• Journal of the Korea institute for structural maintenance and inspection
• /
• v.14 no.5
• /
• pp.128-135
• /
• 2010

Polymer-modified cement mortar(PCM) has been widely used for strengthening of the concrete structures due to its excellent physical properties such as high strength and durability. Adhesive strength or behavior, on the other hands, between PCM and concrete is very important in strengthening the concrete member using PCM. Therefore the adhesive failure mechanism between PCM and concrete should be fully verified and understood. This study was performed to evaluate adhesive strength of PCM to the concrete by the direct pull-out test. In the direct pull-out tests, the adhesive strength under the various pre-treatment conditions such as immersion, thunder shower, freezing and thawing are evaluated. Also, the field direct pull-out test are performed to investigate the adhesive strength of mock-up test specimens. In the results of the test, the adhesive strength value by field test are lower than those of the standard curing condition. From these comparison and investigation, field test result was similar with the thunder shower test result. The results of the test was used to evaluate the korean industrial standard of polymer modified cement mortars for maintenance in concrete.

• Journal of the Korean GEO-environmental Society
• /
• v.8 no.6
• /
• pp.53-60
• /
• 2007

L/EPS, manufactured in the shape of block and used for civil engineering, is a lightweight material with an excellent resistance to compression, and provides a superb self-sufficient stability. EPS is a suitable material capable of resolving the problem of settlement and lateral flow if it is applied as the soil on soft ground. The Korean Standards (KS) has not yet proposed any testing method for use of EPS as an engineering banking material. Only its testing and quality ordinance as a heat insulation material has been standardized. The design criteria for EPS has been established and applied through the trial construction of KHC (Korea Highway Corporation) and quality test of manufacturer, but most studies on them have been confined to factory products. This study is focused on comparing and analyzing long-term durability by conducting cyclic load test, freezing and thawing test, absorption rate test and others. EPS used in the test was chosen from construction sites and factory products, focusing on the long-term durability of EPS depending on the passage of time. Unconfined compression test results indicated that the strength of collected samples was lower than factory products. While the triaxial compression test results indicated that the shear strength increased in proportion to the increase of confining pressure, and factory products had declining shear strength as the confining pressure rose.

• Clinical and Experimental Reproductive Medicine
• /
• v.19 no.2
• /
• pp.153-162
• /
• 1992

To solve the logistical problems of the sperm penetration assay (SPA) to provide just a sufficient number of hamster ova exactly when they are needed, a new method to cryopreserve the ova has been devised (1-step dehydration and 2-step thawing). After freezing & thawing of zona-intact (ZI) and zona-free (ZF) hamster ova according to this new method, the frozen-thawed ova were compared with fresh, control ova (FO) in terms of the degree of sperm penetration in SPA using semen samples from fertile donors, subfertile, and infertile male. Each sperm sample was capacitated for 42 hours inTEST-Yolk Buffer before insemination in SPA. In fertile doner, both the penetration rate and penetration index were lower in SPA using frozen ova (ZI; 92.4%, 6.2, ZF; 63.7%, 3.9) than those of SPA using fresh ova (99.3%, 8.4). There was a significant correlation between the penetration index of SPA using FO and ZI (p<0.001), and between those of SPA using FO and ZF and ova (p<0.001). In subfertile patient, both the penetration rate and penetration index were lowered in frozen ova (ZI; 62.3%, 1.3, ZF; 21.8%, 0.4) than those of fresh ova (74.8%, 1.8). There were significant correlation between the penetration rate and penetration index in ZI ova (p<0.05 and p<0.001, respectively). In infertile patient, both the penetration rate and penetration index were ZI; 3.1%, 0.0, ZF;0.0%, 0.0, respectively. There were significant correlation between the penetration rate and penetration index in ZI ova (p<0.05).

• Korean Journal of Animal Reproduction
• /
• v.13 no.2
• /
• pp.113-120
• /
• 1989

In order to determine the sex of preimplantation embryos prior to transfer in cattle, a series of experiments were carried out using 45 Holstein donor cows to examine the ovarian response on the gonadotropin and PGF2${\alpha}$, and the morphology of fresh embryos or frozen/thawed embryos after deep freezing at -196$^{\circ}C$. The sexing of embryos treated with the medium containing H-Y antiserum(10%, v/v) and FITC anti-mouse IgG(10%, v/v) were analysed by chromosomal analysis, and the sex of the embryos which survived were ascertain after delivering the pups. The results obtained were summarized as follows ; 1. The average number of developed follicle and corpus luteum per cow were 13.5 and 8.1, and the ovalation rate was 60.1%. 2. Of 220-ova recovered, 75(34.1%) were morula and 91(41.4%) were blastocyst, and the morphological normal and abnormal rate of ova recovered were 75.5% and 24.5%, respectively. 3. Of 39 frozen/thawed embryos, the scores of normal morula and blastocyst, after thawing were 79.2%(19/24) and 73.3%(11/15). The average rate of frozen/thawed embryos which appeared morphologically normal post thawing was 76.9%(30/39). 4. The sex ratio was measured using the embryos treated with immunofluorescence assay to examine the relationship between embryo developmental stage, sex ratio of morula stage embryo was 42.2%(19/45) fluorescing and 57.8%(26/45) non-fluorescing, on the other hand, the ratio switched to 46.8%(29/62) fluorescing and 53.2%(33/62) non-fluorescing embryo in blastocyst stage. The sex ratio was also measured between fresh and frozen/thawed embryos, fresh and frozen/thawed treated embryos were indicated 45.8%(38/83) fluorescing, 54.2%(45/83) non-fluorescing and 41.7%(10/24) fluorescing, 58.3%(14/24) non-fluorescing. This trend indicated the approximal sex ratio was 1 : 1. 5. The result of karyotype test showed the successful rate of sexing embryo is fluorescing and non-fluorescing was 21.2%(7/33) and 29.6%(8/27). The female to male ratio within 33 fluorescing was 28.6 : 71.4, and the ratio of 27 non-fluorescing embryos was 87.7 : 12.5. 6. Of the embryo transferred after assignment of H-Y phenotype, five of the fluorescing embryos survived to term, all was males. Whereas six non-fluorescing embryos also survived to term and the sexes of the calves were 1 male 5 female.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.19 no.2
• /
• pp.125-132
• /
• 2015

This paper presents an experimental investigation in order to evaluate fresh and hardened properties of LP (Limestone Powder) blended cement concrete. The cement contents of the mixtures are replaced by LP in the range of 10%, 15%, 25%, and 35%, while a control mixture is prepared with only OPC (Ordinary Portland Cement). The fresh concrete properties like slump and air content are similar to those of control mixture up to 35% of replacement ratio of LP, however a delay in setting time is evaluated. The hardened properties including compressive strength, flexural strength, and rapid freezing and thawing resistance shows similar results of control mixture up to 15% of replacement. Relatively lower strength development is evaluated over 25% replacement of LP. For accelerated carbonation test, resistance to carbonation rapidly decreases with increasing LP replacement ratio due to the limited amount of $Ca(OH)_2$. From the study, LP replacement under 15% can be adopted considering reduction of strength and resistance to carbonation.

• Journal of the Korea Concrete Institute
• /
• v.17 no.5 s.89
• /
• pp.743-750
• /
• 2005

High performance concrete containing silica fume for use in bridge deck overlay emerged as a viable type of bridge deck overlay that economic advantage in construction. They have gained acceptance in Europe, America and Canada in a relatively short time due to their low cost. In this study, high-performance concretes containing silica fume were tested and evaluated in the laboratory to assess their applicability for use in bridge deck overlay. It was conducted with experiments of mechanical and durability characteristics in compressive strength, flexural strength, chloride permeability, abrasion resistance, repeated freezing and thawing cycles and deicing salt scaling resistance. Laboratory test result describe that high-performance concrete containing silica fume for bridge deck overlay application shows most outstanding capacity.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.4
• /
• pp.1095-1104
• /
• 2014

This paper presents the results of experimental work on both strength characteristics and durability of concrete or mortar having 50% ground granulate blastfurnace slag(GBS) with different fineness levels (4,450, 6,000 and $8,000cm^2/g$). Compressive and split tensile strength test results indicated that the concrete with a higher fineness level of GBS exhibited a better strength development due to the acceleration of latent hydraulic property at the later curing stage compared with ordinary portland cement concrete. Meanwhile, it was found that a higher fineness level of GBS showed some negative effects on the resistance against freezing-thawing action. However, incorporation of GBS to concrete, irrespective of fineness levels, significantly enhanced the chloride ions penetration resistance. The resistance against sulfate attack of mortar with GBS was greatly dependent on the attacking sources from sulfate environments.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.21 no.4
• /
• pp.124-131
• /
• 2017

The purpose of this study is to evaluate the basic performance of cement mortar for repair using alumina cement and nitrite can be cured in low temperature environment. For this purpose, the repair mortar used in the domestic construction site was selected and the experimental evaluation was carried out by adjusting the mixing amount by substituting alumina cement and nitrite for the blending ratio. The experimental test results confirmed that alumina cement and nitrite were replaced with the repair mortar, the initial strength was improved. Also, the chemical resistance was improved, the shrinkage behavior was decreased, and the resistance to freezing and thawing was increased. As a result, applying alumina cement and nitrite at a ratio of 2:1 at 7.5%, the surface condition was maintained for 5 months or longer and it was judged to be excellent in practical use for external structures.

• Journal of Embryo Transfer
• /
• v.23 no.2
• /
• pp.115-118
• /
• 2008

Glycerol is the cryoprotectant most frequently used to freeze semen in several of species. The objective of the present study was to compare the effect of three different glycerol concentrations (4, 6 or 8%, v/v) on frozen-thawed dog sperm survival rate. Ejaculates from 9 dogs collected by digital manipulation were pooled and assessed by macroscopic and microscopic criteria. Semen was divided into 3 aliquots, which were centrifuged and the sperm pellets rediluted with first Tris-glucose-citric acid extender. After 1 h cooling at $4^{\circ}C$, second extender containing 4, 6 or 8% glycerol was added, respectively. The semen was loaded into 0.25 ml straws and frozen and stored in liquid nitrogen and thawed. Sperm vigor, live:dead spermatozoa ratio using HOS test, and sperm morphology using $Spermac^{(R)}$ stain were evaluated. After thawing, there were no significant differences among groups in vigor, viability and morphology. In conclusion, the three glycerol concentrations (4, 6 or 8%) can be used successfully in cryopreservation of canine semen. Therefore the use of 4% glycerol in the extender has less toxic effect and reduces of freezing injuries.

• Korean Journal of Animal Reproduction
• /
• v.10 no.1
• /
• pp.19-26
• /
• 1986

This experiment was carried out to investigate the effect of bovine serum ablumin (BSA), sugars, glycerol equilibration time, straw size and thawing method on the survival index and the morphology of frozen boar spermatozoa. The results obtained were summarized as follow: 1. When the semen frozen in BF5 dilutor as pellet form was thawed in BTS at 37$^{\circ}$and 50$^{\circ}C$, BF5 dilutor with fructose showed higher sperm survival index than that with dextrose, however, when the semen was thawed on dry test tube at 37$^{\circ}C$, BF5 dilutor with sucrose showed higher sperm survival index than with other sugars. 2 When the semen forzen in BF5 dilutor with straw and thawed at 37$^{\circ}C$, BF5 dilutor with dextrose showed higher sperm survival index than those with other sugars, and there was no difference in sperm survival index between 0.5 and 1.0 ml straws. 3. The sperm survival index of frozen sperm was significantly (P<0.05) improved due to addition of BSA (0.05%) to BF5 dilutor. 4. When the extended semen with BF5 dilutor contatining 0.01 to 0.05% of BSA was frozen in the straw, the semen without glycerol equilibration showed significantly (P<0.05) higher sperm survival index than those with 2, 4 and 6 hrs glycerol equilibration time. 5. The sperm frozen in BF5 dilutor with dextrose or fructose, sucrose and raffinose showed 77 to 88% in normal acrosome rate and no difference among sugars. 6. The frozen semen showed lower normal acrosome rate than the first and second diluted semen, whereas the frozen semen showed higher swollen, damaged and missing acrosome rate than the first and second diluted semen. 7. Damaged and missing acrosome rate of sperm head due to freezing was somewhat inhibited by addition of BSA (0.01 to 0.05) to the BF5 dilutor.