• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.11
• /
• pp.2317-2322
• /
• 2009

In this paper, look into the applicable communication for unmanned vehicle system development, and make an alternative idea to IEEE 802.11a. "IEEE 802.11a" is differently from "IEEE 802.11b/g"-which used to 2.4GHz ISM band-as it use OFDM modulation system of 5GHz band, as contrasted with "IEEE 802.11b/g" of ISM band, it has advantage against falling-off the capability caused by interfered, and provide maximum 54Mbps communication speed. Made a priority tested Soft Roaming and Hard Roaming to ensure the sound boom of unmanned vehicle in the flat parking. According to the each effect value, Present a most suitable method of applicable to "IEEE 802.11a" to unmanned vehicle system.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.11 no.3
• /
• pp.161-168
• /
• 2011

This paper provides the performance measurement and analysis of Wireless LAN IEEE 802.11 in a mobile environment. The performances of IEEE802.11b/g and IEEE802.11p designed for Vehicle-to-Vehicle(V2V) communication are measured and analyzed. Diameter of communication and link access time are compared under variation of speed of the vehicle.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10A
• /
• pp.816-822
• /
• 2011

This paper provides the performance measurement and analysis of Wireless LAN IEEE 802.11 in a mobile environment. The performance of IEEE802.11b/g and IEEE802.11p that is designed for Vehicle-to-Vehicle(V2V) communication is measured and analyzed. Diameter of communication, link access time and delay are measured as vehicle's speed varies. Also, the performance is checked in a situation that the load to network varies. In conclusion, the futher research topics are discussed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.8A
• /
• pp.640-647
• /
• 2009

IEEE 802.11i is an amendment to the original IEEE 802.11/b,a,g standard specifying security mechanism by stipulating RSNA for tighter security. The RSNA uses TKIP(Temporal Key Integrity Protocol) and CCMP(Counter with CBC-MAC Protocol) instead of old-fashioned WEP(Wired Equivalent Privacy) for data encryption. This paper describes a design of a communication security engine for IEEE 802.11i MAC layer. The design includes WEP and TKIP modules based on the RC4 encryption algorithm, and CCMP module based on the AES encryption algorism. The WEP module suffices for compatibility with the IEEE 802.11 b,a,g MAC layer. The CCMP module has about 816.7Mbps throughput at 134MHz, hence it satisfies maximum 600Mbps data rate described in the IEEE 802.11n specifications. We propose a pipelined AES-CCMP cipher core architecture, which has lower hardware cost than existing AES cores, because CBC mode and CTR mode operate at the same time.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.10A
• /
• pp.1003-1013
• /
• 2006

There is a serious problem in an 802.11g VoWLAN (Voice over Wireless LAN) terminal that talk time is less than 30% compared with an 802.11b terminal. It is almost impossible to achieve talk time level of the 802.11b MAC transmission method because IEEE 802.11g uses OFDM modulation, which is a kind of multi-carrier method and OFDM transmission speed is 54 Mbps faster than normal modulation. In this paper, a new concept of a Holdover time as a power saving method during a call with 802.11g terminal is suggested for the first time. Increase in the number of engaged terminals as a result of holdover time causes to QoS problem because of the increase in the number of back-off and then contention window. In this paper, to solve the QoS problem, a new approach is suggested such that when in down lint the sequence number of 802.11 G.711 is analyzed in the MAC of the terminal and then the Hold over time depending on loss rate is changed. Also, consumption of an electric current of 802.11b/g and MAC parameter's performance due to busy traffic caused by increase in the number of terminal are analyzed and then real data using VQT and Airopeek are analyzed.

• 한국ITS학회:학술대회논문집
• /
• v.2006 no.10
• /
• pp.108-112
• /
• 2006

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.6
• /
• pp.116-126
• /
• 2008

This paper describes the Dual-band WLAN transmitter with 2.4[GHz], 5[GHz]. Dual-band WLAN transmitter was designed at 2.4[GHz] and 5[GHz]. The Dual-band WLAN transmitter has a amplifier which operate at 2.4[GHz] and 5[GHz] frequency and two VCO(Voltage Controlled Oscillator) or VCO has a wide scope of frequency. these problem cause a size and a power consumption, The Dual-band WLAN transmitter module was proposed to solve these. the transmitter was designed to get output signals of IEEE 802.11a's 5.8[GHz] band signal using frequency multiplication way or to act a amplifier about the 2.4[GHz] band signal of IEEE 802.11b/g, according to inputed frequency and bias voltage that a eve using single transmission block. The output spectrum get the improved specification of ACPR of 4[dB], 6[dB], 16[dB] at +11[MHz], +20[MHz], +30[MHz] offset of center frequency compared to no linearization, was satisfied to transmit spectrum mask of IEEE 802.11a wireless Lan.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.1A
• /
• pp.115-124
• /
• 2007

In this paper, the I/Q mismatch problem between the transmission line and antenna switch is solved by a new CPW matching circuit for a VoWLAN terminal with 54 Mbps communication speed through the IEEE 802.11 b/g CCK/OFDM. I/Q performances with the new matching circuit are analyzed and improved by the output spectrum mask, the characteristics of the EVM(Error Vector Magnitude) due to the nonlinear CCK/OFDM demodulation data, and receiver's sensitivity.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.1
• /
• pp.175-181
• /
• 2015

In this paper, we develop a 2.4GHz ISM band wireless communication platform prototype based on embedded linux which support can be u-Hospital service. The developed system is available connecting between ARM920T processor board and FPGA board and linking IEEE 802.11b PHY board, AD/DA(10Bit) and RF(2.4GHz) board for wireless access. It is also can be utilized for the embedded system design with IEEE 802.11b/g Access Point(Option: IEEE 802.11a/b/g) test due to the Embedded Linux. Also, the developed system is possible to test and verify the radio access technology, Modem(OFDM etc) and IP(Intellectual Property) circuit. And make the most use of the system, we search for a expansion to that home and mobile healthcare, wellness service application.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.2
• /
• pp.243-248
• /
• 2012

In this paper we simulate the capacity of VOIP calls through WiFi network by computer simulations using OPNET modeler. The results show that sudden quality degradations occur on all VoIP calls when the number of call of an AP(Access Point) increases beyond a specific value. The reason of the quality degradation was turned out to be the queueing delay at the down link of AP. Under the IEEE 802.11b environments, the maximum number of VoIP calls of an AP maintaining the required voice quality (MOS > 2.5), was evaluated as 5, 12, and 27 when we use G.711, G.729a, and G.729a VAD codec, respectively.