• Publications of The Korean Astronomical Society
• /
• v.19 no.1
• /
• pp.93-99
• /
• 2004

In this paper, we describe a principle of the atomic frequency standard and clock system in VLBI(Very Long Baseline Interferometry). The hydrogen maser is a usual VLBI standard. During VLBI observations, signals emitted by distant sources of radio frequency energy(quasars) are received and recorded at several antennas. At each antenna(VLBI station), a very stable frequency standard(hydrogen maser) provides a reference signal which enables time-tagging to the quasar signals as they are being recorded on magnetic tapes or hard-disk modules. For each VLBl experiment, correlation of the time-tagged recorded information between the participating antennas is used to yield the arrival time differences of any specific quasar radio wave between the antennas. These time differences are used to calculate the relative antennas to each other. In this paper, we also introduce the KVN(Korean VLBI Network) atomic frequency standard and clock system.

• Journal of Institute of Control, Robotics and Systems
• /
• v.5 no.1
• /
• pp.62-68
• /
• 1999

The attitude of a vehicle can be precisely determined using GPS carrier phase measurements from more than two antennas attached to a vehicle and an efficient integer ambiguity resolution technique. Many methods utilizing the known baseline length as a constraint of independent elements of integer ambiguities are proposed to resolve integer ambiguity at real time. Three-dimensional search space is reduced to two-dimensional search space with this constraint. Thus the true integer ambiguity can be easily determined with less computational burden and fewer number of measurements. But there are still strong requirements for the real time integer ambiguity resolution, which uses single epoch measurement of long baseline. In this paper, a new constraint from the geometry of multiple baselines is derived. With this new constraint, two-dimensional search space is further reduced to one-dimensional search space. It makes possible to determine integer ambiguity with single epoch measurement. The proposed method is applied to real data to show its effectiveness.

• Journal of Positioning, Navigation, and Timing
• /
• v.10 no.4
• /
• pp.291-296
• /
• 2021

Recently, the dual-polarized antenna array has drawn attention due to the dependency of its signal processing gain on the signal polarization. Even though this polarization dependency makes it possible to mitigate a non-right-hand circularly polarized (non-RHCP) jamming signal from the same direction as a GPS signal, the dual-polarized antennas are not yet widely used for various applications. This study suggests a method that can acquire the polarization dependency of the signal-processing gain by intentionally misaligning antenna elements in a single-polarized antenna array. The simulation results show that the proposed method can successfully mitigate a non-RHCP jammer from the same direction as a GPS signal as if a dual-polarized antenna array does and provide comparable signal-to-jammer-plus-noise ratio (SJNR) performance with a completely aligned single-polarized antenna array and a dual-polarized antenna array.

• International Journal of Computer Science & Network Security
• /
• v.23 no.3
• /
• pp.203-207
• /
• 2023

A frequency reconfigurable antenna based on graphene and used for multi-band wireless communications is presented in this article. The proposed antenna, which consists of two radiating rectangular loops with a graphene extension, is analyzed for Global Positioning System (GPS) and Iridium applications. Its operating frequency is tuned through the implementation of a layer of graphene and thereby adjusting the applied gate bias. Furthermore, the results show a novel use of graphene for microwave frequencies while achieving a frequency reconfiguration with an improvement of the impedance matching and the gain. The results also prove the importance of graphene, with its exceptional properties, for a promising future in nano-electronics.

• Journal of Navigation and Port Research
• /
• v.38 no.6
• /
• pp.623-627
• /
• 2014

In recent years, wireless communication technologies in human body have received an increasing attention and the research on an antenna that can be worn also has been actively conducted. In this paper, an wearable antenna that can receive GPS signal frequency is proposed. The antenna was manufactured by using a copper polyester fabric with thickness of 0.08mm as a radiator and a ground plate, and a goatskin with thickness of 0.7mm as dielectric substrate. Cutting edges placed in diagonal direction of square patch in order to obtain a circular polarization characteristic, and the conductive cloth and leather was laminated by using a conductive epoxy. First, goatskin dielectric constant was obtained through the simulation and measurement of resonance frequency of the three square patch antennas with different size. On the basis of the results, an antenna operating in the GPS band was designed and the performance of the antenna was validated by making the experiment. The change of the characteristic of the antenna that is located on the shoulder parts of the clothing and wearing person were measured. And it was confirmed that the reception sensitivity has a similar level as compared to the commercially produced ceramic GPS antenna.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.39 no.8
• /
• pp.774-787
• /
• 2011

This paper deals with quantitative analysis about the characteristics of GNSS(Global Navigation Satellite System) signals contaminated with multipath signals and day-to-day repeatability of the navigation solution and SNR(Signal to Noise Ratio) caused by multipath signals using the collected data from GPS receiver installed on KSLV-I which was on standby on the launch pad at Naro Space Center. Since the GPS antennas, surrounding environments and GPS satellite orbits were very slightly changed with respect to the day, the repeating pattern of the solution and SNR caused by the multipath signals was verified from the collected data. Analytic result of the multipath effects and day-to-day repeatability of the navigation solution and SNR observed at the launch pad would be used for obtaining more stable performance of the GPS receiver when the satellite launch vehicles are on standby.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.41 no.6
• /
• pp.481-487
• /
• 2013

In GPS(Global Positioning System)/INS(Inertial Navigation System) integrated navigation systems, GPS antennas and an inertial measurement units are usually installed outside and inside of the vehicle, respectively. By the difference of installed locations, performance of GPS/INS integrated navigation systems is affected by lever arm errors. For more accurate navigation, lever arm errors need to be compensated correctly since it directly affects the accuracy of navigation states. This paper proposes an effective lever arm error compensation method that utilizes velocity measurements of GPS and INS. By an experiment, feasibility of the proposed algorithm is verified. It is also shown that lever arm compensation is especially important when vehicles are experiencing rotational movements.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.5
• /
• pp.455-462
• /
• 2015

In this paper, we suggested multiband antenna that can be equipped on a inflatable life-jacket, operating VHF-DSC band(156 MHz), COSPAS-SARSAT band(406 MHz) and GPS band(1,575 MHz) for search and rescue survivors quickly. The GPS band antenna was implemented with a square ring-slot planar antenna, and the COSPAS-SARSAT and VHF-DSC band antenna were implemented meander type dipole antennas. In order to place the antenna on a life-jacket, we installed it on 0.2 mm thickness FR-4 substrate to obtain a flexibility. It appeared that the antenna has -14.6 dB, -30.9 dB, and -18 dB return loss in COSPAS-SARSAT, GPS, and VHF-DSC band, respectively. In addition, its gain has 0.83 dBi, 2.1 dBi in COSPAS-SARSAT and GPS band, respectively.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.2
• /
• pp.145-150
• /
• 2016

The capability of accurate positioning and tracking is necessary to implement an unmanned autonomous driving system. The moving-baseline GPS Technique is a promising candidate to mitigate positioning errors of conventional GPS system. It provides accurate positioning data based on the phase difference between received signals from multiple GPS antennas mounted on the same platform. In this paper, we propose a dual-band dual-circularly-polarized antenna suitable for the moving-baseline GPS. The proposed antenna operates at GPS L1 and L2 bands, and fed by the side of the antenna instead of the bottom. The antenna is firstly designed by calculating theoretical values of key parameters, and then optimized by means of 3D full-wave simulation software. Simulation and measurement results show that the optimized antenna offers 6.1% and 3.7% bandwidth at L1 and L2, respectively, with axial ratio bandwidth of more than 1%. The size of the antenna is $73mm{\times}73mm{\times}6.4mm$, which is small and low-profile.

• Journal of Positioning, Navigation, and Timing
• /
• v.12 no.2
• /
• pp.101-111
• /
• 2023

Many spoofing detection studies have been conducted to cope with the most difficult types of deception among various disturbances of GPS, such as jamming, spoofing, and meaconing. In this paper, we propose a spoofing detection scheme based on elevation masked-relative received power between GPS L1 and L2 signals in a system using a multi-band array antenna. The proposed scheme focuses on enabling spoofing to be normally detected and minimizes the possibility of false detection in an environment where false alarms may occur due to pattern distortion among elements of an array antenna. The pattern distortion weakens the GPS signal strength at low elevation. It becomes confusing to detect a spoofing signal based on the relative power difference between GPS L1 and L2, especially when GPS L2 has weak signal strength. We propose design parameters for the relative power threshold including beamforming gain, the minimum received power difference between L1 and L2, and the patch antenna gain difference between L1 and L2. In addition, in order to eliminate the weak signal strength of GPS L2 in the spoofing detection process, we propose a rotation matrix that sets the elevation mask based on platform coordinates. Array antennas generally do not have high usefulness in commercial areas where receivers are operated alone, but are considered essential in military areas where GPS receivers are used together with signal processing for beamforming in the direction of GPS satellites. Through laboratory and live sky tests using the device under test, the proposed scheme with an elevation mask detects spoofing signals well and reduces the probability of false detection relative to that without the elevation mask.