• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2006년도 6th International Meeting on Information Display
• /
• pp.333-336
• /
• 2006

High Pressure Annealing System was developed to improve the characteristics of low-temperature poly-silicon thin film transistors.. (TFTs). The high-pressure steam annealing was applied to the poly-silicon film made by rapid thermal annealing method. The carrier lifetime was investigated by Microwave detection of the Photo-Conductive Decay and the increase of carrier lifetime which indicates the reduction of the defect was observed by high-pressure steam annealing of 1MPa 600C 1hour.

• 한국소음진동공학회논문집
• /
• 제24권4호
• /
• pp.339-347
• /
• 2014

Floor impact sound in high-rise apartment building became one of social problems. A lot of civil complaints on floor impact sound occur continuously and the number of disputes between neighbors in small and aged apartment buildings is increasing. Interests on heavy-weight impact sound pressure level measurement and evaluation method is increased. Previous study reported that heavy-weight impact sound level was changed by the sound field condition of receiving reverberation chamber. In this study, heavy-weight impact sound pressure level change by the receiving sound field condition was measured in standard test facility and mock-up test room. These two experimental conditions were designed to simulate averaged living room of common apartment units. By the change of sound absorption power in receiving room, heavy-weight impact sound pressure level in most of frequency bands were changed in standard test facility and mock-up room. Normalized maximum sound pressure level regulated in ISO 16032 showed wider range of heavy/soft impact sound pressure level. Heavy/soft impact sound pressure level change was became smaller by the application of standardized maximum sound pressure level and ISO/CD 10140-3 Amd 2 method. In the case of standardized maximum sound pressure level, absolute sound pressure level changed. From these results, receiving sound field correction method regulated in ISO/CD 10140-3 Amd 2 is needed for the precision measurement and evaluation of heavy-weight impact sound.

• 대한조선학회논문집
• /
• 제49권6호
• /
• pp.484-490
• /
• 2012

Experiments of circulating water channel and two dimensional numerical simulations were performed to investigate the fluctuating characteristics of pressure in moonpool. Based on the quasi-two dimensional characteristics of pressure fluctuations disclosed by the spatial cross-correlations, the numerical results showed qualitatively good agreement with experimental data. Proper orthogonal decomposition was employed to the spatial distributions of pressure fluctuations in order to find the first and second modes of fluctuations. The first mode of pressure fluctuations showed that the fluctuating characteristics of pressure were related to the behaviors of vortical structures. The velocity fluctuations were conditionally averaged to make clear that the coherent structures were responsible for the pressure fluctuations in moonpool.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2004년도 제22회 춘계학술대회논문집
• /
• pp.789-794
• /
• 2004

The pressure sensitive paint (PSP) technique has been well established in external flow field. However, there are still unresolved issues in internal flow field. This work was focused on the application to unsteady pressure measurement of fan flow field. The PSP measurement system was established and the image processing software was developed. First, the performance of PSP was investigated at the static cell. Then the unsteady PSP measurement was carried out at fan test facility. PSP data images were acquired from the suction and pressure surface of stator vanes. Pressure distributions on the surface of the stator vane were detected non-intrusively. The issues of image acquisition and image processing were clarified through the practical PSP application to fan flow field.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2000년도 춘계학술대회논문집
• /
• pp.791-796
• /
• 2000

The cavitation-induced fluctuating pressure of the container ship named "Sydney Express" is measured in Samsung Large Cavitation Tunnel(SCAT). In the measurements, a complete ship model is employed. The effects of thrust coefficient and cavitation number on cavity pattern and cavitation-induced fluctuating pressure were investigated experimentally. It is demonstrated that the fluctuating pressure coefficient is very sensitive to the cavitation number. The results of cavitation and pressure fluctuations are compared with those of ITTC and HSVA, which shows fairly good agreement. It is exhibited that the removal of rudder can significantly change the loading condition of a propeller, and can reduce the fluctuating pressure coefficient almost by half.

• 통합자연과학논문집
• /
• 제7권1호
• /
• pp.39-44
• /
• 2014

The results of the synoptic meteorological analysis showed that when the cold and dry continental high pressure was extended, heavy snow occurred at dawn when the upper atmosphere cooled. In particular, when the continental high pressure was extended and the upper pressure trough passed through, heavy snow occurred due to the convergence region formed in the west coast area, sometimes in the inland of the Honam area. In addition, it was verified that the changes in the humidity coefficients in the upper and lower layers are important data for the determination of the probability, start/end and intensity of heavy snow. However, when the area was influenced by the middle-latitude low pressure, the heavy snow was influenced by the wind in the lower layer (925 hPa and 850 hPa), the equivalent potential temperature, the convergence field, the moisture convergence and the topography. In Case 2010 (30 December 2010), OSTIA had the best numerical simulation with diverse atmospheric conditions, and the maximum difference in the numerically simulated snowfall between NCEP/NCAR SST and OSTIA was 20 cm. Although there was a regional difference in the snowfall according to the difference in the SST, OSTIA and RTG SST numerical tests, it was not as significant as in the previous results. A higher SST led to the numerical simulation of larger snowfall, and the difference was greatest near Buan in the west coast area.

• 대한지리학회지
• /
• 제45권3호
• /
• pp.319-341
• /
• 2010

본 연구에서는 지난 36년 동안(1973/74-2008/09) 우리나라 겨울철 강설자료와 북반구 대기순환장을 분석하여 대설 유형별 지상 종관 기후 패턴의 특징을 밝히고자 한다. 동아시아 기압 배치 및 대설 지역을 복합적으로 고려하여 우리나라 대설 발생 사례를 크게 4가지 종관 기후 범주, 세부적으로 17가지 유형으로 세분하였다. 지상 종관 기후 자료 분석에서 각 대설 유형마다 한반도 주변에 나타나는 기압과 바람벡터 아노말리 핵들의 위치 및 강도 차이가 뚜렷하게 나타난다. 특히, 시베리아 고기압의 장출과 이동성 저기압의 통과 여부가 이러한 차이점에 중요한 영향을 미친다. 반구 규모 종관 기후 패턴으로 북극진동의 음의 모드 또한 한반도 겨울철 대설 발생 증가에 영향을 미친다. 이러한 종관 기후 분석 결과들은 단기 또는 계절 대설 예보 향상에 기초 자료로 활용 될 수 있다.

• 한국소음진동공학회논문집
• /
• 제23권3호
• /
• pp.274-281
• /
• 2013

Field measurement method of heavy/soft impact sound pressure level which is regulated in JIS and ISO has been using in Korea, Japan and Canada. It is reported that heavy/soft impact sound pressure level was varied by the sound field condition of receiving room such as sound absorption power and room volume. In this study, it is checked that heavy/soft impact sound pressure level was affected by the receiving sound field condition. Rubber ball and bang machine sound pressure level was measured in the vertically connected reverberation chamber. In oder to check the effect of receiving sound field on heavy/soft impact sound pressure, sound absorption power was changed with polyester sound absorption blankets with air space and glass wool. The reverberation time at 1 kHz band was changed from 10 s to 0.2 s by sound absorption material. Rubber ball sound pressure level measured without sound absorption material was 58 dB in $L_{i,Fmax,AW}$, but the level was 46 dB with sound absorption treatment. From this result, it is confirmed that sound field correction method is needed in the heavy/soft impact sound pressure level measurement method using bang machine and rubber ball.

• 대한조선학회 특별논문집
• /
• 대한조선학회 2005년도 특별논문집
• /
• pp.44-50
• /
• 2005

Since a cavitation pattern in model scale can be different from that in full scale, it has been highly demanded to measure a fluctuating pressure induced by propeller in full scale. For the verification of the cavitation test for 105K lanker in the large cavitation tunnel in Samsung Ship Model Basin(SSMB), an effective pressure fluctuation measurement system was developed and a series of full scale measurements was carried out. These results were compared with those of cavitation tests in SSMB. The measured results in full scale gave good agreements to those in model tests. The fluctuating pressure at $2^{nd}$ blade frequency in full scale seems to be highly dependent upon tip loading.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2004년도 제22회 춘계학술대회논문집
• /
• pp.472-478
• /
• 2004

This paper describes the characteristics of the unsteady pressure on the stator surface induced by rotor viscous wakes. The primary object of this study is to investigate the effects of axial spacing between the rotor and the stator and three-dimensional vane geometries such as stator sweep and stator lean on the unsteady pressure fluctuations on the stator vane. To predict these fluctuations, unsteady three-dimensional Navier-Stokes analyses are performed. Furthermore, a three-dimensional analytical method using unsteady lifting-surface theory is also used to elucidate the mechanism of interaction of passing rotor wakes with downstream stator. Five different fan configurations with three sets of stator geometries, which are three radial stator configurations with different axial spacing, the swept stator and the swept and leaned stator, are used for this study. It is found that, in axial spacing between rotor and stator, the effect of radial phase skew of incoming rotor wake is important for the reduction of the induced unsteady pressure in addition to the rotor wake decay. It is also shown that incorporation of stator sweep and lean is effective to reduce this unsteady pressure.