• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.10
• /
• pp.2329-2338
• /
• 1997

A conventional digital receiver sampled a baseband signal and processed it digitally for demodulation. But now we can sample at sufficiently high speed a wideband signal to take enough discrete data values due to the advent of economic high-speed ADC. With this technical background, a wideband frequency-division-multiplexed signal can be undersampled and channelized in digital domain by DFT analysis filter using the theory of polyphase. In this paper, we propose a new digital receiver which can digitally process the multichannel received signal by sampling at IF band, develop a mathematical theory and algorithm, and analyze the performance by using C-language simulaation. The proposed receiver can demodulate analog and digital FM signals.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.6 no.4
• /
• pp.20-30
• /
• 1969

Several new modulators using Voltage Variable Capacitance Diode are discribed. It was investigated that amplitude modulation which does not need modulation power is obtained by mdulation VVC diode as a tuning element of the quartz oscillator circuit. It offers a good AM system for carryphones in the citizen bands. While frequency modulated quartz oscillators coupled with a quarter wave network were tested as a wide band frequency modulator, Hartley type transistor oscillator offers the most stable and reproducibel FM quartz oscillator.

• Proceedings of the IEEK Conference
• /
• 2001.06a
• /
• pp.305-308
• /
• 2001

In this paper, we realized a transceiver system for short distance communication with a commercial RF module working in ISM band and a microprocessor. Also we measured system performance by transmitting baseband data in a building and then we compared the demodulated 긴ta bits with stored data bits in a PC connected with demodulator. The RF module in the experiments works oかy in the bandwidth, 424MHz - 429MHz. with FM mode. The signal level degrades as the distance between transmitter and receiver increases we measured the signal level and bit error in the building of engineering college of our university. we present the measured data with various locations in the building. and the data may be used in design short distance network in a building.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2002.11a
• /
• pp.223-227
• /
• 2002

Eureka 747 DAB 시스템의 혼신보호비는 AM, FM, PAL, SECAM, DAB 등의 동일채널 및 인접채널 간섭원에 대한 조사가 수행되었으나, NTSC TV 간섭원에 대해서는 분석되지 않았다. Eureka 141 DAB 시스템 대부분이 TV 대역인 Band III에서 운용되는 상황을 고려한다면, NTSC TV 간섭원에 대한 혼신보호비 분석은 반드시 필요하다. 본 논문에서는 Eureka 147 DAB 시스템과 아날로그 NTSC TV 시스템간의 혼신보호비중 NTSC TV 간섭원에 대한 Eureka 147 DAB 시스템의 혼신보호비 측정을 위한 간섭환경 설정방법 및 DAB송수신기를 이용한 BER 측정방법, 그리고 측정결과를 제시한다.

• Proceedings of the KIEE Conference
• /
• 1998.07g
• /
• pp.2430-2432
• /
• 1998

Generally, in the best-known Pulse-type type and Frequency Modulated Continuous Wave(FM/CW)-type RF range measurement systems, the nearest measurable distance between antenna of system and targets is limited to several tens of meters. Moreover, in case of high-speed targets it is more difficult to measure the distance precisely. In this paper we design our own RF(X-band) range(up to 15 meters) measurement system usi code correlation for high- speed targets. It 0 the correlation value between transmitting receiving PN (Pseudo -Noise) codes. So we determine the distance between antenna of s and targets using this correlation value. We fabricated it using MIC techniques and experimental results show that the proposed syste fully qualified for a short range measurement syste

• Journal of Advanced Navigation Technology
• /
• v.26 no.6
• /
• pp.487-495
• /
• 2022

This paper describes the design and development of a high-power transmit receive module(TRM) for mounting on X-band synthetic aperture radar(SAR) of the NEXTSat-2. The TRM generates a high-power pulse signal with a bandwidth of 100 MHz in the target frequency range of X-band and amplifies a low-noise on the received signal. Tx. path of the TRM has output signal level of more than 200 watts (53.01 dB), pulse droop of 0.35 dB, signal strength change of 0.04 dB during transmission signal output, and phase change of 1.7 ˚. Rx. path has noise figure of 3.99 dB and gain of 37.38 ~ 37.46 dB. It was confirmed the TRM satisfies all requirements. The TRM mounted on the NEXTSat-2 flight model(FM) which will be launched using the KSLV-II (Nuri).

• Journal of Biomedical Engineering Research
• /
• v.28 no.3
• /
• pp.429-440
• /
• 2007

A coded excitation has been studied to improve the performance for ultrasound imaging in term of SNR, imaging frame rate, contrast to tissue ratio, and so forth. However, it requires a complicated arbitrary waveform transmitter for each active channel that is typically composed of a multi-bit Digital-to-Analog Converter (DAC) and a linear power amplifier (LPA). Not only does the LPA increase the cost and size of a transmitter block, but it consumes much power, increasing the system complexity further and causing a heating-up problem. This paper proposes an optimized 1.5bit fourth order sigma-delta modulation technique applicable to design an efficient arbitrary waveform generator with greatly reduced power dissipation and hardware. The proposed SDM can provide a required SQNR with a low over-sampling ratio of 4. To this end, the loop coefficients are optimized to minimize the quantization noise power in signal band while maintaining system stability. In addition, the decision level for the 1.5 bit quantizer is optimized for a given input waveform, which results in the SQNR improvement of more than 5dB. Computer simulation results show that the SQNR of a FM(frequency modulated) signal generated by using the proposed method is about 26dB, and the peak side-lobe level (PSL) of its compressed waveform on receive is -48dB.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.11
• /
• pp.12-17
• /
• 2009

This paper presents a tag emulator for a UHF band RFID system. The tag emulator supports the 1800-6C and EPC global class 1 generation 2 standards. The transmitted signal from a reader is generated using the PIE coding and ASK modulation methods. Signals of a tag are from the FM0 coding and ASK modulation methods. The ARM7 processor carries out the overall control of the system and signal analysis of incoming data. The verification of the tag emulator employs the application platform implemented in C++. Users can define parameter values for protocol during the application run. The tag emulator presented in this paper allows evaluating various design alternatives of the target RFID system in real applications.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.3
• /
• pp.311-318
• /
• 2004

It is required to design the RF link with sufficiently stable signal margin to minimize bit errors and improve the quality of received data in the telemetry system modulated digitally like PCM/FM. In case of the vehicle flying at a high speed, the variation of the gain pattern between transmitting and receiving antenna and the fee space loss due to flight distance cause the fluctuation of link. In this paper, KSR(Korea Sounding Rocket)- III, the first domestic liquid rocket which was successfully launched in Nov. 2002 is introduced. The SNR(signal-to-noise ratio) variation of the telemetry signal which was measured at S-band ground station, the one which was simulated considering the flight trajectory, and the attitude variation such as roll, pitch and yaw are compared, analyzed, and agree very well. In addition, two virtual flying situations are simulated and evaluated-only one antenna is equipped in one case, and rocket is roll-free in the other.

• Journal of Advanced Navigation Technology
• /
• v.2 no.1
• /
• pp.53-60
• /
• 1998

This paper describes some design concepts and design parameters of RZ-SSB which allows full carrier insertion into the single side band to overcome the severe fading in aeronautical telecommunication, and it is described in ARINC Spec. in the name of AME(AM Equivalent), and the necessary transmission bandwidth of RZ-SSB is similar to that of a aeronautical telecommunication. As an amplitude limiter manage to remove the amplitude fading without degrading the quality of output signal, the receiver acts like the FM demodulators. Using the digital Signal Processing(DSP) techniques in the design of transceiver systems has become a performance enhancement of the signal quality and reliability, and making use of DSP, it's able to design low cost, compact transceiver and reduce its weight. For avionics systems is able to eliminate the inherent disadvantages in RZ-SSB, the results of experimental tests suggest that the adoption of RZ concepts is suitable for aeronautical telecommunication transceiver systems use in HF band.