• 한국작물학회지
• /
• 제46권4호
• /
• pp.321-324
• /
• 2001

Tobacco seeds (Nicotiana tabacum L. cv KF109) were primed in the polyethylene glycol 6000(PEG) solution and then stored at 5 and $25^{\circ}C$ under 40, 60 and 80% relative humidity (RH) conditions for six months. The effect of storage temperature and humidity on mean germination time ($T_{50}$), longevity and germination of the primed tobacco seeds were compared. Untreated seeds (control) stored at $5^{\circ}C$ showed high germinability throughout the entire storage period and humidity, and a decline in germinability showed after 6 months at 60% RH and after 3 months at 80% RH when stored at $25^{\circ}C$, Primed seeds retained high germinability until 6 months at 60% RH and 3 months at 80% RH when stored at $5^{\circ}C$ but showed a significant decline in germinability after 3 months at 40% RH, and 1 months at 60% and 80% RH, respectively when stored at $25^{\circ}C$, Primed seeds were completely lost viability when stored at $25^{\circ}C$ under 60% RH for 6 months and under 80% RH for 3 months.

• 한국산업융합학회 논문집
• /
• 제23권6_2호
• /
• pp.1075-1080
• /
• 2020

The control on temperature and humidity on the cow-house is essential to assure production efficiency and the control on disease of cows. Fog system and screen fence are typical methods to drop the temperature inside of cow-house during the summer season. This study focused on the change in temperature and humidity under the condition of application of those methods. The results indicate that the installation of atomizer and insulation curtain cause decrease in temperature and increase in humidity. However, Using both of methods at the same time doesn't make any additional meaningful effects on temperature and humidity.

• Journal of Mechanical Science and Technology
• /
• 제16권5호
• /
• pp.696-702
• /
• 2002

In the present paper, the effects of inlet pressure on the heat and mass transfer rates of an air cooler are numerically predicted by a local analysis method. The pressures of the moist air vary from 2 to 4 bars. The psychrometric properties such as dew point temperature, relative humidity and humidity ratio are employed to treat the condensing water vapor in the moist air when the surface temperatures are dropped below the dew point. The effects of the inlet pressures on the heat transfer rate, the dew point temperature, the rate of condensed water, the outlet temperature of air and cooling water are calculated. The condensation process of water vapor is discussed in detail. The results of present calculations are compared with the test data and shows good agreements.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 1990년도 제12회 학술강연회초록집
• /
• pp.63-68
• /
• 1990

Friction and wear behavior of a unidirectional high modulus carbon fiber reinforced epoxy composite exposed to high and low humidity was experimentally examined with various sliding speeds. The results show that the moisture at the sliding surface greatly influences friction and wear properties of the composite. It is also discoverd that the difference in friction and wear behavior between samples with different fiber orientations is mainly due to the anisotropic properties caused by the microstructure of oriented graphite crystals in the carbon fibers and the macrostructure of fiber orientation in the matrix.

• 약학회지
• /
• 제40권4호
• /
• pp.375-381
• /
• 1996

Five crystal modification of droperidol were prepared by recrystallization. They were characterized by UV spectrophotometer, DSC, and X-ray crystallography. Their dissolution pa tterns were also investigated. After storage of 2 months at 100% humidity, all polymorphic modifications were transformed.

• Tribology and Lubricants
• /
• 제6권2호
• /
• pp.88-93
• /
• 1990

Friction and wear behavior of a unidirectional high modulus carbon fiber reinforced epoxy composite exposed to high and low humidity was experimentally examined with various sliding speeds. The results show that the moisture at the sliding surface greatly influences friction and wear properties of the composite. It is also discoverd that the difference in friction and wear behavior between samples with different fiber orientations is mainly due to the anisotropic properties caused by the microstructure of oriented graphite crystals in the carbon fibers and the macrostructure of fiber orientation in the matrix.

• Journal of the Korean Wood Science and Technology
• /
• 제44권2호
• /
• pp.191-203
• /
• 2016

To investigate the dynamic sorptive and hygroexpansive behaviors of wood by different cyclic hygrothermal changing effects, poplar (populus euramericana Cv.) specimens, were exposed to dynamic sorption processes where relative humidity (RH) and temperature changed simultaneously in sinusoidal waves at 75-45% and $5-35^{\circ}C$ (condition A) and where RH changed sinusoidally at 75-45% but temperature was controlled at $20^{\circ}C$ (condition B), both for three cyclic periods of 1, 6, and 24 h. Moisture and dimensional changes measured during the cycling gave the following results: Moisture and transverse dimensional changes were generally sinusoidal. Moisture and dimensional amplitude increased with increasing cyclic period but all were lower for thicker specimens. The amplitude ratio of condition A to condition B ranged from 1.0 to 1.6 with the maximum value of 1.57 occurring at the shortest cyclic period, not as much as expected. T/R increased as cyclic period increased or specimen thickness decreased. T/R from condition B was weaker than that from condition A. Sorption and swelling hysteresis existed in both conditions. Sorption hysteresis was negatively related to cyclic period but in positive correlation with specimen thickness. Sorption hysteresis was found more obvious in condition B, while moisture sorption coefficient and humidity expansion coefficient showed the opposite results.

• 한국가구학회지
• /
• 제25권2호
• /
• pp.148-153
• /
• 2014

Importance of energy consumptions has being emphasized because of problems of the energy and environment. So, recently, green wall systems have been installed to reduce building energy consumptions. The green wall systems provide several benefits; they make it possible to maintain moderate thermal comforts by greenery. Greening such a surface wall in the building by plants, the temperature of the wall can be properly controlled that purifies the air and improves the view spanning over the space. This study evaluated the effects of green wall systems on reducing room temperature quantitatively, changing of humidity, decreasing of $CO_2$. Test results were confirmed; first, the space installed by green walls showed that temperature and $CO_2$ decreased and humidity was increased. Second, two structures were compared with the solar radiation, and green wall systems controlled the temperature and humidity stably near the wall regardless of the amount solar radiation. In conclusion, the green wall systems can contribute to thermal comforts and indoor air quality in the buildings.

• Journal of Biosystems Engineering
• /
• 제30권2호
• /
• pp.95-101
• /
• 2005

Adsorption and desorption experiments were carried out on rough rice and brown rice (Nampyung) at 5, 15, 25, 35, $45^{\circ}C$ for moisture contents between 8.7 and $25\%$ (db). The method employed was to measure the equilibrium relative humidity (ERH) of air in contact with the grain under static conditions, using an electronic hygrometer The effects of temperature and moisture contents were investigated, and the measured values were fitted to the modified Henderson, the modified Chung-Pfost, the modified Halsey and the modified Oswin model. The ERHs of rough rice and brown rice decreased with an decrease in moisture content and temperature, and the effects of temperature was no significant at moisture content of $25\%$ (db). Equilibrium moisture content (EMC) of brown rice was higher than rough rice at same temperature and relative humidity. Desorption EMC is higher than the adsorption, but there is no significant difference between desorption and adsorption EMC in moisture content near $25\%$ (db) at rough rice and near 9, 21 and $25\%$ (db) at brown rice. The modified Oswin model was the best in describing the adsorption EMC and the modified Chung-Pfost model was the best in describing the adsorption ERH of rough rice. The modified Oswin model was the best in describing the adsorption EMC/ERH of brown rice. The modified Chung-Pfost model was the best in describing the desorption EMC/ERH of rough rice and brown rice.

• 설비공학논문집
• /
• 제19권7호
• /
• pp.537-544
• /
• 2007

To facilitate comparative analysis on the effects of numerous parameters concerning design and operation of a desiccant rotor, it is firstly required to represent the dehumidification performance as numerical indices. In this work is proposed two performance indices of a desiccant rotor: the humidity effectiveness and the enthalpy-leak ratio. The humidity effectiveness represents the actual dehumidification as compared with the dehumidification in an ideal case, while the enthalpy-leak ratio represents the enthalpy transfer from the regeneration side to the dehumidification side. In an ideal case, the two indices approach one and zero, respectively. The effects of numerous parameters on the dehumidification performance of a desiccant rotor are investigated through numerical simulation and represented with the two indices. The results show that the performance indices are mainly determined by three nondimensional parameters each representing the thermal capacity, the sorption capacity, and the transfer capacity of a desiccant rotor.