• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.12 no.4
• /
• pp.267-274
• /
• 2014

The first Low- and Intermediate-Level Waste (LILW) disposal facility with 6 silos has been constructed in granite host rock saturated with groundwater in Korea. A two-dimensional numerical modeling on gas migration was carried out using TOUGH2 with EOS5 module in the disposal facility. Laboratory-scale experiments were also performed to measure the important properties of silo concrete related with gas migration. The gas entry pressure and relative gas permeability of the concrete was determined to be $0.97{\pm}0.15bar$ and $2.44{\times}10^{-17}m^2$, respectively. The results of the numerical modeling showed that hydrogen gas generated from radioactive wastes was dissolved in groundwater and migrated to biosphere as an aqueous phase. Only a small portion of hydrogen appeared as a gas phase after 1,000 years of gas generation. The results strongly suggested that hydrogen gas does not accumulate inside the disposal facility as a gas phase. Therefore, it is expected that there would be no harmful effects on the integrity of the silo concrete due to gas generation.

• The Korean Journal of Ceramics
• /
• v.6 no.2
• /
• pp.124-128
• /
• 2000

Electrical properties of $ZrO_2-TiO_2Yb_2O_3$mixed conductor (Ti-YbSZ) were investigated. This mixed conductor can be applied as a membrane for gas separation at high temperatures. The total conductivity decreased with increasing the $TiO_2$concentration. At high temperatures, the rate of the conductivity degradation became smaller than that at low temperatures. From the oxygen partial pressure dependence of the total conductivity of Ti-YbSZ, the electronic conductivity increased with increasing $TiO_2$concentration at low oxygen partial pressures and at high temperatures. Both 15 and 20 mol% $TiO_2$doped YbSZ showed high oxygen permeability. Mixed conductors, which has high $TiO_2$concentration in YbSZ, are promising materials for using as a membrane for gas separation at high temperatures.

• Journal of the Korean Ceramic Society
• /
• v.32 no.3
• /
• pp.349-358
• /
• 1995

The ceramic composite membrane was synthesized by thermal oxidation after evaporation of Al on the support prepared by slip casting process. Oxidation was performed at $700^{\circ}C$ and 80$0^{\circ}C$ under dry oxygen atmosphere. It was considered as optimum oxidation condition that the membrane showed a knudsen behaviro. A further oxidation resulted in an increase of gas permeability because top layer became densified. Then, a multi-layered composite membrane was synthesized through a sol-gel method, evaporation and thermal oxidation of Al coating processes. While the membrane was thermally stable up to 80$0^{\circ}C$, gas permeability was rapidly decreased even at a slight amount of deposition of Al.

• Membrane Journal
• /
• v.14 no.2
• /
• pp.132-141
• /
• 2004

NBR-Clay hybrid membranes were prepared by melt intercalation method with internal mixer and two roll mills. MMT was intercalated or ekfoliated by the NBR and it was confirmed by X-ray diffraction method. D-spacing of the characteristic peak from MMT plate in WAXD was moved and diminished. Gas permeability, mechanical properties and thermal properties of the NBR-Clay hybrid membranes were investigated. Gas permeability through the NBR-Clay hybrid membranes decreased due to increased tortuosity made by intercalation of clay in NBR.

• Membrane Journal
• /
• v.14 no.4
• /
• pp.320-328
• /
• 2004

Ionomer-Clay hybrid membranes were prepared by melt intercalation method with twin extruder. MMT was intercalated or exfoliated by the ionomer and it was confirmed by X-ray diffraction method. D-spacing of the characteristic peak from MMT plate in WAXD was moved and diminished. Gas permeability, mechanical properties and thermal properties of the ionomer-clay hybrid membranes were investigated. Gas permeability through the ionomer-clay hybrid membranes decreased due to increased tortuosity made by intercalation of clay in Ionomer.

• Membrane Journal
• /
• v.15 no.1
• /
• pp.62-69
• /
• 2005

SEBS-clay hybrid membranes were prepared by melt intercalation method with internal mixer. In the hybrid, the amount of clay content was fixed to 5 phr. MMT was intercalated or exfoliated by the ionomer and it was confirmed by X-ray diffraction method. D-spacing of the characteristic peak from MMT plate in SAXD was moved and diminished. Gas permeability, mechanical properties and thermal properties of the SEBS-clay hybrid membranes were investigated. Gas permeability through the SEBS-clay hybrid membranes decreased due to increased tortuosity made by intercalation of clay in SEBS.

• Journal of Soil and Groundwater Environment
• /
• v.12 no.5
• /
• pp.9-18
• /
• 2007

Soil vapor extraction (SVE) is an effective and cost efficient method of removing volatile organic compounds (VOCs) and petroleum hydrocarbons from unsaturated soils. However, soil vapor extraction becomes ineffective in soils with low gas permeability, for example soils with air permeabilities less than 1 Darcy. Incorporating PVDs in an SVE system can extend the effectiveness of SVE to lower permeability soils by shortening the air flow-paths and ultimately expediting contaminant removal. The objective of the research described herein was to effectively incorporate PVDs into a SVE remediation system. The test results show that the gas permeability was evaluated for four different equivalent diameters, increasing the equivalent diameter results in a decrease in the calculated gas permeability. It was found that the porosity for the dry condition was greater than that of the wet condition and will allow flow rate for the same vacuum flow, offering a low resistance to the air flow.

• Membrane Journal
• /
• v.22 no.5
• /
• pp.309-317
• /
• 2012

In this study, PTMSP/LDH composite membranes were prepared by the solution intercalation method with 1, 3, and 5 wt% LDH contents to PTMSP. To investigate the physico-chemical characteristics of composite membranes, the analytical methods such as FT-IR, TGA, XRD, UTM, and SEM have been utilized, and the gas permeability and selectivity properties of $H_2$, $N_2$, and $CO_2$ were evaluated. The permeability of the PTMSP/LDH composite membranes decreased as LDH content increased and the selectivity $H_2$ and $CO_2$ showed the maximum value at 5 wt% of LDH content. Permeability of PTMSP/LDH composite membrane increased as the gas permeation pressure increased. The difference of the increase in gas permeation pressure of the permeability of PTMSP/LDH composite membrane was slightly smaller than of PTMSP membrane.

• Membrane Journal
• /
• v.25 no.3
• /
• pp.223-230
• /
• 2015

We synthesized novel polyimides with high gas permeability and selectivity for application of gas separation membrane. 2,2-bis(3,4-carboxylphenyl) hexafluoropropane dianhydride (6FDA) and two kinds of amines with high permeability and solubility were used to prepare the novel polymide. 2,4,6-Trimethyl-1,3-phenylenediamine (DAM) was used to improve gas permeability and 4,4-Methylenedianiline was used to improve the gas selectivity respectively. The polyimide copolymers were synthesized by commercial chemical imidization method using Triethylamine and Acetic anhydride and their average molecular weights were over 100,000 g/mol. The glass temperature (Tg) and the thermal degradation temperature were characterized using differential scanning calorimeter (DSC) and thermogravimetric analysis (TGA). The synthesized copolymers showed high Tg over $300^{\circ}C$ and high thermal degradation temperature over $500^{\circ}C$. The gas permeation properties were measured by time-lag equipment. Although general polyimides showed very low gas permeability, synthesized polyimide copolymer showed high $O_2$ permeability of 10.1 barrer with high $O_2/N_2$ selectivity around 5.3. From this result, we confirm that these membranes have possibility to apply to gas separation membrane.

• Elastomers and Composites
• /
• v.54 no.3
• /
• pp.175-181
• /
• 2019

The research and development of high-performance polymer materials with excellent gas barrier properties has gained considerable attention from the viewpoint of expanding their applications in various fields, including tire automobile parts and the polymer film industry. Natural rubber (NR) has been widely used as a rubber material in real-life, but its application is limited owing to its poor gas barrier properties. In this paper, we study the gas barrier properties of NR, epoxidized natural rubber (ENR), and their blend compositions by using molecular simulation. The results show that ENR-50 has superior oxygen barrier properties than those of NR. Moreover, the oxygen barrier properties of a blend of NR/ENR-50 improve with increasing volume fraction of ENR-50. The trend of improved oxygen barrier properties of NR, ENR-50, and their blend is in good agreement with experimental observations.