• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.3
• /
• pp.307-311
• /
• 2004

The objective of this work is to evaluate the hypothesis that a good technique for supplying oxygen to the saturated zone in the presence of light nonaqueous phase liquid (LNAPL) pool contamination at the water table is to pass air through the unsaturated zone above the pool. This hypothesis was evaluated in experimental studies performed using a bench-scale, sand-tank reactor, Steady-state abiotic experiments in the sand-tank reactor with air flowing through the reactor headspace demonstrated that oxygen supply through the water table interface into the saturated zone was enhanced when an LNAPL (dodecane) pool was present at the water table. These experimental results confirmed the hypothesis that an LNAPL pool can serve as a high concentration oxygen source to the oxygen-limited area beneath the pool and, as a result, enhance the in situ biodegradation rate.

• Journal of the Korean Institute of Navigation
• /
• v.8 no.1
• /
• pp.49-70
• /
• 1984

Spatial and temporal variations of hydrography and currents are investigated in the Southeastern Sea of Korea during October 1982. The distribution of the water mass of high salinity (>34.40${\textperthousand}$) and low dissolved oxygen concentration (<5.0ml/l) indicates that the Tsushima current flows northward as it passes the Western Channel of the Korea Strait. The cold water (<$6.0^{\circ}c$) with low salinity (<$34.20{\textperthousand}$) and high dissolved oxygen concentration (>6.0ml/l) reaches the bottom of the western channel of the Korea Strait after flowing southward leaning against the slope rather than following the deepest part of the Channel. Repeated sections in the Korea Strait show a remarkable change of hydrographic structure over a period of 4 days ; both warn and cold waters are intensified, particularly in the eastern part of the strait toward the Tsushima Island.

• Journal of Welding and Joining
• /
• v.17 no.2
• /
• pp.76-83
• /
• 1999

Fracture toughness({TEX}$J_{IC}${/TEX}) on 304 austenitic stainless steel weldments artificially degraded for long period under SCC environments were evaluated to investigate its reliability and environmental characteristics. Electro-chemical polarization tests were previously carried out to evaluate corrosion susceptiblility of weldment, and stress corrosion cracking was tested under various conditions of 3.5wt.% NaCl solution, the temperature of $25^{\circ}$C and $95^{\circ}$C, and oxygen concentration during 3000hours. From the results obtained, it was found that 304 stainless steel weldment was so susceptible under high temperature and high oxygen concentration of 3.5wt.% NaCl solution, and fracture toughness({TEX}$J_{IC}${/TEX}) was also considerably reduced by material degradation.

• 한국연소학회:학술대회논문집
• /
• 2003.12a
• /
• pp.89-94
• /
• 2003

For the development of high efficiency and low emission combustion systems, high temperature air combustion technology has been tested by utilizing preheated air over 1100 K and exhaust gas recirculation. In this system, combustion air is diluted with large amount of exhaust gases ($N_2$, $CO_2$), such that the oxygen concentration is relatively low in the reaction zone, leading to low flame temperature. Since, the temperature fluctuations and sound emissions form the flame are small and flame luminosity is low, the combustion mode is expected to be flameless or mild combustion. Experiment was performed to investigate the turbulent flame structure and $NO_X$ emission characteristics in the high temperature air combustion focused on coflowing jet diffusion flames which has a fundamental structure of many practical combustion systems. The effect of turbulence has also been evaluated by installing perforated plate in the oxidizer inlet nozzle. LPG was used as a fuel. Results showed that even though $NO_X$ emission is sensitive to the combustion air temperature, the present high temperature air combustion system produce low $NO_X$ emission because it is operated in low oxygen concentration condition in excess of dilution.

• Journal of Preventive Medicine and Public Health
• /
• v.20 no.2 s.22
• /
• pp.221-227
• /
• 1987

In vivo ethane production in rats was used as an index of oxygen toxicity. The rats were allocated to four exposure conditions; hyperbaric oxygenation (HBO=5 ATA, 100% $O_2$), normobaric oxygenation (NBO=1 ATA,100% $O_2$), hyperbaric aeration (HBA=5 ATA, 21% $O_2$) and normobaric aeration (NBA=1 ATA, 21% $O_2$). After 120 minutes of exposure, the rats exposed to high concentration and/or high pressure oxygen exhaled significantly larger amounts of ethane than those exposed to NBA, and the differences in ethane production between any two groups were statistically significant (p<.01). This finding supports the hypothesis that hyperoxia increases oxygen free-radicals and the radicals produce ethane as a result of lipid peroxidation. It is notable that the ethane exhalation level of the HBA group was significantly higher than that of the NBO group. This difference could not be accounted for by the alveolar oxygen partial presure difference between the two groups.

• Journal of Hydrogen and New Energy
• /
• v.27 no.5
• /
• pp.589-596
• /
• 2016

Effects of pressure, temperature, gas velocity, and fuel flow rate on reduction of three oxygen carriers, SDN70, OC-1, OC-2, were measured and investigated in a pressurized bubbling fluidized bed reactor. Among three oxygen carriers OC-2 was selected as the best oxygen carrier in view of fuel conversion and $CO_2$ selectivity. However, all oxygen carriers showed good reactivity even at high pressure conditions. SDN70 particle showed maximum reactivity at $900^{\circ}C$ and low reactivity at $950^{\circ}C$. However, reactivity decay of OC-1 and OC-2 particles at high temperature condition was negligible. The fuel conversion and the $CO_2$ selectivity slightly decreased as the gas velocity increased, whereas they are slightly increased as the fuel concentration increased.

• Journal of Microbiology and Biotechnology
• /
• v.10 no.6
• /
• pp.817-822
• /
• 2000

A proper flashing light is expected to enhance microalgal biomass productivity and photosynthetic efficiency. The effect of flashing light on high-density Chlorella kessleri (UTEX 398) cultures was studied using light-emitting diodes. A frequency modulator was designed to flash LEDs, and the device successfully provided wide range of frequencies and various duty cycles of flashing. A relatively high frequencies of 10, 20 and 50 kHz were used in this study. These frequencies have very short flashing time ($2-50{\mu}s$), which corresponded to the time constant of the light reaction of photosynthesis. The specific oxygen production rates of photosynthesis under flashing light were compared with those under an equivalent continuous light in specially designed illumination cuvette. The specific oxygen production rates under flashing light were 5-25% higher than those under the continuous light. A range of cell concentration was discovered, where the benefit of flashing light was maximized. The photosynthetic efficiency was also higher under flashing light with frequencies of over 1 kHz, which was a clear indication of flashing light effect and the degree of mutual shading could by overcome by flashing lights, particularly at high-density algal cultures.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.32 no.6
• /
• pp.753-757
• /
• 1999

The growth of rotifer, Brachionus rotundiformis was evaluated at different culture conditions. Rotifer was fed on condensed freshwater Chlorella. The productivity of rotifer in the high density culture system was compared to that of rotifer in the batch culture system, in which rotifer was fed on baker's yeast. The growth rate of rotifer increased as temperature increased in the culture system supplied with air or oxygen gas. The maximum density of rotifer in the culture systems supplied with air was in range of 16,300$\~$17,000 ind./ml at $24^{\circ}C$. In the culture systems supplied with oxygen gas, it ranged 26,300$\~$30,500 ind/ml at $28^{\circ}C$. When the concentration of dissolved oxygen in the culture system supplied with air reached to below 1 ppm or when the concentration of undissolved ammonia in the culture system supplied with oxygen gas reached 16.6$\~$22.6 ppm, the growth of rotifer decreased. When oxygen gas was supplied and pH was adjusted to 7, the maximum density of rotifer reached to 43,000 ind/ml at $32^{\circ}C$. The production costs for 10 billion rotifer in the high density culture and batch culture were 693,000 and 961,000 won, respectively. Therefore, it was concluded that the productivity of rotifer in the high density culture was higher than that in a batch culture.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.41 no.11
• /
• pp.749-757
• /
• 2017

To cope with the development of alternative fuels and international environmental regulations, this study provides a numerical analysis of the effects of composition and temperature changes of n-decane and ethanol on auto-ignition characteristics. CHEMKIN-PRO is used as the analysis program and the LLNL model is used as the reaction model. The numerical results show that the ignition delay time increases as the mole fraction of ethanol increases for temperatures below 1000 K, where low temperature reactions occur. Because of the high octane number of ethanol, the high percentage of ethanol delays the increase in the concentration of OH radicals that cause ignition. The oxygen concentration in the mixture is changed to apply the exhaust gas recirculation and a numerical analysis is then performed. As the oxygen concentration decreases, the total ignition delay time increases because the nitrogen gas acts as a thermal load in the combustion chamber.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.34 no.3
• /
• pp.47-57
• /
• 2022

We carried out studies on prediction in concentration of dissolved oxygen (DO) with LSTM model and prediction in occurrence of hypoxia water mass (HWM) with decision tree. As results of study on prediction in DO concentration, a large number of Hidden node caused high complexity of model and required enough Epoch. And it was high accuracy in long Sequence length as prediction time step increased. The results of prediction in occurrence of HWM showed that the accuracy of nonHWM case was 66.1% in 30 day prediction, it was higher than 37.5% of HWM case. The reason is that the decision tree might overestimate DO concentration.