• Food Science and Preservation
• /
• v.7 no.2
• /
• pp.177-183
• /
• 2000

A supercritical fluid extraction was performed for the extraction of phenolics from grape seeds which up to now have been discarded. The optimum condition for extraction process was predicted through response surface methodology using central composit experimental design. The extraction amount of grape seed phenolics was increased by increasing extraction temperature, pressure, and concentration of co-solvent (ethanol). The optimum extraction conditions were 84.83$^{\circ}$C, 51.50MPa and 1.27% ethanol. The yield of phenolics using SFE was higher with 3 folds than ethanol and 4 folds than hexane but less than 80% methanol. In the respects of food poisoning, the approved solvents were restricted to ethanol and hexane. So, SFE for extraction of phenolics could be powerful alternative method for solvent extraction.

• Journal of Korean Society on Water Environment
• /
• v.22 no.1
• /
• pp.122-127
• /
• 2006

Fundamental studies were carried out for an effective removal and recovery of silver from waste photo-developing solution by solvent extraction. The organic solvents examined for silver-extraction were ALIQUAT 336, D2EHPA, KELEX 100, and TBP. ALIQUAT 336, which is an anionic exchanger, was found to be efficient for the extraction of silver and the reason for this was considered to be due to the chloride ion contained in its structure. The extent of silver extraction was examined to increase with the concentration of ALIQUAT 336 until it reached 0.6 M and no more extraction was observed above this concentration. The extraction of silver by ALIQUAT 336 was found to reach its pseudo-equilibrium within a few minutes after the reaction started and additional slight increase in silver extraction was observed until 30 minutes of reaction time. The observed differences in silver extraction for artificial and actual waste solutions were considered to be based upon the different ionic form of silver-containing species in these solutions.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.18 no.1
• /
• pp.23-28
• /
• 1985

The extraction rate of lipids from the chopped whole fish was studied with various solvents. Factors which can influence on the extraction rate such as temperature, moisture content, agitation speed and solvent were also examined. In the early stage of extraction, it is considered that the rapid extraction was attributed to cell destruction which occurs in chopping the whole fish and in the later stage, the extraction rate was increased linearly with extraction time. The effect of agitation on the extraction rate had a great influence on the early stage of extraction. In agitation speed of 100, 200, 300 and 500 r.p.m. the slopes of extraction curve were -0.075, -0.075, -0.069 and -0.064, respectively. Extractability between hydrophilic and hydrophobic solvent showed a great difference. It is suggested that extractability difference between acetone and isopropyl alcohol is due to acetone property which can not extract phospholipids in polar lipids. Extractability of lipids was increased with increasing temperature and decreased with increasing moisture content.

• KSBB Journal
• /
• v.16 no.3
• /
• pp.233-236
• /
• 2001

Because of casehardenign effect of amorphous paclitaxel, residual solvents, methylene chloride and emthanol could not be reduced to the maximum value allowed, 600 ppm and 3,000 ppm, in accord with the guidelines issued by the International Conference on Harmonization (ICH, 1997), using rotary evaporation and successive drying in a vacuum oven. However, methylene chloride and methanol were reduced to 486 ppm and 403 ppm, respectively using supercritical $CO_2$ on purified paclitaxel. The optimum pressure and operating time were 80 bar and 30 min at fixed operating temperature ($40^{circ}C$). This approach serves as a novel application of supercritical fluid extraction to remove residual solvents from active pharmaceutical ingredients.

• Membrane and Water Treatment
• /
• v.10 no.5
• /
• pp.361-372
• /
• 2019

Effect of different alkane based solvents on the stability of emulsion liquid membrane was investigated using normal alkanes (n-hexane, n-heptane, n-octane and n-decane) under various operating parameters of surfactant concentration, emulsification time, internal phase concentration, volume ratio of internal phase to organic phase, volume ratio of emulsion phase to external phase and stirring speed. Results of stability revealed that emulsion liquid membrane containing n-octane as solvent and span-80 (5 % (w/w)) as emulsifying agent presented the highest amount of emulsion stability (the lowest breakage) compared with other solvents; however, operating parameters (surfactant concentration (5% (w/w)), emulsification time (6 min), internal phase concentration (0.05 M), volume ratio of internal phase to organic phase (1/1), volume ratio of emulsion phase to external phase (1/5) and stirring speed (300 rpm)) were also influential on improving the stability (about 0.2% breakage) and on achieving the most stable emulsion. The membrane with the highest stability was employed to extract acridine orange with various concentrations (10, 20 and 40 ppm) from water. The emulsion liquid membrane prepared with n-octane as the best solvent almost removed 99.5% of acridine orange from water. Also, the prepared liquid membrane eliminated completely (100%) other cationic dyes (methylene blue, methyl violet and crystal violet) from water demonstrating the efficacy of prepared emulsion liquid membrane in treatment of dye polluted waters.

• Korean Chemical Engineering Research
• /
• v.54 no.3
• /
• pp.310-314
• /
• 2016

The search for natural antioxidants as alternatives to synthetic products is growing. Microalgae have emerged as a source of natural antioxidants with significant and diverse health-promoting properties. In this study, the effects of hot-water extraction conditions on total polyphenol compounds (TPC) production were investigated for lipid extracted microalgae (LEA). In order to enhance the polyphenol productivity, the extraction variables including solvents, temperature, time and ethanol concentration were optimized. The results showed hot-water extraction provided a higher extraction efficiency than the organic solvents and extraction at high temperatures showed a better extraction efficiency. While hot-water extract showed a higher extraction efficiency compared to 98% ethanol extraction, the mixture of water and ethanol (40:60 v/v) showed the highest production of polyphenols. The maximum polyphenols of 3.35 mg GAE (gallic acid equivalent)/g DM were obtained at the optimized extraction time of 10 min, $100^{\circ}C$ and 40% ethanol, respectively. Although Tetraselmis KCTC 12236BP was preprocessed by hexane to remove lipid for bio-diesel production, the results showed LEA contains relatively high level of polyphenols compared to untreated microalgae which can be used in the production of value-added materials. The predictions obtained from the developed Peleg's model were compared with the experimental data under the same operating conditions. The predicted and experimental data were consistent, indicating the reliability of the model.

• Elastomers and Composites
• /
• v.48 no.4
• /
• pp.288-293
• /
• 2013

Crosslink characteristics of maleic anhydride-grafted EPDM (MAH-g-EPDM)/zinc oxide composite were investigated by weight losses after dichloroacetic acid (DCA)/toluene cosolvent extraction at different temperatures and by measurement of crosslink densities. The chemical changes were analyzed using attenuated total reflectance-Fourier transform infrared spectroscopy (ATR-FTIR). The weight losses by extraction at high temperature ($90^{\circ}C$) were remarkably greater than those at room temperature and those by DCA/toluene cosolvent extraction were greater than those by toluene one by more than 5 times. The crosslink densities were measured after the solvent extraction, and the second crosslink densities were higher than the first ones. The first crosslink density was lower when the extraction temperature was high, and it was much lower for the toluene extraction than for the DCA/toluene cosolvent extraction. The second crosslink density of the sample extracted with DCA/toluene cosolvent was greater than that extracted with toluene. The extracted components were depending on the extraction solvents and temperatures, for example; only strong crosslinked networks were remained when extracting with DCA/toluene cosolvent at high temperature, while only uncrosslinked polymer chains were extracted when extracting with toluene at room temperature. Therefore, crosslink characteristics of the MAH-g-EPDM/zinc oxide composite can be analyzed by comparison of the extracted components according to the extraction solvents and temperatures and by measurement of successive crosslink densities.

• KSBB Journal
• /
• v.25 no.4
• /
• pp.371-378
• /
• 2010

For the biodiesel fuel production from microalgae, the lipid from wet and dry samples of green algae Scenedesmus sp. was extracted by using various solvents and pre-treatment methods. Extraction yield of the lyophilized sample was better than that of dry sample. Chloroform/methanol (2:1, v/v) and ultrasonication or homogenization method were also selected as the most effective solvent and pre-treatment methods for lipid extraction, respectively. Under these constraint conditions, optimization experiment of lipid extraction was investigated by Taguchi approach using orthogonal matrix $L_9$ ($3^4$) method. The optimum extraction conditions of lipid extraction was obtained at pre-treatment of homogenization, extraction time of 5 hour, temperature of $35^{\circ}C$, and solvent ratio of 1:20 (w/v). Yield of extraction at optimized condition was 20.55% and it was 96% of total lipid content (21.38%) of Scenedesmus sp.

• Korean Journal of Food Science and Technology
• /
• v.29 no.1
• /
• pp.183-187
• /
• 1997

The analytical conditions of 1,3-dichloro-2-propanol (DCP) and 3-chloro-1,2-propanediol (MCPD) by solid phase extraction were optimized to improve recovery. Selected-ion monitoring technique which was used for GC-MS analysis of both compounds gave substantially higher sensitivity. The detection limits of DCP and MCPD were 25 and 50 ppb, respectively. The effects of extraction column type, elution solvent and salt concentration on recovery were examined. A normal phase column was better than a reverse phase column in solid phase extraction of DCP and MCPD. It was explained in terms of polarity relationship of solvent-solute-solid phase. A maximum recovery was obtained at the salt concentration of 20% (w/v). Water-immiscible and chloropropanol-soluble solvents such as chloroform, diethyl ether, hexane and ethyl acetate were tested for elution solvent. Hexane and ethyl acetate were the most suitable solvents for the extraction of DCP and MCPD, respectively. High recovery better than 95% was obtained with the selected solvents.

• Journal of Mushroom
• /
• v.18 no.3
• /
• pp.244-253
• /
• 2020

The aim of this study was to investigate the biological activity of extracts obtained from the mycelium, sclerotium, and fruiting body of Wolfiporia cocos using different extraction solvents (hot water, 70% ethanol, and 70% methanol). Among the three developmental stages, the mycelium extracts showed the highest DPPH (2,2-diphenyl-1-picrylhydrazyl) radical scavenging activity, ferric reducing antioxidant power (FRAP), nitrite scavenging activity, and total polyphenolic content. Among the extraction solvents in the context of the W. cocos mycelium, the DPPH radical scavenging activity, FRAP, and total polyphenol content in the hot-water extracts were significantly higher than those in the other extracts. In the case of the sclerotium, the reducing power, nitrite scavenging activity, and total polyphenol content were significantly higher in 70% ethanolic extracts. The fruiting body showed the highest DPPH radical scavenging activity, reducing power, nitrite scavenging activity, and total polyphenol content in the context of hot-water extraction. Moreover, the β-glucan content was significantly higher in the sclerotium versus the mycelium or fruiting body. The total amino acid and total essential amino acid contents were remarkably higher in the mycelium and fruiting body than in the sclerotium; of note, and arginine (Arg) and phenylalanine (Phe) were highly detected among the amino acid components.