3543cm^{-1}$. The amethyst from South America showed strong absorption bands of $3584cm^{-1}\;and\;3435cm^{-1}$, and African amethyst had absorption bands of $3299cm^{-1}\;and\;3196cm^{-1}$. $3381cm^{-1}$ absorption band was shown strongly for Asian origins.

• Journal of the Korean Society of Radiology
• /
• v.16 no.1
• /
• pp.61-66
• /
• 2022

The purpose of this study is to derive photon energy fluence and mass energy absorption coefficient for 1 Gy of absorbed dose of water in brachytherapy using an Ir¹⁹² source. From the radiotherapy physics written by Khan, the half-value of lead for the gamma ray beam of the Ir¹⁹² source was obtained. The linear attenuation coefficient and the mass attenuation coefficient were calculated from the obtained half-value layer of lead. By matching the calculated lead mass attenuation coefficient with the NIST mass attenuation coefficient data, the photon energy of the matching mass attenuation coefficient was determined as the effective energy. By matching the determined effective energy with the photon energy of the NIST data on the mass energy absorption coefficient of water, the mass energy absorption coefficient of water was obtained as 0.03273 cm²/g(32.73 cm²/kg). The photon energy fluence was calculated as 0.03055 J/cm² by dividing the obtained mass energy absorption coefficient (32.73 cm²/kg) by the absorbed dose of water 1 Gy.

• Food Science and Biotechnology
• /
• v.18 no.2
• /
• pp.546-551
• /
• 2009

The objective of this study was to investigate Fourier transform infrared (FT-IR) spectrometry and the X-ray diffraction (XRD) characterization of melanoidins formed from glucose and fructose with amino acid enantiomers in the Maillard reaction. Before dialysis, FT-IR spectroscopy of all the samples showed that the characteristic absorption intensities appeared as a broad and intense band of the stretching vibration of the -OH group at 3,400/cm for a high pH. The absorption bands of the melanoidins sharply decreased in intensity after dialysis as compared to those before dialysis. In particular, the absorption bands at 992 and 575/cm disappeared. The XRD confirmed that the crystal structure of the melanoidins disappeared after dialysis and a new crystal structure was formed at 9 and $28^{\circ}$ ($2{\theta}$. In particular, broad diffraction peaks were formed in the $10-21^{\circ}$ ($2{\theta}$) range for a high pH, while other sharp diffraction peaks disappeared.

• Korean Journal of Materials Research
• /
• v.13 no.10
• /
• pp.697-702
• /
• 2003

FT-IR and thermograph were used to investigate the infrared radiation characteristics of $SiO_2$film made by the sol-gel method. FT-IR spectrum of the $SiO_2$film showed high infrared absorption by Si-O-Si vibration at 1220, 1080, 800 and cm$460^{-1}$ The infrared absorption and radiation wavelength ranges of the $SiO_2$film measured by the integration method coincided with the reflection method, and the infrared emissivity was 0.65, equally. Depending on the bonding of elements, the infrared emissivity was high in the wavelength range where the infrared absorption rate was high, that follows the Kirchhoff's law. The emissivity showed the highest value in the wavelength range between $8∼10\mu\textrm{m}$. $SiO_2$film was considered as an efficient materials for infrared radiator at temperature below 10$0^{\circ}C$. The heat radiation temperature was $117^{\circ}C$ for the aluminum plate, but $146^{\circ}C$ for the $SiO_2$film after 7 minutes heat absorption, consiquently, $29^{\circ}C$ higher than the former.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1997.10a
• /
• pp.111-115
• /
• 1997

Iron-doped LiNbO$_3$ crystals were grown by floating zone(FZ) method with different [Li]/[Nb] ratio in order to investigate doping effects of transition metal impurity in LiNbO$_3$ crystal. The grown crystals were analyized edge in UV/VIS/IR spectrometry and EPMA(electron probe micro-analysis). The absorption edge in UV-VIS region and OH-absorption peak in IR region were investigated. The change of Fe concentration along the solidification direction was also investigated