• Journal of Korean Society of Water and Wastewater
• /
• v.24 no.1
• /
• pp.15-24
• /
• 2010

Coagulation can be used for pretreatment of NF membrane filtration. Foulants such as organic matter and particulate can be removed effectively with the process while high flux recovery is maintained. Recently various types of polyaluminium coagulants including polyaluminium chloride(PAC) are commercially available for water treatment. This study examines effects of polymeric Al and hydrolysis products of PAC on nanofiltration membrane performance. Dominant hydrolysis products were polymeric Al, $Al(OH)_3$, and ${Al(OH)_4}^{-1}$ at acidic, neutral, and alkaline pH conditions, respectively. Under acidic pH condition, flux decline was increased with increasing PAC concentrations, possibly due to polymeric Al adsorption on membrane pore and/or surfaces. For neutral and alkaline pH conditions, little flux decline was observed with increasing PAC concentrations except the highest ${Al(OH)_4}^{-1}$ concentration, with which rapid flux decline was shown. Removal of ionic matters was also varied with pH conditions in this study. Especially, conductivity removal was substantially low and $Ca^{2+}$ concentration in the permeate was quite high at neutral pH condition.

• Journal of Ginseng Research
• /
• v.17 no.1
• /
• pp.35-38
• /
• 1993

A new and rapid method for the hydrolysis of ginsenosides to panaxadiol or panaxatriol was developed. It is based on the microwave oven reaction, which is high temperature and high-pressure reaction. The optimal hydrolysis time using 5% $H_2SO_4$ solution was found at 10 min PTFE reaction vessel in microwave oven, which is more than 30 times faster than the conventional hydrolysis method.

• Korean Chemical Engineering Research
• /
• v.52 no.2
• /
• pp.226-232
• /
• 2014

In this study, we investigated kinetic model for the acid-catalyzed xylan hydrolysis at temperature $120{\sim}150^{\circ}C$. Also, we analyzed the kinetic parameters for xylose production and furfural decomposition. The hydrolysis of xylan and the degradation of xylose were promoted by high reaction temperature and acid concentration. The optimal hydrolysis condition for the highest reaction rate constants ($k_1$) was different depending on the acid catalysts. Among sulfuric, oxalic and maleic acid, the xylan reaction rate constants ($k_1$) to xylose had the highest value of $0.0241min^{-1}$ when 100 mM sulfuric acid was used at $120^{\circ}C$. However, sulfuric acid induced more xylose degradation compared to oxalic and maleic acid hydrolysis. The activation energy for xylan degradation was the highest when sulfuric acid was used.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.1
• /
• pp.176-185
• /
• 2016

Yeonsan Ogae has been known as supporting health and high efficacy of treatment. In recent days, as the efficacy of functional peptides has known, the optimization of oligo peptides production and its characteristics from Ogae legs has been performed. Response surface method was used to perform the optimizaion of enzyme hydrolysis. The range of processes was temperature ( 40, 50 and $60^{\circ}C$), pH( pH 6.0, 7.0 and 8.0 ), and enzyme( 1, 2 and 3% ). The degree of hydrolysis, amino acids, molecular weight of products were analyzed. The optimum process of enzyme hydrolysis were determined as temperature $58^{\circ}C$, pH 7.5, and enzyme concentration 3%. At optimum conditions, the degree of hydrolysis after 2 h reaction was 75-80%. The amino acid and were 168.131 mg/100 g, respectively. The molecular weight of products by using MALDI-TOF was ranged from 300 to 1,000 Da.

• Journal of the Korean Applied Science and Technology
• /
• v.8 no.2
• /
• pp.161-167
• /
• 1991

The kinetics of hydrolysis of cinnamenylisophorone derivatives (${rho}-H,\;{rho}-Br,\;P-Cl,\;{rho}-OCH_3$) was investigated using ultraviolet spectrophotometry in 20%(v/v) dicxane-$H_2O$ at 25$^{\circ}C$. A rate equation which can be applied over wide pH range (pH $1.0{\sim}13.0$) was obtained. In order to investigate the substituent effects on cinnarnenylisophorone derivatives, Hammett constant was plotted. As the result, the rate of hydrolysis of cinnamenylisophorone derivatives was facilitated by electron donating group. Final products of the hydrolysis were benzaldehyde and isophorone, From the measurement of reaction rate constant according to pH changes, substituent effect, and final products, it was found that the hydrolysis of cinnarnenylisophorone derivatives was initiated by the neutral $H_2O$ molecule which does not dissociated at below pH 9.0, and in the range of pH $9.0{\sim}11.0$ this reaction occurs by $H_2O$ or hydroxide ion competitively, but proceeded by the hydroxide ion above pH 11.0. On the basis of this kinetic study, the reaction mechanism of the hydrolysis of cinnamenylisophorone derivatives was proposed.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.41 no.5
• /
• pp.26-32
• /
• 2009

As a part of utilizing the nanocellulose (NC) from lignocellulosic components of wood biomass, this paper reports preliminary results on the products of sulfuric acid hydrolysis. The purpose of this study was to investigate the morphology of both NC and micro-sized cellulose fiber (MCF) isolated by acid hydrolysis from commercial microcrystalline cellulose (MCC). Field emission.scanning electron microscopy (FE-SEM) and transmission electron microscopy (TEM) were employed to observe the acid hydrolysis suspension, NC, and MCF. The electron microscopy observations showed that the acid hydrolysis suspension, before separation into NC and MCF by centrifugation, was composed of nano-sized NCs and micro-sized MCFs. The morphology of isolated NCs was a whisker form of rod-like NCs. Measurements of individual NCs using TEM indicated dimensions of 6.96$\pm$0.87 nm wide by 178$\pm$55 nm long. Observations of the MCFs showed that most of the MCC particles had de-fibered into relatively long fibers with a diameter of 3-9 ${\mu}m$, depending on the degree of acid hydrolysis. These results suggest that proper technologies are required to effectively realize the potentials of both NCs and MCFs.

• Fashion & Textile Research Journal
• /
• v.18 no.6
• /
• pp.889-896
• /
• 2016

This study aims to evaluate the hydrolytic activity of a commercial nitrilase and optimize nitrilase treatment conditions to apply eco-friendly finishing on acrylic fabrics. To assess the possibility of hydrolyzing nitrile bonds in acrylic fabric using a commercial nitrilase, the amounts of hydrolysis products, ammonia and carboxylate ions, were measured. The treatment conditions were optimized via the amount of ammonia. The formation of carboxylate ions on the fabric surface was detected by X-ray photoelectron spectroscopy and wettability measurements. After nitrilase treatment, ammonia was detected in the treatment liquid; thus, nitrilase hydrolyzed the nitrile bonds in acrylic woven fabric. The largest amount of ammonia was released into the treatment liquid under the following conditions: pH 8.0, $40^{\circ}C$, and a treatment time of 5 h. The formation of carboxylate ions on the acrylic woven fabric surface by nitrilase hydrolysis was proven by the increased O1s content measuring of XPS analysis. From comparison of the results of nitrilase and alkaline hydrolysis, the white index and strength of the alkali-hydrolyzed acrylic fabric decreased, whereas those of the nitrilase-hydrolyzed samples were maintained. The nitrilase hydrolysis improved the sensitivity of acrylic fabrics to basic dye similarly to alkaline hydrolysis without the drawbacks of yellowing and decreased strength caused by alkaline hydrolysis.

• Journal of the Korean Wood Science and Technology
• /
• v.38 no.5
• /
• pp.429-438
• /
• 2010

In this study, effect of carbon source on the hydrolytic ability of the enzyme from Fomitopsis pinicola, a brown rot fungi, for lignocellulosic biomass were examined on two lignocellulosic biomasses (rice straw and wood) without any pretreatment. Cellulase activities of crude enzyme from F. pinicola, which was cultured on softwood mixture as a carbon source, were 19.10 U/$m{\ell}$ for endo-${\beta}$-1,4-gulcanase (EG), 36.1 U/$m{\ell}$ for ${\beta}$-glucosidase (BGL), 7.27 U/$m{\ell}$ for cellobiohydrolase (CBH), and 7.12 U/$m{\ell}$ for ${\beta}$-1,4 xylosidase (BXL). Softwood mixture as a carbon source in F. pinicola comparatively enhanced cellulase activities than rice straw. The optimal pH and temperature of the cellulase was identified to pH 5 and $50^{\circ}C$for the hydrolysis of rice straw. Under these condition rice straw was hydrolyzed to glucose by the cellulase up to $32.0{\pm}3.1%$ based on the glucan amount of the rice straw for 72 h, while the hydrolytic capability of commercial enzyme (Celluclast 1.5${\ell}$) from rice straw to glucose was estimated to $53.7{\pm}4.7%$ at the same experimental condition. In case of addition of Tween 20 (0.1% w/w, substrate) to the cellulase the hydrolysis of rice straw to glucose was enhanced to $38.1{\pm}2.0%$.

• KSBB Journal
• /
• v.18 no.1
• /
• pp.1-7
• /
• 2003

Screening of a strain was carried out to produce an enantioselective lipase toward the precursor of ltraconazole as azole-containg compounds, which are well known as antifungal drug agents. An Acinetobacter sp. SY-01 strain which can selectively hydrolyze the racemic substrates was isolated and the racemic substrate was resolved to the S-ester in 95.6% enantiomeric excess after 74.8% hydrolysis. The optimum temperature and pH for the conversion were $50^{\circ}C$, pH 7.0. However, the temperature and pH had no effect on the enantiomeric excess. Addition of solvents decreased the conversion and slightly increased the enantiomeric excess. However, the kind of solvents had no effect on enantiomeric excess. The substrate concentration decrease enantiomeric excess and this is confirmed by the products generated from hydrolysis, and also enantiomeric excess could be increased by the removal of reaction products.

• Journal of the Korean Applied Science and Technology
• /
• v.11 no.1
• /
• pp.27-31
• /
• 1994

The rate constants of hydrolysis of ${\alpha}$-phenly-N-iso-propylnitrone and its derivatives have been determined by UV spectrophotometry at $25^{\circ}C$ and a rate equation which can be applied over a wide pH range was obtained. On the basis of rate equations derived and judging from the hydrolysis products obtained and general base and substituent effects, plausible mechanism of hydrolysis in various pH range have been proposed. Below pH 4.5, the hydrolysis was initiated by the protonation and followed by the addition of water to ${\alpha}$-carbon. Above pH 10.0, the hydrolysis was proceeded by the addition of hydroxide ion to ${\alpha}$-carbon. In the range of $4.5{\sim}10.0$, the addition of water to nitrone was rate controlling step.