• Journal of the Korea Concrete Institute
• /
• v.13 no.4
• /
• pp.336-345
• /
• 2001

The construction of underwater structures has been increased, but underwater concrete hassome problems of quality deterioration and contamination around in-situ of civil and architecture; therefore, new materials and methods for them are demanded. In this paper in-situ application of underwater antiwashout concrete which is manufactured for trio purpose of not only decreasing suspended solids and the heat of hydration but also increasing long term strength was studied. In the case of mock-up test(Ⅰ), when underwater antiwashout concrete, whose slump flow was 58 cm, was placed in the mock-up test at a speed of 24 ㎥/hr, it took about a minute to flow to the side wall, and the surface was maintained at horizontal level. In this case, compressive strength of the core specimens in each section was higher than the standard design compressive strength of 240 kgf/㎠. In the case of mock-up test(II), pH value and suspended solids of high strength underwater antiwashout concrete were 10.0∼11.0 and 51 mg/ℓ at 30 minutes later, initial and final setting time were about 30, 37 hr, and the slump flow of that was 53$\pm$2 cm. In the placement at a speed of 27 ㎥/hr, there was no large difference in flowing velocity, with or without reinforcement and flowing slope was maintained at horizontal level. In this case, compressive strength and elastic modulus of the core specimens somewhat decreased as flowing distance was far : however, those of central area showed the highest value.

• Magazine of the Korea Concrete Institute
• /
• v.8 no.6
• /
• pp.173-182
• /
• 1996

An experimental research was carried out to investigate the effect of thc compressive strength of concrete on the stirrup effectiveness in shear behavior of concrete beams. For this purpose. total 24 beams of section dimension of $300{\times}600mm$ were tested: 4 specimens without web reinforcement and 20 specimens with web reinforcement in the form of vertical stirrups. Main variables were two levels(norma1 and high strength) of the compressive strength of concrete and six types of t h e shear rcinfor.cement ratios. Prior to experiment, for given sections and assumed material constants, the reference shear reinforcement ratio(${\rho}_vACI$) which leads to the flexure failure using the provisions of the ACI Building Code(AC1 318-95) was calculated. and the shear reinforcement ratios were relatively selected from the value of ${\rho}_vACI$. From test results, it was shown that thc safety factor of ACI eyuation for p1,ediction of shear strength was decreased with increasing the compressive strength of concrete in beams without stirrups. However. it was observed that as the amount of' stirrup is increased, the safety factor for high strength conci,ete beams with high stirrup ratio is ensured more than that for normal strength concrete beams. Therefore i t appears that the stirrup effectiveness of high strength concrete beams is greater than that of normal strength concrete beams.

• Polymer(Korea)
• /
• v.29 no.5
• /
• pp.501-507
• /
• 2005

Small intestinal submucosa (SIS) had been widely used as a biomaterial without immune rejection responses. SIS sponges prepared by crosslinking with 1-ethyl-3-(3-dimethylaminopropyl) carbodiimide hydrochloride (EDC). SIS powders dissolved in $3\%(v/v)$ acetic acid aqueous solution for 48hrs and freeze-dried. EDC solution ($H_2O$ : ethanol = 5 : 95) as a crosslink agent was used in concentration of 100mM. In vitro, rat-BMSCs seeded in SIS sponges and induced the osteogenesis for 28 days. We have characterized the osteogenic potential of rat-BMSCs in SIS sponges by alkaline phosphatase activity(ALP), n assay, SEM and RT-PCR for osteogenic phenotype. In SEM, all morphology of SIS sponges was regular and showed interconnected pore structure. By RT-PCR analysis, we observed type I collagen expression. These results demonstrate osteogenic differentiation of rat-BMSCs. In conclusion, we confirmed that the morphology of surface, cross-section, and side of SIS sponges were highly porous with good interconnections between each pores, which can support the surface of cell growth, proliferation, and differentiation. This result indicates that SIS sponge is useful for osteogenesis of BMSCs.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.24 no.1
• /
• pp.35-42
• /
• 2020

Torsional behavior due to the plane irregularities of the piloti building can cause excessive story drift in the torsionally outermost column, which can lead to shear failure of the column. As a seismic retrofit method that can control the torsional behavior of the piloti building, the expansion of RC wall, steel frame or steel brace may be used, but such methods may hinder the openness of the piloti floor. Therefore, in this study, linear dynamic analysis and nonlinear static analysis for piloti buildings retrofitted by knee brace were performed, and seismic performance evaluation and torsion control effect of knee brace were analyzed. The results showed that the shear force of the column increased when the piloti building retrofitted by knee brace, but it was effective in controlling the torsional deformation. In case of retrofit between knee brace and column by 30°, the shear force of the column increased less than that of 60°, and the lateral displacement of column was decreased in the order of □, ◯ and Ｈ in cross-section.

• Solar Energy
• /
• v.15 no.2
• /
• pp.77-90
• /
• 1995

An effective heat transfer during freezing process was proposed in the vertical cylinder to improve the effectiveness of the heat storage. Vertical cylinder was filled with pure water in order to investigate ice-shape, temperature distribution of the liquid, temperature distribution of the cylinder tube wall, total heat storage per unit mass in the test section under the two experimental conditions; inlet temperature of working fluid is constant($-10^{\circ}C$) and inlet direction of working fluid is either upward flow or downward. Both the mean temperature of the liquid and temperature difference of cylinder tube wall in the upward were lower than those in the downward. In case that the initial temperature of water was $7^{\circ}C$ and $4^{\circ}C$, the shape of ice layer in the upward was more uniform than that in the downward. In case of $1^{\circ}C$, the shape of ice layer is formed by inlet direction of working fluid. Finally, time-varying total heat energy stored in the water in the upward was higher than that in the downward.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.7
• /
• pp.203-210
• /
• 2019

A recent earthquake on the Korean Peninsula caused much damage to masonry buildings, and research on performance evaluation has been underway. A masonry building is generally constructed using wet construction and is affected by temperature, which reduces the efficiency of the construction. In this study, we propose a dry construction technique for assembling concrete blocks without using mortar and evaluated its performance through experimental and analytical research. To evaluate the performance, experiments were carried out for the prismatic compressive strength, direct terminal strength, and diagonal tensile strength of the dry construction wall. The adequacy of the cross section shape was also reviewed through FEM analysis. The results show that the compressive strength and diagonal tensile strength could exert a certain intensity or higher. Furthermore, the H-type module of a key block acted as a shear key for the entire concrete block, which resulted in excellent shear strength performance. In addition, the shape and thickness of the main block have a major effect on the strength performance of each block. Therefore, an optimal shape and the proposed dry construction method could be applied to replace the wet method by studying the construction or seismic performance of the proposed method.

• Food Engineering Progress
• /
• v.21 no.1
• /
• pp.72-78
• /
• 2017

The objective of this study was to investigate the effects of combinations of tofu paste and non-starch polysaccharides (NSP) on the oil uptake reduction (OTR) of deep-fat fried cake doughnuts. OTR agents were tofu paste (from grinding tofu with deionized water, followed by passage through a 60 mesh sieve), and five neutral and nine anionic NSPs. A control doughnut (without tofu paste or NSP), tofu doughnut (with tofu paste) and NSP-tofu doughnut (with tofu paste and NSP) were prepared. The moisture and total lipid (TL) content, cross-section image, color characteristic, and specific volume were measured. The tofu and NSP-tofu doughnuts exhibited higher moisture and lower TL content than the control. OTR was 10.8% for the tofu doughnut, and between 13.2% and 41.2% for the NSP-tofu doughnut. The highest OTR (41.2%) was found in the NSP-tofu doughnut with a combination of tofu paste and sodium alginate (NaA). The specific volume of the NSP-tofu doughnuts with combinations of tofu paste with NaA (2.5 mL/g), locust bean gum (2.5 mL/g), and ${\kappa}$-carrageenan (2.4 mL/g) was very close to that of the control (2.6 mL/g). Considering the OTR and specific volume of doughnuts, the combination of tofu paste and NaA would be most effective in reducing the oil uptake of doughnuts during deep-fat frying.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.22 no.5
• /
• pp.29-35
• /
• 2022

This paper proposes a fuel cell education framework installed on a Metaverse environment, which is to reduce the burden of education costs and improve the effect of education or learning. This Meta-Fuel cell platform utilizes the Unity 3D Web and enables not only theoretical education but also hands-on training. The platform was designed and developed to accommodate a variety of unit education contents, such as ppt documents, videos, etc. The platform, therdore, integrates ppt and video demonstrations for theoretical education, as well as software content "STACK-Up" for hands-on training. Theoretical education section provides specialized liberal arts knowledge on hydrogen, including renewable energy, hydrogen economy, and fuel cells. The software "STACK-Up" provides a hands-on practice on assembling the stack parts. Stack is the very core component of fuel cells. The Meta-Fuelcell platform improves the limitations of face-to-face education. It provides educators with the opportunities of non-face-to-face education without restrictions such as educational place, time, and occupancy. On the other hand, learners can choose educational themes, order, etc. It provides educators and learners with interesting experiences to be active in the metaverse space. This platform is being applied experimentally to a education project which is to develop advanced manpower in the fuel cell industry. Its improvement is in progress.

• Journal of Ecology and Environment
• /
• v.46 no.2
• /
• pp.136-143
• /
• 2022

Background: In northern Thailand, the longan flower is the principal nectar source for honey production. Microorganisms play a critical function in the agricultural ecology. The morphological characteristics of fungal species found in longan pollen were studied. Aspergillus spp. were found to be invertase-producing strains and were employed in the longan syrup production process. The purpose of this study was to evaluate the effects of invertase-added longan syrup on the adult honey bee population numbers that were fed by this syrup for 16 weeks. Results: Different fungal species were found in longan pollen samples. Aspergillus was the main genus, with three predominant sections: Nigri, Flavi, and Terrei. Other isolated species were Trichoderma spp., Rhizopus spp., Neurospora spp., Chaetomium spp., Fusarium spp. and Penicillium spp. However, Aspergillus spp. is the only fungal species that produces the enzyme invertase. The invertase-producing strains belonging to the Aspergillus section Nigri were found to be A. niger LP5 with an optimum activity at pH 6.0 and 60℃. When A. niger LP5 invertase was used for longan syrup processing, the highest levels of glucose (3.45%) and fructose (2.08%) were found in invertase added longan syrup (C), while fresh (A) and boiled longan syrup (B) had lower contents of both sugars. The sucrose content was detected in (A) at 4.25%, while (B) and (C) were at 4.02% and 3.08%, respectively. An appropriate amount of sugar to feed and maintain the honey bee population was considered. The data showed no statistically significant differences between the two selected forms of longan syrup compared to the sugar syrup examined by the adult honey bee population. Conclusions: The main species of isolated fungi from longan pollen were Aspergillus spp. The discovery of an invertase-producing strain of A. niger LP5 has enabled its application for enzyme utilization in the invert sugar preparation process. The adult worker bee populations fed by longan syrup from both boiled and invertase-added sources showed an increasing trend. Artificial syrup made from longan fruit to feed honey bees when natural food sources are limited can be applied.

• Clinical and Experimental Pediatrics
• /
• v.52 no.4
• /
• pp.429-434
• /
• 2009

Purpose : Severe aspiration of the amniotic fluid is known to cause fatal respiratory distress in neonates. We conducted this study to investigate the clinical findings of severe amniotic fluid aspiration pneumonia (AFAP) in neonates and the effect of pulmonary surfactant replacement therapy (SRT). Methods : Retrospective analysis of medical records was conducted on 28 patients who received ventilator care due to severe AFAP in a neonatal intensive care unit over a 7-year period (2000-2006). Patients whose amniotic fluid was contaminated with meconium were excluded. Results : A large number of cases were term infants (82.1%) and infants born by caesarean section (85.7%), and the 1- and 5-min Apgar scores of these patients were $6.5{\pm}1.2$ and $7.5{\pm}1.3$, respectively. Soon after birth, the amount of amniotic fluid sucked out from airway below the vocal cord was $16.0{\pm}10.1$ mL. All patients received SRT with a modified bovine-derived surfactant (120 mg/kg/dose), and one dose was administered in most cases (75%). Compared with pre-SRT, the oxygenation index ($8.0{\pm}9.6$ vs. $18.9{\pm}7.3$) according to ventilator care was a significant improvement at 12 h after SRT (P<0.001). Furthermore, most cases showed radiological improvement for aeration at 12 h post-treatment. Many cases (46.4%) had cardiorespiratory complications, but their final outcomes were excellent (survival rate, 96.4%). Conclusion : AFAP may be an important cause of serious respiratory distress in near-term and term infants, and SRT seems to be an effective adjuvant therapy in mechanically ventilated neonates with severe AFAP.