• Journal of Power Electronics
• /
• 제16권2호
• /
• pp.480-489
• /
• 2016

A novel hybrid carrier-based pulse width modulation (CBPWM) scheme that combines unipolar and dipolar modulations is proposed for single-phase three-level rectifiers, which are widely applied in railway traction drive systems. The proposed CBPWM method can satisfy the volt-second balancing principle in the complete modulation index region through overmodulation compensation. The modulation scheme features two modulation modes: unipolar and dipolar. The operation range limits of these modulation modes can be modified by changing the separation coefficient. In comparison with the traditional unipolar CBPWM, the proposed hybrid CBPWM scheme can provide advantageous features, such as lower high-order harmonic distortion of the line current and better utilization of switching frequency. The separation coefficient value is optimized to achieve the maximum utilization of these advantages. The experimental results verify the feasibility and effectiveness of the proposed hybrid CBPWM scheme.

• Elastomers and Composites
• /
• 제58권4호
• /
• pp.208-215
• /
• 2023

In this study, the properties of polyurethane-polydimethylsiloxane (PU-PDMS) hybrid foams containing different types and contents of physical blowing agents (PBAs) were investigated. Two types of blowing agents, namely physical blowing agents and thermally expandable microspheres (TEM), were applied. The apparent density was measured using precisely cut foam samples, and the pore size was measured using image software. In addition, the microstructure of the foam was confirmed via scanning electron microscopy and transmission electron microscopy. The thermal conductivities related to the microstructures of the different foams were compared. When 0.5 phr of the hydrocarbon-based PBA was added, the apparent density and pore size of the foam were minimal; however, the pore size was larger than that of neat foam. In contrast, the addition of 3 phr of TEM effectively reduced both the apparent density and pore size of the PBAs. The increase in resin viscosity owing to TEM could enhance bubble production stability, leading to the formation of more uniform and smaller pores. These results indicate that TEM is a highly efficient PBA that can be employed to decrease the weight and pore size of PU-PDMS hybrid foams.

• 천문학논총
• /
• 제30권2호
• /
• pp.737-739
• /
• 2015

To accommodate today's higher education student, fewer textbooks are printed and more are becoming digital. Keeping with the modern era, hybrid versions of textbooks have all end-of-chapter assessment content moved to digital learning systems such as MindTap$^{TM}$ by Cengage $Learning^{(R)}$. In this work, we introduce new pedagogical strategies to combat academic e-cheating, specifically cheating on assessments given in online astronomy courses. The strategies we present in this work are employed in Horizons: Exploring the Universe, Hybrid, 13th Edition, and Universe, Hybrid, 8th Edition, by Seeds, Backman, and Montgomery.

• 한국산업융합학회 논문집
• /
• 제25권4_2호
• /
• pp.663-671
• /
• 2022

Practice through virtual reality can increase the educational effect regardless of time and place, and it is an educational method that is being pursued even in the situation of COVID-19. On the other hand, for VR-based education, related technology development and content development must be made, and experiential methods (flipped learning, blended learning, hybrid learning) must be provided in the educational process. The development scenario was developed with the contents of drone qualification test (ultra-light unmanned multicopter) and drone practice and the possibility of non-face-to-face self-directed learning (flipped learning, blended learning, hybrid learning). It is expected that the quality of vocational education related to drones and the effect of high education will be improved through the contents, and it is thought that it will be possible to suggest a direction for the development of various vocational education contents in non-face-to-face education.

• 대한화학회지
• /
• 제61권4호
• /
• pp.204-210
• /
• 2017

이 연구에서는 2009개정 교육과정 및 화학 I 교과서에 제시된 전자 이동 모델과 산화수 변화 모델의 서술방식을 분석하고, 화학교육전공 교사들을 대상으로 각 모델의 제한 조건에 대한 인식을 알아보았다. 교육과정과 교과서에서는 전자 이동 모델, 산화수 변화 모델을 제시하고 있으나, 각 모델의 제한 조건을 무시한 혼성 모델도 있었다. 혼성 모델은 공유결합 물질의 산화 환원 반응을 전자 이동 모델로 기술하거나 산화수 개념으로 설명하는 경우에도 가상적인 전자 이동과 실제적인 전자 이동을 혼동하게 하는 문제를 가진다. 산화 환원 반응에 대한 화학교육전공 교사들의 인식을 조사하기 위하여 설문지 및 면담을 실시하였다. 연구 결과, 많은 교사들이 각 모델의 제한 조건을 인식하지 못하고 있었으며, 혼성 모델로 인해 산화 환원 반응을 산 염기반응과 구분하는데 어려움을 가지는 것으로 나타났다.

• Bulletin of the Korean Chemical Society
• /
• 제32권2호
• /
• pp.559-565
• /
• 2011

The following noble series of statistical copolymers, poly[(2-(3-thienyl)ethanol n-butoxycarbonylmethylurethane)-co-3-hexylthiophene] (PURET-co-P3HT), were synthesized by the chemical dehydrogenation method using anhydrous $FeCl_3$. The structure and electro-optical properties of these copolymers were characterized using $^1H$-NMR, UV-visible spectroscopy, elemental analysis, GPC, DSC, TGA, photoluminescence (PL), and cyclic voltammetry (CV). The statistical copolymers, PURET-co-P3HT (1:0, 2:1, 1:1, 1:2, 1:3), were soluble in common organic solvents and easily spin coated onto indium-tin oxide (ITO) coated glass substrates. Hybrid bulk heterojunction photovoltaic cells with an ITO/G-PEDOT/PURET-co-P3HT:PCBM:Ag nanowires/$TiO_x$/Al configuration were fabricated, and the photovoltaic cells using PURET-co-P3HT (1:2) showed the best photovoltaic performance compared with those using PURET-co-P3HT (1:0, 2:1, 1:1, 1:3). The optimal hybrid bulk heterojunction photovoltaic cell exhibits a power conversion efficiency (PCE) of 1.58% ($V_{oc}$ = 0.82 V, $J_{sc}$ = 5.58, FF = 0.35) with PURET-co-P3HT (1:2) measured by using an AM 1.5 G irradiation (100 mW/$cm^2$) on an Oriel Xenon solar simulator (Oriel 300 W).

• 한국자동차공학회논문집
• /
• 제23권5호
• /
• pp.537-544
• /
• 2015

The effects of the modification of hybrid vehicle components on diesel exhaust emissions were investigated in this study. We examined the changes in exhaust emissions and the fuel consumption (FC) caused by the modification of generator (alternator) and motors. Exhaust emissions such as black carbon (BC), HC, $NO_X$ and $CO_2$ were measured not only in idle state but also on an actual urban road as well as on a chassis dynamometer. BC, $NO_X$ and HC emissions increased by 95%, 27% and 34% respectively when the generator charged the battery in the idle condition. BC and FC decreased in hybrid mode on the actual urban road partly because the motors were used to assist the diesel engine. In addition, the decreases in exhaust emissions and FC were also evident in the hybrid mode when the vehicle was tested on the chassis dynamometer.

• Structural Engineering and Mechanics
• /
• 제62권5호
• /
• pp.631-642
• /
• 2017

Accurate actuator tracking plays an important role in real-time hybrid simulation (RTHS) to ensure accurate and reliable experimental results. Frequency-domain evaluation index (FEI) interprets actuator tracking into amplitude and phase errors thus providing a promising tool for quantitative assessment of real-time hybrid simulation results. Previous applications of FEI successfully evaluated actuator tracking over the entire duration of the tests. In this study, FEI with moving window technique is explored to provide post-experiment localized actuator tracking assessment. Both moving window with and without overlap are investigated through computational simulations. The challenge is discussed for Fourier Transform to satisfy both time domain and frequency resolution for selected length of moving window. The required data window length for accuracy is shown to depend on the natural frequency and structural nonlinearity as well as the ground motion input for both moving windows with and without overlap. Moving window without overlap shows better computational efficiency and has potential for future online evaluation. Moving window with overlap however requires much more computational efforts and is more suitable for post-experiment evaluation. Existing RTHS data from Network Earthquake Engineering Simulation (NEES) is utilized to further demonstrate the effectiveness of the proposed approaches. It is demonstrated that with proper window size, FEI with moving window techniques enable accurate localized evaluation of actuator tracking for real-time hybrid simulation.

• Smart Structures and Systems
• /
• 제26권1호
• /
• pp.63-75
• /
• 2020

Substructure pseudo-dynamic hybrid simulation (SPDHS) combining the advantages of physical experiments and numerical simulation has become an important testing method for evaluating the dynamic responses of structures. Various parameter identification methods have been proposed for online model updating. However, if there is large model gap between the assumed numerical models and the real models, the parameter identification methods will cause large prediction errors. This study presents an ANN (artificial neural network) method based on forgetting factor. During the SPDHS of model updating, a dynamic sample window is formed in each loading step with forgetting factor to keep balance between the new samples and historical ones. The effectiveness and anti-noise ability of this method are evaluated by numerical analysis of a six-story frame structure with BRBs (Buckling Restrained Brace). One BRB is simulated in OpenFresco as the experimental substructure, while the rest is modeled in MATLAB. The results show that ANN is able to present more hysteresis behaviors that do not exist in the initial assumed numerical models. It is demonstrated that the proposed method has good adaptability and prediction accuracy of restoring force even under different loading histories.

• International Journal of Computer Science & Network Security
• /
• 제23권6호
• /
• pp.193-201
• /
• 2023

In this paper, we consider the maximum scatter traveling salesman problem (MSTSP), a travelling salesman problem (TSP) variant. The problem aims to maximize the minimum length edge in a salesman's tour that travels each city only once in a network. It is a very complicated NP-hard problem, and hence, exact solutions can be found for small sized problems only. For large-sized problems, heuristic algorithms must be applied, and genetic algorithms (GAs) are found to be very successfully to deal with such problems. So, this paper develops a hybrid GA (HGA) for solving the problem. Our proposed HGA uses sequential sampling algorithm along with 2-opt search for initial population generation, sequential constructive crossover, adaptive mutation, randomly selected one of three local search approaches, and the partially mapped crossover along with swap mutation for perturbation procedure to find better quality solution to the MSTSP. Finally, the suggested HGA is compared with a state-of-art algorithm by solving some TSPLIB symmetric instances of many sizes. Our computational experience reveals that the suggested HGA is better. Further, we provide solutions to some asymmetric TSPLIB instances of many sizes.