• Proceedings of the IEEK Conference
• /
• 2000.11b
• /
• pp.37-40
• /
• 2000

This paper has been studied on characteristics of organic light-emitting device with various cathode materials. These catode materials were Al：Li(5%), Al, Cu, CsF/Al. And in these devices, HTL(hole transfer layer) was TPD and EML(emitting layer) was Alq$\sub$3/. We studied the I-V characteristics for each device. And then, the turn-on voltage of device for Al-Li(5%), Al, Cu, CsF/Al cathode were 7, 9, 13, 3V respectively. So, the CsF/Al cathode is superior to other cathode materials for I-V characteristics.

• Transactions on Electrical and Electronic Materials
• /
• v.8 no.4
• /
• pp.174-177
• /
• 2007

We fabricated organic field-effect transistors (OFETs) based a fluorinated copper phthalocyanine ($F_{16}CuPC$) and copper phthalocyanine (CuPc) as an active layer. And we observed the surface morphology of the $F_{16}CuPC$ thin film. The $F_{16}CuPC$ thin film thickness was 40 nm, and the channel length was $50{\mu}m$, channel width was 3 mm. And we also fabricated the $F_{16}CuPc/CuPc$ double layer FET and with different $F_{16}CuPc$ film thickness devices. We observed the typical current-voltage (I-V) characteristics and capacitance-voltage (C-V) in $F_{16}CuPc$ FET and we calculated the effective mobility. From the double layer FET devices, we observed the higher drain current more than single layer FET devices.

• Journal of computational fluids engineering
• /
• v.8 no.2
• /
• pp.1-7
• /
• 2003

The V2F turbulence model, which has shown very good performance in several test cases at low speeds, has been applied to supersonic ramp flow with 20. corner angle at the free stream Mach number of 2.79. The flow is known to manifest strong shock wave/turbulent boundary layer interactions. As a comparative study, low-Reynolds k-ε models are also considered. While the V2F model predicts wall-pressure distribution well, it relatively predicts larger separation bubble and higher skin-friction after the reattachment than the experimental data. Although the ellpticity of f equation is the characteristics of incompressible flows, the converged solutions are acquired in the compressible flow with shock waves. The effect of the realizability constraints used in the model is also examined. In contrast to the result of impinging jet flows, the realizability bounds proposed by Durbin deterioate the overall solutions of the supersonic ramp flow.

• Korean Journal of Veterinary Service
• /
• v.39 no.4
• /
• pp.221-226
• /
• 2016

The animal welfare issues in cattle breeding include breeding environment, elimination, and castration. Among these, castration is unavoidable because it decreases cattle aggressiveness, improves meat quality, and enhances feed efficiency. In this study, the degree of stress associated with various methods of castration treatment was investigated for animal welfare in Hanwoo breeding. Cortisol levels dramatically increased right after castration in both the SoF and SoV groups. However, the increase in the SoF group was significantly (P<0.05) higher than that in the SoV group, and the range of decrease was also smaller. Among the behavioral characteristics, standing was significantly (P<0.05) higher in the SoV ($374.93{\pm}21.51$) and SoF ($379.93{\pm}21.30$) groups based on the behavioral time (min/12 hours) compared to that in the NC group ($359.37{\pm}19.69$). The SoF and SoV groups did not show any significant (P<0.05) difference. In terms of behavioral frequency, the NC group demonstrated a significantly (P<0.05) high frequency of drinking, self-grooming, scratching, and rubbing, and a significantly (P<0.05) less frequency of fighting behavior. The feeding time significantly (P<0.05) decreased in the SoV and SoF groups, and their frequencies of pairwise grooming were significantly (P<0.05) less. Based on the results, the cattle experienced less stress during castration by a veterinarian than during treatment using a move-stop.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.5
• /
• pp.616-624
• /
• 2011

The flow characteristics and heat transfer augment on the periodically arranged semi-circular ribs in a rectangular channel for turbulent flow has been investigated numerically. The aspect ratio of the rectangular channel was AR=5, the rib height to hydraulic diameter ratio were 0.07 and rib height to channel height ratio was set as e/H=0.117 for various PR(rib pitch-to-rib height rate) between 8~14, respectively. The SST k-${\omega}$ turbulence model and v2-f turbulence model were used to find out the heat transfer and the flow characteristics of near the wall which are suited to obtain realistic phenomena. The numerical analysis results show turbulent flow characteristics, heat transfer enhancement and friction factor as observed experimentally. The results predict that turbulent kinetic energy(k) is closely relative to the diffusion of recirculation flow. and v2-f turbulence model simulation results have a good agreement with experimental values.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.23 no.4
• /
• pp.240-246
• /
• 2018

In this paper, a sensorless V/f control based on maximum torque per ampere (MTPA) operation for PMSMs is proposed. Given that the MTPA operation is not considered in the conventional sensorless V/f control, efficient PMSM drives cannot be achieved. Therefore, this paper proposes an improved technique based on the d-axis current control to enable the MTPA operation in the V/f control for PMSMs. A stabilization technique is also proposed to improve the dynamic characteristics and stability against load variation. The effectiveness of the proposed technique is verified by conducting experiments with a 250 W SPMSM for driving a blower.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.10
• /
• pp.31-36
• /
• 1999

The $CaSiN_2:Eu$ and $CaSiN_2:Tb$ phosphors were synthesized and analyzed to develop new nitride compound phosphors. $Ca_3N_2$, $Si_3N_4$ and $EuF_3$(or $TbF_3$) powders were mixed, cold-pressed, and sintered to synthesize $CaSiN_2:Eu$ and $CaSiN_2:Tb$ phosphors. Photoluminescence(PL) and electroluminescence(EL) characteristics of the synthesized phosphors were measured and found to be similar to general emission spectra of 뗘 and Tb ion, respecticely. Threshold voltage($V_{th)$) and luminance of the $CaSiN_2:Eu$ TFEL device fabricated by sputtering were 90 V and 1.62 $cd/m^2$ at 280 V, respectively. The charge-voltage(Q-V) and transferred charge-phosphor field($Q_t-F_p$) characteristics of the TFEL devices were also measured.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.48 no.6
• /
• pp.442-450
• /
• 1999

In this paper, we have fabricated Langmuir-Blodgett(LB) films by LB technique and evaluated the deposited status of LB films by UV-vis absorbance. It was found thatthe thickness of LB films per a layer are $27~30[{\AA}]$ by ellipsometry. The responeses between LB films and organic gases were investigated using by I-V characteristics of LB films and F-R diagram of quartz crystal. The response orders between LB films and organic gases observed by I-V characteristics were as following ; chloroform, methanol, acetone and ethanol in the order of their short chain length. The response mechanism between LB films and organic gases observed by F-R diagram of quartz crystal could be modeled on adsorption at surface, penetration, desorption at surface and inside.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.303-304
• /
• 2009

We fabricated organic field-effect transistors (OFETs) based a fluorinated copper phthalocyanine. ($F_{16}CuPc$) as an active layer. And we observed the surface morphology of the $F_{16}CuPc$ thin film. The $F_{16}CuPc$ thin film thickness was 40nm, and the channel length was $50{\mu}m$, channel width was 3mm. We observed the typical current-voltage (I-V) characteristics and capacitance-voltage (C-V) in $F_{16}CuPc$ FET and we calculated the effective mobility.

• Microbiology and Biotechnology Letters
• /
• v.23 no.5
• /
• pp.617-623
• /
• 1995

A new thermotolerant yeast strain was siolated, and its characteristics have been studied. The strain was identified and named Saccharomyces cerevisiae F38-1. This strain could grow not only at high temperature, but also in high concentrations of sugar and ethanol. S. cerevisiae F38-1 could grow in a medium containing 50% glucose. The isolate produced ethanol at 43$\circ$C, but didn't grow at 40$\circ$C in the presence of 8% ethanol. Fermentation studies showed that the isolate ferments 20% glucose to 9.8% (V/V) ethanol at 40$\circ$C in the presence of 0.2%, yeast extract.