• Journal of information and communication convergence engineering
• /
• 제6권4호
• /
• pp.417-420
• /
• 2008

Solar electric systems have very little impact on environment, making them one of the cleanest power-generating technologies available. While they are operating, PV systems produce no air pollution, hazardous waste, or noise, and they require no transportable fuels. In PV system design, the selection and proper installation of appropriately-sized components directly affect system reliability, lifetime, and initial cost. In this research, we have studied the PWM(Pulse Width Modulation) signals. I proposed an efficient photovoltaic power interface circuit incorporated with a DC-DC converter and a sine-pwm control method full-bridge inverter. In grid-connected solar power systems, the DC-DC converter operates at high switching frequency to make the output current a sine wave, whereas the full-bridge inverter operates at low switching frequency which is determined by the ac frequency. Thus, it can reduce the switching losses incurred by the full-bridge inverter. Full-bridge converter is controlled by using microprocessor control method, and its operation is verified through computer aided simulations.

• 한국산학기술학회논문지
• /
• 제16권1호
• /
• pp.646-651
• /
• 2015

본 논문에서는 일반적인 건물자동제어 시스템의 아키텍처를 네트워크 구성과 관제점, 상호운영성, 성능 측면에서 분석하고, 점대점 고속 유선 방식으로 연결된 가상화 기반의 새로운 건물자동제어 시스템을 제시하였다. 클라우드 컴퓨팅 기반의 건물자동제어 시스템은 사용자 기반의 환경제어를 가능하게 하며 건물자동제어 시스템의 성능 향상을 통하여 건물에너지관리를 효율적으로 수행할 수 있다. 또한, 가상화 방식은 부하관리사업자의 건물 군관리를 효율적으로 수행할 수 있도록 한다.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 춘계학술대회
• /
• pp.184-187
• /
• 2007

본 논문은 DSP Controller를 적용한 연료전지시스템의 유량제어에 관한 논문이다. 그리고 이 연구에서 사용된 시스템은 1kW급 계통연계 연료전지 시스템이다. 이 연료전지 시스템이 안정적으로 전원을 공급할 수 있도록 시스템에서 요구하는 공기 유량을 정확히 공급하도록 제어하는 것이 본 연구의 목적이다. 이 목적을 이루기 위해 공기 공급 장치에 PID 제어기를 설계하여 적용하였다. PID 제어기의 Gain값은 지글러 니콜스 Tuning 방식으로 정하였다. 이 제어기를 적용하여 실험한 결과, 적용 전 상태와 비교하면 맥동이 30% 저감하였고, 정상상태 오차가 제거되어 온도 변화와 같은 외란과 상관없이 정확한 요구 공기 유량을 공급함을 확인할 수 있었다. 그리고 부하가 변동함에 따라 해당 요구 공기 유량이 바뀔 때 1초 내에 그 요구 공기 유량을 추종하여 스택이 안정적으로 운전될 수 있도록 하였다.

• 전력전자학회논문지
• /
• 제17권3호
• /
• pp.205-212
• /
• 2012

This paper proposes the fuzzy logic based variable step-size MPPT (Maximum Power Point Tracking) method for the stability at the steady state and the improvement of the transient response in the wind power system. If the change value of duty ratio is set on stability of the steady state, MPPT control traces to maximum power point slowly. And if the change value is set on improvement of the transient response, the system output oscillates at the maximum power point. By adjusting the step size with fuzzy logic, it can be improved the MPPT response speed and stability at steady state when MPPT control is performed to track the maximum power point. The effectiveness of the proposed method has been verified by simulations and experimental results.

• Journal of Electrical Engineering and Technology
• /
• 제3권4호
• /
• pp.491-498
• /
• 2008

In this paper a decoupled control of a doubly-fed induction machine(DFIM) feed by a matrix converter is presented. It provides a robust regulation of the stator side active and reactive powers by the direct and quadratic components of the stator current vector, presented in a line-voltage-oriented reference frame. In this case, the stator windings are directly connected to the line grid, while the rotor windings are supplied by this later through a matrix converter controlled by a space vector modulation technique. The proposed solution is suitable for both energy generation and electrical drive applications with restricted speed variation range.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 A
• /
• pp.111-114
• /
• 1999

This paper deals with the rated output power using grid-connected Doubly-Fed Induction Generator(DFIG) in the supersynchronous speed regions. The rated output power is controlled by both magnitude and frequency of the voltage fed to the rotor. And this rotor voltage is controlled by control of inverter switching frequency and fire angle. A DFIG generating characteristic is analyzed by simulation of steady-state algebraic equation of equivalent circuit using numerical analysis. And it is compared with results of experiment. Consequently, This paper presented to control method for rated output power of DFIG in variable wind speed.

• Journal of Power Electronics
• /
• 제8권2호
• /
• pp.156-162
• /
• 2008

This paper proposes a low-cost power converter for micro wind turbine systems using permanent magnet synchronous generators (PMSG). The proposed converter consists of a two-leg three-phase PWM inverter for the generator control and a single-phase half-bridge PWM converter which is connected to the utility grid. For the two separate DC-link voltages, a balancing control is added and the adverse effect of the DC-link voltage ripples on the inverter output voltage is compensated. The control performance of the proposed converter topology for the micro wind turbine system is shown by the simulation results using PSIM software.

• Journal of Power Electronics
• /
• 제17권4호
• /
• pp.1071-1087
• /
• 2017

This paper introduces a DC/AC converter, which can be connected in parallel with a diode rectifier for regenerative applications. The DC/AC converter is supposed to transmit regenerative energy to the power grid when a motor is braking. Isolation transformers are not needed in the topology, which can reduce the size and cost. An analysis of the zero-order current existing in the system is carried out. In addition, algorithms to minimize the zero-order current, control the power factor and keep the DC bus voltage stable are discussed. A 55kW industrial prototype is built to verify the proposed analysis and control strategies.

• 정보보호학회논문지
• /
• 제21권4호
• /
• pp.125-136
• /
• 2011

우리나라의 전력분야 제어시스템은 보안에 우수한 폐쇄형 네트워크로 운영되고 있어 보안피해의 심각성을 대체로 인지하지 못하고 있다. 앞으로 스마트그리드 사업이 지속적으로 확대되면 스마트미터에서부터 발전소에 이르기까지 다양한 형태의 사이버공격이 이루어질 수 있다. 향후 스마트미터를 통해 발전소에서 가정집까지의 전체 전력망이 연결되면 보안은 더욱 중요한 요소가 될 것이다. 본 연구에서는 스마트그리드 환경 즉, 외부의 혹독한 환경과 전국적인망에서의 안정적 데이터 전송과 외부로부터의 침입방지를 위해 필요한 가상사설망(VPN) Gateway 구조를 설계 및 구현하였다. 본 연구를 통해 완성된 시제품으로 기 운영 중인 상용제품과 다양한 방식으로 연동 테스트를 시행하였으며, IPSec 방식의 터널링과 ARIA 암호화 알고리즘을 통한 암호화를 통해 전력선통신(PLC) 저압원격검침 분야에 시범 설치되어 보안이 강화된 데이터통신을 하고 있다.

• 한국산업융합학회 논문집
• /
• 제25권3호
• /
• pp.423-431
• /
• 2022

The UPS(Uninterruptible Power Supply) system operates in the battery charging mode when the grid is normal, and in the UPS mode, which is the battery discharge mode when a grid error occurs. Since the UPS must supply the same voltage as the grid to the load within 4 [ms] in case of a grid error, the switching time and power recovery time should be short when controlling the output voltage and current of the UPS, and the power failure detection time is also important. The power outage detection algorithm using DFT(Discrete Fourier Transform) proposed in this paper compares the grid voltage waveform with the voltage waveform including the 9th harmonic generated through DFT using Schmitt trigger to detect power outage faster than the existing power outage monitoring algorithm. There are advantages. Therefore, it is possible to supply instant and stable power when switching modes in the UPS system. The multi-power-applied UPS system proposed in this paper uses DFT, which is faster than the conventional blackout monitoring algorithm in detecting power failure, to provide stable power to the load in a shorter time than the existing power outage monitoring algorithm when a system error occurs. The detection method was applied. The changeover time of mode switching was set to less than 4 [ms], which is 1/4 of the system cycle, in accordance with KSC 4310 regulation, which was established by the Industrial Standards Council on the regulation of uninterruptible power supply. A 10 [kW] UPS system in which commercial voltage, vehicle generator, and auxiliary diesel generator can be connected to each of the proposed transfer devices was constructed and the feasibility was verified by conducting an experiment.