• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.5
• /
• pp.651-658
• /
• 2011

Nitrate is a common contaminant in industrial wastewater and ground water. The maximum contaminant level set by EPA for nitrate of 10 mg/L as N. In this study, nitrate was removed using bipolar ZVI packed bed electrolytic cell that maximized the contact area between each electrode and contaminants under 600 V. Also this study investigates the simultaneously deals with removal of ammonia by operating air stripping tower. In addition to the air stripping also helped to precipitate iron ions to the form of iron oxides. Bipolar ZVI packed bed electrolytic cell was also effective in removing coliform by electrical power. In the continuous experiments for the simulated wastewater (initial nitrate for 25 mg/L as N), maximum 96.3% removal of nitrate was achieved in the applied 600 V at the flow rate of 6 mL/min.

• Journal of Korean Society of Forest Science
• /
• v.20 no.1
• /
• pp.51-60
• /
• 1973

The trend and achievments of soil erosion control research in Japan were investigated through observation tours and reference work and following facts were found to be important aspects which should be considered in the soil erosion control research program in Korea. Experiments on forest and water relations, and ground water phenomena at the water source zone in Tokyo University. Studies on land-slides and erosion control dam in Kyoto University. Studies on mud-flow and snow avalanches in Hokkaido University. Studies on sanddune fixation and disaster damage prevention forests in Kyushu University. Studies on forest denudations in Nagoya University. Studies on Greening-works and soil erosion prevention chemicals in Tokyo Agriculture University. Training on planning of erosion control works and prevention of disaster damages in Forest Research Institute. Experiments on soil erosion phenomena and infiltration in Tohoku Branch, FRI. Experiments on erosion and surface stratum failure of steep slopes and their prevention methods in Railway Technical Research Institute.

• Computers and Concrete
• /
• v.18 no.2
• /
• pp.179-199
• /
• 2016

The aim of this study is to investigate arrival direction effects of travelling waves on non-linear seismic response of arch dams. It is evident that the seismic waves may reach on the dam site from any direction. Therefore, this study considers the seismic waves arrive to the dam site with different angles, ${\theta}=0^{\circ}$, $15^{\circ}$, $30^{\circ}$, $45^{\circ}$, $60^{\circ}$, $75^{\circ}$, and $90^{\circ}$ for non-linear analysis of arch dam-water-foundation interaction system. The N-S, E-W and vertical component of the Erzincan earthquake, on March 13, 1992, is used as the ground motion. Dam-water-foundation interaction is defined by Lagrangian approach in which a step-by-step integration technique is employed. The stress-strain behavior of the dam concrete is idealized using three-dimensional Drucker-Prager model based on associated flow rule assumption. The program NONSAP is employed in response calculations. The time-history of crest displacements and stresses of the dam are presented. The results obtained from non-linear analyses are compared with that of linear analyses.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.3
• /
• pp.246-252
• /
• 2014

This study is on the development of 150PS inboard type of compact water jet propulsion system. The water jet is composed of intake, impeller, diffuser, reverse bucket and main shaft. Components of water jet have been manufactured through precision processing after sand casting. Development of water jet propelled engine has been finally completed by processes which are design, production and inspection on each component. The water jet performance characteristics show that 0.29 m3/s of maximum flow rate and 37 m/s of flow velocity have been secured in the ground test pool. Field test was performed by 21ft test ship that water jet propulsion equipment developed in this study was installed. As a result, the weight of hull, engine and other parts of the ship has been almost 1.2 ton and 45 km/h of maximum sailing speed has been recorded with 3700 rpm of engine in the domestic coast test.

• Water for future
• /
• v.9 no.1
• /
• pp.55-69
• /
• 1976

The purpose of this paper is to provide basic data for construction methods of leakage pretaction for estuary barrien which is constructed to in take restoration water from irigative use and a river flow in its ultimate dsicharge to ward to sea, The water, accordingly, has reviewed the discrepancis between theories and experiments based on the hydraulic analysis of ground water through a series of sourveys on equi-patential line of seepage flow and a series of some experiments. apparently, however, the research results herein might reflect in some part not more than inference since those experiments are not conducted in a real foundation but from an indoor experiment or calculation, conclusion in brief are itemized here-under. 1. small-scale barrier require cut-off wall, which should reach the complete impereable layer, 2. Duplication barrier is provided effective in protection saline water seepage. 3. a barrier with broad crest might enable protection of massive seepage by fresh water lens formed from precipitation.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.3 no.3
• /
• pp.53-61
• /
• 1999

Impinging jets are observed when exhaust gases from missiles or V/STOL aircrafts impinge on the ground, flame deflector, ship deck, etc. The flow shows different patterns according to the nozzle geometry, nozzle-to-plate distance, and plate angle, for example. This paper describes experimental works on the phenomena (pressure distribution, occurrence of stagnation bubble, and so on.) when underexpanded supersonic jets impinge on a perpendicular flat plate using a supersonic cold-flow system, and compares the results with those obtained using a shock tunnel. The flow characteristics for the supersonic cold-flow system were also investigated. Surface pressure distribution of supersonic cold-flow system differed from that of shock tunnel because of water and temperature in the low-pressure chamber. Surface pressure distribution as to underexpanded ratio showed similar patterns together.

• Journal of Korea Water Resources Association
• /
• v.38 no.8 s.157
• /
• pp.631-643
• /
• 2005

The objective of this study is to perform hydraulic and numerical model experiments of the flows in circulation-water-pump(CWP) chambers of combined cycle power plants (CCPP) to be built and to suggest improvement plans if the flows might cause a serious problem on the operation of CWPs. Hydraulic model was constructed in a scale of 1 to 20 using acrylic sheets and a two dimensional numerical model used was RMA2. To evaluate results of Hydraulic and numerical model experiments, evaluation criteria of flow conditions in the intake canal and CWP chambers were determined. Vertical vorticities obtained from numerical simulations for the initial plan of CCPPs were qualitatively compared with results of hydraulic model experiments and the formation possibility of a large scale vortex, one of the flow evaluation criteria, was evaluated. The initial plan was found not to satisfy the flow evaluation. Nine improvement plans were devised and numerically simulated. Four alternative plans among nine improvement plans were selected and hydraulically experimented. On the ground of the results of hydraulic model experiments, a final improvement plan, one of four improvement plants, was suggested. When CWP chambers and intake canals were designed with spatial constraints, flow separating wall and guide walls were found to improve flow conditions in CWP chambers.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2002.09a
• /
• pp.163-178
• /
• 2002

Investigation of underwater sedimentary layers has been carried out with GPR (Ground Penetration Radar) survey. GPR survey has been proved to be very satisfactory since the target area has shallow water depth of about 2.5 m, is lake with no water flow, and the thickness of mud layer, which is a main survey target, is relatively thin. The results clearly showed the underwater sedimentary layers, which includes mud, sand, gravel and basement layer. Specially, the distribution and total amount of mud layers from the survey, which is main target of removal, can be used as a basic data for the dredging of mud layer in the area.

• Geomechanics and Engineering
• /
• v.17 no.2
• /
• pp.133-143
• /
• 2019

An optimal hydraulic section is critical for irrigated water conservancy in seasonal frozen ground due to a large proportion of water leakage, as investigated by in-situ surveys. This is highly correlated with the frost heave of underlain soils in cold season. This paper firstly derived a practical model for frost heave of clayey soils, with temperature dependent thermal indexes incorporating phase change effect. A model test carried out on clay was used to verify the rationality of the model. A novel approach for optimizing the cross-section of irrigation canals in cold regions was suggested with live updated geometry characterized by three unique geometric constraints including slope of canal, ratio of practical flow section to the optimal and lining thickness. Allowable frost heave deformation and tensile stress in canal lining are utilized as standard in computation iterating with geometry updating while the construction cost per unit length is regarded as the eventual target in optimization. A typical section along the Jinghui irrigation canal was selected to be optimized with the above requirements satisfied. Results prove that the optimized hydraulic section exhibits smaller frost heave deformation, lower tensile stress and lower construction cost.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2023.05a
• /
• pp.343-343
• /
• 2023

식생피복(Vegetation cover)은 대기 중의 강우와 토양 사이에서 침식으로부터 표토를 보호하는 역할을 한다. 자유 낙하하는 강우의 물방울은 식생을 통과하면서 차단(interception), 수관통과(throughfall), 수간유하(stemflow)의 형태로 변화한다. 식생은 강우입자의 운동에너지와 수량을 감소시키고, 지표면에 도달하는 시간을 지연시킴에 따라 지표유출(overland flow) 저감에 기여한다. 유출수의 흐름과정에서 식물의 줄기, 낙엽, 뿌리 등은 유속을 감소시키는 장애물로 작용하여 궁극적으로 토양침식은 감소한다. 토양침식은 식생피복이 증가함에 따라 일반적으로 감소하며, 지수함수의 관계를 갖는다. 식생의 종류와 구조 그리고 잎의 모양 등에 따라 수문물리적인 반응이 달라진다. 캐노피를 갖는 지상식물(canopy cover plant)은 물방울의 운동에너지를 갖는 반면, 지피식물(ground cover plant)은 낙하고가 작기 때문에 운동에너지는 적으며, 특히 낙엽층은 지표면을 보호하여 토양침식의 저감효과가 더욱 크다. 산불지역의 식생피복에 따른 토양침식 측정 자료에 따르면, 강우운동에너지는 식생피복이 증가함에 따라 지상피복(canopy cover)에 의한 감소보다는 지면피복(ground cover)과 낙엽피복(litter cover)에 의한 감소효과가 상대적으로 컸다. 식생피복에 의해 차단되는 강우의 손실량보다 침투량 증가에 의한 손실량이 상대적으로 많았다. 낙엽피복에 대한 강우모의 실험 결과에 따르면, 낙엽의 피복율이 증가함에 따라 지수적으로 토양침식량은 감소하였다. 낙엽 피복율의 40% 이상은 토양침식량을 현격이 감소시킨 반면, 피복율의 70% 이상은 지표유출량을 현저히 감소시켰다. 낙엽 피복율이 70%이상이면, 유출계수가 33%가 감소하였으나, 토양침식민감도는 94%로 크게 감소하였다.