• 한국음향학회지
• /
• 제35권3호
• /
• pp.216-222
• /
• 2016

3차원 잡음환경에서 정숙공간은 현실적으로 매우 중요한 문제이다. 본 논문은 3차원 잡음 환경에서 정숙 공간의 성능을 크기와 소음제거 면에서 향상시키는 다채널 실시간 능동소음 제어시스템의 개발과 구현을 다루고 있다. 제안된 능동소음제어 시스템은 delay-compensated Filtered-X Least Mean Square (FXLMS) 알고리즘을 적용한다. 이와 같은 시스템의 실시간 적용을 위해서 TMS320C6713 DSP 프로세서 기반으로 설계되었다. 제안된 실시간 다채널 능동소음제어기의 성능평가는 100 ~ 500 Hz 범위의 다양한 잡음 환경에서 잡음제거를 수행하고, 정숙공간에서 음압레벨(Sound Pressure Level, SPL)측정하여 평가하였다. 실험결과는 정숙공간의 크기는 만족스러우며 최대 24 dB의 소음 감쇄가 성공적으로 생성된 것을 보여준다.

• 한국소음진동공학회논문집
• /
• 제19권3호
• /
• pp.251-260
• /
• 2009

In this paper, we studied on an attenuation effect of automobile exhaust noise according to the direction of canceling speaker in ANC system. Automobile exhaust noise was recorded at 800 rpm, 3500 rpm and 5000 rpm of a diesel engine. Directions of canceling speaker can be set to $30^{\circ}$, $90^{\circ}$ and $150^{\circ}$ against the primary noise flow by acrylic ducts to be made for the experimentation. DSP board with TMS320C6416 chip of Texas Instrument Co. used to control the ANC system. The algorithm of this ANC system applied the Filtered-x-LMS algorithm that is modified to compensate for a property of DSP input signal and the secondary-path effect. As an experiment result, the direction of canceling speaker was proved to influence the reduction effect of noise. The $150^{\circ}$ duct in the attenuation effect of noise showed a better result than the $90^{\circ}$ or $30^{\circ}$ duct.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.433-434
• /
• 2007

In this paper, active control of noise in a HVAC duct is considered. Most adaptive control filters have used FIR structures based on filtered-x LMS algorithms. But, the IIR structures are more desirable for the active control of duct noise in order to remove the poles introduced by the acoustic feedback and presented an algorithm to adjust the coefficients of an IIR filter using the recursive least mean square (RLMS) algorithm. A smoothed LMS algorithm is proposed to improve a convergent speed of filter parameters when the noise is wide band and power of input is time varying. And computer simulations have performed to show the effectiveness of the proposed algorithm.

• 전자공학회논문지S
• /
• 제34S권12호
• /
• pp.106-113
• /
• 1997

While driving, the low frequency interior noise below 200Hz causes the main component that irritates the auditory acoustic sense. But these passive control methods bring out increment in cost and weight of the vehicle and result in low efficiency. Recently, various ANC(Active Noise Control) methos to suppress the low frequency noise began to launch into application. In this study, we implemented the active noise control system for passenger vehicle to cancel the engine booming noise using DSP-based control unit, 4 micorphones, and 2 speakers. We used MEFX-LMS (Multiple Error Filtered X-Least Mean Square) algorithm since it can be easily implemented in real time. Also, MEFX-RLS algorithm was taken to enhance the suppression of the harmonic components of the engine booming noise inspite of its computational complexity. The performance of two adaptive algorithms were analyzed with experimental resutls.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 1998년도 춘계학술대회논문집; 용평리조트 타워콘도, 21-22 May 1998
• /
• pp.670-677
• /
• 1998

Many of the adaptive noise control systems utilize a form of the least mean square (LMS) algorithm. In the active control of noise, it is common practice to locate an error microphone far from the control source to avoid the near-field effects by evanescent waves. Such a distance between the control source and the error microphone makes a certain level of time-delay inevitable and, hence, may yield undesirable effects on the convergence properties of control algorithms such as filtered-x LMS. This paper discusses the dependence of the convergence rate on the acoustic error path in these popular algorithms and introduces new algorithms which increase the convergence region regardless of the time-delay in the acoustic error path. Performances of the new LMS algorithms are presented in comparison with those by the conventional algorithms based on computer stimulations and experiments.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제53권12호
• /
• pp.827-833
• /
• 2004

In active noise control (ANC) systems, the error-reduction performance of the conventional Filtered-X Least Mean Square (FXLMS) algorithm may be affected by nonlinear distortions in the secondary path such as in the power amplifiers, loudspeakers and transducers. In this paper, a nonlinear FXLMS algorithm with high error-reduction performance is proposed to compensate for undesirable nonlinearities in the secondary-path of ANC systems by employing the inverse Volterra filtering approach. In particular, the proposed approach is based on the utilization of the conventional P-th order inverse approach to nonlinearity compensation in the secondary path of ANC systems. Finally, the simulation results showed that the proposed approach yields a better nonlinearity compensation performance for the ANC systems with a nonlinear secondary path than the conventional FXLMS.

• 한국정밀공학회지
• /
• 제18권9호
• /
• pp.71-81
• /
• 2001

This paper analyzes the effectiveness of minimizing vibration and sound transmission on/through a thin rectangular plate by both feedback control and hybrid control which combines adaptive feedforward control with a feedback loop. An experimental system identification technique using the matrix-fractional curve-fitting of the frequency response data is introduced for complex shaped structures. This identification technique reduces the model order o the MIMO(Multi-Input Multi-Output) system which simplifies the practical implementation. The adaptive feedforward control uses a Multiple filtered-x LMS(Least Mean Square) algorithm and the feedback control uses a multivariable digital LQG(Linear Quadratic Gaussian) algorithm. Experimental results show that an effective reduction of sound transmission is achieved by the hybrid control scheme when both vibration and noise measurement signals are incorporated in the controller.

• 전자공학회논문지
• /
• 제50권9호
• /
• pp.172-176
• /
• 2013

This paper presents a modified filtered-x least mean square (FxLMS) algorithm to improve the stability of active noise control (ANC) system in realistic environment. A real-time ANC system employing modified FxLMS is designed and implemented on digital signal processor (DSP) board. The ANC system is evaluated for cancelling various tonal frequency noises in the range from 100 to 500 Hz and the performance is measured in terms of sound pressure level (SPL) attenuation. Experiment results show that a quiet zone with maximum 20 dB SPL attenuation can be generated around the location of error microphone.

• 소음진동
• /
• 제10권6호
• /
• pp.1048-1058
• /
• 2000

본 논문에서는 압전 세라믹 재료를 작동기 및 감지기로 이용한 사각 경계면이 고정된 얇은 사각평판의 능동 진동제어 방법을 제시한다. 실험 데이터에 기초한 다중 입출력계의 주파수영역 모델링방법을 이용하여 분포된 센서 및 구동기 특성이 포함된 구조물의 동적 특성이 규명된다. 제어기 구조로는 혼합형을 채택하고 되먹임 제어기는 LQG 제어기법에 의해 설계된다. 앞먹임 제어기는 다중 filtered-$x$ 최소자승오차법에 의해 적응되도록 한다. 진동제어에 대한 시뮬레이션 및 실험결과는 제안된 제어기법이 지속적 외란 및 과도적 외란에 효율적으로 적용될 수 있음을 보인다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2004년도 추계학술대회논문집
• /
• pp.1016-1019
• /
• 2004

The study of the noise reduction of an automobile has been concentrated on the reduction of the automotive engine noise because the engine noise is the major cause of automotive noise. However, many studies of automotive engine noise led to the interest of the noise reduction of the exhaust and intake system. The method of the reduction of the induction noise can be classified by the method of passive control and the method of active control. However, the passive control method has a demerit to reduce the effect of noise reduction at low frequency (below 500Hz) range and to be limited by a space of the engine room. Whereas, the active control method can overcome the demerit of passive control method. The algorithm of active control is mostly used the LMS (Least-Mean-Square) algorithm because the LMS algorithm can easily obtain the complex transfer function in real-time. Especially, Filtered-X LMS (FXLMS) algorithm is applied to an ANC system. However, the convergence performance of LMS algorithm goes bad when the FXLMS algorithm is applied to an active control of the induction noise under rapidly accelerated driving conditions. So, in order to this problem, the modified FXLMS algorithm using Moving Bandpass Filter was proposed. In this study, MBPF was implemented and use ANC for automotive intake under revived rapidly accelerated driving conditions and it was verified its performance.