• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.2
• /
• pp.63-67
• /
• 2003

Synthesis of $PbLaTiO_{3}$ : Mn powders containing La and Mn was carried out using $PbO,\;TiO_{2},\;La_{2}O_{3}\;and\;MnO_{2}$ as starting materials by hydrothermal method. In the synthesis of single phase $PbLaTiO_{3}$ : Mn powder containing La and Mn, the optimal x value corresponding to La substitution was 0.01 which corresponds to $0.99(Pb_{1-x}La_{2x/3}TiO_{3})+0.01MnO_{2}$. The optimal conditions for the preparation of the powder synthesis were 8 M-KOH solvent of hydrothermal solvent, $270^{\circ}C$ of reaction temperature and 24 hrs of run time. It was found that the synthesized powders had spherical morphology with average particle size of 70 nm and specific surface area of $5.5\;m^{2}/g$.

• Korean Journal of Materials Research
• /
• v.21 no.4
• /
• pp.232-235
• /
• 2011

ZnO nanorods for gas sensors were prepared by a hydrothermal method. The ZnO gas sensors were fabricated on alumina substrates by a screen printing method. The gas-sensing properties of the ZnO nanorods were investigated for $CH_4$ gas. The effects of growth time on the structural and morphological properties of the ZnO nanorods were investigated by X-ray diffraction and scanning electron microscope. The XRD patterns of the nanocrystallized ZnO nanorods showed a wurtzite structure with the (002) predominant orientation. The diameter and length of the ZnO nanorods increased in proportion to the growth time. The sensitivity of the ZnO sensors to 5 ppm $CH_4$ gas was investigated for various growth times. The ZnO sensors exhibited good sensitivity and rapid response-recovery characteristics to $CH_4$ gas, and both traits were dependent on the growth time. The highest sensitivity of the ZnO sensors to $CH_4$ gas was observed with the growth time of 7 h. The response and recovery times were 13 s and 6 s, respectively.

• Journal of Powder Materials
• /
• v.23 no.4
• /
• pp.270-275
• /
• 2016

We report on an all-solution-processed hydrothermal method to control the morphology of ZnO nanostructures on Si substrates from three-dimensional hemispherical structures to two-dimensional thin film layers, by controlling the seed layer and the molar contents of surfactants during their primary growth. The size and the density of the seed layer, which is composed of ZnO nanodots, change with variation in the solute concentration. The ZnO nanodots act as heterogeneous nucleation sites for the main ZnO nanostructures. When the seed layer concentration is increased, the ZnO nanostructures change from a hemispherical shape to a thin film structure, formed by densely packed ZnO hemispheres. In addition, the morphology of the ZnO layer is systematically controlled by using trisodium citrate, which acts as a surfactant to enhance the lateral growth of ZnO crystals rather than a preferential one-dimensional growth along the c-direction. X-ray diffraction and energy dispersive X-ray spectroscopy results reveal that the ZnO structure is wurtzite and did not incorporate any impurities from the surfactants used in this study.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.1
• /
• pp.100-104
• /
• 1994

KTP seed crystals were grown by the hydrothermal method and the properties of grown crystals were investigated by means of infrared spectrophotometer. The hydrothermal conditions for high growth rates of seed crystals are as follows: temperature ranges, between , $430 and 450^{\circ}C $ ; hydrothermal solvent, 4m KF solution ; temperatures difference, $30<{\triangle}T<65^{\circ}C$ ; filling %, 65% ; growth method, vertical temperature gradient method. Under these conditions, morphologies of the grown KTP single crystals tended to be bounded by (100), (011) and (201) faces and hydroxyl groups were observed in the grown crystals.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.4
• /
• pp.145-151
• /
• 2005

Color enhancement of African rubies with dark red was carried out by the heat treatment and the hydrothermal treatment method respectively. The heat treatment method brought about an adverse effect causing the color to be deteriorated. However, the hydrothermal treatment method enhanced its color and clarity. The hydrothermal treatment conditions for color enhancement of them were as follows: solvent: 0.9M $Na_2CO_3-1M\;K_2CO_3$, temperature: $450^{\circ}C$, duration: 48 hrs, filling: $30\%$, pressure: 375 atm. As the results of characteristics for African rubies obtained under these conditions, it was known that the amount of $Cr^{3+},\;Fe^{3+},\;Ti^{4+}$ was reduced after the hydrothermal treatment from the ICP/MS and XRF analyses. Also, it was found that the red color from the colorimeter analyses was getting lighter. These results were consistent with the PL analysis showing that the intensity of the luminescence peak generated by the electron transition of $Cr^{3+}$ ion became lower after the hydrothermal treatment compared with the non-treated rubies.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.1 no.1
• /
• pp.60-65
• /
• 1991

The hydrothermal growth of $GaPO_{4}$ Single Crystals was carried out by the horizontal temperature gradient method. The most promising solvents for the crystal growth of $GaPO_{4}$ are $H_{3}PO_{4}$ and HCl solutions. Single crystals have been hydothermally grown at temperatures over the range $210-290^{\circ}C$ in these solutions with seed crystals. The glowth rates in HCl solution were higher than that for comparable conditions in $H_{3}PO_{4}$ solution. Morphologies of crystals grown at temperatures below $200^{\circ}C$ tended to be bounded by small major rhombohedral(10$\bar{1}$1) faces. In the temperature range from 200 to $430^{\circ}C$, the single crystals have morphologies bounded by prism (10$\bar{1}$0), small major rhombohedral(10$\bar{1}$1) and minor rhombohedral(01$\bar{1}$1) faces at the early stage, and grew with well developed basal(0001) faces by increasing the growth temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.2
• /
• pp.139-147
• /
• 1994

Orthophosphate crystals were grown by the hydrothermal method and the properties of grown crystals were investigated by means of X-ray diffraction. Vickers hardness tester, etc. The starting powders of $AIPO_4 and GaPO_4 $were prepared as a single phase by the solid state reaction of stoichiometric mixture of $AI_2O_3 or Ga_2O_3$ and $NH_4H_2PO_4$ and the subsequently by the hydrothermal treatment. The hydrothermal conditions for high growth rates of the orthophosphate crystals are as follows: $AlPO_4$ crystal; temperature ranges, between $170$~$200^{\circ}C$; temperatures difference, $15$~$20^{\circ}C;$, hydrothermal solvent, 4m HCl, $GaPO_4 crystal; temperature ranges, between $210 and 240^{\circ}C;$; temperature difference, $25$~$30^{\circ}C; $, hydrothermal solvent, 4m HCl. Morphologies of grown crystals tended to be bounded by (1010), (1011) and (0111) faces at low temperatures, and grew with well developed (0001) faces by increasing the growth temperature. On the other hand, the properties of orthophosphate crystals $(AlPO_4/GaPO_4)$ were as follows: lattice parameters (nm); a=0.494, c=1.094/a=0.490, c=1.105, density (gcm-3); 2.62/3.56, Vickers hardness (Nm^2); $1.02{\times}10^1^0/7.06{\times}10^9$, refractive indices; $ne=1.529{\pm}0.003, no=1.519{\pm}0.003/ne=1.611{\pm}0.006, no=1.599{\pm}0.006, birefringence; {\pm}0.01/{\pm}0.012$, dielectric constant (Fm-1); 6/7.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.2
• /
• pp.370-376
• /
• 1998

The powder preparation of Zinc-Silicate phosphors compound was studied by hydrothermal reaction starting from the precursor which prepared by spray pyrolysis method. This process protect including of impuritied from crushing process and Mineralizing in hydrothermal reactions. Using spray pyrolysis precursor, ${\alpha}-Zn_2SiO_4$ powder was prepared by the hydrothermal reaction under $250^{\circ}C$.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.6 no.2
• /
• pp.254-262
• /
• 1996

$Pb(Zr_{0.52}Ti_{0.48})O_{3}$ (PZT) ceramics were prepared with uniform particle size of $1~3\;\mu\textrm{m}$ by hydrothermal synthesis at various conditions, such as hydrothermal reaction temperature, concentration of mineralizer and reaction time. PZT ceramics were formed above $180^{\circ}C$ for 2 hrs reaction using 10 M KOH solution as a mineralizer, but reaction condition was slightly different by starting materials. Morphology and characterization of PZT powders were investigated by XRD and SEM. By increasing the reaction temperature, KOH concentration and reaction time, the composition of the PZT phase tended to be homogeneous phase.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.281-281
• /
• 2010

In this study, ZnO nanorod arrays are grown on organic substrates by hydrothermal method which requires a low temperature, simple process, and no vacuum. The structure properties of ZnO nanorods were examined by field emission scanning electron microscopy and X-ray diffraction. To detect the optical transmission, ultraviolet visible spectrophotometer was also used. From results, the ZnO nanorods were grown the horizontal growth on the organic substrates had the length of over $10\;{\mu}m$. After deposition of ZnO seed layer, the ZnO nanorod arrays had uniformity orientation and length.