• Journal of Sensor Science and Technology
• /
• v.32 no.4
• /
• pp.207-212
• /
• 2023

H₂S is a toxic and harmful gas, even at concentrations as low as hundreds of parts per million; thus, developing an H₂S sensor with excellent performance in terms of high response, good selectivity, and fast response time is important. In this study, an H₂S sensor with a high response and fast response time, consisting of a sensing material (SnO₂), an electrode, a temperature sensor, and a micro-heater, was developed using micro-electro-mechanical system technology. The developed H₂S sensor with a micro-heater (circular type) has excellent H₂S detection performance at low H₂S concentrations (0-10 ppm), with quick response time (<16 s) and recovery time (<65 s). Therefore, we expect that the developed H₂S sensor will be considered a promising candidate for protecting workers and the general population and for responding to tightened regulations.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.6
• /
• pp.810-817
• /
• 2014

An on-chip current sensor with fast response time for the peak-current-mode buck regulator is proposed. The initial operating points of the peak current sensor are determined in advance by the valley current level, which is sensed by a valley current sensor. As a result, the proposed current sensor achieves a fast response time of less than 20 ns, and a sensing accuracy of over 90%. Applying the proposed current sensor, the peak-current-mode buck regulator for the mobile application is realized with an operating frequency of 2 MHz, an output voltage of 0.8 V, a maximum load current of 500 mA, and a peak efficiency of over 83%.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.549-552
• /
• 1999

We have developed an novel vertical-alignment (VA) - $\pi$ cell mode that provides a wide viewing angle and fast response times for negative dielectric anisotropy nematic liquid crystal (NLC) on a homeotropic polyimide (PI) surfaces. We had the good voltage-transmittance curves and low driving voltages were achieved with the novel VA - $\pi$ cell mode without negative compensation film. Iso-viewing angle characteristics using the novel VA - $\pi$ cell mode without negative compensation film of NLC was also successfully observed. As well a fast response time of 31.7ms for the novel VA - $\pi$ cell mode was measured. Consequently, It is seen that by using the novel VA - $\pi$ cell mode the iso-viewing angle, fast response time, and low driving voltage characteristics can be achieved.

• Journal of the Optical Society of Korea
• /
• v.17 no.2
• /
• pp.200-204
• /
• 2013

We propose a cell structure for the fast switching of liquid crystals by the fringe field. By forming protrusion between patterned electrodes, we can obtain enhancement of response time. The protrusion reduces the effective cell gap, with which a fast response time can be realized. There is little decrease in the transmittance because the protrusion is located between patterned electrodes. We confirmed that the total response time can be decreased by 33% with little loss of the transmittance by optimizing the shape of the protrusion structure.

• Proceedings of the KSME Conference
• /
• 2008.11b
• /
• pp.3079-3084
• /
• 2008

A fast response $CO_2$ analyzer has been developed for measuring the $CO_2$ concentration during transient condition of SI engine. The analyzer is based on the non-dispersive infrared absorption technique, electrical chopping system and water cooling system. The analyzer has good repeatability, linearity and permissible drift characteristic. Besides, it has 18ms with a response to measure the $CO_2$ concentration. The fast response $CO_2$ analyzer was applied to single cylinder SI engine and the $CO_2$ emission was examined during engine start. Simultaneously, the standard exhaust gas analyzer, which has slow response time, was used for considering the engine-out $CO_2$ characteristic. The developed analyzer showed much faster responsive characteristic than that of a standard analyzer and made cycle by cycle exhaust gas analysis possible. The transient engine operating characteristics will be estimated and the transient behaviors on engine-out emission and performance will be improved.

• 제어로봇시스템학회:학술대회논문집
• /
• 1999.10a
• /
• pp.116-120
• /
• 1999

The step response of the Manabe standard form[1］has little overshoot and shows almost same waveforms regardless of the order of the characteristic polynomials. In some situations it is difficult to control the rise time and settling time simultaneously of the step response of the Manabe standard form. To control its rise time and settling time efficiently, we develop the generalization of the Manabe standard form: we try to find out the SRFS(Slow Rise time & Fast Settling time) form which has the slower rise time and faster settling time than those of the Manabe standard form. we also consider the other three forms: FRSS(Fast Rise time & Slow Settling time), SRFS(Slow Rise time ＆ Fast Settling time) and SRSS(Slow Rise time & Slow Settling time) forms. In this paper, by using the genetic algorithm, we obtain all the coefficient of the four forms we mention above. Finally, we design a controller for a given plant so that the overall system has the performance that the rise time is faster, the settling time is slower than those of the Manabe standard form.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.864-867
• /
• 2006

In order to satisfy with the clear visibility without any difficulties such as blurring and tailing, the high refreshing rate technology and fast response time of LC itself were applied to TFT-LCDs. In proportion to the decrease of holding time of 1 frame, the fast transition of LC behavior was necessary to both maintain the luminance and minimize the tailing appearance. The introduction of a new LC mixture for faster response times was realized by the good combination of newly introduced dielectrically neutral LC material so called 'Super Low Viscosity' (SLV) and highly polar $CF_2O-linkage$ LC material. This resulted in about a 20% reduction in the ${\gamma}_1$ of the new LC mixture compared to the references. In accordance with a new LC mixture with low ${\gamma}_1$, fast response time of 5ms has been made for S-IPS LCD TV application. Consequently, by applying the high frame frequency of 120Hz driving alongside the 5ms response time characteristics, the MPRT value was reduced by half.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.11a
• /
• pp.514-517
• /
• 2002

We investigated response characteristics of twisted nematic (TN) cell with different nematic liquid crystals (NLCs) and cell gap d on a rubbed polyimide (PI) surface. High transmittance and fast response time of the TN cell on the rubbed PI surface were achieved by using high birefringence (${\Delta}n$) and low cell gap d. The response time of TN cell on the rubbed PI surface was measured 5.1 ms. The transmittance and response time of the TN cell on the rubbed PI surface decreased with decreasing ${\Delta}nd$.

• Journal of Information Display
• /
• v.9 no.3
• /
• pp.12-15
• /
• 2008

A bent electrode structure is proposed in the super in-plane switching (S-IPS) liquid crystal (LC), as it can reduce the response time without loss of transmittance in the bright state. The electrode angle in each position of the bent electrode was optimized to simultaneously achieve high transmittance and fast response time. The electro-optical characteristics of the proposed LC cell structure were experimentally compared with those of the conventional cell. It was observed that the response time became over 8% shorter without loss of transmittance when the proposed bent structure was applied.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.205-208
• /
• 2004

The switching mechanism of multi-domain vertical alignment mode LCD and delayed on response time phenomenon in special conditions are investigated. A modified DCC (Dynamic Capacitance Compensation), DCCII has been developed for the fast response time performance in PVA TFT-LCD TVs. DCCII applies a pre-tilt voltage to addressed pixels during the previous frame in addition to an overshoot voltage. In result, the response time less than 8 msec, has been obtained for all moving images through the DCCII technique.