• Korean Journal of Remote Sensing
• /
• v.37 no.4
• /
• pp.665-685
• /
• 2021

This study focused on the a 20-year evaluation of the dynamism of critical thermal anomalies in Busan metropolitan area prompted by unusual infrastructural development and demographic growth rate. Archived Landsat thermal data derived-LST was the major input for UTFVI and hot spot analysis (Getis-Ord Gi^*). Results revealed that the surface urban heat island-affected area has gradually expanded overtime from 23.32% to 32.36%; while the critical positive thermal anomalies (level-3 hotspots) have also spatially increased from 19.88% in 2000 to 23.56% in 2020, recording a net LST difference of > 5℃ between the maximum level-3 hotspot and minimum level-3 coldspot each year. It is been observed that thermal conditions of Busan have gradually deteriorated with time, which is potentially inherent in the rate of urban expansion. Thus, this work serves as an eye-opener to powers that be, to think and act constructively towards a sustainable thermal conform for city dwellers.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.27 no.6
• /
• pp.535-540
• /
• 2022

DC-link capacitors are reliability-critical components in a photovoltaic (PV) inverter. Typically, the lifetime of a DC-link capacitor is evaluated by considering the voltage and hot-spot temperature of the capacitor under the specific operating condition of the PV inverter. However, the output of the PV inverter is determined by solar irradiation and ambient temperature, which vary with the seasons; accordingly, the hot-spot temperature of the capacitor also changes. Therefore, the mission profile of the PV system should be considered to effectively evaluate the reliability of the DC-link capacitor. In this study, the reliability of the DC-link capacitor of a three-level NPC inverter is comparatively analyzed with and without considering the mission profiles of the PV system, where two mission profiles recorded in Arizona and Iza are considered. The accumulated damage of the DC-link capacitor is calculated based on the lifetime model by analyzing its thermal loading. Afterward, a reliability evaluation of the DC-link capacitor is performed at the component level and then at the system level by considering all capacitors by means of Monte Carlo analysis. Results reveal the importance of performing a mission-profile-based reliability evaluation during the design of high-reliability PV inverters to achieve the target reliability performance.

• Health Policy and Management
• /
• v.26 no.3
• /
• pp.233-241
• /
• 2016

Background: This study purposed to analyze and understand how spatial accessibility of patients influenced the number of outpatient visits for the internal medicine of a hospital. Methods: A hospital with 100 beds in Seoul, South Korea provided data from 2013 January 1 to 2013 June 30. Euclidean distance and road ares were used to represent the spatial accessibility. Patient level data and dong level data were collected and used in spatial analysis. Dong level data was converted into grid level ($500{\times}500m$) for the multivariate analysis. Hot-spot analysis and generalized linear model were applied to the data collected. Results: Hot-spots of outpatient visits were found around the study hospital, and cold-spots were not found. Number of outpatient visits was varied by the distance between patient resident and hospitals, and about 80% of total outpatient visits was occurred in within the 5 km from study hospital, and 50% was occurred in within 1.6 km. Spatial accessibility had significant influences on the outpatient visits. Conclusion: Findings provide evidences that spatial accessibility had influences on the patients' behaviors in utilizing the outpatient care of internal medicine in a hospital. Results can provide useful information to health policy makers as well as hospital managers for their decision making.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.254-260
• /
• 1999

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antenna beam width to cover entire hot-spot region in the space and, by compensating effective burst length through cutting down man-made noises introduced by antenna. Based on the analysis, we are developed a small-opening-cavity antenna, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antenna exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100 km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antenna under same testing condition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.9 no.6
• /
• pp.788-801
• /
• 1998

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed ; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antennal beam width to cover entire hot-spot region in the space and, by compensating effective burst length throughcutting down man-made noises introduced by antennal. Based on the analysis, we are developed a small-opening-cavity antennal, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antennal exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antennal under same testing condition.

• Economic and Environmental Geology
• /
• v.41 no.2
• /
• pp.253-265
• /
• 2008

Sustainable resource management(SRM) is regarded as the core strategy to achieve Dematerialisation and Decoupling of economic growth from the use of natural resources and environmental degradation. This paper presents status SRM policy and research in worldwide, and analyzes decoupling of economic activity from energy consumption of domestic manufacturing, using decoupling factor. Also This paper suggests methodologies and strategies of SRM in Korea. SRM is established through various analysis and survey as following; forecasting of resource demand, material flow analysis and value chain analysis, resource market structure analysis. Through these analysis, we can obtain hot-spot and solution of environmental burden, recycling market management, recycling technology and best-optimal supply rate of primary and secondary resource. In Korea, resource management system must be linked with national and regional material flow analysis, and it is necessary to make SRM-law of national dimension for effective run of sustainable resource management system.

• Proceedings of the KSRS Conference
• /
• 2008.10a
• /
• pp.224-227
• /
• 2008

Land cover and its changes, affecting multiple aspects of the environmental system such as energy balance, biogeochemical cycles, hydrological cycles and the climate system, are regarded as critical elements in global change studies. Especially in arid and semiarid regions, the observation of ecosystem that is sensitive to climate change can improve an understanding of the relationships between climate and ecosystem dynamics. The purpose of this research is analyzing the ecosystem surrounding the Gobi desert in North Asia quantitatively as well as qualitatively more concretely. We used Normalized Difference Vegetation Index (NDVI) derived from SPOT-VEGETATION (VGT) sensor during 1999${\sim}$2007. Ecosystem monitoring of this area is necessary because it is a hot spot in global environment change. This study will allow predicting areas, which are prone to the rapid environmental change. Eight classes were classified and compare with MODerate resolution Imaging Spectrometer (MODIS) global land cover. The time-series analysis was carried out for these 8 classes. Class-1 and -2 have least amplitude variation with low NDVI as barren areas, while other vegetated classes increase in May and decrease in October (maximum value occurs in July and August). Although the several classes have the similar features of NDVI time-series, we detected a slight difference of inter-annual variation among these classes.

• Journal of Ship and Ocean Technology
• /
• v.3 no.4
• /
• pp.35-51
• /
• 1999

Fatigue strength assessment procedures have been implemented in the ship design rules by many classification societies. However, a large variation tin the details of the different approaches exists in practically all aspects influding load history assessment, stress evaluation and fatigue strength assessment. In order to assess the influences of thesd variations on the prediction of fatigue lives. a comparative study is organized by the ISSC Committee III.2 Fatigue and Fracture. A pad detail on the top of longitudinal hatch coaming of a panamax container vessel is selected for fatigue calculation. The work described in this paper is one set of results of this comparative study in which the ABS dynamics approach is applied. Through this analysis the following conclusions can be drawn. (1) With the original ABS approach, the fatigue life of this pad detail is very low, only 2.398 years. (2) The treatment of the stillwater bending moment in the ABS approach might be a source of conservatism. If the influence of stillwater bending moment is ignored, then the fatigue life for this pad detail is 7.036 years. (3) The difference between the nominal stress approach and the hot spot stress approach for this pad detail is about 26%.

• Annual Conference of KIPS
• /
• 2003.05b
• /
• pp.1369-1372
• /
• 2003

가까운 장래에 싼 가격의 블루투스가 여러 가지 이동, 휴대 장치에 내장되어 다양한 응용서비스를 제공할 것이다. 본 논문에서는 공항이나 쇼핑몰 등 사람들이 많이 몰리는 공공장소와 같은 핫스팟(hot spot) 지역에서 블루투스 기지국을 통한 음성서비스 제공을 위하여 다수의 기지국을 유서 LAN으로 협동시켜 각각 기지국별로 따로 제공되던 음성 채널들을 집합화(aggregation) 함으로써 보다 많은 음성 서비스 채널들을 동시에 수용할 수 있는 방법을 제시하고 성능을 분석하였다. 단독으로 동작하는 기지국은 ACL채널을 사용하는 경우 7개까지의 채널 수용이 가능하므로 이상적인 경우에서도 오버랩 영역의 기지국의 개수가 n이면 7n 만큼 채널의 증가가 가능한 반면 협동으로 동작하면 블록킹 율도 개선되면서 집합화된 채널들을 보간(interpolation) 기법을 통한 통계적 사용으로 음성 패킷의 허용 손실 범위 내에서 음성채널의 수를 약 14n 정도까지 확장할 수 있다. 또한 음성전송과 데이터 전송이 혼합 서비스 될 때 수용하는 음성 채널의 수에 따른 데이터 전송지연시간 특성을 분석하였다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.1
• /
• pp.382-389
• /
• 2012

The fabricated report attack will not only cause false alarms that waste real-world response efforts such as sending response teams to the event location, but also drains the finite amount of energy in a wireless sensor network. In this paper, we propose a probabilistic filtering method for sensor network security (PFSS) to deal with filtering for the fabricated report. On the basis of filtering scheme, PFSS combines cluster-based organization and probabilistic verification node assignment using distance of from cluster head to base station for energy efficiency and hot spot problem. Through both analysis and simulation, we demonstrate that PFSS could achieve efficient protection against fabricated report attack while maintaining a sufficiently high filtering power.