• 공업화학
• /
• 제7권5호
• /
• pp.977-984
• /
• 1996

실관막 모듈을 이용한 액-액추출은 반응기 단위부피당 표면적이 크므로 신속히 진행된다. 이러한 실관막내에서 추출제와 원료액은 빠른 속도로 접촉하며 두 흐름이 완전히 독립적이므로 부하나 편류현상이 일어나지 않는다. 본 연구에서는 실관막을 이용하여 수용액으로부터 중금속들을 추출하기 위한 추출제들의 선택성을 고찰하였다. 또한, 실관막 내에서 용질의 물질전달에 미치는 분배비의 영향을 확인하기 위하여, 분배비와 총괄물질전달계수를 비교하였다. 이로부터, 분배비가 높은 계는 낮은 계에 비해 실관막 모듈 내에서 물질전달에 미치는 분배비의 영향이 미약함을 알 수 있었다.

• 한국막학회:학술대회논문집
• /
• 한국막학회 2001년도 추계 총회 및 학술발표회(한국막학회)
• /
• pp.93-95
• /
• 2001

• 한국막학회:학술대회논문집
• /
• 한국막학회 2000년도 춘계 총회 및 학술발표회
• /
• pp.47-50
• /
• 2000

• Korean Membrane Journal
• /
• 제7권1호
• /
• pp.19-27
• /
• 2005

PP hollow fiber membrane was hydrophilized by EVOH dip coating followed by low temperature plasma treatment and UV irradiation. EVOH coating attained high water flux without any prewetting but its stability did not guaranteed at high water permeation rate. At high water permeation rate, water flux declined gradually due to swelling and delamination of the EVOH coating layer causing pore blocking effect. However, plasma treatment reduces the swelling, which suppress delamination of the EVOH coating layer from PP support result in relieving the flux decline. Also, UV irradiation helped the crosslinking of the EVOH coating layer to enhance the performance at low water permeation rate. FT-IR and ESCA analyses reveal that EVOH dip coating performed homogeneously through not only membrane surface but also matrix. Thermogram of EVOH film modified plasma treatment and W irradiation show that crosslinking density of EVOH layer increased. Chemical modification by plasma treatment and UV irradiation stabilized the hydrophilic coating layer to increase the critical flux of the submerged membrane.

• 상하수도학회지
• /
• 제30권3호
• /
• pp.313-319
• /
• 2016

In this study, the performance experiment was conducted to compare the permeate flux of hollow fiber Vacuum Membrane Distillation module according to leak problem between module housing and membrane bundle. For the permeate flux performance experiment of the two Vacuum Membrane Distillation modules, the Lab-scale experimental equipment was built in the capacity of $1m^3/day$. The performance test of the two Vacuum Membrane Distillation modules were analyzed according to the feed water conditions. As a result, it was analyzed that the leak VMD module decreased about 14% of permeate flux than normal VMD module.

• Membrane and Water Treatment
• /
• 제2권2호
• /
• pp.121-136
• /
• 2011

A bench-scale test has recently been proposed as a predictive tool to minimize the scope of pilot-scale testing or to optimize the operation of full-scale membrane filtration systems. Consequently, a bench-scale testing unit was developed for this purpose and systematically evaluated in this study. This unit was capable of accommodating commercially available, low pressure, hollow fiber (LPHF) membranes with various configurations for testing under conditions comparable to real-world applications. Reproducibility of this unit in assessing membrane fouling and microbial removal efficiency of LPHF membranes was tested and statistically comparable results were obtained. This unit serves as a useful apparatus for academic researchers and utilities to evaluate the performance of LPHF membranes used for water treatment.

• 한국막학회:학술대회논문집
• /
• 한국막학회 2004년도 Proceedings of the second conference of aseanian membrane society
• /
• pp.69-69
• /
• 2004

Cellulose hollow fiber membranes (CHFM) were prepared from the cellulose/N-methylmorpholine-N-oxide/$H_2O$ system by immersion-precipitation and wet spinning. Different drying methods were carried out to investigate their influences on the properties of CHFM.(omitted)

• 멤브레인
• /
• 제30권6호
• /
• pp.443-449
• /
• 2020

본 연구에서는 CH4/CO2 혼합가스에서 CO2 분리를 위해 세라믹 중공사 접촉막 모듈(HFMC)을 이용하여 실험을 수행하였다. 고 내구성의 HFMC를 제작하기 위해, 고강도의 중공사막을 제조하여 평가하였다. 제조한 중공사막을 이용하여 HFMC를 제작하였고, 실험은 CH4/CO2 혼합 기체(30% CO2, CH4 balance)와 monoethanolamine (MEA)를 사용하였다. HFMC 운전 중 기체와 흡수제의 압력이 CO2 제거 효율에 어떠한 영향을 주는지 평가하였다. CO2 제거 효율은 기체압력이 증가함에 따라 같이 상승하였으며, CO2 흡수 flux 또한 액체유량과 함께 증가하는 추세를 보였다. 또한 CO2 흡수율이 40% 이하일 때는 흡수제가 아래쪽에서 들어가는 향류형태인 LTS-1이 흡수제가 위쪽에서 들어가는 향류형태인 LTS-2보다 CO2 제거 성능이 높았으며, 흡수율이 40% 이상일 때는 LTS-2가 LTS-1보다 성능이 높았다.

• 한국물환경학회지
• /
• 제20권4호
• /
• pp.365-369
• /
• 2004

Submerged membrane bio-reactor equipped with a hollow fiber microfiltration was applied to reuse weaving wastewater of water jet loom, where two parameters such as the concentration of MLSS and the flux were controlled. While the flux at the concentration of MLSS around 900mg/L was constantly kept over 0.4m/d and 0.8m/d in a short time, the stable flux at around 300mg/L of MLSS was shown at the 8 days later. Regardless of MLSS and flux, BOD, CODcr and Turbidity of the permeate were 1~2mg/L, 7~10mg/L and below 1 NTU, which were 85~90%, 87~90% and 98% of removal efficiency, respectively. The stable operation without fouling was achieved because the contents of ECP were smaller than those of common MBR processes and the composition(saccharide/protein) was kept constantly. In this study, 0.5~1.0m/d of flux and 400~900mg/L of MLSS were considered as the most recommendable operating condition for the reuse of weaving wastewater.

• 한국물환경학회지
• /
• 제20권3호
• /
• pp.296-300
• /
• 2004

The rejection properties of 6 aromatic pesticides were evaluated by a continuous flow system equipped with a hollow fiber NF membrane. Different from the separation experiment of batch cell, the rejection and the removal could be calculated exactly because the concentration of feed, permeate and retentate was separately obtained. The lowest and the highest rejection were found in carbaryl(54.8%) and methoxychlor(99.2%), respectively, and the removals were always shown higher than rejections. This may be caused by some reasons such as the solute adsorption on the membrane, the variation of feed concentration. Although molecular weight, molecular width regarded as solute characteristics and log P(n-octanol/water partition coefficient) as hydrophobicity could be applied to explain the rejection property, these factors should be considered together for better analysis. According to the higher relationship between log B(solute permeability) and molecular weight, it was revealed that the solute separation with this membrane was influenced more by molecular weight.