• Structural Engineering and Mechanics
• /
• v.23 no.3
• /
• pp.293-308
• /
• 2006

This paper presents a complete and consistent formulation to study the seismic response of a free-standing ship supported by an arrangement of n keel blocks which are all located in a dry dock. It is considered that the foundation of the system is subjected to both horizontal and vertical in plane excitation. The motion of the system is classified in eight different modes which are Rest (relative), Sliding of keel blocks, Rocking of keel blocks, Sliding of the ship, Sliding of both keel blocks and the ship, Sliding and rocking of keel blocks, Rocking of keel blocks with sliding of the ship, and finally Sliding and rocking of keel blocks accompanied with sliding of the ship. For each mode of motion the governing equations are derived, and transition conditions between different modes are also defined. This formulation is based on a number of fundamental assumptions which are 2D idealization for motion of the system, considering keel blocks as the rigid ones and the ship as a massive rigid block too, allowing the similar motion for all keel blocks, and supposing frictional nature for transmitted forces between contacted parts. Also, the rocking of the ship is not likely to take place, and the complete ship separation from keel blocks or separation of keel blocks from the base is considered as one of the failure mode in the system. The formulation presented in this paper can be used in its entirety or in part, and they are suitable for investigation of generalized response using suitable analytical, or conducting a time-history sensitivity analysis.

• Journal of Korean Academic Society of Home Health Care Nursing
• /
• v.6
• /
• pp.19-32
• /
• 1999

The purpose of this study was to develop of home nursing care classification and home health care costs of the free-standing home nursing care agency. This study was done through 3 steps The First stage, home nursing care classification was identified and classified by literature, review-committee and expert meeting. The second stage, cost elements for home nursing care visit were identified and accounted. That were divided into direct nursing care cost, indirect nursing care cost, management cost and transportation cost. Third stage, total cost of per visit was produced. Data were collected from 810 visits of 120 patients received home dare and from January. 1999 to November, 1999, and analysed with EXCEL program. The obtained results are as follows : 1. Home nursing care classification was consisted of 6 high level classification domain and 10 low level classification domain and 163 home nursing care behavior. 2. The cost of home nursing care per visit was 30,638 won which were direct and indirect nursing care cost(16.305won), management cost(5,255won) and transportation cost (9,098won). In conclusion. Home nursing behavior care classification developed in this study would be used as home health care standard. And the home nursing care costs can be used as a fundamental data for the further development of home health care costs in Korea.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.11
• /
• pp.702-706
• /
• 2016

We demonstrated that self-separation FS-GaN (freestanding-GaN) was grown on MELO (maskless epitaxially lateral overgrowth) GaN template by horizontal HVPE (hydride vapor phase epitaxy). Before thick GaN grwoth, MELO GaN template was grown on patterned GaN template by MOCVD (metal organic chemical vapor deposition). The laterally overgrown GaN would consist of a continuous well coalesced layer. The mixed TDD (threading dislocation density) of seed and wing region were $8{\times}10^8cm^{-2}$ and $7{\times}10^7cm^{-2}$, respectively. After thick GaN grown by HVPE, the self-separation between thick GaN and sapphire substrate was generated at seed region. The regions of self-separation for FS-GaN and sapphire were observed by FE-SEM. Moreover, Raman results indicated that the compressive strain of seed and wing regions at FS-GaN substrate were slightly released compared to that of thick GaN grown on conventional GaN template. The optical properties of the FS-GaN substrate were examined by using PL (photoluminescence). The PL exhibited that donor bound exciton and donor acceptor pair were observed at low temperature. The effects on optical and structural properties of FS-GaN substrate have been discussed in detail.

• Polymer(Korea)
• /
• v.35 no.6
• /
• pp.615-618
• /
• 2011

Carbon nanotubes (CNTs) draw attention as promising materials due to their excellent electrical and mechanical properties. However, the intrinsic strong interaction between CNTs presents a challenge to their use in various applications. Here, we present a facile method to disperse single-walled carbon nanotubes (SWCNTs) in a polar solution using a graft copolymer, poly(vinyl chloride)-graft-poly(oxyethylene methacrylate), PVC-g-POEM. The graft copolymer was synthesized via atom transfer radical polymerization (ATRP), as confirmed by gel permeation chromatography (GPC) and $^1H$ NMR spectroscopy. The SWCNTs were uniformly dispersed in a polar solvent such as dimethylsiloxane (DMSO) using PVC-g-POEM as a dispersant, due to interaction between CNT and the graft copolymer, as revealed by transmission electron microscopy (TEM) analysis. Upon removal of the solvent, free standing nanocomposite films with good homogeneity were obtained.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.18 no.4
• /
• pp.43-49
• /
• 2014

This experimental study has been conducted to scrutinize the effects of an ultrasonic standing wave (USW) on the propagating velocity and structure of methane/air premixed flame. Propagating flame was caught by high-speed Schlieren photography, and the variation of flame-behavior was analyzed in detail. It is revealed that horizontal splitting in burnt zone is resulted by the USW, and the flame propagation velocity is augmented due to the strengthened chemical reaction. Evolutionary feature of the flame perturbed by USW, maintaining a pseudo-symmetry of top and bottom flame-front about the propagation axis tends to be free from buoyancy effect.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.2
• /
• pp.858-864
• /
• 2017

This study aims to restrain free conducting wire-type particles which are commonly and dangerously existing within DC gas-insulated transmission lines. A realistic platform of a coaxial cylindrical electrode was established by using a high-speed camera and a partial discharge (PD) monitor to observe the motion, PD, and breakdown of these particles. The probabilities of standing or bouncing, which can be affected by the length of the particles, were also quantitatively examined. The corona images of the particles were recorded, and particle-triggered PD signals were monitored and extracted. Breakdown images were also obtained. The air-gap breakdown with the particles was subjected to mechanism analysis on the basis of stream theory. Results reveal that the lifting voltage of the wire particles is almost irrelevant to their length but is proportional to the square root of their radius. Short particles correspond to high bouncing probability. The intensity and frequency of PD and the micro-discharge gap increase as the length of the particles increases. The breakdown voltage decreases as the length of the particles decreases.

• Archives of Plastic Surgery
• /
• v.32 no.3
• /
• pp.281-286
• /
• 2005

The goal in facial paralysis treatment is to achieve the normal appearance of the face as well as to reconstruct the natural symmetrical smile. In cases of facial paralysis, a widely accepted procedure is the two stage method, which combines neurovascular free muscle transfer with cross face nerve grafting. Although the results are promising, the two operations of this method, which are about 1 year apart, impose an economic burden on the patients and require a lengthy period before results are obtained. In order to overcome these drawbacks, one stage method, using latissimus dorsi neurovascuular free muscle flap was introduced. Between January 2000 and January 2004, fifteen patients with long standing facial paralysis were treated in the Korea University Anam Hospital. The segmental latissimus dorsi with long nerve and pedicle was transferred to the paralyzed side of the face. The first postoperative movement of the transferred muscle was reported at 8.9 months, faster than that of the two stage method. During the next 24 months, a constant increase in the power of muscle contraction was observed. The fifteen cases were evaluated within an average of 31.7 months following the surgery and satisfactory results including muscle contraction were obtained in eleven of the cases but muscle contraction was not found in three cases.

• Korean Institute of Interior Design Journal
• /
• no.23
• /
• pp.100-108
• /
• 2000

The study intends to systematically arrange and classify the museum layouts in terms of their structure of exhibition space. The exhibition space, here, means the whole area where visitors are allowed to move and visit in museums. Through this, I tied to understand the characteristics and trends comparing and analyzing international and national exhibition space layout, and then grope the standard in case of establishing museum. The first criteria is based on the point of view that the typical museum experience is made in the exhibition space. Accordingly, the exhibition space can be grouped into two categories; one is 'room type' consisting mostly of individual rooms as in classical museums, and the other is 'open plan type' consisting free standing walls as in miesian free plan. The second criteria is dependent on the way how visitors move about in exhibition spaces. In other words, museum layouts can be categorized in terms of mutual connection between individual spaces including exhibition spaces and corridor spaces designated for the purpose of moving. consequently, the layouts can be categorized into five groups such as 'free plan', 'linear type', 'room to room', 'room & corridor' and 'composition type'. The third criteria is about the overall structure of museum layouts including such elements as whether it contains a certain type of central major space or not and whether and how the exhibition spaces are connected to it. By applying these classificatory criteria, the study analyzed and classified 90 sample of museum layouts in order to understand clearly and succintly the spatial characteristics and implications contained in them.

• Archives of Plastic Surgery
• /
• v.49 no.3
• /
• pp.448-452
• /
• 2022

Total reconstruction of the penis (TPR) represents a challenge for urologists and plastic surgeons, especially when urethral length is severely reduced. We here describe, for the first time in an oncologic scenario, a double flap phalloplasty using a pedicled anterolateral thigh (ALT) flap for penile reconstruction and a radial forearm free flap (RFFF) for complete neourethra and glans reconstruction following penile amputation. A 48-year-old patient came to our department following a total penectomy with inferior urethral derivation. The indication for a double flap phalloplasty was posed as only way to fully reconstruct the urethra on its length avoiding possible complications of single flap reconstruction using tube-into-tube technique. Both flaps healed uneventfully with no neourethral strictures or fistulas described. At 18 months follow-up, the patient was extremely satisfied with the aesthetic result and was able to void in standing position. We think that a double free tissue transfer for TPR should be considered, particularly when a urethral length > 14 cm needs to be reconstructed. While the pedicled ALT can be used to reconstruct a proper penile shaft with an easily concealed scar, the RFFF can provide adequate neourethra length with satisfactory sensory recovery at the neoglans.

• The Journal of the Acoustical Society of Korea
• /
• v.26 no.1
• /
• pp.32-41
• /
• 2007

The control room has been usually designed by the consideration of only one listening position for the sound engineer. By this study. many listening positions with the very similar acoustical condition were located in the specific region, so-called 'the reflection free zone', where the several engineer could evaluate the quality of sound at the same time. For constructing the reflection free zone, the control room has been designed by the concept of the $LEDE^{TM}$, and the initial time delay gap has been controled by the structure of control room and the properties of sound-absorbing materials. diffuser, Helmholtz resonator and image source of sound. The occurrence of any harmful phenomena like the standing wave, acoustic focusing. coloring. Hass effect and flutter echo, has greatly reduced in the reflection free zone.