• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.72-74
• /
• 2001

This paper deals with a dynamic analysis and a position control for air-core type linear synchronous motor with Halbach array (HA) permanent magnet mover. The primary coils are designed to be air-cored, so the HA-PMLSM don't exist the detent force. The secondary HA array of PMs does not require any ferro-magnetic yoke and excites stronger magnetic flux density and closer to the sinusoids than a conventional PM array.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.641-643
• /
• 2002

Synchronous generator needs slip-ring and brush for supplying current to rotor with external source. but slip-ring and brush have some problems to supply DC power to field winding with friction and high power loss due to brush voltage drop at high field current. Thus synchronous generator have been designed to brushless machine. Brushless synchronous machines of using permanent halbach array can composed without back core and coreloss. In this paper, analyse on the characteristics of external rotor type permenant magnet brushless with halbach array.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 추계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.86-88
• /
• 2006

This paper presents normal force analysis and its minimization of synchronous permanent magnet planar motor(SPMPM) with Halbach array. Firstly, the experimental error of thrust is investigated and it is caused by the friction force generated by normal force. Then normal force Is analyzed by Maxwell stress tensor. At last, the normal force is minimized by using genetic algorithm and it is decreased from 672.83[N] to 144.24[N] remarkably.

• 한국초전도ㆍ저온공학회논문지
• /
• 제14권3호
• /
• pp.60-64
• /
• 2012

In this paper, an investigation of a room temperature active magnetic regenerative refrigerator is carried out. Experimental apparatus includes two active magnetic regenerators containing 186 g of Gd spheres. Four E-type thermocouples are installed inside the Active magnetic regenerator(AMR) to observe the instantaneous temperature variation of AMR. Both warm and cold heat exchangers are designed for large temperature span. The cold heat exchanger, which separates the two AMRs, employs a copper tube with length of 80 mm and diameter of 6.35 mm. In order to minimize dead volume between the warm heat exchanger and AMRs, the warm heat exchangers are located close to the AMRs. The deionized water is used as a heat transfer fluid, and maximum 1.4 T magnetic field is supplied by Halbach array of permanent magnets. The AMR plate, which contains the warm and the cold heat exchangers and the AMRs, has reciprocating motion using a linear actuator and each AMR is alternatively magnetized and demagnetized by a Halbach array of permanent magnet. Since the gap of the Halbach array of permanent magnets is 25 mm and two warm heat exchangers have the motion through it, a compact printed circuit heat exchanger (PCHE) is used as a warm heat exchanger. A maximum no-load temperature span of 26.8 K and a maximum cooling power of 33 W are obtained from the fabricated Active Magnetic Regenerative Refrigerator (AMRR).

• Smart Structures and Systems
• /
• 제25권4호
• /
• pp.393-399
• /
• 2020

In this paper, the design method and experimental validation for the two-degree-of-freedom (2DOF) electromagnetic energy harvester are presented. The harvester consists of the rigid body suspended by four tension springs and electromagnetic transducers. Once the two resonant frequencies and the mass properties are specified, both the constant and the positions for the springs can be determined in the closed form. The designed harvester can locate two resonant peaks close to each other and forms the extended frequency bandwidth for power harvesting. Halbach magnet array is also introduced to enhance the output power. In the experiment, two resonant frequencies are measured at 34.9 and 37.6 Hz and the frequency bandwidth improves to 5 Hz at the voltage level of 207.9 mV. The normalized peak power of 4.587 mW/G² is obtained at the optimal load resistor of 367 Ω.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 춘계학술대회 논문집 전기기기 및 에너지변환시스템부문
• /
• pp.119-121
• /
• 2003

In the machine tool industry, direct drive linear motor technology is of increasing interest as a means to achieve high acceleration, and to increase reliability [1]. In this paper, we analyze and compare the characteristics of tubular motor with halbach and vertical magnet array respectively. We derive magnetic field solutions due to the PMs and to the currents. Motor thrust is then derived. The results are shown in good conformity with those obtained from the commonly used finite element method.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 B
• /
• pp.1076-1078
• /
• 2004

This paper deals with eddy-current magnetic repulsion system. The passive system employing permanent magnets on the moving part maximizes levitation forces by using Halbach array and conducting plate. We predict force characteristics according to permanent magnet array and conducting bar

• 전기학회논문지
• /
• 제64권12호
• /
• pp.1679-1685
• /
• 2015

This paper examines the effect of the magnetization pattern on the partial demagnetization of a permanent magnet (PM) machine that uses a ferrite magnet. Although the use of halbach-magnetized PM (HMPM) arrays in PM machines has been dramatically increasing because of their attractive features, the demagnetization characteristics of HMPM arrays have not yet been examined. In this study, two analyses of the demagnetization characteristics of HMPM arrays and parallel magnetized PMs (PMPMs) are performed, with the demagnetization characteristics being analyzed using a finite element method. According to our results, partial demagnetization occurred dramatically in the HMPM arrays. Thus, it is important to consider the vulnerability of HMPM arrays when designing PM machines.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 B
• /
• pp.1048-1050
• /
• 2003

Recently, many linear motion generators and motors are rapidly finding applications that ranges from short stroke linear motion vibrators, such as dynamic con type loud speakers to stilting engine driven linear reciprocating alternators, compressors, textile machines etc. In this paper, we analyze the characteristics of tubular linear motor with Halbach and radial magnet array respectively. We already derived magnetic field solutions due to the PMs and to the currents and Motor thrust. On the basis of analytical field solutions, this paper deals with flux linkages and back emf. The results are validated extensively by comparison with finite element analyses. Then, this parer also presents thrust characteristics according to design parameters for each model.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2008년도 제39회 하계학술대회
• /
• pp.856-857
• /
• 2008

Wave power generation as an environmentally -friendly energy has received the attention. In this paper, therefore, the tubular type Permanent Magnet Linear Synchronous Generator (PMLSG) is proposed for wave power generation. The characteristics of tubular type PMLSG are investigated by analysis using a Finite Element Analysis (FEA). Moreover, the operating performance of generator under no-load and load with variable resistance is examined. And Taguchi method is applied for considering tolerance in manufacture. The results of FEA show that proposed tubular type PMLSG is a useful solution for small-scale wave power generation.