• Applied Chemistry for Engineering
• /
• v.30 no.2
• /
• pp.241-246
• /
• 2019

In this paper, reactive surfactants were synthesized by using acrylic acid or 3-butenoic acid as nonionic surfactants, polyoxyethylene(23) lauryl ether (Brij 35) and polyoxyethylene(20) stearyl ether (Brij S20). The synthesis of surfactants was confirmed by FT-IR and $^1H$-NMR. The surface tension, emulsifying property, and foam power and stability were also measured. The surface tension value was 35~41 dyne/cm at an critical micelle concentration (cmc) which was measured as $1.0{\times}10^{-4}{\sim}9.7{\times}10^{-5}mol/L$ using a surface tension method. The emulsifying power of synthesized surfactant was measured with benzene, soybean oil and monomer. Also, the initial height of the bubbles and the height after 5 minutes were measured and the values were compared with each other.

• Applied Chemistry for Engineering
• /
• v.19 no.1
• /
• pp.51-58
• /
• 2008

A series of oleic acid esters containing mercaptobenzothiazole and dialkylenedithiocarbamate, which are potential environmentally friendly lubricating grease additives, were synthesized as 90% yield through several method such as nucleophilic substitution of dialkyl amine and carbon disulfide, reduction reaction, and condensation reaction. The structures of the additives were confirmed by $^1H$-NMR, FT-IR and EA analysis. The additives (1 wt%) were soluble in 100 N BO except C4-DTC-OE and soluble in soybean oil. The tribological properties as lubricating additives in 100 N BO were evaluated using 4-ball tester and the results showed as follows: Bz-thia-OE < C4-DTC-OE < Pyrro-DTC-OE < C8-DTC-OE. Whereas, the 4-ball anti-wear properties were not shown in soybean oil.

• Clean Technology
• /
• v.17 no.4
• /
• pp.314-324
• /
• 2011

Several amide derivatives have been used as additives for base oil of metal working fluids and pressure working oils. In this paper, a series of succinic acid alkyl half-amide derivatives were synthesized as over 97% yields by ring-opening reaction of succinic anhydride and several amines and were soluble in 100 N base oil within 1 wt% concentration. The structures of the synthesized amides were confirmed by $^1H$-NMR, FT-IR spectrum and GC analysis. Anti-corrosion properties of the amides in sea water were evaluated through ASTM D665 method and weight loss method. As the results of anti-corrosion properties, the properties of the amides with shorter alkyl chain and high concentration showed better performance than those with longer alkyl chain and low concentration. Also, the dialkyl amides showed better anti-corrosion properties than those of the monoalkyl amides. Inhibition efficiency% (IE%) was over 93% in the concentration of 40 ppm and corrosion rate (CR) was below 0.5 mm/year in the same concentration.

• Applied Chemistry for Engineering
• /
• v.22 no.4
• /
• pp.367-375
• /
• 2011

Succinic acid ester derivatives have been used as additives for the base oil of metal working fluids and pressure working oils. In this paper, a series of succinic acid alkyl half-esters were synthesized with over 97% yields by ring-opening reaction of succinic anhydride and fatty alcohol and were soluble in 100 N base oil within 1 wt% concentration. The structures and purities of ester derivatives were confirmed by $^1H-NMR$ and FT-IR spectrum and GC analysis. Anti-corrosion properties of the esters in sea water were evaluated through ASTM D665 method and weight loss method and compared to that of succinic alkyl esters without carboxylic acid group in the molecule. As the results, anti-corrosion properties of succinic acid alkyl half-esters with carboxylic acid group were better than those of succinic acid alkyl esters without carboxylic acid group. And, Anti-corrosion properties of the esters with a shorter alkyl chain of high concentration showed better performance than those with longer alkyl chain of low concentration. Inhibition efficiency % (IE%) of the esters was over 95% in the concentration of 80 ppm and corrosion rate (CR) was below 0.3 mm/year at the same concentration. Thus, the corrosion properties of succinic acid alkyl half-esters result from the carboxylic acid groups in molecules.

• Journal of Conservation Science
• /
• v.36 no.3
• /
• pp.213-224
• /
• 2020

This research conducted a component analysis and conservation treatment of "Sangryangmun," a material which had been written in 1965 and was discovered during the repair project for "Jinnamgwan" in Yeosu. The "Sangryangmun" has been stored in a cylindrical metal storage; however, defects, discolorations, hardening, and damages caused by pollutants were found. Based on the XRF analysis, rust in the cylindrical metal storage, which was made of Cu, was stuck on the surface of the "Sangryangmun". Using FT-IR and Pyrolysis-GC/MS analyses, carbonyl and compounds of fatty acids were detected; the organic material on the surface of the "Sangryangmun" was identified to have belonged to oil-based components. Therefore, it was presumed that the bast fibers of a mulberry was used in the paper. To determine the conservation materials, component analysis, condition survey, and preliminary test on adhesives were conducted. Moreover, the missing parts and partial linings were filled using mulberry-fiber paper, methyl cellulose, etc.

• Korean Journal of Agricultural Science
• /
• v.38 no.2
• /
• pp.277-284
• /
• 2011

The compositions of health functional food products (HFFP; 18 products) containing gamma linolenic acid (GLA; $C_{18:3}$, n-6) and omega-3 fatty acids (EPA and DHA) were investigated. The contents of index components (especially, GLA and omega-3) in HFFPs were monitored by GC-FID analysis. Among the GLA products (sample No. 1~8), the content of GLA in most samples (except sample No.6) ranged from 8.04 to 9.98 g/100 g. These results were suitable for the reference standard (more 7.0 g/100 g) of HFF. In the omega-3 products (sample No. 10 and 15) derived from harp seal oil (HSO), the total contents of EPA and DHA were 14.21-15.98 g/100 g, respectively. These values were suitable for the reference standard (more 12.0 g/100 g) of HFF. Besides, among the omega-3 products (sample No.9, 11~14, 16~18) derived from fish oil, the total content of EPA and DHA ranged from 24.11 to 31.20 g/100 g. These results were suitable for the reference standard (more 18.0 g/100 g) of HFF. In the result of TLC analysis, the HFFPs of 18 were mainly composed of triacylglycerols (TAGs). The content of trans fatty acid in 18 HFFPs was detected in less than 0.30 g/100 g. For the detection of trans fatty acid, $^1H$-NMR (600 MHz) can be used because chemical shift of trans fatty acid was observed at 5.3 ppm in this study.

• Food Engineering Progress
• /
• v.14 no.2
• /
• pp.118-126
• /
• 2010

The fibrous material fraction as a by-product from the commercial aloe vera gel processing was obtained and freeze dried. The physicochemical characteristics such as the proximate composition, crystalline/surface structures and several physical functionalities including the water holding capacity (WHC), swelling capacity (SW), oil holding capacity (OHC), emulsion/foam properties and viscosity properties of this powdered sample (100 mesh) were investigated and analyzed by comparison with commercial $\alpha$-cellulose as a reference sample. The total dietary fiber content of powdered sample was very high as much as 87.5%, and the insoluble dietary and soluble dietary fiber content ratios were 77.6 and 22.4%, respectively. The FT-IR spectrum of powdered sample showed a typical polysaccharide property and exhibited a x-ray diffraction pattern for cellulose III and IV like structure. SW (8.24${\pm}$0.15 mL/g), WHC(6.40${\pm}$0.19 g water/g solid) and OHC(10.32${\pm}$0.29 g oil/g solid) of freeze dried aloe cellulose were about 3.3, 1.4 and 2 times higher than those of commercial $\alpha$-cellulose, respectively. Aloe cellulose (~2%, w/v) alone had no foam capacity while improved the foam stability of protein solution (1% albumin+0.5% $CaCl_{2}$) by factor of 300%. Emulsion capacity of 2%(w/v) aloe cellulose was about 70% level of 0.5%(w/v) xanthan gum, but its emulsion stability was about 1.2 times higher than that of xanthan gum. Also, aloe cellulose containing CMC (carboxyl methyl cellulose) of 0.3%(w/v) showed a very good dispersity. Aloe cellulose dispersion of above 1%(w/v) exhibited higher pseudoplasticity and concentration dependence than those of $\alpha$-cellulose dispersion, indicating the viscosity properties for new potential usage such as an excellent thickening agent.

• Korean Chemical Engineering Research
• /
• v.40 no.6
• /
• pp.769-777
• /
• 2002

Using four components - nonionic surfactants, water, hydrocarbon oil and an alcohol as cosurfactant, 12 types of cleaning agents were prepared, and their physical properties such as surface tension, viscosity, electroconductivity and phase stability were measured. As the formulated cleaning agents have low surface tensions(30.5-31.1 dyne/cm) and low viscosities (1.6-7.2 c.p.), they are satisfied with the general physical properties of water-in-oil(W/O) microemulsions for their industrial use. They showed a tendency that their temperature range for stable one-phase microemulsion decreased in accordance with the increase of alcohol/surfactant(A/S) ratio in the formulations. However, the temperature range of one-phase microemulsion was much more affected by hydrophilic lipophillic balance(HLB) value of the nonionic surfactant which increased its temperature range and it increased in accordance with the higher HLB value in the formulations. And the maximum content of water which can keep stable one-phase W/O microemulsion was measured at each sample. In addition, their temperature range for stable one-phase microemulsion was also measured. It was confirmed that the selection of surfactant type was very important for formulating a cleaning agent, since the W/O microemulsion system with the nonionic surfactant of the lower HLB value showed better cleaning efficacy that of the higher HLB value for abietic acid as a soil, which was used for preparing a rosin-type flux. In the formulated cleaning agents with the increase of A/S ratio in the formulations, however, there was no significant difference in cleaning efficacy. It was investigated that the differences of their cleaning efficacy was affected by the change of the condition of temperature and sonicating frequency as important factors in the industrial cleaning. That is, the higher, their cleaning temperature and the lower, their sonicating frequency, the more increased, their cleaning efficacy. Furthermore, using optical instruments like UV/Visable Spectrophotometer and FT-IR Spectrometer, their cleaning efficacy for abietic acid was measured. The removal of soil from the contaminated rinse water was measured by gravity separation method in the rinse bath. As a result, the cleaning agent system having the nonionic surfactant of HLB value 6.4 showed over 85% water-oil separation efficacy at over $25^{\circ}C$. Therefore, it was demonstrated in this work that the formulating cleaning agents were very effective for cleaning and economical in the possible introduction of water recycling system.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2000.06a
• /
• pp.99-105
• /
• 2000

Greases composed of base oil and thickener are widely used in the purpose of lubrication and anti-corrosion of machinery. However, greases are sometimes oxidized and decomposed by heat of friction, and produced organic acid. And the greases leaked out ordinary spot make the concrete structures weaken. In this study, the chemical effects of the greases with the concrete structures were investigated through oxidation reaction under pressure and oxygen, and evaluated by the analysis of TAN, Ca content, FT-IR and XRD of grease and cement powder after the oxidation reaction. As the results, TAN value decreased with the increase of the content of cement because of neutralization of organic acid produced by the oxidation of grease with calcium contained in the cement. The content of calcium linearly increased with the increase of cement due to calcium salt by neutralization of acid. Also, according to XRD results of the cement powder oxidized at 99 $^{\circ}C$, the diffraction peak due to calcium hydroxide decreased in comparison with that at room temperature because of the reaction of calcium and organic acid.

• Journal of Nutrition and Health
• /
• v.31 no.2
• /
• pp.153-158
• /
• 1998

The purpose of this study was to investigate the effect of vitamin E supplementation on the lipid peroxidation and activities of antioxidative enzymes in the pancreas of diabetic KK mice. KK mice were fed high ft diet containing 20% corn oil(wt/wt), and sacrificed at 2 months of diabetes. A hish vitamin E diet consisted of the high fat diet supplemented with an excessive amount of 이-$\alpha$-tocopheryl acetate (2080IU/kg diet). The incidence of diabetes mellitus was 61% when mice were fed the high fat diet, but was 44% when mice were fed the high vitamin E diet, Vitamin E supplementation fhus seems to have the effect of decreasing of decreasing the onset of diaetes. In the diabetic group, we found increases of MDA (malondialdehyde) and antioxidative enzyme activities. Treatment with vitamin E did not modify the level of fasting blood glucose. However, MDA and antiosicative enzyme activities in diabetic mice were decreased by the high vitamin E diet. Increased levels of lipid peroxidation products suggests the occurrence of oxidative damage in the pancreas of diabetic mice. The increased level of antiosicative enzyme activities could be due to an adaptive response to conditions of increased peroxidative stress. Significant normalization on catalase activity was noted in vitamin E supplemented animals.