• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.5
• /
• pp.889-895
• /
• 2008

In this paper a Fractional-N frequency synthesizer is designed for UHF RFID readers. It satisfies the ISO/IEC frequency band($860{\sim}960MHz$) and is also applicable to mobile RFID readers. A VCO is designed to operate at 1.8GHz band such that the LO pulling effect is minimized. The 900MHz differential I/Q LO signals are obtained by dividing the differential signal from an integrated 1.8GHz VCO. It is designed using a $0.18{\mu}m$ RF CMOS process. The measured results show that the designed circuit has a phase noise of -103dBc/Hz at 100KHz offset and consumes 9mA from a 1.8V supply. The channel switching time of $10{\mu}s$ over 5MHz transition have been achieved, and the chip size including PADs is $1.8{\times}0.99mm^2$.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.11a
• /
• pp.209-212
• /
• 2002

The realization for code domain analyzing system on WCDMA is presented. This system is realized with the RF, FPGA and DSP processor. The FPGA firgures out the scambling code, and DSP produces the power of code domain using OVSF. The experiment results allow the code domain power accuracy to keep $\pm$1dB low. This system leads to split the text, sound and image signal.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.303-306
• /
• 2006

A roll rate estimation method is proposed using the GPS measurement for spinning vehicles such as guided munitions and smart bombs. Before designing the roll rate estimator, the carrier phase and the carrier frequency deviation caused by spinning have been observed. Based on the observation, the spinning frequency is estimated using I and Q value from the correlator. The proposed method is evaluated through computer simulations using a software defined receiver and a GPS IF signal generator.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.2
• /
• pp.395-398
• /
• 2006

In this paper, for implementing a real-time software GNSS receiver we propose the highly efficient and fast algorithms such as partial down-conversion, phase rotator, composite I&Q accumulation, Virtual DCO technique, and parallel acquisition using FFT. When the proposed algorithms are used, more 30 tracking channels with 3 tracking arm(early-prompt-late) is operated real-time on Intel 2.8GHz personal computer. Also, the partial down-conversion reduces the FFT size, for parallel acquisition, to 1/8 of conventional FFT-size and the program size includes map is not exceed 1Mbyte. Finally, the proposed real-time software GNSS receiver using the proposed algorithms provides the navigation solution with below 10 meter rms error.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.7
• /
• pp.761-768
• /
• 2010

This paper presents an effective method to achieve the wideband waveform for high resolution SAR(Synthetic Aperture Radar) using the frequency multiplication technique. And also this paper analyzes the root causes for the spectral regrowth due to 3rd-order intermodulation in chirp bandwidth expansion scheme using quadrature modulator and frequency multipliers. The amplitude and phase imbalance requirement are defined based on the simulation results in terms of quadrature channel imbalance. This minimizes the degradation of range resolution, peak sidelobe ratio and integrated sidelobe ratio. The wideband chirp generator using the frequency multiplier and memory map scheme was manufactured and the compensation technique was presented to reduce the spectral regrowth of SAR waveform by minimizing the amplitude and phase imbalance. After I and Q channel imbalance adjustment, the carrier level reduces －28.7 dBm to －53.4 dBm. Chirp signal with 150 MHz bandwidth at S-band expands to 600 MHz bandwidth at X-band. The sidelobe levels are reduced by about 8 to 9 dB by compensating the amplitude balance between I and Q channels.

• Proceedings of the KIEE Conference
• /
• 1996.07a
• /
• pp.603-605
• /
• 1996

The SLIM used in the conveyance system has been generally developed the controller based on the slip frequency control and the VVVF method to obtain the quick response for the position control signal. This paper deals with the trust control of the SLIM by vector control with Bang-Bang condition. Also, the control system is composed of the PI controller for soft start of the SLIM and the q-axis current controller for correction in phase with Space Vector for reducing the harmonic pulsation in low speed. The processing for vector control and robust dynamic breaking control is carried out by MC80196KC micro processor and IGBT module. The proposed scheme is verified through the computer simulation and experiments for the 10KW SLIM.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.10
• /
• pp.27-33
• /
• 2004

In this paper, we present a carrier recovery circuit using the polarity-decision algorithm that recovers a phase and a frequency error simultaneously. The proposed algorithm catches a frequency error based on a differential of an angular velocity of the signal constellations. Using the differential of a phase error may compensate the frequency error. The symbol prediction method in the proposed algorithm accumulates the symbols, which makes easy to calculate a phase differential. The hardware size of the algerian is small since we use Q data or I only to get phase information. As a result, the algerian shows a pull-in range of normalized frequency error 0.5 under AWGN 15dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.3A
• /
• pp.282-290
• /
• 2006

In this paper, we propose an enhanced Timing Estimator algorithm for 2.45GHz LR-WPAN receiver. Because an expensive and highly efficient oscillator can't be used for low-cost implementation, a Timing Estimator algorithm having stable operation in the channel environment with center frequency tolerance of 80 ppm is required. To enhance the robustness to frequency offset and the stability of receiver performance, multiple delay differential filter is adopted. By utilizing the characteristic that the correlation result between the output signal of Multiple delay differential filter and reference signal is restricted on the In-phase part of the correlator output, a coherent detection scheme instead of the typical noncoherent one is adopted for Timing Estimator. The application of the coherent detection scheme is suitable for LR-WPAN receiver aimed at low-cost, low-power, and low-complexity, since it can remove performance degradation due to squaring loss of I/Q squaring operation and decrease implementation complexity. Computer simulation results show that the proposed algorithm achieved performance improvement compared with the differential detection-based noncoherent scheme by 2dB in average.

• Journal of Animal Science and Technology
• /
• v.46 no.4
• /
• pp.537-546
• /
• 2004

Adiponectin is adipocyte complement-related protein which is highly specialized to play important roles in metabolic and honnonal processes. This protein, called GBP-28, AdipoQ, and Acrp30, is encoded by the adipose most abundant gene transcript 1 (APM1) which locates on human chromosome 3q27 and mouse chromosome 16. In order to determine chromosomal localization of the porcine APM1, we carried out PCR analysis using somatic cell hybrid panel as well as porcine whole genome radiation hybrid (RH) panel. The result showed that the porcine APM1 located on chromosome 13q41 or 13q46-49. These locations were further investigated with the two point analysis of RH panel, revealed the most significant linked marker (LOD score 20.29) being SIAT1 (8 cRs away), where the fat-related QTL located. From the SSCP analysis of APM1 using 8 pig breeds, two distinct SSCP types were detected from K~ native and Korean wild pigs. The determined sequences in Korean native and Korean wild pigs showed that two nucleotide positions (T672C and C705G) were substituted. The primary sequence of the porcine APM1 has 79 to 87% identity with those of human, mouse, and bovine APM1. The domain structures of the porcine APM1 such as signal sequence, hypervariable region, collagenous region. and globular domain are also similar to those of mammalian genes.

• Journal of Microbiology and Biotechnology
• /
• v.24 no.4
• /
• pp.431-439
• /
• 2014

We report the construction of two Bacillus subtilis expression vectors, pBNS1/pBNS2. Both vectors are based on the strong promoter P43 and the ampicillin resistance gene expression cassette. Additionally, a fragment with the Shine-Dalgarno sequence and a multiple cloning site (BamHI, SalI, SacI, XhoI, PstI, SphI) were inserted. The coding region for the amyQ (encoding an amylase) signal peptide was fused to the promoter P43 of pBNS1 to construct the secreted expression vector pBNS2. The applicability of vectors was tested by first generating the expression vectors pBNS1-GFP/pBNS2-GFP and then detecting for green fluorescent protein gene expression. Next, the mannanase gene from B. pumilus Nsic-2 was fused to vector pBNS2 and we measured the mannanase activity in the supernatant. The mannanase total enzyme activity was 8.65 U/ml, which was 6 times higher than that of the parent strain. Our work provides a feasible way to achieve an effective transformation system for gene expression in B. subtilis and is the first report to achieve B. pumilus mannanase secretory expression in B. subtilis.