• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2018.05a
• /
• pp.97-98
• /
• 2018

Despite of its advantange on shortening framework period of a super-tall building, gangform is prone to high safety risk due to its heavy weight during operation. Thus, this study is conducted to investigate the applicability of a lightweight gangform made of engineering composite materials. Compared to the conventional gangform, the proposed gangform showed greater performance not only in reduction of safety accidents on-site, but also in constructability and environmental aspects. The results of this study are expected to be served as the basis for developing the lightweight gangform in future.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2014.05a
• /
• pp.72-73
• /
• 2014

Recently the concurrent construction method of framework and windows work has been applied for early beginning of exterior finishing works in tall building construction. However, the conventional method makes difficulties in auto-climbing of gang-form and climbing work of lift car since the removal of ACS(auto climbing system) should be preceded for operation of lift car up to the top floor. This study propose a concept model of integrated ACS and lift car system to resolve these problems and begin windows works early in tall building construction.

• 한국생물공학회:학술대회논문집
• /
• 2000.04a
• /
• pp.394-397
• /
• 2000

Lab-scale biofilter was evaluated for the removal of styrene from a waste gas stream. Compost and polyurethane form were used as packing material (50 : 50) and activated sludge from a wastewater treatment plant was innoculated initially. Nitrogen limitation was observed during the biofilter operation and nitrogen source should be properly supplemented. When ammonium sulfate is used as N-source. 200mg carbon was removed for each mg of nitrogen. The effects of the volumetric styrene loading on the styrene elimination capacity (EC) and the removal efficiency (RE) was also tested. The results showed $EC_{max}$ was 4.8kg $C/m^3{\cdot}day$ and above RE 95% was achieved at EBRT 1min.

• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.9
• /
• pp.839-845
• /
• 2013

A CSTR (Continuous Stirred Tank Reactor) is a highly nonlinear process with varying parameters during operation. Therefore, tuning of the controller and determining the transition policy of controller parameters are required to guarantee the best performance of the CSTR for overall operating regions. In this paper, a methodology employing the 2DOF (Two-Degree-of-Freedom) PID controller, the anti-windup technique and a fuzzy gain scheduler is presented for the temperature control of the CSTR. First, both a local model and an EA (Evolutionary Algorithm) are used to tune the optimal controller parameters at each operating region by minimizing the IAE (Integral of Absolute Error). Then, a set of controller parameters are expressed as functions of the gain scheduling variable. Those functions are implemented using a set of "if-then" fuzzy rules, which is of Sugeno's form. Simulation works for reference tracking, disturbance rejecting and noise rejecting performances show the feasibility of using the proposed method.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2016.11a
• /
• pp.97-97
• /
• 2016

Development of advanced Li-ion battery cells with high durability is critical for safe operation, especially in applications to electric vehicles and portable electronic devices. Understanding fundamental mechanism on the formation of a solid-electrolyte interphase (SEI) layer, which plays a substantial role in the electrochemical stability of the Li-ion battery, in a cathode was rarely reported unlike in an anode. Using first-principles density functional theory (DFT) calculations and ab-initio molecular dynamic (AIMD) simulations we demonstrate atomic-level process on the generation of the SEI layer at the interface of a carbonate-based electrolyte and a spinel $LiMn_2O_4$ cathode. To accomplish the object we calculate the energy band alignment between the work function of the cathode and frontier orbitals of the electrolyte. We figure out that a proton abstraction from the carbonate-based electrolyte is a critical step for the initiation of an SEI layer formation. Our results can provide a design concept for stable Li-ion batteries by optimizing electrolytes to form proper SEI layers.

• Journal of Korean Society of Water and Wastewater
• /
• v.26 no.1
• /
• pp.107-113
• /
• 2012

Pollutants in aquaculture system effluent mostly originated from solid wastes including uneaten feed and excreta of cultured species. In this research, DAF(Dissolved Air Flotation) unit is suggested as an integrated solid control unit especially as a form of IIBG(Inline Injection Bubble Generation) process in aquaculture system. Solid removal performance of DAF unit was examined under various operation and salinity conditions with turbidity and suspended solid. Solid waste removal efficiencies were found to be affected by operation conditions including saturator pressure, recycle ratio, coagulant concentration. Solid removal efficiency was higher under higher saturator pressure and recycle ratio under which condition larger number of bubbles is generated. Coagulant is thought to have important role in creating bubble-particle aggregate by showing better removal efficiency with higher concentration. However higher saline water showed less effectiveness in removing solids by DAF(IIBG). Application of DAF(IIBG) process also showed additional effect in phosphate removal and DO(Dissolved Oxygen) supply. Phosphate existed in polluted water was removed up to 46% after treatment, which is thought to attribute to aluminium phosphate precipitation. And DO concentration was found to increase over 50% of initial saturation concentration after the injection of micro-bubbles. Through experiments on solid removal from aquaculture effluent, DAF(IIBG) process is estimated to be effective solid control method. This property can help aquaculture system being installed and operated simply and effectively.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2003.11a
• /
• pp.230-248
• /
• 2003

In this work an integrated model for paper plants combining wet-end and dry section is developed and a model predictive control scheme based on the plant model is proposed. Closed-loop process identification method is employed to produce a state-space model. Thick stock, filler flow, machine speed and steam pressure are selected as Input variables and basis weight, ash content and moisture content are considered as output variables. The desired output trajectory is constructed in the form of 1st-order dynamics. Results of simulations for control of grade change operations are compared with plant operation data collected during the grade change operations under the same conditions as in simulations. From the comparison, we can see that the proposed model predictive control scheme reduces the grade change time and achieves stable steady-state.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.308-309
• /
• 2012

One of the critical issues in the growth of multijunction solar cell is the formation of a highly doped Esaki interband tunnel diode which interconnects unit cells of different energy band gap. Small electrical and optical losses are the requirements of such tunnel diodes [1]. To satisfy these requirements, tens of nanometer thick gallium arsenide (GaAs) can be a proper candidate due to its high carrier concentration in low energy band gap. To obtain highly doped GaAs in molecular beam epitaxy, the temperatures of Si Knudsen cell (K-cell) for n-type GaAs and Be K-cell for p-type GaAs were controlled during GaAs epitaxial growth, and the growth rate is set to 1.75 A/s. As a result, the doping concentration of p-type and n-type GaAs increased up to $4.7{\times}10^{19}cm^{-3}$ and $6.2{\times}10^{18}cm^{-3}$, respectively. However, the obtained n-type doping concentration is not sufficient to form a properly operating tunnel diode which requires a doping concentration close to $1.0{\times}10^{19}cm^{-3}$ [2]. To enhance the n-type doping concentration, n-doped GaAs samples were grown with a lower growth rate ranging from 0.318 to 1.123 A/s at a Si K-cell temperature of $1,180^{\circ}C$. As shown in Fig. 1, the n-type doping concentration was increased to $7.7{\times}10^{18}cm^{-3}$ when the growth rate was decreased to 0.318 A/s. The p-type doping concentration also increased to $4.1{\times}10^{19}cm^{-3}$ with the decrease of growth rate to 0.318 A/s. Additionally, bulk resistance was also decreased in both the grown samples. However, a transmission line measurement performed on the n-type GaAs sample grown at the rate of 0.318 A/s showed an increased specific contact resistance of $6.62{\times}10^{-4}{\Omega}{\cdot}cm^{-2}$. This high value of contact resistance is not suitable for forming contacts and interfaces. The increased resistance is attributed to the excessively incorporated dopant during low growth rate. Further studies need to be carried out to evaluate the effect of excess dopants on the operation of tunnel diode.

• Journal of Chest Surgery
• /
• v.10 no.1
• /
• pp.98-105
• /
• 1977

A 36 year old blindman, engineer was admitted with chief complaints of hemoptysis, recurrent sore throat, pyoderma in genital organ, uveitis and thrombophlebitis for 10 years. Above the chief complaints were remission or exacerbation during hospitalization. Physicalexamination showed that left radial, ulnar & brachial pulse was not palpable. No bruit or murmur was obtained over the mass. Neurologic examination revealed no significant finding.On admission, chest P-A showed hen egg sized round & oval compact hazy density on left upper lung field. Bronchogram revealed no pathological finding and Lt. tomogram showed well define large,ovoid mass density in the superior mediastinum. Fluoroscopy finding showed nonpulsatile on left upper lung field. Pre-op. aortography was not taken, under the impression of lung Ca. rule out .sortie aneurysm, exploratory operation was performed through the 2nd intercostal space, Lt. It was performed that the mass was ascending sortie aneurysm of saccular type. Direct aneurysmectomy with multiple figure of eight suture were done without any prosthetic graft. Post-op. control I.V.C graphy showed completely obstruction sign. Postopcontrol aortography revealed good surgical result. Final, histopathological answered non-specific sortie aneurysm, saccular type. Post-op. courses were uneventful except mild neurologic disturbance with subclavian steal syndrome and associated with both lower leg pitting edema due to inferior vena cava obstruction. After op, 3 month later, discharged to home, with big systemic problem. Behcet`s syndrome reviewed with related literatures. The coexistence of mouth and genital ulceration with hypopyon mentioned by hippocrates and described by various workers in the early part of this century was first defined as a syndrome by Behcet in 1937. In 1937 Behcet described a chronic relapsing triple symptom complex of oral ulceration, genital ulceration, and ocular inflammation. The place of the syndrome as part of a systemic disorder in now clearer, and the under lying pathology appears to be a vasculitis. The disease runs a- chronic course, blindness being the greatest disability and control nervous system involvement a cause of death. Thrombophlebitis is fairly frequent, france et al [1951] giving an incidence of 25% and Dowling [1961] 12%, superficial thrombophlebitis migrans and thrombosis of large veins, including venae cavae [Thomas, 1947: Boolukos 1960] are recorded. Little attention has been paid to arterial involvement. Mishima et al. [1961] described resection cf an aortic aneurysm in a 38 year old man with Behcet`s syndorme. Mounsey in a clinicopathological conference described a case [Brit, med. J., 1966] of ruptured aortic aneurysm in Bechcet`s syndrome treated by aorto-iliac graft. Also, Shikano and Oshima et al [1963] recorded two aneyrysm of smaller arteries. Unfrequently, aortic aneurysm was presumed to be secondary to osteomyelitis of the lumber spine, though the possible association between aortic aneurysm and Behcet`s syndrome was raised. A further case is reported here, in which ascending aortic aneurysm with Behcet`s Ds. appeared to form part of this generalized disease. This is a case report of surgical experience of Behcet`s Ds. with ascending aortic aneurysm which had nearly all the typical clinical features. Above mentioned and was reviewed with related literatures.

• Convergence Security Journal
• /
• v.17 no.5
• /
• pp.41-47
• /
• 2017

The Marine Environment Observation Information System supplies oceanographic information elements such as water temperature, chlorophyll, float, etc. based on satellite images to consumers. The data produced by the Korean marine environmental observatories are located in the coastal areas of Korea. But if the range is too far from a particular area of interest, due to distance or spatial constraints, the accuracy and up-to-dateness of the data can not be relied upon. Therefore, it is necessary to perform fusion and complex operation to solve the difference between the field observation and the marine satellite image. In this study, we develop a system that can process marine environmental information in the user's area of interest in the form of layered character (numeric) information considering the readability and light weight rather than the satellite image. In order to intuitively understand satellite image information, we characterize (quantify) the marine environmental information of the area of interest and we process the satellite image band values into layered characters to minimize the absolute amount of transmitted / received data. Also we study modular location-based interest information service method to be able to flexibly extend and connect interested items that diversify various observation fields as well as application technology to serve this.