• Journal of The Korean Society of Agricultural Engineers
• /
• v.57 no.4
• /
• pp.51-59
• /
• 2015

Various Best Management Practices (BMPs) have been suggested to reduce soil erosion and non point source (NPS) pollutant loads from agricultural fields. However, very little research regarding water quality improvement with No-till (NT) has been performed in Korea. Thus, effects of NT were investigated in this study. The objective of the study was to investigate the effect of NT on the surface runoff and sediment discharge in a field. Eight experimental plots of $5{\times}30m$ in size and 3 % or 8 % in slope prepared on gravelly sandy loam soil were treated with Conventional-till (CT) and NT. Runoff and NPS pollution discharge were monitored and compared the treatments. The amounts of rainfall from 13 monitored events ranged from 28.7 mm to 503.5 mm. The runoff amount was reduced by 17.6~59.2 % in 3 % NT and 29.6~53.2 % in 8 % NT. The average NPS pollution loads of the 3 % NT plots and 8 % NT plot were reduced about 45.1~89.2 % and 47.7~98.0 % compared to those of the CT plots, respectively. This research revealed that NT can reduce the NPS pollution loads substantially as well as increase the crop yield. Runoff and NPS pollution loads reduction by NT method could be contribute to improve the water quality of streams in agricultural regions.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.4
• /
• pp.199-206
• /
• 2002

The bearing capacity of open-ended piles is affected by the degree of soil plugging, which is quantified by the incremental filling ratio, IFR. However, most design criteria for open-ended piles do not consider the variation of pile bearing capacity with IFR. In this study, new design equations for calculating the pile base and shaft load capacities, based on IFR value of the pile, were proposed using the results of model pile tests. A full-scale pile load test was also conducted on fully instrumented open-ended pile driven into gravelly sand. The IFR for the pile was continuously measured during pile driving. In order to check the accuracy of predictions made with the proposed equations, the equations were applied to two examples, including the pile load test preformed in this study. Based on the comparisons with the pile load tests results, the proposed equations appear to produce satisfactory predictions.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.8 no.1
• /
• pp.141-150
• /
• 1988

Damping characteristics of chemically treated solls were studied by the use of FFT Analyzer and Bandwidth method. Also Modal Analysis was performed for the solidified silty sand samples. The soil samples were made of gravelly sand, sand, and silty sand, treated by water-glass chemical grouts. As the result of the study, it was found that the chemical grouting could be used for the vibration diminutinn effect as well as cut-off effect and strength improvement by the fact that the damping ratio of chemically treated soils was highly increased as the damping ratio of solidified soil was 0.11~0.22 and rathier high values in compare with the damping ratio of common soils which was 0.01~0.10.

• Journal of Korean Society on Water Environment
• /
• v.28 no.3
• /
• pp.436-443
• /
• 2012

This research was focused on the effect of rice straw and rice straw mat on the reduction of upland field non-point source (NPS) pollution discharges. Six experimental plots of $5{\times}22m$ in size and 3% in slope prepared on gravelly sandy loam soil were treated with control, rice straw cover and rice straw mat cover. Radish in Spring growing seasons were cultivated. NPS pollution discharge was monitored and compared with respect to the treatments. The surface cover rate of rice straw and rice straw mat right after the treatments was 64.7% and 73.7%, respectively. Rainfall of the 16 monitored events ranged from 12.8 mm to 538.2 mm. Runoff coefficient of the events was 0.01~0.67 in control plot, 0~0.63 in rice straw plot and 0~0.45 in rice straw mat plot. The reduction of runoff compared to the control plot was 5.4~99.7% in rice straw plot and 32.9~100% in rice straw mat plot. The reduction of NPS pollution load was 52.0% for SS, 28.5% for T-N and 35.2% for T-P in rice straw plot and 79.8% for SS, 68.3% for T-N and 53.3% for T-P in rice straw mat plot. This research revealed that rice straw mat cover on the soil surface could not only increase the crop yield and farmer's income but also reduce the NPS pollution loads significantly.

• Journal of Korean Society of Forest Science
• /
• v.89 no.2
• /
• pp.275-284
• /
• 2000

This study was carried out to analyze the mechanical properties of soil and the slope stability on the fill slope of forest road constructed in the regions which consist of igneous and metamorphic rock area. The results were summarized as follows. 1) Soil type by Unified Soil Classification System(USCS) was classified as SW in soil slope, GP in weathered rock slope, GP in soft rock slope for both types of parent rock, but gravelly soil slopes in igneous and metamorphic rock area were classified as SP and GW, respectively. 2) Dry unit weight was $1.34g/cm^2{\sim}1.59g/cm^2$, specific gravity 0.57~0.61, and void ratio 0.66~0.93 in the case of igneous rock area, a dry unit weight was $1.35g/cm^2{\sim}1.51g/cm^2$, specific gravity 2.67~2.77, and void ratio 0.78~1.01 in the case of metamorphic rock area. 3) The strength parameters such as internal friction angle(${\phi}$) and cohesion(c) were selected and tested for slope stability analysis. ${\phi}$ and c of soil in igneous rock area were within the range of $29.51^{\circ}{\sim}41.82^{\circ}$ and $0.03kg/cm^2{\sim}0.38kg/cm^2$, respectively, and $21.43^{\circ}{\sim}41.43^{\circ}$ and $0.05kg/cm^2{\sim}0.44kg/cm^2$ in metamorphic rock area, respectively. 4) Result of the slope stability analysis of forest road showed that, in the weathered rock slope of igneous rock and the weathered rock and soil slope of metamorphic rock area, the possibility of slope failure was high as safety factor was below 1.0.

• Korean Journal of Soil Science and Fertilizer
• /
• v.42 no.5
• /
• pp.330-335
• /
• 2009

This study was conducted to reclassify Jangho series based on the second edition of Soil Taxonomy : A Basic System of Soil Classification for Making and Interpreting Soil Surveys. Morphological properties of typifying pedon of Jangho series were investigated and physico-chemical properties were analyzed according to Soil Survey Laboratory Methods Manual. The typifying pedon of Jangho series has very dark grayish brown (10YR 3/2) gravelly silt loam A horizon (0~14 cm), very dark brown (7.5YR 3/2) silty clay BAt horizon (14~31 cm), dark brown (7.5YR 3/4) silty clay Bt1 horizon (31~58 cm), brown (7.5YR 4/4) silty clay Bt2 horizon (58~90 cm), and brown (7.5YR 4/4) clay Bt3 (90~120 cm) horizon. That is developed on river terraces. The typifying pedon has an argillic horizon from a depth of 14 to more than 120 cm and a base saturation (sum of cations) of less than 35% at 125 cm below the upper boundary of the argillic horizon. That can be classified as Ultisol. The typifying pedon has 0.9 % or more organic carbon in the upper 15 cm of the argillic horizon, and can be classified as Humult, which is reported for the first time in Korea. That does not have fragipan, kandic horizon, sombric horizon, plinthite, etc. in the given depths, and keys out as Haplohumult. Also that meets the requirements of Typic Haplohumult. That has 35 % or more clay at the particle-size control section, and has mesic soil temperature regime. Jangho series can be classified as fine, mixed, mesic family of Typic Haplohumults, not as fine silty over clayey, mixed, mesic family of Mollic Hapludalfs.

• Journal of Soil and Groundwater Environment
• /
• v.22 no.3
• /
• pp.27-41
• /
• 2017

This study dealt with the characteristics and the interrelations of hydrogeological parameters such as hydraulic conductivity, dispersivity and effective porosity of unconsolidated sediments for providing the basic data necessary for the planning of the management and preservation of groundwater quality in the Nakdong River Delta of Busan City, Korea. Groundwater quality in this area has been deteriorated due to seawater intrusion, agricultural fertilizer and pesticide, industrial wastewater, and contaminated river water. The physical properties (grain size distribution, sediment type, sorting) and aquifer parameters (hydraulic conductivity, effective porosity, longitudinal dispersivity) were determined from grain size analysis, laboratory permeability test and column tracer test. Among 36 samples, there were 18 Sand (S), 7 Gravelly Sand (gS), 5 Silty Sand (zS), 5 Muddy Sand (mS), and 1 Sandy Silt (sZ). Hydraulic conductivity was determined through a falling head test, and ranged from $9.2{\times}10^{-5}$ to $2.9{\times}10^{-2}cm/sec$ (0.08 to 25.6 m/day). From breakthrough curves, dispersivity was calculated to be 0.35~3.92 cm. Also, effective porosity and average linear velocity were obtained through the column tracer test, and their values were 0.04~0.46 and 1.06E-04~6.49E-02 cm/sec, respectively. Statistical methods were used to understand the interrelations among aquifer parameters of hydraulic conductivity, effective porosity and dispersivity. The relation between dispersivity and hydraulic conductivity or effective porosity considered the sample length, because dispersivity was affected by experimental scale. The relations between dispersivity and hydraulic conductivity or effective porosity were all in inverse proportion for all long and short samples. The reason was because dispersivity was in inverse proportion to the groundwater velocity in case of steady hydrodynamic dispersion coefficient, and groundwater velocity was in proportion to the hydraulic conductivity or effective porosity. This study also elucidated that longitudinal dispersivity was dependent on the scale of column tracer test, and all hydrogeological parameters were low to high values due to the sand quantity of sediments. It is expected that the hydrogeological parameter data of sediments will be very useful for the planning of groundwater management and preservation in the Nakdong River Delta of Busan City, Korea.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.55 no.4
• /
• pp.350-356
• /
• 2010

This experiment was conducted to select optimum minor cereal crop and variety for the marginal agricultural lands so that they would be used to increase the agricultural land use rate in mountainous areas. This experiment used three different marginal agricultural lands, that is, slope land, barren land and gravelly land. Soil pH of control field was 7.85, slightly alkali, whereas gravelly land showed strong acid(pH 5.1). EC of marginal agricultural lands was generally lower compared to the control, especially barren land showed 0.05dS $m^{-1}$ which was the lowest among marginal agricultural lands. Foxtail millet showed no significant difference of heading and ripening date among marginal agricultural lands. Foxtail millet of slope land showed the highest culm length(169.5 cm) and grains per ear(4913.9 grains) among marginal agricultural lands except control field. Growth duration of three varieties was varied from 112 to 113days, which was not different statistically. In grains per ear of common millet, slope land showed 787.1 grains which was the highest among marginal agricultural lands except control field. Among varieties, Byorukgijang showed the highest grains per ear(827.2 g/ear), whereas 1000 grain weight was 5.5 g which was lower compared to that of Hwanggijang(6.2 g). In sorghum, slope land showed the highest grains(2563.8 grains) per ear and ears per 3.3 $m^2$(26.0 ears) except control field. Growth duration of three sorghum varieties almost the same from 122 to 123 days, whereas the highest grains per ear was obtained from Moktaksusu(2357.6 grains). Jangmoksusu showed the highest 1000 grain weight(23.8 g) among three sorghum varieties. In yield of three foxtail millets, the highest yield was obtained from slope land(282.0 kg/10a) among marginal agricultural lands and Mongdangjo showed the highest yield(252.3 kg/10a) among three varieties. In yield of three common millets, the highest yield was obtained from slope land(196.0 kg/10a) among marginal agricultural lands and Byorukgijang showed the highest yield(173.8 kg/10a) in three varieties. In three sorghum varieties, the highest yield was obtained from slope land(301.7 kg/10a) among marginal agricultural lands and Moktaksusu showed the highest yield(236.5 kg/10a) among three varieties.

• Geophysics and Geophysical Exploration
• /
• v.15 no.1
• /
• pp.1-7
• /
• 2012

To evaluate methods of determining near-surface shear-wave velocities (${\nu}_s$), we derived dispersion curves of Rayleigh waves generated by both passive and active sources in Chuncheon, Korea. Microtremors were recorded for 5 minutes in each of four triangular arrays with radii of 5 ~ 40 m. Those data were analyzed using the Spatial Autocorrelation method. Rayleigh waves were also generated by a hammer source and recorded in the same area for 2 s using 24 4.5-Hz geophones. Multichannel Analysis of Surface Waves was applied to those data. Velocity spectra were derived with relatively high signal-to-noise ratios in the frequency ranges of 7 ~ 19 and 11 ~ 50 Hz for the microtremors and synthetically generated Rayleigh waves, respectively. The resultant dispersion curves were combined as one and then input to inversion to derive shear wave velocities that were compared with a lithology log from a nearby well. Shearwave velocities in the top soil and soft-rock layers are almost constant with values of 221 and 846 m/s, respectively; while the inverse-modeled ${\nu}_s$ increases linearly in the gravelly sand, cobbles, and weathered-rock layers. If rock type is classified based on shear-wave velocity, the inversion-derived boundary between weathered-rock and soft rock may be about 5 m deeper than in the well log.