• 전기의세계
• /
• v.22 no.1
• /
• pp.35-41
• /
• 1973

An automatic point traffic control method is recommended for more idealistic traffic flow over coarse road netowrks. The automatic control apparatus recommended, consists of a transceiver, amplifier, digital-to-analog converter, signal light controller for emergency and steady state, and digital counter as monitor. The transmitter sends a signal to the target vy means of Microwave-FM-CW and a diode detector picks up the echo signal. Thus the operation of the entire system will be carried out through an open loop state. Some factors necessary for an ideal detector system are rapid response, longevity and stability. An analytical method of the Doppler effect substitutes the conventional frequency deviation into the amplitude of detector output. The changing rate of amplitude is proportional to the voltage of the detector output. Some induced formula from Maxwell's radiation field theory ensures this new method, and, new method, and proves the fact with an experimental data presentation. Stability depends upon Klystron as an oscillator and a diode as a detector. the transceiver installation affects on the response and sensitivity of the system. In accordance with the detector output, several targets are easily classified by amplitudes on the scope. The traffic flow, i.e., target movement which is analyzed by the amplitude method, is shown through the scope and indicates it on the digital counter. The best efficiency for the amplitude analysis can be attained through use of an antenna having the highest sensitivity.

• Journal of Biomedical Engineering Research
• /
• v.28 no.3
• /
• pp.429-440
• /
• 2007

A coded excitation has been studied to improve the performance for ultrasound imaging in term of SNR, imaging frame rate, contrast to tissue ratio, and so forth. However, it requires a complicated arbitrary waveform transmitter for each active channel that is typically composed of a multi-bit Digital-to-Analog Converter (DAC) and a linear power amplifier (LPA). Not only does the LPA increase the cost and size of a transmitter block, but it consumes much power, increasing the system complexity further and causing a heating-up problem. This paper proposes an optimized 1.5bit fourth order sigma-delta modulation technique applicable to design an efficient arbitrary waveform generator with greatly reduced power dissipation and hardware. The proposed SDM can provide a required SQNR with a low over-sampling ratio of 4. To this end, the loop coefficients are optimized to minimize the quantization noise power in signal band while maintaining system stability. In addition, the decision level for the 1.5 bit quantizer is optimized for a given input waveform, which results in the SQNR improvement of more than 5dB. Computer simulation results show that the SQNR of a FM(frequency modulated) signal generated by using the proposed method is about 26dB, and the peak side-lobe level (PSL) of its compressed waveform on receive is -48dB.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.23 no.1
• /
• pp.11-17
• /
• 1987

This paper describes an availability of the teltmeter device made as a trial to measure the under-water noise, and the results of the test. This telemeter device adopts FM-FM system, and its main carrier wave is 146.2MHz. The trans-mission power is about 1w, and the available distance of transmission is 2.5KM. The timer built in the telemeter device controls transmission time and pause time automatically by the R-C time-constant. The former is 30-32 seconds and the latter is 10-12 seconds. The underwater noise in the set net fishing ground and at the breeding tank was measured, and recorded simultaneously on land and at sea with the telemeter device. When the input voltages of the transmitter is 100-300mV, the value of telemetering ambient noise and bio-acoustic underwater noise well agreed with that of the direct measurement. And the teleme-tered underwater noise decreases in proportion the distance between the transmitter and receiver.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.24 no.1
• /
• pp.7-11
• /
• 1988

This Paper describes technique for the design of system for telemetering the water temperature at sea. This telemetering device adopts FM-FM system, and its main carrier wave is 146.2MHz. The transmission power is about 1W, and the available distance of transmission is 2km. The telemetering time for the transmission and pause is controlled automatically by the CMOS programmable timer. The water temperature is measured by the electronic thermometer, it is varied by V-F converter which is built to a linear voltage controlled oscillator. The results of the experiment at the place where the receiver is off 2km from the transmitter, the water temperature measured with the mercury thermometer well agree with that of the telemetering device.

• Journal of Broadcast Engineering
• /
• v.15 no.1
• /
• pp.99-111
• /
• 2010

In this paper as a follow-up to Paper I, the required fade margin derived in Paper I to preserve the same service quality has been examined by analyzing system and propagation characteristics as well as measured data. The comparison of the fade margin between simulated and measured results is also performed for the actual operating line-of-sight(LOS) and non-LOS links, and practical usefulness as an analysis tool is revealed by checking service quality of M/W system relevant to frequency reallocation. According to simulated and measured results, there was a little difference for LOS link between Mt. Moodung and Mt. Mangun, but a fairly good agreement was reached for non-LOS link between Andong KBS and transmitter site.

• Electronics and Telecommunications Trends
• /
• v.9 no.4
• /
• pp.131-138
• /
• 1994

최근 무선통신의 활성화에 따라, V/UHF(very/ultra high Frequency) 대역에서 한정된 주파수를 효율적으로 이용하기 위한 방법의 하나로서, 점차 점유 주파수 대역의 폭을 축소하여 보다 많은 이용자를 수용하도록 무선 채널의 협대역화가 추진되고 있다. 본 고에서는 먼저 V/UHF 대역 무선 통신에서 채널의 협대역화에 관련된 기술 중에서 현재까지 사용되고 있는 FM(frequency modulation), AM(amplitude modulation) 변조 방식의 장,단점을 살펴본후, 새로운 LM(linear modulation) 변조 방식에 대한 기술적 배경 및 특성을 알아보았다. LM은 SSR(single side band)-AM이 발전한 것으로서, TTIB(transparent tone-in-band), CLT(Cartesian loop transmitter), FFSR(feed-forward signal regeneration), DSP(digital signal processing)등 4가지의 기술이 결합하여 만들어진 것이다. LM 방식에 사용된 4가지 기술을 소개하고, 기존의 변조 방식에 비해 개선된 사항에 대해 서술한다.

• Proceedings of the IEEK Conference
• /
• 2001.06a
• /
• pp.305-308
• /
• 2001

In this paper, we realized a transceiver system for short distance communication with a commercial RF module working in ISM band and a microprocessor. Also we measured system performance by transmitting baseband data in a building and then we compared the demodulated 긴ta bits with stored data bits in a PC connected with demodulator. The RF module in the experiments works oかy in the bandwidth, 424MHz - 429MHz. with FM mode. The signal level degrades as the distance between transmitter and receiver increases we measured the signal level and bit error in the building of engineering college of our university. we present the measured data with various locations in the building. and the data may be used in design short distance network in a building.

• Proceedings of the IEEK Conference
• /
• 2000.06e
• /
• pp.113-116
• /
• 2000

In this paper presents the portable wireless ECG data detection and diagnosis system based on discreet wavelet transform. An algorithm based on wavelet transform suitable for real time implementation has been developed in order to detect ECG characteristics. In particular, QRS complex, S and T waves may be distinguished form noise, baseline drift or artifacts. Proposed telemetry system that a transmitting media using radio frequency(RF) for the middle range measurement of the physiological signals and receiving media using optical for electromagnetic interference problem. A standard hi-directional serial communication interface between the telemetry system and a personal computer or laptop, allows read-time controlling, diagnosing and monitoring of system. A portable telemetry system within a size. of 65${\times}$125${\times}$45mm consists of three parts: a digital signal processing part for physiological signal detect or diagnose, RF transmitter for data transfer and a optical receiver for command receive. Advantages of proposed telemetry system is wireless middle range(50m) FM transmission, reduce electromagnetic interference to a minimum. which enables a comfortable diagnosis system at home.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.8 no.5
• /
• pp.27-39
• /
• 1971

It is described in this paper that a newly developed quartz frequency modulator using V. V. C. diode would be more suitable for mobile FM portable transmitter, than conventional reactance modulator because of less need for multiplier stages in the former type. It is realized by theoretical and experimental results what is the most optimum relationship between the quartz oscillator, V. V. C. diode and coupled circuit elements in order to get the desired modulation linearity and carrier frequency stability depending upon the variation of circumference temperature and suplied source voltages.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.7
• /
• pp.1787-1802
• /
• 1996

In this paper, the performance for FH/CPFSK system with limiter-discriminator detection and integrage-and-dump post-detection filtering under thermal noie, partial-band noise jamming and rayleigh fading have been analyzed. The method of hard-decision diversity of which the transmitter repeated L times on different hops for each data symbol in a way to mutigate the effects of the jamming has been applied, and the receiver has been combined the L chips. Also, error-correcting code have been applied for improving performance of system. The thermal noise and partial-band noise jamming, intersymbol interference for all eight of the possible adjacent bit data patterns, and FM noise click for evaluating systems have been considered. Also optimum parameters to improve performance of FH/CPFSK system have been obtained and validities have been proved through computer simulation.