• Journal of the Korean Vacuum Society
• /
• v.5 no.1
• /
• pp.54-61
• /
• 1996

Indium-tin oxide (ITO) films were deposited on the glass substrate by the reactive -ionized cluster beam deposition(ICBD) method. In the oxygen atmosphere, indium cluster formed through the nozzle is ionized by the electron bombardment and is accelerated to be deposited on the substrate. And tin is simultaneoulsy evaporated from the boron-nitride crucible. The chracteristics of films were examined by the X-ray photoelectron spectroscopy(XPS), glancing angle X-ray diffractrion(GXRD) and the electrical properties. were measured by 4-point-probe and Hall effect measurement system . From the XPS spectrum , it was found that indium and tin atoms combined with the oxygen to form oxide$(In_2O_3, SnO_2)$. In the case of films with high tin-concentration, the GXRD spectra show that the main $In_2O_3$ peak of (222) plane, but also sub peaks((440) peak etc.) and $SnO_2$ peaks were detected. From that results, itis concluded that the heavily dopped tin component (more than 14 at. %) disturbs to form $In_2O_3$(222) phase. Four-point-probe and Hall effect measurement show that, in the most desirable case, the transmittance of the films is more then 90% in visible range and its resistivity is $$\rho$=3.55 \times10^{-4}\Omega$cm and its mobility is $\mu$=42.8 $\textrm{cm}^2$/Vsec.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.23 no.2
• /
• pp.98-102
• /
• 2010

This paper describes that single crystalline 3C-SiC (cubic silicon carbide) thin films have been deposited on carbonized Si(100) substrates using hexamethyldisilane (HMDS, $Si_2(CH_3){_6}$) as a safe organosilane single precursor and a nonflammable mixture of Ar and $H_2$ gas as the carrier gas by APCVD at $1280^{\circ}C$. The deposition was performed under various conditions to determine the optimized growth condition. The crystallinity of the 3C-SiC thin film was analyzed by XRD (X-ray diffraction). The surface morphology was also observed by AFM (atomic force microscopy) and voids between SiC and Si interfaces were measured by SEM (scanning electron microscopy). Finally, residual strain and hall mobility was investigated by surface profiler and hall measurement, respectively. From these results, the single crystalline 3C-SiC film had a good crystal quality without defects due to viods, a low residual stress, a very low roughness.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.184-185
• /
• 2007

We investigated the growth behaviors of ZnO epilayers on sapphire substrates fabricated sing RF magnetron puttering and RTA. The effects of deposition temperature and oxygen partial pressure in plasma on the structural and electrical properties were measured by XRD, AFM, SEM, and Hall effect measurement. It was found that ZnO thin films became denser and smoother with increasing deposition temperature and $O_2$ content in the puttering gas. ZnO thin film of oxygen and argon with a ratio of 5:5 had an electron concentration of $8.048{\times}10^{18}cm^{-3}$, resistivity of $0.0141{\Omega}{\cdot}Cm$, and mobility of $55.07cm^2/V{\cdot}s$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.06a
• /
• pp.121-122
• /
• 2007

Single crystal $CuAlSe_2$ layers were grown on thoroughly etched sem-insulating GaAs(l00) substrate at $410^{\circ}C$ with hot wall epitaxy (HWE) system by evaporating $CuAlSe_2$ source at $680^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction (DCXD). The carrier density and mobility of single crystal $CuAlSe_2$ thin films measured with Hall effect by van der Pauw method are $9.24{\times}l0^{16}\;cm^{-3}$ and $295\;cm^2/V{\cdot}s$ at 293K, respectively. The temperature dependence of the energy band gap of the $CuAlSe_2$ obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)\;=\;2.8382\;eV\;-\;(8.68\;{\times}\;10^{-4}\;eV/K)T^2/(T\;+\;155\;K)$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.160-162
• /
• 2003

ZnO epilayer were synthesized by the pulesd laser deposition(PLD) process on $Al_2O_3$ substrate after irradiating the surface of the ZnO sintered pellet by the ArF(193nm) excimer laser. The substrate temperatures was $400^{\circ}C$. The crystalline structure of epilayer was investigated by the photoluminescence and double crystal X-ray diffraction (DCXD). The carrier density and mobility of ZnO epilayer measured with Hall effect by van der Pauw method are $8.27{\times}10^{16}\;cm^{-3}\;and\;299\;cm^2V{\cdot}s$ at 293 K, respectively. The temperature dependence of the energy band gap of the ZnO obtained from the absorption spectra was well described by the Varshni's relation, $E_g(T)\;=\;3.3973\;eV\;-\;(2.69{\times}10^{-4}\;eV/K)T^2/(T\;+\;463K)$. After the as-grown ZnO epilayer was annealed in Zn atmospheres, oxygen and vaccum the origin of point defects of ZnO atmospheres has been investigated by the photoluminescence(PL) at 10 K. The native defects of $V_{Zn}$, Vo, $Zn_{int}$, and $O_{int}$ obtained by PL measurements were classified as a donors or accepters type.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.06a
• /
• pp.138-139
• /
• 2006

Metal organic chemical vapor deposition has been investigated for growth of $Sb_{2-x}Bi_xTe_3$ films on (001) GaAs substrates using diisopropyltelluride, triethylantimony and trimethylbismuth as metal organic sources. The thermoelectric properties were measured at room temperature and include Seebeck coefficient, electrical conductivity and Hall effect. In-plane carrier concentration and electrical Hall mobility were highly dependent on precursor's composition ratio and deposition temperature. The thermoelectric Power factor($={\alpha}^2{\sigma}$) was calculated from theses properties. The best Power factor was $2.6\;{\times}\;10^{-3}W/mK^2$, given by grown $Sb_{1.6}Bi_{0.4}Te_3$ at $450^{\circ}C$. These materials could potentially be incorporated into advanced thermoelectric unicouples for a variety of power generation applications.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.33 no.1
• /
• pp.241-249
• /
• 2013

Since the enactment of "Mobility Promotion Law for Transportation Vulnerable", each municipality has been various efforts to improve the transportation vulnerable's the right of movement. However, the effectiveness of mobility promotion policy for the transportation vulnerable is awfully inadequate because circumstances which associated with operation of transportation of the handicapped such as local conditions and transport characteristics have not been considered. Thus, in this study investigated traffic characteristics of the transportation vulnerable through the data of regional slope, non-step buses and handicap vehicles operating conditions and so on in Busan Metropolitan. Also, we proposed to introduction of the 'mobility index' which is based on local condition analysis of Busan. And we suggested that how to improve the convenience of transportation vulnerable's movement.

• Korean Journal of Materials Research
• /
• v.30 no.10
• /
• pp.558-565
• /
• 2020

AZO thin films are grown on a p-Si(111) substrate by RF magnetron sputtering. The characteristics of various thicknesses and heat treatment conditions are investigated by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), Hall effect and room-temperature photoluminescence (PL) measurements. The substrate temperature and the RF power during growth are kept constant at 400 ℃ and 200 W, respectively. AZO films are grown with a preferred orientation along the c-axis. As the thickness and the heat treatment temperature increases, the length of the c-axis decreases as Al³⁺ ions of relatively small ion radius are substituted for Zn²⁺ ions. At room temperature, the PL spectrum is separated into an NBE emission peak around 3.2 eV and a violet regions peak around 2.95 eV with increasing thickness, and the PL emission peak of 300 nm is red-shifted with increasing annealing temperature. In the XPS measurement, the peak intensity of Al_2p and O_ll increases with increasing annealing temperature. The AZO thin film of 100 nm thickness shows values of 6.5 × 10¹⁹ cm^-3 of carrier concentration, 8.4 cm^-2/V·s of mobility and 1.2 × 10^-2 Ω·cm electrical resistivity. As the thickness of the thin film increases, the carrier concentration and the mobility increase, resulting in the decrease of resistivity. With the carrier concentration, mobility decreases when the heat treatment temperature increases more than 500 ℃.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.292-292
• /
• 2011

TFT (Thin Film Transistor)에서 공정을 단순화 시키고, 가격을 하락시키기 위해서는 Poly-Si을 대체할 물질이 필요하다. 이 연구에서는 Chalcogenide Material의 하나인 GeTe 박막을 이용하여 TFT Channel으로 사용 가능한 물질인지 알아보기 위하여 Post-Annealing을 한 뒤, 상 변화에 따른 박막의 저항 변화, Carrier Concentration (cm-3)과 Mobility (cm2V-1s-1)의 변화를 알아보았다. Sputtering을 이용하여 증착한 GeTe 100 nm Thin Film 위에 Sputtering을 이용하여 SiO2 5 nm를 Capping Layer로 증착한 후, Post-Annealing을 200$^{\circ}C$, 300$^{\circ}C$, 400$^{\circ}C$, 500$^{\circ}C$로 온도를 변화 시키며 진행하였고, 이로 인하여 GeTe Thin Film에 외부의 영향을 최소화 하였다. 먼저 GeTe Thin Film의 Sheet Resistance를 측정한 결과는 300$^{\circ}C$ 까지 낮은 Sheet Resistance의 거동을 보이며 반면, 400$^{\circ}C$ 이상이 되면 높은 Sheet Resistance의 거동을 보인다. Hall Measurement를 통해, Carrier Concentration과 Mobility를 알아보았다. Carrier Concentration은 온도가 증가하면 1E+19에서 1E+21 까지 증가하며, Mobility는 감소하는 경향을 보인다. 500$^{\circ}C$ Post-Annealed GeTe Thin Film에서는 Resistivity가 상당히 높아 4 Point Probe (Range : 1 mohm/sq~2 Mohm/sq)로 측정이 불가능하다. XRD로 GeTe Thin Film을 분석한 결과 as-grown, 200$^{\circ}C$, 300$^{\circ}C$에서는 Cubic의 결정 구조를 보이며, Sheet Resistance가 급격히 증가한 400$^{\circ}C$, 500$^{\circ}C$에서는 Rhombohedral의 결정구조를 보인다. GeTe Thin Film은 400$^{\circ}C$ 이상의 Post-Annealing 온도에서 cubic 구조에서 Rhombohedral 구조로 상 변화가 일어난다. 위 결과를 통해, 결정 구조의 변화가 GeTe Thin Film의 저항, Carrier Concentration과 Mobility에 밀접한 영향이 미치는 것을 확인하였다.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.7 no.3
• /
• pp.366-376
• /
• 1997

$CdGa_2Se_4$, epilayer of tetragonal type are grown on Si(100) substrate by hot wall epitaxy method. The source and substrate temperature is $580^{\circ}C$ and $420^{\circ}C$ respectively, and the thickness of the film is 3 $\mu \textrm{m}$. The crystallihe structure of epilayers were investigated by double crystal X-ray diffraction(DCXD). Hall effect on this sample was measured by the method of van der Pauw and studied on carrier density and mobility depending on temperature. From Hall data, the mobility was likely to be decreased by pizoelectric scattering in the temperature range 30 K to 200 K and by polar optical scattering in the temperature range 200 K to 293 K. In order to explore of photocurrent to darkcurrent (pc/dc), maximum allowable power dissipation (MAPD), spectral response and response time. The results indicated that for the samples annealed in Se vapor the photoconductive characteristics are best. Then we obtained the sensitivity of 0.98, the value of pc/dc of $9.62{\times}10^6$, the MAPD of 321 ㎽ and the rise and decay time of 9 ㎳ and 9.5 ㎳, respectively.