• 대한전기학회논문지
• /
• 제43권3호
• /
• pp.409-419
• /
• 1994

This paper deals with the design criteria and conduction noise reduction of electronic ballast system which is based on half-bridge series inverters. The system is theoretically analyzed in six modes and operating frequency range is selected to obtain the high efficacy and no sound noise. It is proposed the criteria for determining the values of L and C which are the dey points in system design Because of high operating frequency, electromagnetic noise, especially conduction noise, is a serious problem in electronic ballasts. To reduce the conduction noise, the operation and attenuation characteristics of noise filter are analyzed and the method to determine the values of filter elements is proposed. Also, the parasitic components of the inductor and capacitor are taken into consideration in filter analysis. Digital simulations and experiments are carried out to prove the theoretical results. And perfor mances of the system are verified through tests.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 B
• /
• pp.738-740
• /
• 2003

A lot of R&D on the diagnosis of stator winding insulation for large rotating machines has been carried out since the 1970s. The on-line partial discharge measurement has proved to be an effective technique in the evaluation of the state of stator insulation in high voltage rotating machines. It is well known that if the discharge pulses propagate through the winding conductor, they are attenuated and delayed. In the present study, to investigate the attenuation and the time delay of discharge pulses through the winding conductor, a series of tests were conducted using a model coils and slot. Thus it could be concluded that while the high frequency pulse propagates in radiation or end-winding coupling modes, the low frequency one does in a series mode through the coil conductor.

• 비파괴검사학회지
• /
• 제19권2호
• /
• pp.110-117
• /
• 1999

크리프 손상을 단계적으로 받은 순수 구리 시편에 대하여 손상 진전에 따른 기공의 미시구조 변화를 관찰하고 초음파 속도와 주파수 의존 진폭 스펙트럼 및 감쇠를 측정하였다. 손상 진전에 따른 입계기공의 비등방적 성장으로 인하여 하중축에 대하여 세 방향으로 측정한 속도는 이방성 거동을 보였다. 최대 2%의 기공에 대하여 종파와 횡파는 각각 11%와 4%의 속도 감소를 보였으며, 기공량의 증가와 함께 비선형적인 감소 경향을 보였다. 진폭 스펙트럼은 기공량이 증가함에 따라 고주파수 성분이 감소하고 중심 주파수가 저주파수로 이동하였으며, 감쇠는 사용 주파수 범위에서 거의 선형적인 거동을 보였다. 기공량의 정량적 비파괴평가 파라미터로서 정규화 속도, 진폭 스펙트럼의 중심 주파수, 감쇠 기울기를 선정하였으며 기공량과의 상관관계를 제시하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 C
• /
• pp.1333-1334
• /
• 2006

중, 저압 배전 시스템을 통신망으로 사용하는 전력선 통신(PLC, Power Line Communication)에서 신호결합은 하드웨어 측면에서 매우 중요하다. 본 논문에서는 2-40MHz의 통신 신호를 수백 A의 전류가 흐르는 배전선으로 보내고 추출하는 유도성 신호결합장치와 통신신호 손실에 대하여 조사하였다.

• 한국해안해양공학회:학술대회논문집
• /
• 한국해안해양공학회 1993년도 정기학술강연회 발표논문 초록집
• /
• pp.20-25
• /
• 1993

In coastal waters, more often than not, waves propagate on currents driven by tidal forces, earth’s gravity, or wind. There have been a number of studies for dealing with the change of wave spectrum due to tile presence of current. Based on the conservation of wave action, Hedges et al. (1985) have proposed an equation which describes the influence of current on the change of wave spectrum in water of finite depth. (omitted)

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 합동 추계학술대회 논문집 정보 및 제어부문
• /
• pp.65-67
• /
• 2001

PLC (Power Line Communication) is the communication method using the existing power line installed in houses and offices to convert and transmit high frequency communication signal from tens of KHz to tens of MHz, and receive the filtered signal using high frequency filter. The advantage of PLC is that PLC uses the existing power line installed in houses and offices so it does not require separate power line. Easy and convenient access using electric outlets is another advantage of PLC. However, PLC has some disadvantages such as limited transmission power, high load interference and noise, variable signal attenuation, characteristic of impedance selective possibility of frequency property. This study designed the boiler temperature control system by unit using the modem designed on the basis of technology used for PLC modem, and designed remote control system using internet. After conducting experiments with those two systems, it was possible to control stably. By commercializing this product, we can avoid unnecessary heating of separate temperature control unit, and save the cost according1y, and it is possible to control on a remote site using internet in a more convenient way.

• 한국자동차공학회논문집
• /
• 제5권3호
• /
• pp.54-65
• /
• 1997

To quantify the LII signals from soot particle of flames in diesel engine cylinder, a new method has been proposed for correcting LII signal attenuated by soot particles between the measuring point and the detector. It has been verified by an experiment on a laminar jet ethylene-air diffusion flame. Being proportional to the attenuation, the ratio of LII signal at two different detection wavelengths can be used to correct the measured LIIsignal and obtain the unattenuated LII signal, from which the soot volume fraction in the flame can be estimated. Both the 1064-nm and frequency-doubled 532-nm beams from the Nd : YAG laser are used. Single-shot, one-dimensional(1-D) line images are recorded on the intensified CCD camera, with the rectangular-profile laser beam using 1-mm-diameter pinhole. Two broadband optical interference filters having the center wavelengths of 647 nm and 400 nm respectively and a bandwidth of 10 nm are used. This two-wavelength correction has been applied to the ethylene-air coannular laminar diffusion flame, previously studied on soot formation by the laser extinction method in this laboratory. The results by the LII measurement technique and the conventional laser extinction method at the height of 40 nm above the jet exit agreed well with each other except around outside of the peaks of soot concentration, where the soot concentration was relatively high and resulting attenuation of the LII signal was large. The radial profile shape of soot concentration was not changed a lot, but the absolute value of the soot volume fraction around outside edge changed from 4ppm to 6.5 ppm at r=2.8mm after correction. This means that the attenuation of LII signal was approximately 40% at this point, which is higher than the average attenuation rate of this flame, 10~15%.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2009년도 추계학술대회
• /
• pp.86-89
• /
• 2009

본 논문에서는 광대역 전력선 통신 모뎀 및 네트워크 기술개발을 위하여 실측 실험을 통한 지중 전력선 통신채널의 특성을 해석한다. 지중 배전선로의 길이 및 구조물에 따른 지중 배전선로 광대역 전력선통신 채널상의 감쇠 량을 측정하기 위해 신호발생기, 스펙트럼 분석기, 비접촉식 커플러 등을 이용하여 채널 측정 시스템을 구성하였다. 실증시험은 시험선로 내 단일 선로로서 가장 긴 고압 선로 두 곳을 선택하여 채널상의 노이즈 측정 및 신호감쇠 레벨을 측정하였다. 측정결과 통신성능을 매우 떨어뜨릴 수 있는 임펄스 노이즈가 존재하는 것을 확인하였으며, 장거리 선로의 경우 선로 길이에 의한 고주파 감쇠가 나타나는 것으로 확인하였다.

• 한국산학기술학회논문지
• /
• 제14권7호
• /
• pp.3425-3430
• /
• 2013

최근 이동통신 시장의 급속한 증가에 따라 단말기 설계는 다표준 방식으로 발전하고 있다. 본 논문에서는 다표준 이동통신 시스템에 적용할 수 있는 주파수 가변형 능동 RC 대역통과 필터를 능동 인덕터를 사용하여 설계하였다. 기존의 대역통과 필터 설계법에서는 저지대역의 감쇠 특성과 통과대역의 주파수 선택도를 향상시키기 위하여 필터의 차수를 높게 하거나 극점 Q를 증가시키는 설계법을 사용한다. 본 논문에서는 극점 Q가 높은 능동 인덕터로 대역통과 필터를 설계하여 주파수 특성이 향상되었다. 또한 설계된 대역통과 필터는 튜닝 회로를 이용하여 필터의 중심주파수와 이득을 간단히 조절할 수 있도록 제안하였다. 설계된 능동 RC 대역통과 필터 특성은 TSMC $0.18{\mu}m$ 공정 파라미터를 이용하여 해석하였다. 시뮬레이션 결과, Q=20.5를 갖는 능동 인덕터를 이용한 필터는 1.86GHz 중심주파수에서 90MHz의 대역폭을 갖고, 튜닝 회로의 커패시터 값으로 중심주파수를 1.86~2.38GHz 범위까지 튜닝이 가능하여 다표준 무선통신 시스템에 적용할 수 있다.

• 한국안전학회지
• /
• 제26권5호
• /
• pp.1-6
• /
• 2011

Flame extinction and the chemistry of stoichiometric methane/air mixture were investigated numerically in the PSR(perfectly stirred reactor). For the study, PSR code was modified to be possible to unsteady calculation, and the sinusoidal fluctuation was subjected to the residence time. In the region of residence time far from the extinction limit, combustion mode was strongly dependent on the frequency. The low frequency excitation provided the quasi-steady behavior on the temperature and the concentrations of related species, but small variation of temperature was observed under high frequency. In the region of residence time near the extinction limit, the mixture subjected above 1 KHz was still reacting even though extinction had to be occurred under quasi-steady concept. The attenuation of extinction limit resulted from that chemical time was comparable to the flow time. The mean mole fractions of both NO and CO were almost same regardless of imposed frequency. However, the average mole fraction of $C_2H_2$ was decreased as increasing frequency, which implies that soot yield might be reduced at the higher frequency of flow excitation. The result provides the basic concept for flame stabilization, and it will be used to design a mild combustor.