• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.5
• /
• pp.427-431
• /
• 2011

Hybrid $SiO_2-TiO_2$ photoelectrode with different type of layers was investigated in dye-sensitized solar cells (DSSC). Use of a thin layer of nanocrystalline $TiO_2$ would imply reduction in the amount of dye coverage, however, lower amount of dye in the thin films would imply fewer electron generation upon illumination. So, thus, it becomes necessary to include a $SiO_2-TiO_2$ layer for increase light harvesting effect such that the lower photon conversion due to thin layer could be compensated. In this paper reports the use of transparent high surface area $TiO_2$ layer and an additional $SiO_2-TiO_2$ layer, thus ensuring adequate light harvesting in these devices. The best solar conversion efficiency 6.6% under AM 1.5 was attained with a multi-layer structure using $TiO_2$ layer/$SiO_2-TiO_2$ layer/$TiO_2$ layer for the light harvesting and this had resulted to about 44% increase in photocurrent density of dye-sensitized solar cells.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.6
• /
• pp.2441-2446
• /
• 2018

This paper presents a radio frequency-to-direct current (RF-to-DC) converter for special RF power harvesting application at 915 MHz. The major featured components of the proposed RF-to-DC converter is the combination of a cross-coupled rectifier and an active diode: first, the cross-coupled rectifier boosts the input voltage to desired level, and an active diode blocks the reverse current, respectively. A prototype was implemented using $0.18{\mu}m$ CMOS technology, and the performance was proven from the fact that the targeted RF harvesting system's full-operation with higher power efficiency; even if the system's input power gets lower (e.g., from nominal 0 to min. -12 dBm), the proposed RF-to-DC converter constantly provides 1.47 V, which is exactly the voltage level to drive follow up system components like DC-to-DC converter and so on. And, maximum power conversion efficiency is 82 % calculated from the 0 dBm input power, 2.3 mA load current.

• International Journal of Precision Engineering and Manufacturing-Green Technology
• /
• v.5 no.5
• /
• pp.643-650
• /
• 2018

A self-powered electrochromic device was fabricated on an indium tin oxide-polyethylene naphthalate flexible substrate using a dye-sensitized solar cell (DSSC) as a self-harvesting source; the electrochromic device was naturally bleached and operated under outdoor light conditions. The color of the organic electrochromic polymer, poly(3,4-ethylenedioxythiophene) polystyrene sulfonate, was shifted from pale blue to deep blue with an antimony tin oxide film as a charge-balanced material. Electrochromic performance was enhanced by secondary doping using dimethyl sulfoxide. As a result, the device showed stable switching behavior with a high transmittance change difference of 40% at its specific wavelength of 630 nm for 6 hrs. To improve the efficiency of the solar cell, 1.0 wt.% of Ag NWs in the photoanode was applied to the $TiO_2$ photoanode. It resulted in an efficiency of 3.3%, leading to an operating voltage of 0.7 V under xenon lamp conditions. As a result, we built a standalone self-harvesting electrochromic system with the performance of transmittance switching of 29% at 630 nm, by connecting with two solar cells in a device. Thus, a self-harvesting and flexible device was fabricated to operate automatically under the irradiated/dark conditions.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2009.05a
• /
• pp.524-528
• /
• 2009

The objectives of this study were to install RCR systems at a typical single family house and a school in Alabama, and evaluate the feasibility and efficiency of using the RCR systems for water harvesting in Alabama. The RCR systemswere equipped with a control system and a CR10X data logger to monitor the system operation and to collect data on precipitation, temperature, overflow, water depth in the storage tank and daily uses of toilet flushing. Daily average water use of the home for toilet flushing was 95 liter and 2100 liter was used at the school during the school days. Rainwater harvesting efficiency was 83.3 and 89 percent and RCR use efficiency was 18 and 98 percent from the home and the school, respectively. A computer program was developed to estimate potential effectiveness of RCR systems. From the analysis result with 10 years rainfall data, a total of 67,000 liters of rainwater could be harvested for domestic uses from a typical single family house which supplies 190 liters per day.

• Journal of IKEEE
• /
• v.22 no.1
• /
• pp.174-179
• /
• 2018

In this paper, design of high-efficiency DC-DC converter is presented for low-power PMIC (power management integrated circuit). As PMIC technologies for IoT and wearable devices have been continuously improved, high-efficiency energy harvesting schemes should be essential. Since the supply voltage resulting from energy harvesting is low and widely variable, design techniques to achieve high efficiency over a wide input voltage range are required. To obtain a constant switching frequency for wide input voltage range, frequency compensation circuit using supply-voltage variation sensing circuit is included. In order to obtain high efficiency performance at very low-power condition, accurate burst-mode control circuit was adopted to control switching operations. In the proposed DC-DC buck converter, output voltage is set to be 0.9V at the input voltage of 0.95~3.3V and maximum measured efficiency is up to 78% for the load current of 180uA.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.2
• /
• pp.45-49
• /
• 2015

In this paper, we proposed not specturm sensing but also save energy without consume energy of secondary network that spectrum sensing of cognitive applied energy harvesting scheme. Algorithms of sensing and harvesting is determine active or idle of primary network, compares the amount of energy that is harvested by energy harvesting scheme with the threshold. If secondary network to send a message and primary network is active, by changing frequency to use the spectrum. Further, if secondary network have no message, continues energy harvest. Therefore, spectrum sensing applied energy harvesting scheme, energy of secondary network is remove waste and charge energy, efficiency and utilization of cognitive network can be increase.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.15 no.3
• /
• pp.73-76
• /
• 2015

In this paper, we propose energy harvesting apply to spectrum sensing. In this case, we can be spectrum sensing without consume energy. Algorithms of sensing and harvesting are determine active or idle of primary network, Compares with the threshold energy and the amount of energy that is harvested by energy harvesting scheme. If the secondary network want to send a message while the primary network is active, secondary users will change frequency to use the spectrum. Further, if the secondary network has not message, it will continues harvest energy. Therefore, spectrum sensing applied the energy harvesting method, energy of secondary network is remove waste and charge energy. So, efficiency and utilization of cognitive network can be increase.

• KSBB Journal
• /
• v.27 no.2
• /
• pp.103-108
• /
• 2012

The harvesting of microalgae is a critical step that precedes biodiesel conversion. The most widely used harvesting technology is flocculation and floatation. In this study, the efficiency of the flocculants aluminum sulfate and poly aluminum chloride were evaluated for harvesting the alga Dunaliella tertiolecta in conjunction with dissolved air floatation. Using the jar test the optimum concentration range for aluminum sulfate was 1.0~1.5 g/L and for poly aluminium chloride, 1.5~2.0 g/L. The degree of coagulation was visualized by microscopy. Further analysis in combination with dissolved air floatation showed that the optimal concentration for aluminum sulfate was 1.1 g/L and for poly aluminum chloride, 1.6 g/L.

• Journal of Communications and Networks
• /
• v.17 no.3
• /
• pp.256-264
• /
• 2015

Energy harvesting devices have been proposed for sensor networking applications where batteries cannot be replaced, and cooperative communication schemes have been used to increase energy efficiency for wireless systems. Here, we develop transmission scheduling schemes for multi-terminal cooperative energy harvesting networks that maximize the packet delivery ratio, i.e., the probability that an event is reported successfully. We see that the proposed scheme provides virtually the same performance as the state-of-the-art threshold-based scheme, but does not require auxiliary parameter optimization. The proposed scheme also permits extensions to multiple cooperating nodes and sources, and it can be modified to accommodate fairness constraints.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.49 no.3
• /
• pp.179-183
• /
• 2004

This study was conducted to investigate the effects of using barley seeder attached to rice harvest combine that could be used in rice harvesting and barley seeding simultaneously on the growth characteristics of barley and labor-saving efficiency. In developed seeding system, burley seeding was earlier about 5 days than in the conventional system, because of conducting rice Harvesting and barley seeding simultaneously. The germination of barley seed after seeding was protected from drought damage by the rice straw covering. Among the growth characteristics of barley using developed seeding system, the number of spikes per m$^2$ was lower than that of conventional system, but others showed longer culm length, hove kernel numbers per spike and heavier 1,000 kernel weight than those of conventional system. Developed seeding system resulted in about 57% labor-saving efficiency compared with conventional system. The cost of whole works from seeding to harvest of barley was saved about 8% compared with conventional system. A total of income increased about 16% than that of conventional system.