• Korean Journal of Materials Research
• /
• v.8 no.3
• /
• pp.229-237
• /
• 1998

We grew the hexagonal GaN films on (100) Si and (00.1) sapphire substrates in the temperature range of $300~730^{\circ}C$ by the direct reaction between thermally ionized N-source and thermally evaporated Ga-source. The GaN growth rates are increased at the initial stage of GaN formation and it was saturated to some values by the coalescence of each crystallites. The oxygen signal was observed in XPS spectra for all the GaN films grown in this work, especially low- temperature grown GaN film may due to incorporation of the residual oxygen in the growth chamber. The surface of low-temperature and shorter time grown films covered only Ga-droplets. however, with increasing the both substrate temperature and the growth time GaN is growth to crystallites. and coalescence to ring-type crystallites. With sufficient supply of N-source, they were changed to platelets. In the PL spectrum measured at 20 K, we observed the impurity related emission at 3.32eV and 3.38eV.

• Journal of the Korean Vacuum Society
• /
• v.12 no.S1
• /
• pp.56-59
• /
• 2003

Wurtzite GaN films are grown by low-pressure MOCVD on (0001)-plane sapphire substrates. The GaN films have a total thickness of 4 $\mu$m with a surface Mg-doped p-type layer, which has a thickness of 0.5 $\mu$m. 90k eV $Mn^{+}$ ions are implanted into the GaN films at room temperature with doses ranging from $1 \times10^{15}$ to $1 \times 10^{16}\textrm{cm}^{-2}$. After an annealing step at $770^{\circ}C$ in flowing $N_2$, the structural characteristics of the $Mn^{+}$ implanted GaN films are studied by X-ray diffraction (XRD), Rutherford backscattering spectrometry (RBS) and atomic force microscopy (AFM). The structural and morphological changes brought about by $Mn^{+}$ implantation and annealing are characterized.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1999.07a
• /
• pp.121-121
• /
• 1999

Gallium nitride (GaN) semiconductor is intensively under investigation for commercialization of short wavelength light emitting devices and laser diodes. One of serious obstacles to overcome is to reduce the defect density in GaN film grown by various techniques such as MOCVD, HVPE, etc. Many research groups including SAIT are trying to improve the defect density to 106-107/cm2 from the level of 108-1010/cm2. We have investigated epitaxial growth behaviour of GaN thin and thick films under hidride vapour phase epitaxy (HVPE) condition. In this report, we present the microstructural and crystallographical characteristics of the GaN films grown on sapphire (0001) substrate which were studied by both conventional and high-resolution transmission electron microscopy (TEM). Also we present some microscopic analysis results obtained from GaN films grown by ELO(dpitzsial lateral overgrowth)-HVPE and from GaN quantum well structures grown by MOCVD. Another serious problem in growing GaN thick film by HVPE is internal micro-cracks. We also comment the origin of the micro-crack.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2004.05a
• /
• pp.80-80
• /
• 2004

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.8
• /
• pp.677-681
• /
• 2009

$In_xGa_{1-x}N$ alloys with 20-nm-thickness were deposited onto Mg:GaN/AlN/SiC substrates by MOCVD at $800\;^{\circ}C$. TMGa, TMIn and $NH_3$ were used as the precursor of gallium, indium and nitrogen, respectively. The mole ratio of indium in $In_xGa_{1-x}N$ films varied between 0 and 0.2. The energy-band-gaps of the films were obtained from the photoluminescence and cathodoluminescence peaks. The mole ratios of $In_xGa_{1-x}N$ films were calculated by applying Vegard's law to XRD results. The energy-band-gap versus indium composition plot for $In_xGa_{1-x}N$ alloys were well fit with a bowing parameter of 2.27.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.7
• /
• pp.603-609
• /
• 2008

Photoluminescence (PL) of neutron-irradiated GaN films and nanowires is investigated in this study. The GaN films and nanowires were irradiated by neutron beams in air at room temperature, and the neutron-irradiated films and nanowires were annealed in an atmosphere of $NH_3$ at temperatures ranging from 500 to $1100^{\circ}C$. The line-shapes of the PL spectra taken from the neutron-irradiated GaN films and nanowires were changed differently with increasing annealing temperature. In this study, light-emitting centers created in the neutron-irradiated GaN films and nanowires are examined and their origins are discussed. In addition, it is suggested here that the neutron-transmutation-doping is a simple and useful means of homogeneous impurity doping into nanowires with control of the doping concentration.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.7
• /
• pp.953-956
• /
• 2003

Hexagonal GaN (h-GaN) films have been grown on Si(111) substrates by metal organic chemical vapor deposition using the azidodiethylgallium methylamine adduct, Et₂Ga(N₃)·NH₂Me, as a new single precursor. Deposition was carried out in the substrate temperature range 385-650 °C. The GaN films obtained were stoichiometric and did not contain any appreciable amounts of carbon impurities. It was also found that the GaN films deposited on Si(111) had the [0001] preferred orientation. The photoluminescence spectrum of a GaN film showed a band edge emission peak characteristic of h-GaN at 378 nm.

• Korean Journal of Crystallography
• /
• v.5 no.1
• /
• pp.24-32
• /
• 1994

The study of (0001), (1120) and (1011) GAN epitaxy films grown on the (0001),(1012) and (1120) α-Al2O3 substrates have been investigated using the haliar vapor phaes epitaxy(HVPE) method in Ga/HCI/NH3/He system. XRD, RHEED and SEM are used for the study of the films struction and surface morphology. Chemical composition of the film surface is estimsted by XPS. The following orientation relationships are observed; (0001) GaN /(0001) Al2O3 (1120) GaN/ (1012) Al2O3 and (0001) and (1011) GaN/ (1120) Al2O3 in accordance with growth conditions. The (0001) GaN films grown on(0001) and (1120) a-Al2O3 substrates at higer temperature(1050℃) have shown two dimensional grownth mechanism. Form SEM and RHEED, the smoother surface morphology and better structure are observed for the (1011) GaN films grown on (1120) sapphire at higer temperature.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.66-69
• /
• 2001

Effect of $N_2$ flow rate on properties of GaN thin films grown by plasma-enhanced molecular beam epitaxy(PEMBE) was discussed to optimize the quality of thin films. It was found that at low $N_2$ flow rate indicating high III/V flux ratio, the growth rate of GaN thin films was controlled by $N_2$ flux, and at high $N_2$ flow rate the growth rate was not controlled by $N_2$ flux any longer. It was also found that III/V flux ratio affected film quality. The film grown at higher $N_2$ flow rate showed low background carrier concentration, higher carrier mobility, and narrow FWHM in band-edge emission of low temperature PL. It is thought that the film in more Ga flux region was grown by 2-dimensional layer-by-layer growth mode, and the film in more nitrogen region was grown by 3-D island growth mode. All samples exhibited a good crystallinity.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.174-174
• /
• 2010

Gallium Nitride(GaN) attracts great attention due to their wide band gap energy (3.4eV), high thermal stability to the solid state lighting devices like LED, Laser diode, UV photo detector, spintronic devices, solar cells, sensors etc. Recently, researchers are interested in synthesis of polycrystalline and amorphous GaN which has also attracted towards optoelectronic device applications significantly. One of the alternatives to deposit GaN at low temperature is to use Single Source Molecular Percursor (SSP) which provides preformed Ga-N bonding. Moreover, our group succeeds in hybridization of SSP synthesized GaN with Single wall carbon nanotube which could be applicable in field emitting devices, hybrid LEDs and sensors. In this work, the GaN thin films were deposited on c-axis oriented sapphire substrate by MBE (Molecular Beam Epitaxy) using novel single source precursor of dimethyl gallium azido-tert-butylamine($Me_2Ga(N_3)NH_2C(CH_3)_3$) with additional source of ammonia. The surface morphology, structural and optical properties of GaN thin films were analyzed for the deposition in the temperature range of $600^{\circ}C$ to $750^{\circ}C$. Electrical properties of deposited thin films were carried out by four point probe technique and home made Hall effect measurement. The effect of ammonia on the crystallinity, microstructure and optical properties of as-deposited thin films are discussed briefly. The crystalline quality of GaN thin film was improved with substrate temperature as indicated by XRD rocking curve measurement. Photoluminescence measurement shows broad emission around 350nm-650nm which could be related to impurities or defects.