• International Journal of Naval Architecture and Ocean Engineering
• /
• v.13 no.1
• /
• pp.65-74
• /
• 2021

A key factor that governs the wave interferences of a submerged body is the dimensionless Froude number. Computational Fluid Dynamics (CFD) is used to describe the resistance force coefficients and the generated waves of two SUBOFF submarine models. Grid independence studies are performed on two cases, totally and shallowly submerged cases, with four sets of computing meshes. The highest peaks are marked by red points at given wavelengths, a line is fitted to those points with a least-squares approximation, and the half wake angle at multiple Froude numbers is defined between the fitted line and the centerline of the free surface. The results show that when the depth of the target is 1.1D, constructive interferences occur at Fn = 0.3 and 0.5, while destructive interference occurs at Fn = 0.35 with distortion of the waveform. The half wake angle is less than 19.47° because of the interference between the bow and stern wave systems.

• 유체기계공업학회:학술대회논문집
• /
• 2006.08a
• /
• pp.411-414
• /
• 2006

풍력 발전기의 블레이드는 다른 회전기와는 달리 항상 지면의 경계층, 요-에러에 의한 어긋난 유입류, 타워와의 간섭효과의 환경에서 운영된다. 따라서 정상운전상태에서도 이와 같은 환경에서 겪게 되는 공력하중의 해석이 블레이드의 설계에서 중요하게 요구된다. 본 연구에서는 이의 비정상 공력하중해석을 위하여 자유후류기법을 이용한 방법을 연구하였다. 특히, 타워와의 간섭해석을 위하여 FVE라 명명한 후류 모델을 개발하여 적용하였다.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11a
• /
• pp.318.2-318
• /
• 2002

Axial fans are widely used in heavy machines due to their ability to produce high flow rate fur cooling of engines. At the same time, the noise generated by these fans causes one of the most serious problems. This work is concerned with the low noise technique of discrete frequency noise. To calculate the unsteady resultant force over the fan blade in an unsymmetric engine room, Time-Marching Free-Wake Method is used. From the calculations of unsteady force on fan blades, noise signal of an engine cooling fan is calculated by using an acoustic similarity law. (omitted)

• Journal of the Korean Society of Safety
• /
• v.9 no.4
• /
• pp.77-84
• /
• 1994

A study is performed in order to design a effective ventilation equipment for the pollutants in workshop. The procedure has been used to calculate the flow in a confined rectangular space channel. A cross free stream is flowed from open space and jet stream including pollutants is injected from bottom area. Calculation results shows a wake region which exists immediarely downstream of the jet discharge and are compared with the experimental data. Calculation data are in good agreement with experimental results. A wake plays an important role on a stagnation of the pollutants. Thus ventilation equipment has to be designed without a stagnation region which give rise to concentration stratification. In this study, calculation parameters are the position and velocity of pollutants and fresh air from cross free stream. It is concluded that more measurements of local velocities, temperatures and concentrations of the pollutants.

• 유체기계공업학회:학술대회논문집
• /
• 1999.12a
• /
• pp.208-217
• /
• 1999

The present work describes the prediction method for the unsteady flow field and the acoustic pressure field of a ducted axial fan. The prediction method is comprised of time-marching free-wake method, acoustic analogy, and the Helmholtz-Kirchhoff BEM. The predicted sound signal of a rotor is similar to the experiment one. We assume that the rotor rotates with a constant angular velocity and the flow field around the rotor is incompressible and inviscid. Then, a time-marching free-wake method is used to model the fan and to calculate the flow field. The force of each element on the blade is calculated by the unsteady Bernoulli equation. Lowson's method is used to predict the acoustic source. The newly developed Helmholtz-Kirchhoff BEM for thin body is used to calculate the sound field of the ducted fan. The ducted fan with 6 blades is analysed and the sound field around the duct is calculated.

• International Journal of Aeronautical and Space Sciences
• /
• v.6 no.2
• /
• pp.84-96
• /
• 2005

Helical tip vortex is known as stable vortex structure, however the specific frequency component of far wake perturbation induces the vortex pairing in hover and axial flight. It is expected that the tip vortex pairing phenomena may happen in transition flight and very low advance ratio flight so that inflow may be most nonuniform in the low advance ratio flight. The objectives of this paper are that a tip-vortex instability during the transition from hover into very low advance ratio forward flight is numerically predicted to understand a physics by using a time-marching free-wake method. To achieve the objectives, numerical method is firstly validated in typical axial and forward flights cases. Present scheme with trim routine can predict airloads and inflow distribution of forward flight with good accuracy. Then, the transition flight condition is calculated. The rotor used in this wake calculation is a small-scale AH-1G model. By using a tip-vortex trajectory tracking method, the tip-vortex pairing process are clearly observed in transient flight($\mu$=0.03) and disappears at a slightly higher advance ratio($\mu$=0.05). According to the steady flight simulation at $\mu$=0.03, it is confirmed the tip-vortex pairing process is continued in the rear part of rotor disk and not occurs in the front part. Time averaged inflow in this case is predicted as smooth distribution.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2002.05a
• /
• pp.220-224
• /
• 2002

In this paper, flow in the wake region of a butterfly valve is studied numerically and experimentally. The disk angle of the valve is fixed as $30^{\circ}$ and the free stream velocity as 0.13m/s in the experiment. Numerical analysis is performed in similitude of the experiment. The standard LES model is used to represent the turbulence effect in the commercial code Fluent 5.5. It is shown that the numerical result is similar to the experimental result for the wake flow of a butterfly-type valve.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.16 no.3 s.108
• /
• pp.291-297
• /
• 2006

The BVI(blade vortex interaction) noise Prediction has been one of the most challenging acoustic analyses in helicopter aeromechanical Phenomenon. It is well known high resolution airloads data with accurate tip vortex positions are necessary for the accurate prediction of this phenomenon. The truly unsteady time-marching free-wake method, which is able to capture the tip vortices instability in hover and axial flights, is expanded with the rotor flapping motion and trim routine to predict unsteady airloads in forward and descent flights. And Farassat formulation 1-A based on the FW-H equation is applied for the noise prediction considering the blade flapping motion. Main objective of this study is to validate the newly developed prediction code. To achieve the objective, the descent flight condition of AH-1 OLS(operational loads survey) configuration is analyzed using present code. The predicted sectional thrust distribution and sectional airloads time histories show the present scheme is able to capture well the unsteady airloads caused by a parallel BVI. Finally, the predicted noise data, observed in two different positions where are 3.44 times of rotor radius far from the hub center, are quite reasonable agreements with the experimental data compared to the other analysis results.

• Proceedings of the KSME Conference
• /
• 2001.06e
• /
• pp.582-587
• /
• 2001

A numerical method using FLUENT code was employed to investigate fluid drag and lift forces on a cylinder in a group of circular cylinders, subjected to a uniform cross flow. The cylinders can be arranged in tandem or in a staggered arrangements relative to the free stream flow. A vortex street behind the cylinder pairs or jets between the cylinders forms according to the arrangements. Vibration on a cylinder can occurs due to vortex shedding, fluid-elastic stiffness and wake galloping. The flow is first investigated and then the forces acting on the cylinder are calculated. The lift and drag forces on an elastically mounted cylinder in the wake of an upstream fixed cylinder arise from the mean flow plus velocity and pressure gradients in the wake. The analytical results of two staggered cylinder were compared with the existing experimental ones for validation of the present method. The analytical results of the forces were in good agreement with the experimental ones. The present method can be used for the analysis of the fluid induced vibration where the group of circular cylinders are subjected to a cross flow.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.23 no.7
• /
• pp.864-870
• /
• 1999

An experimental study Is conducted in a four-vane linear cascade in order to examine the influence of the wake behind rectangular bars on the flow and heat transfer characteristics. Flow and heat transfer measurements are made for the inlet Reynolds number of 66000(based on chord length and free-stream velocity). Turbulent intensity and stress are measured using a hot-wire anemometer, and to measure the convective heat transfer coefficients on the blade surface liquid crystal/gold film Intrex technique is used. Each of experimental cases is characterized by the unsteadiness measured at the entrance of the cascade. The wake behind the rectangular bars enhances the turbulent motion of the flow in the cascade passage. It also promotes the boundary layer development and transition. The results show that heat transfer coefficients on the blade surface increase with increasing unsteadiness.