• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 춘계학술대회 논문집
• /
• pp.419-422
• /
• 1998

There are lots of researches which are using quratz crystal in order to apply it to sensors, for example, mass detect sensor, humidity sensor, gas sensor, etc. We tried to apply quartz crystal to the sensor using the resonant frequency and the resistance properties. Four kinds of fatty acid which are having the same head group are coated at the surface of quartz crystal, the shift of the resonant frequency and the resistance are observed according to length of the tail group. Myristic acid$(C_{14})$, palmitic acid$(C_16)$, stearic acid$(C_{18})$, and arachidic acid$(C_{20})$ were coated by Langmuir-Blodgett(LB) technique. As results, the resonant frequency shift was observed linearly. However, there are some difference compared with Sauerbrey's equation. It can be explained by the effect of the temperature property and/or humidity. On the other hand, the shift of the resistance was observed nonlinearly.

• 한국전기전자재료학회논문지
• /
• 제31권2호
• /
• pp.107-111
• /
• 2018

In this study, we designed the temperature coefficient of resistance (TCR) and heat radiation properties of shunt fixed resistors by adjusting the atomic composition of a metal alloy resistor, and fabricated a resistor that satisfied the designed properties. Resistors with similar atomic composition of copper and nickel showed low TCR and excellent shunt fixed resistor properties such as short-time overload, rated load, humidity load, and high temperature load. Finally, we expect that improved sensor accuracy will be obtained in current-distribution-type shunt fixed resistor for IoT sensors by designing the atomic composition of the metal alloy resistor proposed in this work.

• Computers and Concrete
• /
• 제8권2호
• /
• pp.229-241
• /
• 2011

In this work, cement paste samples with 1% (by cement mass) of a conductive carbon fiber admixture have been studied under uniaxial compression. Three different arrangements were used to measure the resistivity of the samples. According to the results obtained, the resistance should be measured using the four wire method in order to obtain good sensitivity and repeatability. The effect of the load value and the load rate on the fractional change of the volume resistivity has been determined. It has been observed that the gage factor (fractional change in resistance respect to strain) increases when the maximum load is increased, and the loading rate does not affect significantly this parameter. The effect of the sample ambient humidity on the material piezoresistivity has also been studied, showing that the response of the composite is highly affected by this parameter.

• E2M - 전기 전자와 첨단 소재
• /
• 제4권1호
• /
• pp.31-37
• /
• 1991

습도센서용 기판으로 사용하기 위한 MgFe$_{2}$O$_{4}$ 세라믹스의 성능개선을 위하여 Li$_{2}$CO$_{3}$와 V$_{2}$O$_{5}$를 첨가한 MgFe$_{2}$O$_{4}$-LiMgVO$_{4}$ 세라믹스를 만들고, 기공율, 기공분포, 센서특성, 응답속도 등을 조사하여 다음의 결과를 얻었다. 기공율은 MgFe$_{2}$O$_{4}$ 세라믹스가 29[%]에서 34[%]인데 비하여 본 연구결과는 34.5[%]에서 39[%]로 증가하였으며 센서특성은 $10^{7}$ [.OMEGA.] 단위의 변화에서 $10^{7}$ [.OMEGA.]에서 $10^{6}$[.OMEGA.] 단위로 변화함을 알수 있었고 응답속도는 10초정도 빨라졌음을 알수 있었다. 또한 기공분포를 이용하여 모형 센서를 제안하여 시뮬레이션을 하고 실제 특성과 이론적인 특성을 비교하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 하계학술대회 논문집 C
• /
• pp.1226-1228
• /
• 1994

Applications of poly-Si layers which are important as sensing and structural material of various sensors were reviewed in this research. A piezoresistive pressure sensor with piezoresistors has sensitivity of $6.93{\mu}$ V/(VmmHg) within 300mmHg. Temperature sensor was studied with measurement range of $-40{\sim}140^{\circ}C$ and $400{\sim}800^{\circ}C$ using boron-doped and undoped poly-Si resistors, respectively. Poly-Si layer was used to transduce volume change of polyimide to stress of silicon diaphragm for humidity sensor.

• E2M - 전기 전자와 첨단 소재
• /
• 제6권4호
• /
• pp.339-346
• /
• 1993

정전결합 유동가스형 플라즈마 중합장치를 이용하여 여러가지 모노머에 대한 유기고분자 박막을 빗모양 전극위에 형성하고 이들 박막의 감습특성을 검토하기 위해 주파수범위를 60[kHz]-100[kHz]로 변화시켜 가면서 상대습도 20-90[%RH]범위에서 정전용량의 변화를 측정하였다. 상대습도가 증가함에 따라 정전용량은 일반적으로 증가했으며 방전조건중 방전전력이 낮을수록 그리고 중합시간이 짧을수록 정전용량의 증가폭이 크게 나타났다. 그리고 정전용량 측정시 박막에 인가한 전원의 주파수가 낮을수록 정전용량의 변화에 대한 선형성과 증가폭이 분명함을 알았다.

• 한국의학물리학회지:의학물리
• /
• 제27권4호
• /
• pp.224-231
• /
• 2016

The usefulness of Gel Bolus phantom was investigated by comparing the temperature distribution characteristic of the agar phantom produced to investigate the dose distribution characteristic of radiofrequency hyperthermia device with that of the Gel Bolus phantom under conditions similar to those of an agar phantom that can continuously carry out temperature measurement. The temperatures of the agar phantom and the Gel Bolus phantom were raised to $36.5{\pm}3^{\circ}C$ and a temperature sensing was inserted at depths of 5, 10, and 15 cm from the phantom central axis. The temperature increase rate and the coefficient of determination were analyzed while applying output powers of 100 W and 150 W, respectively, at intervals of 1 min for 60 min under conditions where the indoor temperature was in the range $24.5{\sim}27.5^{\circ}C$, humidity was 35~40%, internal cooling temperature of the electrode was $20^{\circ}C$, size of the upper electrode was 250 mm, and the size of the lower electrode was 250 mm. The coefficients of determination of 150 W output power at the depth point of 5 cm from the central axis of the phantom were analyzed to be 0.9946 and 0.9926 in the agar and Gel Bolus phantoms, respectively; moreover, the temperature change equation of the agar and Gel Bolus phantoms with time can be expressed as follows in the state the phantom temperature is raised to $36^{\circ}C:Y(G)$ is equation of Gel Bolus phantoms (in 5 cm depth) applying output power of 150 W. Y(G)=0.157X+36. It can be seen that if the temperature is measured in this case, the Gel Bolus phantom value can be converted to the measured value of the agar phantom. As a result of comparing the temperature distribution characteristics of the agar phantom of a human-body-equivalent material with those of the Gel Bolus phantom that can be continuously used, the usefulness of Gel Bolus phantom was exhibited.

• 한국전자파학회논문지
• /
• 제26권1호
• /
• pp.39-46
• /
• 2015

본 논문에서는 2.4 GHz에서 동작하는 $90^{\circ}$ 하이브리드 커플러 구조에 전도성 고분자 화합물을 적용한 가스 센서를 제안하였다. 가스 센서에서 전도성 고분자 화합물(Conducting Polymer: CP)는 특정 가스를 검출하는 검출 물질로 사용되며, 특정 가스와 반응할 때 대개 물질의 일함수(work function)와 전도도(conductivity) 및 임피던스가 변하게 된다. 이러한 물성변화 특성의 근거로 마이크로파 대역에서 $90^{\circ}$ 하이브리드 커플러 구조에 전도성 고분자를 적용하여 가변 감쇄기 및 가변 위상 천이기 형태의 센서를 제작하였다. 본 연구에서 제안한 센서는 전도성 고분자 화합물의 높은 전도도를 이용하여 기존 전송선로의 일부를 전도성 고분자 물질로 대체하였다. 실험은 온도 $28^{\circ}$와 상대습도 85 % 환경에서 진행되었으며, 센서에 100 ppm 농도의 에탄올 가스를 노출시켰다. 그 결과, $S_{21}$의 진폭 특성이 최대 0.13 dB 변하였고, ${\angle}S_{21}=360^{\circ}$를 만족하는 주파수가 2.875 MHz 이동한 것을 확인하였다.