• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.12
• /
• pp.9-14
• /
• 2000

A numerical method for scattering of electromagnetic waves from a arbitrary shaped grating covered with dielectric slab is considered for TE polarization case from the viewpoints of both reflection grating problem and leaky wave antenna problem. The analysis is based on a periodic Green's function and the method of moments. Numerical results involving some combinations of geometric parameters are presented in terms of relative scattered powers of spectral modes and complex propagation constants.

• Korean Journal of Optics and Photonics
• /
• v.16 no.2
• /
• pp.133-137
• /
• 2005

A photonic RF true-time delay using a tapered chirped fiber Bragg grating coated with a heating electrode has been proposed and fabricated. For an RF signal carried over an optical signal, the time delay has been achieved by controlling the voltage applied to the electrode and thus adjusting its reflection positions from the fiber grating through the thermooptic effect. It features continuous voltage-controlled operation, requiring no mechanical perturbation and no moving parts. The measured time delay was about 120 ps with the electrical power consumption of $250{\cal}mW$.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.3
• /
• pp.43-51
• /
• 2020

In this paper, the design of 64 array antennas applied to RWP (Radar Wind Profiler) was described. The design point of the antenna is to ensure isolation between each element and to match the vertical / horizontal radiation pattern. To this end, a single element of the array antenna was proposed as a Bend dipole type, and through simulation, When sequentially sending 5 beams including vertical, the east/west/south/north direction was ±20°, and it was confirmed that no Grating Lobe occurred when steering the beam. The 64 array antenna proposed in this paper was designed with performance equal to or higher than that of overseas products, and was confirmed to be applicable to RWP.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.345-349
• /
• 2000

A microstrip polarized 8${\times}$2 linear phased array antenna with four 4-bit phase shifters is designed at 10 GHz. The 180$^{\circ}$and 90$^{\circ}$ sections of the phase shifter are of the switched line type, and the rests are of the loaded line type. A 2${\times}$2 sequential sub-array is adopted for a broad axial ratio bandwidth. The construction of the array antenna is of the tile type placing the phase shifters on the same layer containing the feed network. The element spacing is chosen to be 0.45λ$\sub$0/ to exclude the grating lobe. Measurement results show a gain 9.69 dB at broadside and 8.3 dB at the beam-tilt angle of 16$^{\circ}$ by imposing a progressive phase of 90$^{\circ}$.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.7
• /
• pp.52-60
• /
• 2009

In this pater, a CP-DRA(Circularly Polarized Dielectric Resonator Antenna) using cross-slot-feed is studied to enhance the gain and axial ratio bandwidth. First, a single layer CP-DRA is studied as a reference for comparison. Then a new type of multilayer CP-DRA is proposed to enhance the gain and axial ratio bandwidth. In consideration of the antenna gain enhancement, the spacing between the elements of the multilayer CP-DRA is examined through analysis of the radiation performance of a 2$\times$2 planar amy of DRAs with a spacing of 0.7$\lambda_0$ and 1.2$\lambda_0$ using CST Microwave Studio. The measured result shows that the gain and bandwidth of the multilayer structure is approximately twice that of the single layer one. In the case of the array antenna in which the spacing between multilayer CP-DRA element is 1.2$\lambda_0$, a grating lobe is reduced, in contrast to what we can expect from a conventional antenna array. The gain is 13.4dBi and axial ratio bandwidth is 0.8GHz.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.43-55
• /
• 2013

In this paper, we propose a cylindrical active phased array antenna of Beam Steering Characteristics in the horizontal plane(H-plane) and vertical plane(E-Plane) on the cylinder form array structure. We design the bent dipole antenna of the cylindrical array structure adapted excellent mutual-coupling characteristics, designed and manufactured the cylindrical array antennas and power combiner/divider unit for power dividing and combining on the antenna. The radiating elements array spacing of Cylindrical array antenna were determined to avoid grating lobes at half power beam steering. Beam steering of the antenna was implemented with 6-bit phase shifter in the transceiver and have been designed based on the characteristics the antenna beam steering at -24 degrees to 24 degrees horizontal, vertical 0 degrees to 36 degrees beam steering. A cylindrical active phased array antenna that produced for verification the performance of the antenna are measured radiation characteristics in accordance with beam steering at L-Band.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.2
• /
• pp.50-55
• /
• 2012

Fabry-Perot (FP) resonator antennas with scan capabilities are described in this paper. The proposed antennas, excited by a thinned array, not only achieve higher directivities but also improve suppression of sidelobes relative to that of the thin array alone. Compared to the conventional microstrip patch array, the directivity enhancement and suppression of sidelobe level were achieved by increase of the aperture size of the proposed Fabry-Perot resonator antenna.

• Journal of the Korea Society of Computer and Information
• /
• v.8 no.1
• /
• pp.90-96
• /
• 2003

In this paper, arranged the isotropic point source of N number with the structure which is identical with the receive area. And against the array structure which has the radiation pattern which is identical with the receive area it researched. The arranged the element space flees grating lobe and in order to set the characteristic of optimum with half-wave equally space it selects. After inducing the array factor of each array structure, it calculated a radiation pattern. As a result of, the radiation pattern of the each Planar array antenna with structure of the receive area was similar and the possibility of getting an beam characteristic it was.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.10 s.113
• /
• pp.1000-1006
• /
• 2006

In this paper, the gain of the square hem antenna is enhanced with $3{\times}3$ latticed aperture. In order to get the uniform field distribution on the aperture, the different thicknesses of dielectric plates for the phase compensation are inserted into the center and the edge of the aperture respectively. The proposed horn antenna is designed at 12.5 GHz band, and then the analysis of the field distribution on the aperture is performed by using FDTD method. The radiation pattern is also calculated from the analysis. Based on the measured data, it is verified that the gain of a horn antenna with latticed aperture is 18 dBi and this is 2 dB gain enhancement compare with a normal horn antenna without latticed aperture.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.8
• /
• pp.45-53
• /
• 1999

Electromagnetic scattering by finite number of conducting strips loaded on a grounded dielectric is considered for the TM polarization case from the viewpoints of transmitting(receiving) leaky wave antenna and grating coupler. An integro-differential equation whose unknowns are the induced currents over the strips is derived and solved by use of the method of moments. In order to construct the non-uniform leaky wave structures with specific source(current) distributions over the strips, distances between two adjacent strips and strip width are simultaneously varied along the structure. From some results for the current distributions over the strips and surface wave powers, it is observed that the maximum coupling efficiencies of the appropriately constructed non-uniform leaky wave structures from the viewpoints of both a receiving leaky wave antenna and a grating coupler amount upto 95%, which are about 15% improvements compared with those(80%) of the uniform structures.