• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2000년도 제15차 학술회의논문집
• /
• pp.285-285
• /
• 2000

A continuous and reliable electrical energy supply is the objective of any power system operation. A transmission line is the part of the power system where faults are most likely to happen. This paper describes the use of wavelet transform for analyzing power system fault transients in order to determine the fault location. Synchronized sampling was made possible by precise time receivers based on GPS time reference, and the sampled data were analyzed using wavelet transform. This paper describes a fault location monitoring system and fault locating algorithm with GPS, DSP processor, and data acquisition board, and presents some experimental results and error analysis.

• Journal of Positioning, Navigation, and Timing
• /
• 제7권2호
• /
• pp.53-59
• /
• 2018

This paper proposes a pseudo-random beamforming technique for time-synchronized mobile base stations (BSs) for multi-cell downlink networks which have mobility. The base stations equipped with multi-antennas and mobile stations (MSs) are time-synchronized based on global positioning system (GPS) signals and generate a number of transmit beamforming matrix candidates according to the predetermined pseudo-random pattern. In addition, MSs generate receive beamforming vectors that correspond to the beam index number based on the minimum mean square error (MMSE) using transmit beamforming vectors that make up a number of transmit beamforming matrices and wireless channel matrices from BSs estimated via the reference signals (RS). Afterward, values of received signal-to-interference-plus-noise ratio (SINR) with regard to all transmit beamforming vectors are calculated, and the resulting values are then feedbacked to the BS of the same cells along with the beam index number. Each of the BSs calculates each of the sum-rates of the transmit beamforming matrix candidates based on the feedback information and then transmits the calculated results to the BS coordinator. After this, optimum transmit beamforming matrices, which can maximize a sum-rate of the entire cells, are selected at the BS coordinator and informed to the BSs. Finally, data signals are transmitted using them. The simulation results verified that a sum-rate of the entire cells was improved as the number of transmit beamforming matrix candidates increased. It was also found that if the received SINR values and beam index numbers are feedbacked opportunistically from each of the MSs to the BSs, not only nearly the same performance in sum-rate with that of applying existing feedback techniques could be achieved but also an amount of feedback was significantly reduced.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제55권6호
• /
• pp.286-295
• /
• 2006

This paper presents a design of a real-time software GPS receiver which runs on a PC. The software GPS receiver has advantages over conventional hardware based receivers in terms of flexibility and efficiency in application oriented system design and modification. In odor to reduce the processing time of the software operations in the receiver, a shared memory structure is used with a dynamic data control, and the byte-type IF data is processed through an Open Multi-Processing technique in the mixer and integrator which requires the most computational load. A high speed data acquisition device is used to capture the incoming high-rate IF signals. The FFT-IFFT correlation technique is used for initial acquisition and FLL assisted PLL is used for carrier tracking. All software modules are operated in sequence and are synchronized with pre-defined time scheduling. The performance of the designed software GPS receiver is evaluated by running it in real-time using the real GPS signals.

• 한국정보통신학회논문지
• /
• 제8권5호
• /
• pp.1004-1009
• /
• 2004

컴퓨터 시스템에서의 시각 메커니즘은 기본적이고 필수적인 요소로써 현재 시각의 유지 및 프로세스 점유 시간, 디스크 I/O 등, 시스템의 각종 성능 평가를 위한 척도이다. 분산 시스템에서 응용프로세스들은 시스템 내 여러 노드에서 동시에 수행되며 정확한 결과를 얻기 위해서는 노드 간 시각 동기가 이루어져야 한다. 현재 통신망이 보편적 요소가 되면서 분산 환경 구성 및 네트워크 기반 운용이 일반화됨에 따라 시각 동기는 필수 사항이 되었다. 네트워크 시각 서버는 시스템의 지역 클럭을 표준 참조 시각원에 동기시킴으로써 정확하고 정밀한 시각을 획득, 유지하고 표준 시각 동기 프로토콜을 통해 시각 정보를 네트워크에 분배한다. 본 논문은 네트워크 시각 동기를 위한 시각 서버의 설계 및 구현에 대해 제시한다. 시스템은 표준 참조 시각원으로 GPS (Global Positioning System)를 사용하며 NTP (Network Time Protocol)를 통해 표준시 (UTC: Universal Time Coordinated)를 제공한다.

• 제어로봇시스템학회논문지
• /
• 제14권9호
• /
• pp.963-968
• /
• 2008

A new method to deal with GPS indoor positioning by means of time synchronized switching GPS repeater has been developed by authors[1]. But the developed indoor positioning system has problems. Therefore, we proposed a method for indoor positioning using GNSS Repeater-Assisted. To solve the 3-dimensional user's position, the 4 or more retransmission antennas are needed in the previously proposed methods. If a GPS repeater periodically transmits the signal like as pseudollite, the information for assisting an acquisition and tracking can be informed to receiver. Then, the user position can be calculated using the induced weak signal. The advantage of the proposed algorithm is use of only 1 re-transmission antenna because the re-transmitted signal are not used for positioning but used for assisting an acquisition and tracking weak signals induced indoor. We analyze the propose algorithms through the experiment and performed the test of feasibility.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2006년도 International Symposium on GPS/GNSS Vol.1
• /
• pp.309-314
• /
• 2006

In general DGPS system, the correction message is transferred to users by wireless modem. To cover wide area, many DGPS station should be needed. And DGPS users must have a wireless modem that is not necessary in standalone GPS. But SBAS users don't need a wireless modem to receive DGPS corrections because SBAS correction message is transmitted from the GEO satellite by L1 frequency band. SBAS signal is generated in the GUS(Geo Uplink Subsystem) and uplink to the GEO satellite. This uplink transmission process causes two problems that are not existed in GPS. The one is a time delay in the uplink signal. The other is an ionospheric problem on uplink signal, code delay and carrier phase advance. These two problems cause ranging error to user. Another critical ranging error factor is clock synchronization. SBAS reference clock must be synchronized with GPS clock for an accurate ranging service. The time delay can be removed by close loop control. We propose uplink ionospheric error correcting algorithm for C/A code and carrier. As a result, the ranging accuracy increased high. To synchronize SBAS reference clock with GPS clock, I reviewed synchronization algorithm. And I modified it because the algorithm didn't consider doppler that caused by satellites' dynamics. SBAS reference clock synchronized with GPS clock in high accuracy by modified algorithm. We think that this paper will contribute to basic research for constructing satellite based DGPS system.

• 한국통신학회논문지
• /
• 제38C권2호
• /
• pp.141-154
• /
• 2013

신호수신장치들간 시각 동기화는 TDoA를 이용한 위치 탐지에 있어 가장 중요한 전제 사항이 된다. 본 논문에서는 시스템의 시각동기 정확도를 위하여 고정밀도의 OCXO와 DPLL을 이용하여 원자 클럭을 사용하는 GPS 위성으로부터 수신되는 1 pps(pulse per second) 신호에 위상동기 되는 방식을 제안한다. GPS 기반 고정밀 타이밍 레퍼런스의 성능은 근본적으로 매우 우수한 장기간에 걸친 주파수 안정도(long-term frequency stability)를 갖는 GPS 타이밍 신호의 특성을 따라간다고 볼 수 있으며, GPS 타이밍 신호에 동기가 되면 0.001 ppb(part per billion) 급의 초정밀 타이밍 레퍼런스를 통해 시각 동기의 정확도를 향상시킨다. 제안하는, 향상된 시각 동기 정확도를 통해 TDoA 기반의 위치 탐지 기술에서의 측정 오차를 평가하고, 시각동기 오차 개선 방법이 TDoA 기반의 위치 측정 오차를 크게 개선함을 보인다.

• 조명전기설비학회논문지
• /
• 제30권3호
• /
• pp.46-52
• /
• 2016

When a fault occurs on a transmission line, it is important to identify the fault location as speedily as possible for improvement of the power supply reliability. Generally, distance to fault location is estimated by off line from the recorded data. Conventional fault recorder uses the fault data at one end. This paper deals with the design of an advanced fault recorder for enhancement accuracy of the fault distance estimation and fast detection a fault occurrence position. The major emphasis of the paper will be on the description of the hardware and software of the fault recorder. The fault locator algorithm utilizes a GPS time-synchronized the fault data at both ends. The fault data is transmitted to the other side substation through communication. The advanced fault locator includes a Power module, MPU(Main Processing Unit) module, ADPU(Analog Digital Processing Unit) module, and SIU(Signal Interface Unit) modules. The MMI firmware and software of an advanced fault recording device was implemented.

• 한국측량학회지
• /
• 제18권3호
• /
• pp.295-303
• /
• 2000

본 연구는 GPS사용에 따른 많은 장점 때문에 보편화되어 가는 DGPS기술에 의한 조위측위의 효율성과 정도의 향상을 위한 것으로, 연구결과 여러 형태의 수학적인 회귀공식에 의하여 최적화공식의 선택 및 회귀처리가 가능하였다. 또한 종래에는 단계적인 방법에 의하여 GPS시간과 조위시간을 일치시켰으나 실시간적으로 평면과 표고(2D+1D) 좌표변환하여 해양바닥면의 높이를 Cm정확도로 계산하게 되었다. 이러한 시각동기화로 실시간 DGPS 수심측량은 지역적인 조류와 조위의 변화에 대처할 수 있다.

• 한국인터넷방송통신학회논문지
• /
• 제12권1호
• /
• pp.217-223
• /
• 2012

다양한 산업 분야와 일상생활에서 시각동기 문제는 매우 중요하다. 일상생활에서 사용하는 전자제품 중에서 보다 정확한 시각정보를 활용 한다면 좀 더 정확한 동작을 수행하게 할 수 있다. 전력선을 통해 전원을 공급받아 동작하는 제품의 경우, 전력선을 통해 정확한 시각 정보를 전송 받을 수 있다면 시각동기 문제를 좀더 쉽게 해결할 수 있다. 본 논문에서는 GPS위성으로부터 수신한 시각정보를 전력선을 통해서 각 단말에 전송하는 전력선 방송 시스템을 개발하였다. 또한 시각 소스를 GPS에 동기된 스마트폰을 이용할 수 있도록 하였으며, 전력선 모뎀 기술이 갖는 장거리 전송의 어려움을 해결하기 위한 중계 방식을 제안하고 중계 시스템을 구현하였다. 본 논문에서 개발된 시스템은 시각 정보의 전송 거리를 확장하여 광역 PLB(Power Line Broadcasting) 시각방송을 구현하였다. 또한 본 논문에서는 중계 시스템의 성능을 평가하여 그 유용성을 확인하였다.