• 대한전자공학회논문지
• /
• 제15권1호
• /
• pp.23-26
• /
• 1978

Full-wave를 얻기 위한 회로와 그 회로의 해석을 하여 간단한 결과식을 얻고 또 full-wave를 이용한 duty ratio가 가변인 square wave를 얻을 수 있음을 옳바른 이론과 실험을 통해 구현하였다.

• 한국전자파학회논문지
• /
• 제15권4호
• /
• pp.345-352
• /
• 2004

본 논문은 페라이트 필름을 기반으로 하는 마이크로스트립 선로로부터 여기되는 정자표면파의 복사 임피던스를 full-wave모멘트 해석법을 이용하여 계산하였다. 마이크로스트립 선로 폭과 페라이트 필름 두께 변화에 따른 여 기 특성 변화도 분석하였다. 정자파 근사에 의하여 계산된 복사 저항값은 주파수가 증가할수록 실험 값과 차이가 심해지나, full-wave 해석에 의하여 계산된 복사 저항값은 실험값에 매우 근접함을 알 수 있었다.

• 대한방사선기술학회지:방사선기술과학
• /
• 제3권1호
• /
• pp.81-86
• /
• 1980

To compare three-phase 12-pulse full-wave X-ray generators with single-phase full-wave X-ray generators on their performance of outputs, authors studied the generating X-ray by means of exposure dose and radiographic density. The results were as follows; 1. The exposure doses of three-phase full-wave X-ray generators showed a 30%-60% increase as compared against of single-phase full-wave generators. 2. The transmitted doses of three-phase full-wave generators were more increased than single-phase full-wave X-ray generators. 3. To obtain the same density, 60kVp in three-phase full-wave generators were equivalent to $60{\sim}65kVp$ in single-phase full-wave generators, and 100kVp in those generators were equivalent to $100{\sim}125kVp$ in these generators.

• 한국재료학회지
• /
• 제32권7호
• /
• pp.320-325
• /
• 2022

Single OLED and tandem OLED was manufactured to analyze the electroluminescence characteristics of DC driving, AC driving, and full-wave rectification driving. The threshold voltage of OLED was the highest in DC driving, and the lowest in full-wave rectification driving due to an improvement of current injection characteristics. The luminance at a driving voltage lower than 10.5 V (8,534 cd/m²) of single OLED and 20 V (7,377 cd/m²) of a tandem OLED showed that the full-wave rectification drive is higher than that of DC drive. The luminous efficiency of OLED is higher in full-wave rectification driving than in DC driving at low voltage, but decrease at high voltage. The full-wave rectification power source may obtain higher current density, higher luminance, and higher current efficiency than the AC power source. In addition, it was confirmed that the characteristics of AC driving and full-wave rectification driving can be predicted from DC driving characteristics by comparing the measured values and calculated values of AC driving and full-wave rectification driving emission characteristics. From the above results, it can be seen that OLED lighting with improved electroluminescence characteristics compared to DC driving is possible using full-wave rectification driving and tandem OLED.

• 산업기술연구
• /
• 제24권B호
• /
• pp.163-170
• /
• 2004

In this study, First, the results of travel-time inversion (first arrival inversion using the travel-time of the first arrival) were compared with those of full-wave inversion for numerical data. Numerical experiments to find key parameters other than initial velocity model showed that the frequency of source has a great effect on the result of full-wave inversion. Finally, this research presented the corrected full-wave inversion applying the correction term to the final result of full-wave inversion. The corrected full-wave inversion depicted cavities inside concretes even when the inversion started with 20% error in an initial velocity model for cavities. However, full-wave inversion did not reveal cavities.

• 한국해안·해양공학회논문집
• /
• 제25권5호
• /
• pp.285-290
• /
• 2013

선형과 천해 edge wave로 구분되는 이들의 거동을 더 잘 이해하기 위해 비교하였다. 본 연구에서는 변수분리법을 사용하여, Ursell (1952)이 해의 유도과정 없이 제시한, 선형 edge wave의 해를 얻었다. 천해 edge wave는 비록 천해방정식으로부터 유도되지만 분산특성을 갖는다. 완만한 해저경사의 경우, 천해 파형은 선형 파형과 거의 같게 되고 천해 파형은 다루기가 쉬운 장점이 있다. Gaussian 분포형태의 이동체에 의해 생성되는 edge wave를 계산하기 위해 천해 고유파형으로 전개한 해를 구성하였고, 이에 대한 결과를 제시하고 특성을 기술하였다.

• 대한방사선기술학회지:방사선기술과학
• /
• 제20권2호
• /
• pp.44-48
• /
• 1997

For the efficient management of the diagnostic x-ray equipment, a nation-wide inspection of hospitals was performed by an inspection institute in Taejon in the first half of 1997. Among those hospitals inspected, 28 equipments(machines) which were over 500 mA were randomly selected according to their characteristics : 7 condenser type x-ray equipments, 7 three control phase of full wave rectification of type remote control x-ray equipments, 7 single phase of full wave rectification type for general radiography equipments, and 7 single phase of full wave rectification type of R/F equipments. We obtained the following results by conducting the experiment based on the efficiency of the equipments mentioned above. 1) When the equipments are analyzed, 2 out of 7 single phase of full wave rectification type of general radiography equipments(28.6%), 3 out of 7 single phase of full wave rectification type of R/F equipments(42.9%), 5 out of 7 three phase of full wave rectification type remote of control x-ray equipments(71.4%), and 4 out of 7 condenser type of x-ray equipments(57.1%) showed suitability. It proves the superiority of the three phase of full wave rectification type of remote control x-ray equipments. 2) From the overall analysis, only about 50% of the equipments(suitability of 14 out of 28) maintain the efficient management. Therefore, maintenance management of equipments is more necessary. If the efficiency of the x-ray equipment is uniformly maintained and managed to prevent the breakdown(trouble) beforehand especially through the continuous inspection of tube voltage, tube current, exposure time, and collimator, the financial loss and exposure dose to the patient, as well as the workers engaged in radiation, can be reduced for better medical service.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.138-138
• /
• 2010

X-ray systems for medical treatment use noninvasive procedures. I fabricated a high tension generator of a full-wave rectification type using a LC resonant inviter. It is said that a full-wave rectifying X-ray equipment such as the fabricated system can shorten initiating period and be precision control because of stable output, compared with the X-ray equipment of a half wave rectifying type used in the usual clinical medicine. In order to evaluate the capability of the fabricated high tension generator, I performed exposure dose characteristics experiments.

• 반도체디스플레이기술학회지
• /
• 제14권4호
• /
• pp.84-87
• /
• 2015

We have designed and fabricated two different RF-DC Converters called doubler for 5.8GHz Microwave Wireless Power Transmission. The doubler as RF-DC Converter makes the rectified voltage be doubled. We measured and compared voltages of the doublers with those of the previous full-wave rectifying RF-DC Converter. The doublers show rectified double voltages. However, the full-wave rectifying converter has a high efficiency due to the suppression of reflecting harmonics. The other fabricated doublers causes so many harmonics that they can't convert the low-power RF to the full DC. In this paper, we show that the different doublers doesn't double the rectifying voltages compared with those of the full-wave rectifying converter and give a reason about that.

• Journal of electromagnetic engineering and science
• /
• 제6권4호
• /
• pp.197-202
• /
• 2006

This paper presents a study on the differential signaling for the rectangular power-bus structure. The full-wave modal analysis method analyzes how the differential-signaling can lower the power-bus resonance noise levels. The methodology is validated by the use of the FDTD method and reference measurements.