• Journal of Veterinary Clinics
• /
• v.27 no.5
• /
• pp.610-613
• /
• 2010

An 8-year-old male dog weighing 7.9 kg was referred to us for evaluation of exophthalmos and corneal edema of the left eye, on which cataract surgery had been performed 3 years prior. On ophthalmic examination, the left eye showed an extremely high intraocular pressure (47 mmHg), with no menace response, dazzle reflex, or pupillary light reflex. The dog was treated with systemic and topical glaucoma medications. After treatment, corneal edema decreased but IOP did not return to within acceptable limits. Seventeen months later, the dog presented with hyphema, episcleral congestion, and corneal edema attributable to accidental trauma. The owner wished to maintain an attractive ocular appearance, and an intraocular silicone prosthesis (ISP) was thus inserted after the evisceration. Three months postoperatively, a corneal ulcer was detected, but this resolved successfully after prescription of appropriate medication. One year after surgery, no complications related to surgery were evident.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.1
• /
• pp.118-128
• /
• 2016

As the interest on the air-pollution is gradually rising up at home and abroad, automotive and fuel researchers have been working on the exhaust emission reduction from vehicles through a lot of approaches, which consist of new engine design, innovative after-treatment systems, using clean (eco-friendly alternative) fuels and fuel quality improvement. This research has brought forward two main issues : exhaust emission and PM (particulate matter) particle emissions of gasoline vehicle. Exhaust emission and PM particle of automotive had many problem that cause of ambient pollution, health effects. In addition, researcher studied the environment problems of the MTBE contained in the fuel as oxygenate additives. The researchers have many data about the health effects of ingestion of MTBE. However, the data support the conclusion that MTBE is a potential human carcinogen at high doses. Based on the oxygenated fuel additive types (MTBE, Bio-ETBE, Bio-ethanol, Bio-butanol), this paper discussed the influence of oxygen contents on gasoline fuel properties and evaporative emission characteristics. Also, this paper assessed the acceleration and power performance of gasoline vehicle for the fuel property.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.3 no.1
• /
• pp.12-17
• /
• 1993

Growth runs of KTP single crystals were carried out by the hydrothermal method. KTP powders used for the crystal growth were prepared as a single phase by the solid state reaction of a stoichiometric mixture of $KH_2PO_4 and TiO_2$ at TEX>$800^{\circ}C$ and subsequently by the hydrothermal treatment at $250^{\circ}C$ 4m KF solution. The most effective solvents for the crystal growth of KTP were KF and K $K_2HPO_4$ solutions. Solubilities of KTP in these solutions were positive over the range $350~450^{\circ}C$.Seed crystals of good quality could be obtained by the horizontal temperature gradient method at temperatures over the range 380~430^{\circ}C$ in these solutions. The hydrothermal conditions for the high growth rates of seed crystals are as follows: growth method; vertical temperature gradient method, solvent; 4m KF or $K_2HPO_4$ solution, temperature region; $400~450^{\circ}C$, pressure region; $1000~1500kg/cm^2$, where solubility of KTP was large enough to proceed the growth. Under such conditions, seed crystals of KTP are grown at a rate of approximately 0.06-0.08mm/day in the direction of the c-axis. Morphologies of grown crystals tended to be bounded by (100), (011) and (201) faces.

• KSBB Journal
• /
• v.16 no.4
• /
• pp.403-408
• /
• 2001

Distillation condensate generated from downstream processing of microbial alcohol fermentation imposes a serious burden to biological wastewater treatment or anaerobic digestion due to its high contents of SS (suspended solids) and TN (total nitrogen), A pilot scale microfiltration of the stillage condensate with a stainless steel SCEPTER membrane of 0.1 ${\mu}$m pore size was carried out to remove SS which was mostly composed of microbial cell residue. A stable permeate flux was achieved when the decanter effluent containing 0.7% of SS was filtered under the conditions of X10 VCR (volume concentration ratio), 2.5 bar of TMP (transmembrane pressure), and 60$^{\circ}C$. When stillage condensate with 2.6% SS was treated directly with microfiltration, VCR below X3 was recommended for a long duration of filtration. The permeate and retentate obtained from microfiltration were recycled to make-up medium of fermentation. Adding permeate or retentate up to 30% of fermentation volume showed no distinguished undesirable influence during the course of alcohol fermentation. Although only slight improvements in the final amount of CO$_2$ evolution and alcohol content were observed, fermentation rate increased so that the required time to reach 450 L/ton of CO$_2$ evolution was shortened to 72% of that with normal media.

• Journal of Science and Technology Studies
• /
• v.14 no.2
• /
• pp.165-198
• /
• 2014

This study investigated a mechanism of naming a disease, as examining how obesity attain a status of disease. WHO(World Health Organization) warned 'The obesity is definitely a disease to need medical treatment' in 1996 and 1997. However, before then, obesity was classified as unusual or nonstandard body status but it was not categorized as a disease. In order to examine a mechanism how obesity attain the status of disease, this study examined the historical process of construction to obesity in discourse of disease and ontological reality of pathological epidemiological to obesity. As a result of this research, it was found that the medical community manipulated BMI(Body Mass Index) and deliberately narrowed the range of person's normal weight, and institutionalized sizism. Especially, it was found that as the medical community associated the body state of obesity with high blood pressure, diabetes, and etc that causes burden of medical expenses to patients, that was fatphobia. And it tried to from a medical control mechanism to assign obesity to an independent status of a disease. Based on this examination, this study found an entailment: the noninfectious disease such as obesity attains the status of disease not because of the pathologic reason but because of cultural or socio-economical reason which han nothing to do with any medical source.

• The Journal of the Acoustical Society of Korea
• /
• v.35 no.2
• /
• pp.92-101
• /
• 2016

There are many results in which acoustical conditions of a classroom play an important role for studying effects and academic achievement of students. However, there are very few guidelines or design proposals which could make appropriate acoustic environment when classrooms are built or renovated. The present study suggests various design proposals satisfying acoustic standards of classrooms based on theoretical calculation and acoustic field experiments. At first, minimum area of sound absorption was calculated which is required to satisfy the acoustic standard for domestic middle and high schools. Also, room acoustic measurements were carried out in order to investigate the acoustic performance of an existing classroom by changing interior finishing materials on ceiling and rear walls. As a result, it was revealed that reverberation time standard below 0.8 s can be acquired even if there is no sound absorption on ceiling which is a general practice executed in Korea. Specially, it was found that if partial area of ceiling would be treated as reflective with the ratio of sound absorption and reflection as 2:1, almost similar acoustic parameters of $C_{50}$, $D_{50}$, RASTI (Rapid Speech Transmission Index) and higher sound levels could be acquired in comparison with the case of entire sound absorption on ceiling.

• Journal of the Korean Magnetics Society
• /
• v.21 no.4
• /
• pp.136-140
• /
• 2011

Mechanical properties of degraded materials must be measured for evaluating the integrity of the facilities operating at high temperature. In fact it is complicated to obtain the different degraded specimens from an operating facility. Specimens of 1Cr-0.5Mo steel prepared by the isothermal heat treatment at $700^{\circ}C$ were tested, which has been widely used as tubes for heat exchangers and as plates for pressure vessels. The magnetic properties and Rockwell hardness (HRB) were measured at room temperature. The peak interval of Barkhausen noise envelope (PIBNE), coercivity, and hardness decreased with the increase of degradation. The magnetic and mechanical softening of matrix is likely to govern the properties of the specimen more than the hardening of grain boundary by carbide precipitations. The degradation of test material may be determined by the linear correlation of PIBNE and HRB. Degradation of 1Cr-0.5Mo steel could well be nondestructively evaluated by PIBNE measured with surface type probe.

• Journal of Adhesion and Interface
• /
• v.2 no.2
• /
• pp.1-10
• /
• 2001

Silica for Epoxy Molding Compound (EMC) was coated via plasma-polymerization with RF plasma (13.56 MHz) as a function of treatment time, power and pressure. 1,3-diaminopropane, allylamine, pyrrole, 1,2-epoxy-5-hexene, allylmercaptan or allylalcohol were utilized for plasma polymerization coating and adhesion of coated silica was evaluated by measuring flexural strength. CTE and water absorption of EMC were also measured, and fracture surface of flexural specimen was analyzed by SEM in order to elucidate the failure mode. The plasma polymer coated silica was analyzed by FT-IR and reactivity of plasma polymer coating with epoxy resin was evaluated with DSC in order to investigate the adhesion mechanism. The EMC prepared from the silica coated with 1,3-diaminopropane or allylamine exhibited high flexural strength, low CTE, and low water absorption compared with the control sample, and also exhibited 100% cohesive failure mode. These results can be attributed to the chemical reaction between the functional groups in the plasma polymer coating and epoxy resin, and also consistent with the results from FT-IR and DSC analysis.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.6
• /
• pp.323-328
• /
• 2016

Pressurized membrane used for side-stream MBR process requires fouling control strategy both for normal and abnormal operation conditions for stable operation of the facilities. In this study, $85m^3/day$ of pilot-scale side-stream MBR process was constructed for the evaluation of fouling mitigation by air bubble injection into the membrane module. In addition, fouling phenomena at abnormal operation conditions of low influent and/or loading rate were also investigated. Injection of air bubble was found to be effective in delaying transmembrane pressure (TMP) increase mainly due to scouring effect on the membrane surface, resulting in expanded filtration cycle at a high flux of $40L/m^2{\cdot}h$ (LMH). At abnormal operation condition, injection of PACl (53 mg/L as Al) into the bioreactor showed 19% reduction of TMP increase. However, inhibition of nitrifying bacteria by continuous PACl injection was observed from batch experiments. In contrast, injection of powdered activated carbon (PAC, 0.6 g/L) was able to maintain the initial TMP of $0.2kg/cm^2$ for 5 days at the abnormal conditions. It may have been caused from the adsorption of extracellular polymeric substances (EPS), which was known to be excessively released during growth inhibition condition and act as the major foulants in MBR operations.

• Food Science of Animal Resources
• /
• v.29 no.6
• /
• pp.719-725
• /
• 2009

Heterocyclic aromatic amines (HCAs) are potent mutagens and possible human carcinogens that are formed during the heating of protein-rich foods. The effects of preheating treatment of beef patties using a microwave prior to frying at $220^{\circ}C$ for 10 min on each side on the reduction of HCAs (amino-carbolines and amino-imidazo-azaarenes) were evaluated. The amount of HCAs was then evaluated by solid-phase extraction and high pressure liquid chromatography (HPLC) analysis. The beef patties were treated by microwaving for various times (0, 1, 1.5, 2, or 3 min) before pan-frying. The results revealed the presence of 3-amino-1-methyl-5H-pyrido[4,3-b]indole (Trp-P-2), 3-amino-1,4-dimethyl-5H-pyrido-[4,3-b] indole (Trp-P-1), 2-amino-6-methyldipyrido[1,2-a:3',2'-d]imidazole (Glu-P-1), 2-aminodipyrido[1,2-a:3',2'-d]imidazole (Glu-P-2), 9H-pyrido[3,4-b]indole (Norharman), 1-methyl-9H-pyrido[3,4-b]indole (Harman), 2-amino-9H-pyrido[2,3-b] indole ($A{\alpha}C$), 2-amino-3,8 dimethylimidazo[4,5-f]-quinoxaline (MeIQx) and 2-amino-1-methyl-6-phenylimidazo[4,5-b]-pyridine (PhIP) in all samples. However, microwave pretreatment for 1 min inhibited the formation of these HCAs by up to 90% when compared to the control.