• Proceedings of the Polymer Society of Korea Conference
• /
• 2006.10a
• /
• pp.175-175
• /
• 2006

Considering the number of chemosensors that have been developed for the sensing of metal ions, only a few chemosensors for fluoride anion have been described in the literature that are based on fluorescent or chromogenic responses. We performed colorimetric anion sensing based on the binding of anion analytes with hydrogen donor group in polymer backbone resulting in naked-eye color change and fluorescent quenching. Our challenges using hydrogen donor moiety was designed effectively are continuing in order for high selectivity and sensitivity for ultimate applications such as fluid solution sensing in biomolecules and gas vapor sensing.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2017.05a
• /
• pp.96.2-96.2
• /
• 2017

This research was conducted to investigate the electrochemical properties of the thin air-formed oxide film-covered AZ31 Mg alloy. In this work, native air-formed oxide films on AZ31 Mg alloy samples were prepared by knife-abrading method and the changes in the electrochemical properties of the air-formed oxide film were investigated in seven different electrolytes containing the following anions $Cl^-$, $F^-$, $SO{_4}^{2-}$, $NO_3{^-}$, $CH_3COO^-$, $CO{_3}^{2-}$ and $PO{_4}^{3-}$. It was observed from open circuit potential (OCP) transients that the potential initially decreased before gradually increasing again in the solutions containing only $CO{_3}^{2-}$ or $PO{_4}^{3-}$ ions, indicating the dissolution or transformation of the native air-formed oxide film into new more protective surface films. The Nyquist plots obtained from electrochemical impedance spectroscopy (EIS) showed that there was growth of new surface films with immersion time on the air-formed oxide film-covered specimens in all the electrolytes; the least resistive surface films were formed in fluoride and sulphate baths whereas the most protective film was formed in phosphate bath. The potentiodynamic polarization curves illustrated that passive behaviour of AZ31 Mg alloy under anodic polarization appears only in $CO{_3}^{2-}$ or $PO{_4}^{3-}$ ions containing solutions and at more than $-0.4V_{Ag/AgCl}$ in $F^-$ ion containing solution.

• Journal of Microbiology and Biotechnology
• /
• v.14 no.1
• /
• pp.140-147
• /
• 2004

Urokinase is an enzyme with fibrinolytic activity (plasminogen activator) isolated from fresh urine of healthy men. Viral safety is an important prerequisite for clinical preparation of the protein from urine. In order to increase the viral safety of a high purity urokinase in regard to non-enveloped viruses, a virus removal process using a novel polyvinylidene fluoride membrane filter (Viresolve NFP) has been optimized. Urokinase was able to pass through the filter with recoveries of 95% in the production scale process. No substantial changes were observed in physical and biochemical characteristics of the filtered urokinase in comparison with those of the enzyme before filtration. A 47-mm disk membrane filter was used to simulate the process performance of the production scale cartridges and tested if it could remove several experimental model viruses for human pathogenic viruses, including porcine parvovirus (PPV), human hepatitis A virus (HAV), murine encephalomyocarditis virus (EMCV), bovine viral diarrhoea virus (BVDV), and bovine herpes virus (BHV). Non-enveloped viruses (PPV, HAV, and EMCV) as well as enveloped viruses (BVDV and BHV) were completely removed during filtration. The log reduction factors achieved were $\geq$4.86 for PPV, $\geq$4.60 for HAV, $\geq$6.87 for EMCV, $\geq$4.60 for BVDV, and $\geq$5.44 for BHV. These results indicate that the virus filtration process successfully improved the viral safety of the final products.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.66-66
• /
• 2011

Anodic titanium dioxide (TiO2) nanotubes are very attractive materials for gas sensors due to its large surface to volume ratios. The most widely known method for fabrication of TiO2 nanotubes is anodic oxidation of metallic Ti foil. Since the remaining Ti substrate is a metallic conductor, TiO2 nanotube arrays on Ti are not appropriate for gas sensor applications. Detachment of the TiO2 nanotube arrays from the Ti Substrate or the formation of electrodes onto the TiO2 nanotube arrays have been used to demonstrate gas sensors based on TiO2 nanotubes. But the sensitivity was much lower than those of TiO2 gas sensors based on conventional TiO2 nanoparticle films. In this study, Ti thin films were deposited onto a SiO2/Si substrate by electron beam evaporation. Samples were anodized in ethylene glycol solution and ammonium fluoride (NH4F) with 0.1wt%, 0.2wt%, 0.3wt% and potentials ranging from 30 to 60V respectively. After anodization, the samples were annealed at $600^{\circ}C$ in air for 1 hours, leading to porous TiO2 films with TiO2 nanotubes. With changing temperature and CO concentration, gas sensor performance of the TiO2 nanotube gas sensors were measured, demonstrating the potential advantages of the porous TiO2 films for gas sensor applications. The details on the fabrication and gas sensing performance of TiO2 nanotube sensors will be presented.

• Journal of Periodontal and Implant Science
• /
• v.26 no.2
• /
• pp.557-566
• /
• 1996

It is known that some natural extracts from plants have a various range of antimicrobial and antiinflammatory activity. There are lots of clinical trials to develop toothpastes containing natural extracts for prevention of dental caries and gingival inflammation. The purpose of this study was to evaluate antimicrobial and antiinflammatory activity of magnolol containing toothpastes and other commercial toothpastes. Eleven kinds oftoothpastes were used. They include magnolol, sanguinarine, Myrrha, Mori radicis cortex,Cimicifugae rhizoma, sodium fluoride, aminocaprolactic acid etc. Six strains of bacteria were used for this test, ego Porphylomonas gingivalis, Prevotellain-termedia, Actinobacillus actinomy cetemcomitans, Streptococcus mutans, Stretococcus sanguis, and Actinomyces species. Antimicrobial activity was determined by an agar dillution method and a broth microdillution method. Antiinflammatory activity was assessed by the inhibition of $PGE_2$ production from gingival fibroblast with the addition of rHIL-1 and centrifuged solution of toothpastes. Control group was only rHIL-1 additive sample. $PGE_2$ enzyme immunoassay systemfAmersham, In. Buckinghamshire, U.K). $PGE_2$ level was measured by ELISA reader with 450 nm, The results from the study revealed that toothpastes containing natural extracts generally had high antimicrobial and antiinflammatory activity. Especially magnolol containing toothpaste showed higher antimicrobial activity than other toothpastes, and sanguinarine containing toothpaste showed particularly high antimicrobial activity in A. actinomicetemcomitans and A. viscosus. In some degree all toothpastes inhibited $PGE_2$ production, but magnolol containing toothpaste was potent inhibitor of $PGE_2$. Sodium chloride containing toothpaste had also effective result. The results suggested that toothpastes containing natural extracts were promising in plaque control and prevention of dental caries and gingivitis.

• Korean Chemical Engineering Research
• /
• v.51 no.5
• /
• pp.580-586
• /
• 2013

In this paper, polymer composite membranes and ceramic composite membranes were prepared in order to compare differences in pervaporation performances relative to the support layers. PVDF was used for the polymer support layers, and $a-Al_2O_3$ was used for the ceramic support layers. For active layer was coated for PDMS, which is a rubbery polymer. The characterization of membranes were analysed by SEM, contact angle, and XPS. We studied performances relative to the composite membrane support layers in the ABE mixture solutions. The results of the pervaporation, the flux of the ceramic composite membrane was shown to be $250.87g/m^2h$, which was higher than that of polymer composite membranes, at $195.64g/m^2h$. However, it was determined that the separation factor of the polymer composite membranes was 31.98 which were higher than that of the ceramic composite membranes, at 20.66.

• Membrane and Water Treatment
• /
• v.7 no.3
• /
• pp.241-255
• /
• 2016

In this study, the treatability of arsenic (As) contaminated water by direct contact membrane distillation (DCMD) at different delta temperatures (${\Delta}T$) 30, 40 and $50^{\circ}C$ has been investigated. Two different pore sizes ($0.22{\mu}m$ and $0.45{\mu}m$) of hydrophobic membranes made of polyvinylidene fluoride (PVDF) were used. The membrane pore sizes, the operating temperatures, the feed solution As concentration and conductivity have been varied during the experimental tests to follow the removal efficiency and flux behavior. Both membranes tested had high removal efficiency of arsenite (As (III)) and arsenate (As (V)) and all permeates presented As concentration far lower than recommended $10{\mu}g/L$ of world health organization (WHO). As concentration was below detection limit in many permeates. Conductivity reduction efficiency was over 99% and the transmembrane flux (TMF) reached $19L/m^2.h$ at delta temperature (${\Delta}T$) of $50^{\circ}C$ with PVDF $0.45{\mu}m$ membrane. The experimental results also indicated that $0.45{\mu}m$ pore sizes PVDF membranes presented higher flux than $0.22{\mu}m$ pore sizes membranes. Regardless of all operating conditions, highest fluxes were observed at highest ${\Delta}T$ ($50^{\circ}C$).

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.13 no.1
• /
• pp.43-46
• /
• 2010

As one of the methods for recycling the FRP used for the small and medium-sized waste ships, separation of the roving layer from the mat has some merit in a sense of the recycling energy and the environmental effects. Similar characteristics between the roving and the mat make the mechanically automatic differentiation difficult. They, however, contain different ratio of the resin and the glass and the thickness. In this study photo physical differentiation between the two layers has been made using (1) boiling concentrated sulfuric acid which can dissolve the resin in the FRP layer and (2) hydrogen fluoride(HF) solution which can reacts with $SiO_2$ fragments of the glass. Furthermore coloring the FRP sample with water-soluble dye following the HF treatment makes the roving layer more distinguishable photophysically. The implementation of HF treatment has been successfully tested in this study.

• Journal of Sensor Science and Technology
• /
• v.29 no.2
• /
• pp.93-99
• /
• 2020

A colorimetric paper sensor was used to detect volatile nitrogen-containing compounds emitted from spoiled salmon filets to determine their freshness. The sensing mechanism was based on acid-base reactions between acidic pH-indicating dyes and basic volatile ammonia and amines. A sensing layer was simply fabricated by drop-casting a dye solution of bromocresol green (BCG) on a polyvinylidene fluoride substrate, and its color-change response was enhanced by optimizing the amounts of additive chemicals, such as polyethylene glycol, p-toluene sulfonic acid, and graphene oxide in the dye solution. To avoid the adverse effects of water vapor, both faces of the sensing layer were enclosed by using a polyethylene terephthalate film and a gas-permeable microporous polytetrafluoroethylene sheet, respectively. When exposed to basic gas analytes, the paper-like sensor distinctly exhibited a color change from initially yellow, then to green, and finally to blue due to the deprotonation of BCG via the Brønsted acid-base reaction. The use of ammonia analyte as a test gas confirmed that the sensing performance of the optimized sensor was reversible and excellent (detection time of < 15 min, sensitive naked-eye detection at 0.25 ppm, good selectivity to common volatile organic gases, and good stability against thermal stress). Finally, the coloration intensity of the sensor was quantified as a function of the storage time of the salmon filet at 28℃ to evaluate its usefulness in monitoring of the food freshness with the measurement of the total viable count (TVC) of microorganisms in the food. The TVC value increased from 3.2 × 10⁵ to 3.1 × 10⁹ cfu/g in 28 h and then became stable, whereas the sensor response abruptly changed in the first 8 h and slightly increased thereafter. This result suggests that the colorimetric response could be used as an indicator for evaluating the degree of decay of salmon induced by microorganisms.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.3 no.2
• /
• pp.149-157
• /
• 2005

PFC(Perfluorocarbon) decontamination process is one of best methods to remove hot particulate adhered at inside surface of hot cell and surface of equipment in hot cell. It was necessary to develop a particulate filtration equipment to reuse PFC solution used on PFC decontamination due to its high cost and to minimize the volume of second wastewater. Contamination characteristics of hot particulate were investigated and then a filtration process was presented to remove hot particulate in PFC solution generated through PFC decontamination process. The removal efficiency of PVDF(Poly vinylidene fluoride), PP(Polypropylene), Ceramic(Al$_{2}$O$_{3}$ filter showed more than 95$\%$. The removal efficiency of PVDF filter was a little lower than those of other kiters at same pressure(3psi). A ceramic filter showed a higher removal efficiency with other filters, while a little lower flux rate than other filters. Due to inorganic composition, a ceramic filter was highly stable against radio nuclides in comparison with PVDF and PP membrane, which generate H$_{2}$ gas in e-radioactivity atmosphere. Therefore, the adoption of ceramic filter is estimated to be suitable for the real nitration process.