• Korean Journal of Weed Science
• /
• v.30 no.1
• /
• pp.25-33
• /
• 2010

Several experiments were conducted in growth chambers and a greenhouse to determine the influence of various environmental factors on seed germination and seedling emergence of Indian jointvetch. Fully matured seeds of Indian jointvetch germinated only 42%. The germination percent increased as the storage temperature increased with time. More than 90% seeds germinated when the seeds were kept at $40^{\circ}C$ for seven months, but germination was 58.9 and 55.1% when kept at 25 and $4^{\circ}C$, respectively. Non-dormant seeds of Indian jointvetch germinated 91.1 and 92.4% at 30 and $30/25^{\circ}C$, respectively. Germination percent increased with increasing both prethermal temperature and time. The prethermal temperature of $90^{\circ}C$ for 40 minutes was the best for maximum germination (94.5%). Germination and growth of Indian jointvetch tended to decrease slightly until -0.3 MPa osmotic potential (water stress induction) and then declined drastically and the seeds did not germinate at below -0.5 MPa osmotic potential. Indian jointvetch seems to grow well in moist and flooding conditions since emergence and growth of seedling increased with increasing soil moisture content and the water level.

• Journal of the Korean earth science society
• /
• v.33 no.7
• /
• pp.596-607
• /
• 2012

The R-Z relationship is one of important error factors to determine the accuracy of radar rainfall estimation. In this study, we have explored the effect of the R-Z relationships derived from disdrometer data in estimating the radar rainfall. The heavy rain event that produced flooding in St-Remi, Quebec, Canada has been occurred. We have tried to investigate the severity of rain for this event using high temporal (2.5 min) and spatial resolution ($1^{\circ}$ by 250 m) radar data obtained from the McGill S-band radar. Radar data revealed that the heavy rain cells pass directly over St-Remi while the coarse raingauge network was not sufficient to detect this rain event. The maximum 30 min (1 h) accumulation reaches about 39 (42) mm in St-Remi. During the rain event, the two disdrometers (POSS; Precipitation Occurrence Sensor System) were available: One used for the reflectivity calibration by comparing disdrometer Z and radar Z and the other for deriving disdrometric R-Z relationships. The result shows the significant improvement with the disdrometric reflectivity-dependent R-Z relationships against the climatological R-Z relationship. The bias in radar rain estimation is reduced from +12% to -2% and the root-mean squared error from 16 to 10% for daily accumulation. Using the estimated radar rainfall rate with disdrometric R-Z relationships, the flood event was well captured with proper timing and amount.

• Journal of Korea Water Resources Association
• /
• v.38 no.10 s.159
• /
• pp.825-839
• /
• 2005

Application of the EST approach for the simulation of the risk-based typhoon hazard potential is described in this paper. For six selected cities In the Korean peninsula, EST simulations for one hundred years were performed one hundred times using historical typhoon data as a training data set. The analytical results of EST simulations were then post-processed to estimate the means, standard deviations, and ranges of variation for the maximum wind velocities and the daily rainfalls. From the comparison of the averages of the wind velocities for the 100 year recurrence interval typhoons, the wind hazard potential of them was revealed to be highest for Mokpo among the six cities, followed by Busan, Cheju, Inchun, Taegu, and Seoul in descending order For the flood hazard potential associated with a typhoon, Busan was ranked to be the highest hazard potential area, followed by Mokpo, Cheju, Seoul, Inckun, and Taegu. In terms of the overall typhoon hazard potential, cities in the southern coastal regions were identified as being exposed to the most severe typhoon hazard.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.308-308
• /
• 2017

The low and unstable yield of soybean has been a major problem in Japan. Excess soil moisture conditions are one of the major factors to restrict soybean productivity. More than 80 % of soybean crops are cultivated in converted paddy fields which often have poor drainage. In central and eastern regions of Japan, the early vegetative growth of soybean tends to be restricted by the flooding damage because the early growth period is overlapped with the rainy season. Field observation shows that induced excess water stress in early vegetative stage reduces dry matter production by decreasing intercepted radiation by leaf and radiation use efficiency (RUE) (Bajgain et al., 2015). Therefore, it is necessary to evaluate the responses of soybean growth for excess water conditions to assess these effects on soybean productions. In this study, we aim to modify the soybean crop model (Sinclair et al., 2003) by adding the components of the restriction of leaf area development and RUE for adaptable to excess water conditions. This model was consist of five components, phenological model, leaf area development model, dry matter production model, plant nitrogen model and soil water balance model. The model structures and parameters were estimated from the data obtained from the field experiment in Tsukuba. The excess water effects on the leaf area development were modeled with consideration of decrease of blanch emergence and individual leaf expansion as a function of temperature and ground water level from pot experiments. The nitrogen fixation and nitrogen absorption from soil were assumed to be inhibited by excess water stress and the RUE was assumed to be decreasing according to the decline of leaf nitrogen concentration. The results of the modified model were better agreement with the field observations of the induced excess water stress in paddy field. By coupling the crop model and the ground water level model, it may be possible to assess the impact of excess water conditions for soybean production quantitatively.

• Ocean and Polar Research
• /
• v.25 no.3
• /
• pp.277-286
• /
• 2003

Nitrification performance of fixed film biofilters using coarse sand, loess bead, or styrofoam beads in biofilter columns 1 meter high and 30cm in diameter were studied at different hydraulic and organic matter loading rates. Synthetic wastewater was supplied to the culture tank in order to maintain desired TAN concentrations in inlet water to biofilters. All the biofilters were conditioned 5 months before start of sampling. TAN and $NO_2-N$ conversion rates increased with an increase in the hydraulic loading rate (HLR). However, the improvement in biofilter performance was not linearly correlated to HLR in styrofoam bead filters. This is mainly due to the characteristics of the styrofoam beads used. TAN conversion rates of sand filters increased with the increase of HLR up to $200m^3/m^2$. per day. No increase in the TAN conversion rate was observed at the highest HLR since flooding on the media surface took place. HLR had a significant impact on the TAN conversion rates in loess bead filter up to the highest HLR tested (P<0.05). TAN conversion rates were much less at organic matter loading rates of 9 and 18kg $O_2/m^3$ per day than those without the addition of organic matter in styrofoam bead filters. The addition of glucose resulted in a reduction of the TAN conversion rate from 540 to 284g $TAN/m^3$ per day. No significant difference of TAN conversion rates between the two organic matter loading rates was found (p<0.05). This indicates that the impact of organic matter on nitrification becomes less and less sensitive with an increase in the COD/TAN ratio. At an organic matter loading rate of 9kg $O_2/m^3$. per day, a great reduction of TAN conversion rates was observed in sand filters and loess bead filters. Clearly, organic matter can be one of the most Important Impacting factors on nitrification. $NO_2-N$ conversion rates showed a similar trend for TAN. Based on the TAN and nitrite conversion rates, styrofoam beads showed the best performance among the three filter media tested. Also, the low gravity and price of styrofoam beads make the handling easier and more cost-effective for commercial application. The results obtained at the highest organic matter loading rates can be used in the biofilter design in recirculating aquaculture system.

• Journal of Korea Water Resources Association
• /
• v.51 no.4
• /
• pp.301-311
• /
• 2018

Recently, the flood inundation caused by heavy rainfall in urban area is increasing due to global warming. The variability of climate change is described in the IPCC 5th report (2014). The precipitation pattern and hydrological system is varied by climate change. Since the heavy rainfall surpassed the design capacity of the pipeline, it caused great damage in metropolitan cities such as Seoul and Busan. Inundation in urban area is primarily caused by insufficient sewer capacity and surplus overflow of river. Inundation in urban area with concentrated population is more dangerous than rural and mountains areas, because it is accompanied by human casualties as well as socio-economic damage to recover destruction of roads, brides and underground spaces. In addition, various factors such as an increase in impervious area, a short time of concentration to outlet, and a shortage of sewer capacity's lack increase flooding damage. In this study, flood inundation analysis was conducted for vulnerable areas using XP-SWMM. Also, three structural flood prevention measures such as drainage pipeline construction, detention reservoir construction, and flood pumping station construction are applied as flood damage prevention alternatives. The flood data for each alternative were extracted by dividing the basin by grid. The Spatial Compromise Programming are applied using flood assessment criteria, such as maximum inundation depth, inundation time, and construction cost. The purpose of this study is to reflect the preference of alternatives according to geographical condition even in the same watershed and to select flood defense alternative considering regional characteristics.

• Journal of the Korean Institute of Traditional Landscape Architecture
• /
• v.35 no.4
• /
• pp.126-133
• /
• 2017

This study analyzed hydrological changes of stormwater runoff of Seolleung Jeongneung zone according to the application of LID system based on landscape Architectural technology. The results are as follows. First, when flooding occurred in Gwanghwamun in July 27, 2011, the maximum instantaneous rainfall amount was 183 mm/hr recorded at 10:00 on 27th for 10 minutes, and it was confirmed that rainfall intensity more than three times as high as the maximum rainfall of 57.5 mm/hr. Second, it is possible to control peak flow rate in the case of 1,500mm of soil thickness, so that it is possible to improve the vulnerability of flood damage in Seolleung and Jeongneung zone when applying the LID system. Third, in the berm height scenario, peak flow rate control was not controled in all depth level models, but the first stormwater runoff was delayed by 4 hours and 10 minutes compared to the soil thickness scenario. It was interpreted as a relatively important indicator the soil thickness for the initial stromwater runoff reduction and the berm height for the peak runoff. Through this, the systematic adaptation of landscape-friendly ecological factors within the cultural property protection zone could theoretically confirm the effects of flood disaster prevention.

• Journal of Wetlands Research
• /
• v.23 no.4
• /
• pp.307-316
• /
• 2021

Due to rapidly increased urbanization, impervious area has been extended and concerns about urban flooding has been increased as well. A lot of effort has been made to restore the urban water circulation. Low Impact Development (LID) technology that consist of retention, infiltration, and evapotranspiration has begun to attract attention to simulate the hydrologic phenomenon before and after development. Many researches on the technique is being actively conducted. In this study, the effect on reducing runoff in urban catchment was analyzed and evaluated by applying LID techniques using SWMM and six scenarios. A SWMM-LID model was built for the Gasan 1 rainwater pumping station basin, and Green Roof and Permeable Pavement were selected as LID techniques to be applied. As a result, the reduction effect of the permeable pavement was larger than green roof. In the future, the results could be used to design a LID facility using the characteristics of the watershed, and other urban water resource factors such as river and groundwater levels that affect each other should be considered, so that the entire system can be considered.

• Journal of Korean Society of Disaster and Security
• /
• v.14 no.2
• /
• pp.1-11
• /
• 2021

Recently, in Korea, the risk of meteorological disasters is increasing due to climate change, and the damage caused by rainfall is being emphasized continuously. Although the current weather forecast provides quantitative rainfall, there are several difficulties in predicting the extent of damage. Therefore, in order to understand the impact of damage, the threshold rainfall for each watershed is required. The damage caused by rainfall occurs differently by region, and there are limitations in the analysis considering the characteristic factors of each watershed. In addition, whenever rainfall comes, the analysis of rainfall-runoff through the hydrological model consumes a lot of time and is often analyzed using only simple rainfall data. This study used GIS data and calculated the threshold rainfall from the threshold runoff causing flooding by coupling two hydrologic models. The calculation result was verified by comparing it with the actual case, and it was analyzed that damage occurred in the dangerous area in general. In the future, through this study, it will be possible to prepare for flood risk areas in advance, and it is expected that the accuracy will increase if machine learning analysis methods are added.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.38 no.6
• /
• pp.793-800
• /
• 2018

It is necessary to determine an optimal design frequency for establishing stable flood control against frequent flood disasters. Depending on the importance of river and regional characteristics, design return periods are suggested from at least 50 years up to 200 years for river design. However, due to the wide range of applications, it is not desirable to reflect the geographical and flood control characteristics of river. In this study, Bayes theory was applied to seven evaluation factors to determine the optimal design return period of rivers in Chungcheongnam-do; urbanization flooded area, watershed area, basin coefficient, slope, water system and stream order, range of backwater effect, abnormal rainfall occurrence frequency. The potential flood damage (PFD) capacity was estimated considering climate change and the appropriate design return period was determined by analyzing the capacity of each district. We compared the design return periods of 382 rivers in Chungcheongnam-do with the existing design return periods. The number of rivers that were upgraded from the existing return period were 65, which have relatively large flooding areas and have large PFDs. Whereas, the number of rivers that were downgraded were 169.