• 대한조선학회논문집
• /
• 제51권5호
• /
• pp.435-449
• /
• 2014

The effects of the gravity field and the free surface on the cavity shape and the drag are investigated through a numerical analysis for the steady supercavitating flow past a simple two-dimensional body underneath the free surface. The continuity and the RANS equations are numerically solved for an incompressible fluid using a $k-{\epsilon}$ turbulence model and a mixture fluid model has been applied for calculating the multiphase flow of air, water and vapor using the method of volume of fluid and the Schnerr-Sauer cavitation model. Numerical solutions have been obtained for the supercavitating flow about a two-dimensional $30^{\circ}$ wedge in wide range of depths of submergence and inflow velocities. The results are presented for the cavity shape, especially the length and the width, and the drag of the wedge in comparison with those of the case for the infinite fluid flow neglecting the gravity and the free surface. The influences of the gravity field and the free surface on the aforementioned quantities are discussed. The length and the width of the supercavity are reduced and the centerline of the cavity rises toward the free surface due to the effects of the gravity field and the free surface. The drag coefficient of the wedge, however, is about the same except for shallow depths of submergence. As the supercavitating wedge is approaching very close to the free surface, it is found the length and the width of a cavity are shorten even though the cavitation number is reduced. Also the present result suggests that, under the influence of the gravity field and the free surface, the length of the supercavity for a certain cavitation number varies and moreover is proportional to the inverse of the submergence depth Froude number.

• 한국전기전자재료학회논문지
• /
• 제36권6호
• /
• pp.609-613
• /
• 2023

In this paper, a 1,200 V Si-based IGBT used in electric vehicles and new energy industries was designed. A field stop IGBT with a separate gate structure, which is the proposed structure, was designed to change trench depth and split gate width variables. Then, the general trench structure and electrical characteristics were compared and analyzed. As a result of conducting the trench depth experiment, it was confirmed that the breakdown voltage was the highest at 6 ㎛, and the on-state voltage drop was the lowest at 3.5 ㎛. In the separate gate width experiment, it was confirmed that the breakdown voltage decreased as the variable increased, and the on-state voltage drop increased. Therefore, it may be seen that it is preferable not to change the width of the separate gate. In addition, experiments show that there is no difference in on-state voltage drop compared to a structure in which a general field stop structure has a separate gate structure. In other words, it is determined that adding a dummy gate with a separate gate structure to the active cell will significantly improve the on-voltage drop characteristics, while confirming that the on-voltage drop does not change, and while having excellent characteristics in terms of breakdown voltage.

• Journal of Magnetics
• /
• 제5권3호
• /
• pp.90-98
• /
• 2000

The change in the magnetic properties of a spin-valve multilayer with the structure IrMn (9 m)/CoFe (4 nm)/Cu (2.6 nm)/CoFe (2 nm)/NiEe (6 nm) is investigated as a function of the size and the aspect ratio. At a fixed aspect ratio (the length/width ratio) of 2, the magnetostatic interactions begin to affect the magnetic properties substantially at a spin-valve length of 5 $\mum$, and, at a length of 1 $\mum$, they become even more dominant. In the case of a fixed multilayer size (2.4 $\mum$) which is indicated by the sum of the length and the width, magnetization change occurs by continuous spin-reversal and M-H loops are characterized by no or very small hysteresis at aspect ratios smaller than unity, At aspect ratios greater than unity, magnetization change occurs by spin-flip resulting in squared hysteresis loops. A very large changes in the coercivity and the bias field is observed, and these results are explained by two separate contributions to the total magnetostatic interactions: the coercivity by the self-demagnetizing field and the bias field by the interlayer magnetostatic interaction field.

• 한국도로학회논문집
• /
• 제18권1호
• /
• pp.73-83
• /
• 2016

PURPOSES : The purpose of this study is to develop a method for improving the accuracy of analysis results obtained from a two-dimensional (2-D) numerical analysis model of continuously reinforced concrete pavement (CRCP). METHODS : The analysis results from the 2-D numerical model of CRCP are compared with those from more rigorous three-dimensional (3-D) models of CRCP, and the relationships between the results are recognized. In addition, the numerical analysis results are compared with the results obtained from field experiments. By performing these comparisons, the calibration factors used for the 2-D CRCP model are determined. RESULTS : The results from the comparisons between 2-D and 3-D CRCP analyses show that with the 2-D CRCP model, concrete stresses can be overestimated significantly, and crack widths can either be underestimated or overestimated by a slight margin depending on the assumption of plane stress or plane strain. The behaviors of crack width in field measurements are comparable to those obtained from the numerical model of CRCP. CONCLUSIONS : The accuracy of analysis results from the 2-D CRCP model can be improved significantly by applying calibration factors obtained from comparisons with 3-D analyses and field experiments.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제17권2호
• /
• pp.260-264
• /
• 2017

Process variation effect on arch-structured gate stacked array (GSTAR) 3-D NAND flash is investigated. In case of arch-structured GSTAR, a shape of the arch channel is depending on an alignment of photo-lithography. Channel width fluctuates according to the channel hole alignment. When a shape of channel exceeds semicircle, channel width becomes longer, increasing drain current. However, electric field concentration on tunnel oxide decreases because less electric flux converges into a larger surface of tunnel oxide. Therefore, program efficiency is dependent on the process variation. Meanwhile, a radius of channel holes near the bottom side become smaller due to an etch slope. It also affects program efficiency as well as channel width. Larger hole radius has an advantage of higher drain current, but causes degradation of program speed.

• 한국음향학회지
• /
• 제18권7호
• /
• pp.75-79
• /
• 1999

다중채널 탄성파 음원배열에서 불발 음원에 따라 탐사 성능에 미치는 영향을 확인하기 위하여 음원배열의 빔 패턴과 원거리장 파형 변화를 비교 분석하였다. 원거리장 파형의 주신호 진폭은 전체 건 부피의 약 40%에 해당하는 음원들이 불발을 일으킬 경우, 탐사성능이 66% 정도 유지되는 것으로 확인되었다. 154㎐에서 같은 간격의 음원들이 불발 시에는 배열 형태와 관계없이 길이 및 폭 배열의 빔 폭이 동일하게 나타난다. 길이 배열의 빔 패턴에서는 불발된 음원의 부피가 증가됨에 따라 빔 폭이 41°에서 34°로 좁아지는 경향을 나타낸다. 따라서 부피가 작은 음원 배열일수록 빔폭이 좁고 양호한 파형이 생성되므로 작은 에너지가 요구되는 천부 지층탐사에 적합한 것으로 확인되었다.

• Journal of Biosystems Engineering
• /
• 제43권1호
• /
• pp.30-36
• /
• 2018

Purpose: The objective of this study is to evaluate the effect of cultivation conditions on the growth and glucosinolate content of Chinese cabbage and kale. Methods: Chinese cabbage and kale were grown in three different cultivation conditions, including a plant factory, greenhouse, and open field. Samples were collected at two harvesting times (10 d and 20 d after transplanting the seedlings). Nine growth parameters (plant height, plant width, number of leaves, petiole diameter, SPAD readout, leaf length, leaf width, stem diameter, and plant weight) were measured immediately after harvesting, and the samples were freeze-dried and stored until the glucosinolate content was analyzed. Mean values of the growth parameters and glucosinolate contents were evaluated using Duncan's multiple range tests. Results: The results indicated that the plant parameters of the Chinese cabbage and kale were greater for plants grown in the plant factory and greenhouse. The plant height, width, and weight showed significant differences in the Duncan's multiple range tests at a 5% level. The plant factory also produced greater contents of most of the glucosinolates. Conclusions: Three different cultivation conditions significantly affected the growth and glucosinolate contents of Chinese cabbage and kale. Further study is necessary to investigate other functional components and different vegetable varieties.

• Journal of Mechanical Science and Technology
• /
• 제15권1호
• /
• pp.117-124
• /
• 2001

This paper presents turbulent characteristics of an impinging F-O-O-F type injector in which fuel ad oxidizer impinge on each other to atomize under the different momentum ratio. Water was used as an inert simulant liquid instead of fuel and oxidizer. The droplet size and velocity in the impinging spray flow field were measured using a PDPA. The gradient of the spray half-width(b$_2$) along the long-axis direction declined throughout the entire spray flow field with increasing the momentum ratio from 1.19 to 6.48. However, the gradient of the half-width(b$_1$) along the short-axis direction decreased with increasing the momentum ratio. The turbulence intensity and turbulent kinetic energy were converged into the center of the center of the initial region with increasing the momentum ratio. As the momentum ratio increased from MR=1.19 to MR=6.48, the turbulent shear stress decreased. The results of this study can be used for the design of an impinging type injector for liquid rackets.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.288-293
• /
• 2000

BPM simulation was used in order to fabricate the LiNbO$_3$optical waveguide with optical source of He-Ne laser(λ=0.6328[$\mu$m]). we observed electric field E$_{x}$, E$_{y}$ in the x,y-direction are simulated at the LiNbO$_3$substrate (X1 55[$\mu$m]$\times$Z1 5000[$\mu$m]), where the depth, width and buffer layer of waveguide are 0.2[$\mu$m],4[$\mu$m] and 0.02[$\mu$m] respectively. By applying these parameters of single waveguide to simulate a X-switch, we have chosen index change of 0.002, width of 3[$\mu$m] and angle of 0.4$^{\circ}$~0.6$^{\circ}$of optical waveguide and under these conditions, optical beam propagates cross-side at 0.4$^{\circ}$. When applied switching voltage of 25[V], optical beam of X-switch turns cross-side to bar-side at intersection angle 0.4$^{\circ}$, index change of 0.002, waveguide width of 3[$\mu$m], electrode gap 2[$\mu$m]. By the above results, we can obtain design conditions of theoretical analysis of an X-switch optical waveguide.e.e.

• Wind and Structures
• /
• 제28권5호
• /
• pp.331-345
• /
• 2019

Long-span bridge decks are often shaped as streamlined to improve the aerodynamic performance of the deck. There are a number of important shaping parameters for a streamlined bridge deck. Their effects on aerodynamics should be well understood for shaping the bridge deck efficiently and for facilitating the bridge deck design procedure. This study examined the effect of various shaping parameters such as the bottom plate slope, width ratio and side ratio on aerodynamic responses of single box streamlined bridge decks by employing unsteady RANS simulation. Steady state responses and flow field were analyzed in detail for wide range of bottom plate slopes, width and side ratios. Then for a particular deck shape Reynolds number effect was investigated by varying its value from $1.65{\times}10^4$ to $25{\times}10^4$. The aerodynamic response showed very high sensitivity to the considered shaping parameters and exhibited high aerodynamic performance for a particular combination of shaping parameters.