• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.25 no.12
• /
• pp.107-112
• /
• 2011

Multiple ground rods are commonly used to obtain the low ground impedance, but they will not reduce the ground impedance unless the spacings between the ground rods are sufficient. This paper presents the experimental results of frequency-dependent resultant ground impedance of two ground rods in parallel. The resultant ground impedance of two ground rods in parallel were measured as functions of the spacing and length of ground rods and the frequency of test currents and were discussed based on the potential interferences. As a consequence, the frequency-dependent ground impedance of single ground rod and two combined ground rods give capacitive. It was found that the effect of potential interference on the ground impedance is directly associated with the frequency-dependent ground impedance and is strong in low frequency. Also, in order to reduce the increasing rate of resultant ground impedance of two ground rods due to potential interference to within 10(%), two ground rods in parallel will be placed over one rod length apart.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5A
• /
• pp.441-449
• /
• 2011

Sample timing offset (STO) and carrier frequency offset (CFO) are caused by inter-symbol interference (ISI), inter-carrier interference (ICI) and phase error in orthogonal frequency division multiplexing (OFDM) system. OFDM characteristic is sensitive about STO and CFO. So when ICI occurs, compensation is hard and complex equalizer is needed. In this paper, we propose an effective correction method using feedback process with pilot and synchronization symbol. After feedback with estimated value in frequency domain, STO and CFO are corrected by control sample & and holder and oscillator. As a result of simulation, we confirm that STO and CFO can be corrected without equalizer through feedback.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.76-82
• /
• 2014

In order for heterogeneous unlicensed devices to co-exist on the same frequency band, the frequency interference avoidance mechanism is necessary. In this paper, a frequency interference between WLAN and WPAN systems that operate at 2.4 GHz ISM band was analyzed in the MAC layer. We observed that WPAN systems suffer from severe interference from WLAN systems. To avoid this interference problem, we propose a new channel shift algorithm for WPAN systems. We showed that the proposed channel shift algorithm is better than the traditional WPAN system which uses a fixed channel in terms of throughput.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.10
• /
• pp.843-850
• /
• 2013

Cognitive radio systems have been considered as a strong solution of frequency scarcity due to the limit of frequency resources. This paper proposed an active interference management scheme that the secondary system can coexist with the primary system in the same frequency band without interference. Using the proposed protocol, the secondary user acquires interference channel information and transmit/receive filter information and designs precoding matrix using these information. Since interference from the secondary systems are collected to unused subchannels of the primary system, the primary system can suppress interference without additional process. The secondary systems suppress interference from the primary system using whitening matched filter so that the spectral efficiency can be improved. Numerical results provides that the proposed scheme improves performance of the secondary systems without interference to the primary system and do not degrade performance of the primary system even if the number of the secondary systems increases.

• Journal of Industrial Technology
• /
• v.24 no.A
• /
• pp.127-131
• /
• 2004

In this paper, we proposed an optical balance using a Michelson Interferometer structure. The frequency of the interference signal is changed nonlinearly related with a weight to be measured, and this frequency change is processed by a processor to give a measured weight. Several measurements were performed and the good results were obtained with the fluctuation of about 1g.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.1
• /
• pp.216-239
• /
• 2021

The present work addresses the challenging problem of coordinating power allocation with interference management in multi-robot networks by applying the promising expansion capabilities of multiple-input multiple-output (MIMO) and full duplex systems, which achieves it for maximizing the throughput of networks under the impacts of Doppler frequency shifts and external jamming. The proposed power allocation with interference coordination formulation accounts for three types of the interference, including cross-tier, co-tier, and mixed-tier interference signals with cluster head nodes operating in different full-duplex modes, and their signal-to-noise-ratios are respectively derived under the impacts of Doppler frequency shifts and external jamming. In addition, various optimization algorithms, including two centralized iterative optimization algorithms and three decentralized optimization algorithms, are applied for solving the complex and non-convex combinatorial optimization problem associated with the power allocation and interference coordination. Simulation results demonstrate that the overall network throughput increases gradually to some degree with increasing numbers of MIMO antennas. In addition, increasing the number of clusters to a certain extent increases the overall network throughput, although internal interference becomes a severe problem for further increases in the number of clusters. Accordingly, applications of multi-robot networks require that a balance should be preserved between robot deployment density and communication capacity.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.7
• /
• pp.554-561
• /
• 2003

Results of the numerical simulation and experimental data analysis for identification of mode cutoff frequency and estimation of sound speed of seabed from the spectrum of acoustic signal received at fixed source-receiver range are presented. Model simulations for Pekeris waveguide show that the frequency-dependent propagation loss and interference pattern are closely related to mode cutoff frequencies and it could be possible to the identify them from the changes of interference pattern. The concept considered at numerical simulations is applied to signals acquired at sea test. Cutoff frequency and sound speed of seabed are estimated from the interference pattern of measured signal. Propagation loss predicted using the estimated sound speed of seabed as model input parameter shows similar estimation result compared to propagation loss derived from measured data.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.2
• /
• pp.215-220
• /
• 2009

LR-WPAN(Low-Rate Wireless Personal Area Network) hewn as IEEE 802.15.4 is considered as one of the most suitable specifications published until now to accomplish USN(Ubiquitous Sensor Network). In this paper we simulate interference effects to other systems if LR-WPAN will be used in 900MHz. In considering the current usage situation of 900MHz frequency band, we can think LR-WPAN shares the frequency band of $908.5{\sim}914MHz$ assigned for RFID/USN. The simulation results of the case of LR-WPAN and RFID/USN sharing the frequency band show that the probability of interference of LR-WPAN to CT1 and RFID is 2.5% and 2.1%, respectively. In order to avoid interference effects to public communications, simulations results show that the protection distance of about loom is needed.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.13 no.11
• /
• pp.831-837
• /
• 2003

This paper investigates the insertion loss of nosie barrier with a interference device, The efficiency of the conventional interference-type noise barrier depends on specific frequency, Thus this study is performed to improve the efficiency of the nosie barrierin the range of broadband frequency. by changing the shape of interference device and adding the channel with various depths, The boundary element method (BEM) is used to predict the insertion loss of noise barrier. Two-dimensional boundary element model is created to simulate the performance of long barrier with a line source.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.749-754
• /
• 2002

This paper investigates the insertion loss of nosie barrier with a interference device. The efficiency of the conventional interference-type noise barrier depends on specific frequency. Thus this study is performed to improve the efficiency of the nosie barrier in the range of broadband frequency, by changing the shape of interference device and adding the channel with various depths. The boundary element method (BEM) is used to predict the insertion loss of noise barrier. Two-dimensional boundary element model is created to simulate the performance of long barrier with a line source.