• 한국전기전자재료학회논문지
• /
• 제32권3호
• /
• pp.219-222
• /
• 2019

In this study, we fabricated plate-type shunt resistors with thermal stability by parallelly connecting metal alloy plates with positive temperature coefficient of resistance (TCR) and carbon nanotube (CNT) plates with negative TCR. The metal alloy plates, which were prepared by alloying Cu and Mn with a composition of 91 wt% of Cu and 9 wt% of Mn, showed around $800ppm/^{\circ}C$ of TCR, and the CNT plates prepared from the CNT solution by using the vacuum filtration method showed around $-800ppm/^{\circ}C$ of TCR. The shunt resistor that was fabricated by stacking metal alloy plates and CNT plates in this work showed about $46.93ppm/^{\circ}C$ of TCR. Therefore, we conclude that a shunt resistor with low TCR can be realized by simply adjusting the TCR of the metal alloy only, because the TCR of the CNT plate has an identical value.

• 한국정밀공학회지
• /
• 제32권10호
• /
• pp.903-909
• /
• 2015

In this study, we used GO (graphene oxide) in order to enhance the adhesion between Ag NWs (nanowires) and substrates. By using a mixture solution of GO and Ag NW, a vacuum filtration process was used to fabricate a 50nm diameter thin film. Next, by using a light annealing process, the mechanical and electrical stability of Ag NW network was improved without any other treatment. The physical properties of the Ag NW - GO hybrid transparent conductive thin film was characterized in terms of a bending test, resistance and transmittance test, and nanoscale imaging using field-emission scanning electron microscopy.

• 약학회지
• /
• 제34권4호
• /
• pp.252-261
• /
• 1990

Arachidonic acid which is precursor of prostaglandins, when administered ($100.0\;{\mu}g/kg$, or $100.0\;{\mu}g/kg/min$) intravenously, did not influence on renal function of dog. Arachidonic acid, when infused ($10.0\;{\mu}g/kg/min$) into a renal artery, produced marked diuretic action accompanied with augmentation of renal plasma flow and with little changed glomerular filtration rate, and exhibited the increased clearances of osmolar substance and free water, and the decreased reabsorption rates of sodium and potassium in renal tubules in only experimental kidney, but did not influenced at all in control kindey. The diuretic acition of arachidonic acid infused into a renal artery was not affected by pretreatment of indomethacin (10.0 mg/kg. i.v) which is inhibitor of cyclooxygenase. Above results suggest that arachidonic acid infused into a renal artery produced diuretic action through direct renal hemodynamic changes, that is mediated by reduction of postglomerular resistance being caused by dilation of vas efferense.

• 펄프종이기술
• /
• 제36권2호
• /
• pp.10-16
• /
• 2004

Structures and strengths of paper have been studied by analyzing fibers characteristics depending on refining methods. Mixing ratio of softwood and hardwood fibers and fibers characteristics have been analyzed for paper quality improvement. In this study flocculation and drainage of fibers were analyzed to improve the production efficiency and paper product's quality. Floc size and drainage rate depending on stock consistency and fines content were analyzed. Total amount of drainage during drainage process was measured quantitatively by using DI(drainage index). Floc size, viscosity of floc and dewatering times were also measured. In the case of refining load $2.8 kg_f$ , drainage was occurred by filtration mechanism rather than thickening mechanism because drainage resistance increased by fibrillation of fibers. Therefore, the drainage rate of $2.8 kg_f$ refining load stock was slower than that of $5.6 kg_f$.

• 펄프종이기술
• /
• 제32권3호
• /
• pp.1-9
• /
• 2000

The MDDA (Modified Dynamic Drainage Analyzer) was developed to evaluate the drainage characteristics on paper machine. The initial forming vacuum velocity was decreased with the increase of stock consistency and there were no significant effects of the applied vac-uum. On the other hand the initial forming drainage velocity was rapidly decreased with the increase of stock consistency above the 0.35 bar of applied vacuum. The final drainage time and wet web permeability showed similar trends under 0.075% consistency but increased rapidly at the higher consistencies. SFR(Specific Filtration Resistance) and drainage obtained for different vacuum level applied and deposited weights measured by using MDDA showed the linear relationship.

• 한국막학회:학술대회논문집
• /
• 한국막학회 1998년도 춘계 총회 및 학술발표회
• /
• pp.22-24
• /
• 1998

1. INTRODUCTION : The phase inversion method is widely used to prepare a variety of polymeric membranes ranging from micro-filtration to gas separation. The final morphology obtained by immersion precipitation strongly reflects the thermodynamics and kinetics of the system involved. The equilibrium thermodynamics of the ternary system of polymer/solvent/ nonsolvent is still very important to understand and predict membrane structure. Polysulfone (PSf) and polyethersulfone (PES) are important polymers as membrane materials due to the chemical resistance, mechanical strength, thermal stability and transport properies. There are several reports on the experimental phase diagrams in ternary mixtures of PSf/solvent/nonsolvent, and PES/solvent/nonsolvent. It would be interesting to investigate the solution thermodynamics containing these two polymers since PES is slightly less hyclrophobic than PSf.

• 한국막학회:학술대회논문집
• /
• 한국막학회 1998년도 춘계 총회 및 학술발표회
• /
• pp.105-109
• /
• 1998

1. Introduction : In microfiltration the transport, deposition and removal of particles control cake formation on a filter. In this connection a new model on cake formation, based on the wall shear stress, was tested here in comparison with experiments of fine particle slurry under Taylor-vortex flow. The model expresses the deposition process for particles as two first-order steps in series of mass transfer and adhesion, and their removal process as a linear relation to the wall shear stress. This embraces characteristics of both dead-end and crossflow filtration. The correlation resulting from fitting to experimental data represented the experimental data reasonably well. This study will be helpful in analyzing fouling in heat exchangers.

• 한국환경보건학회지
• /
• 제35권1호
• /
• pp.58-63
• /
• 2009

This study investigated improvement to sludge dewaterability and coagulation for sewage treatment plant sludge by using sodium hypochlorite solution (NaOCl), ferric sulfate [$Fe_2(SO_4)_3$] and zeolite. The specific resistance to filtration(SRF), chloride, pH and turbidity were used to evaluate the sludge dewatering behaviors. The results of study were as follows: By varying the amount of NaOCl added the optimum result in terms of enhancement for pretreatment occurred when 34 mg/l of NaOCl was injected. When the total solids concentration of the sludge was 10,000 mg/l, the optimum ferric sulfate dosage for the sludge dewaterability was 150 mg/l and the corresponding SRF was $1.7{\times}10^7sec^2/g$. It was observed that injecting zeolite into sludge was effective in improving the dewaterability of sludge.

• Korean Membrane Journal
• /
• 제11권1호
• /
• pp.15-20
• /
• 2009

The periodic water-back-flushing using permeate water was performed to minimize membrane fouling and to enhance permeate flux in tubular ceramic ultrafiltration (UF) system for Gongji stream water treatment in Chuncheon city. The filtration time (FT), which was the water-back-flushing period, 2 min with periodic 15 sec water-back-flushing showed the highest value of dimensionless permeate flux ($J/J_o$), and the lowest value of resistance of membrane fouling ($R_f$), and we acquired the highest total permeate volume ($V_T$) of 6.35 L. Consequently FT 2 min at back-flushing time (BT) 15 sec could be the optimal condition in advanced UF water treatment of Gongji stream. Then the average rejection rates of pollutants by our tubular ceramic UF system were 99.4% for Turbidity, 31.8% for $COD_{Mn}$, 22.6% for $NH_3$-N and 65.9% for T-P.

• Korean Membrane Journal
• /
• 제11권1호
• /
• pp.21-28
• /
• 2009

We investigated the effect of organic materials on membrane fouling in advanced drinking water treatment by a hybrid module packed with granular activated carbon (GAC) outside multi-channel ceramic microfiltration membrane. Synthetic water was prepared with humic acid and kaolin to simulate natural water resouces consisting of natural organic matter and inorganic particles. Kaolin concentration was fixed at 30 mg/L and humic acid was changed as 2~10 mg/L to inspect the effect of organic matters. Periodic back-flushing using permeate water was performed for 10 sec per filtration of 10 min. As a result, both resistance of membrane fouling (Rf) and permeate flux (J) were influenced highly by concentration of humic acid. It proved that NOM like humic acid could be an important factor on membrane fouling in drinking water treatment. Turbidity and UV254 absorbance were removed up to above 97.4% and 59.2% respectively.