• 한국화재소방학회논문지
• /
• 제28권2호
• /
• pp.14-19
• /
• 2014

현재 국내의 침윤소화약제 기술기준은 표면장력에 대한 기준만 존재하여 이를 통한 약제의 성능평가는 어려운 실정이다. 따라서 침윤소화약제의 성능평가 기법을 제시하기 위해 축소모형 실험 장치를 통한 최적화된 성능평가 방법을 제시하고자 한다. 본 연구는 해외 기준인 NFPA 18의 실험과 자체 제작된 축소모형 실험 장치를 이용한 실험의 결과 비교분석을 통해 자체 제작 축소모형 실험 장치실험 결과의 타당성을 규명하고자 한다. 목화솜을 대상으로 침투성능만을 평가하는 NFPA 18 실험과 목분을 대상으로 침투성능과 소화성능을 모두 평가하는 축소모형 실험을 비교분석한 결과 NFPA 18의 실험과 자체 제작 축소모형 실험에서 모두 소화용수의 침투성에 관한 변별력을 확인할 수 있었다. 또한 자체 제작 축소모형 실험에서는 T/C를 통한 내부온도 측정을 통해 보다 명확한 변별력을 나타냄을 확인하였다.

• KIEAE Journal
• /
• 제6권4호
• /
• pp.25-32
• /
• 2006

Mock-up model can be applied to measure accurate performance data but difficult to apply the variables in experiment. There can be a slight experiment errors in Scale model, but various parameters can be applied for a objective experiment. This paper aims to compare the daylighting performance in 1, 1/5, 1/10 scale model of offices and analyze the experiment errors to certificate the influence of model experiment. To analyse daylighting performance, a comparison of a Mock-up model, sized $12.0m(w){\times}7.2m(l){\times}3.7m(h)$, designed for experimentation of daylighting systems and its 1:5, 1:10 scale model. It has an identical configuration of reference room and the test room. For the test room, the lightshelf system was designed as Micro-4 reflective material. To assess work plane illuminance and light factor, photometric sensors of each room were installed at work-plane(6 points) and exterior horizontal illuminance (1 point). And luminance of window, rare of the room was measured under clear sky. It is to be monitored by Agilent data logger, photometric sensor Li-cor and the Radiant Imaging ProMetric 1400. Comparisons with a light factor, increase-decrease ratio and luminance are discussed.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2003년도 추계학술대회 논문집(III)
• /
• pp.132-137
• /
• 2003

This paper concerns the prediction of railway noise propagation using scale model experiment in acoustics. In order to make acoustical experiment the digital signal processing technique are applied and spark discharge sound sources have been developed in which impulse response measured in 1/20 scale model railway. In the case of scale model experiment, it is difficult to realize sufficiently small size and directivity and to get sufficient sound energy and to get repeatability. Several type of Spark discharge sound source is made in laboratory. Experiment results are compared with the calculated results by the prediction model. As the results, it was found that railway noise could be predicted in acoustical scale model experiment using spark discharge sound source.

• 소음진동
• /
• 제9권3호
• /
• pp.466-471
• /
• 1999

The prediction methods of diffraction field in barrier has beenreported much about the infinite length barrier and it is very few work that reasonable sound source was used in experiment. This study, however, has worked about the several model barrier with acoustic scale model experiment. In the case of scale model experiment, it is difficult to use the kind of source with sufficiently characteristics. A spark discharge sound source with the high repeatability, broad band spectra, small size and omnidirectivity has veen used for the prediction of diffraction field. Several model barriers with different length on the ground were considered for the experiment and compared with the the results calculated by the approximation.

• 제어로봇시스템학회논문지
• /
• 제11권3호
• /
• pp.246-253
• /
• 2005

An experimenal study on flight control of high-speed AEV(Aero-levitation Electric Vehicle) scale model in wind-tunnel is conducted. The AEV is to fly at very low altitude in predesigned track so that it is always under the wing-in-ground effect. The experiment is intended to fly the scale model to follow the predesigned altitude schedule while holding its attitude (pitch, roll, and yaw). Especially, the altitude changes for climb, cruise, and descent with constant pitch angle are most important maneuvers. The experiment shows that the required mission flights can be performed with appropriate sensors, processors, and actuators.

• 한국화재소방학회:학술대회논문집
• /
• 한국화재소방학회 1997년도 International Symposium on Fire Science and Technology
• /
• pp.413-422
• /
• 1997

Fire characteristics of a typical apartment building in Korea was studied through full scale experiment and zone model simulation. The fire was ignited at the living room and allowed to spread to other parts of a single unit in a five storied apartment building. Various data including temperatures, species concentrations, and images were collected in the experiment. A zone model(CFAST) was used to analyze the same apartment building that represents the average households in Korea. The results were compared with a full scale experiments. While CFAST allows one compartment involved with fire, the experiment allowed the fire to spread to other compartments. Therefore, the comparison between experimental data and Zone-Model data is valid until the living-room fire spread to other parts of the apartment. Flashover occurred at approximately 380 seconds in a fire experiment, and at approximately 420 seconds in Zone-Model. Based on all of data between experimental data and Zone-Model data, it is concluded that the safe escape time is about 250 seconds.

• Structural Engineering and Mechanics
• /
• 제54권5호
• /
• pp.909-922
• /
• 2015

The dynamic response and the mooring line tension of a 1/75 scale model of spar-type platform for 2.5 MW floating offshore wind turbine subject to one-dimensional regular harmonic wave are investigated numerically and verified by experiment. The upper part of wind turbine which is composed of three rotor blades, hub and nacelle is modeled as a lumped mass the scale model and three mooring lines are pre-tensioned by means of linear springs. The coupled fluid-rigid body interaction is numerically simulated by a coupled FEM-cable dynamics code, while the experiment is performed in a wave tank with the specially-designed vision and data acquisition system. The time responses of surge, heave and pitch motions of the scale platform and the mooring line tensions are obtained numerically and the frequency domain-converted RAOs are compared with the experiment.

• 수산해양기술연구
• /
• 제42권3호
• /
• pp.148-157
• /
• 2006

A model experiment, simulation test using personal computer and real sea trial fishing were carried out to investigate the basic efficiency of bottom trawl net which can be used in the sea mount of North West Pacific, and experimental values were analyzed as the values of full-scale bottom trawl net. Hydrodynamic resistance for the full-scale trawl net according to the Koyama equation was 2.1 times higher than that of simulation and 2.4 times higher than that of model experiment at the average towing velocity. At the 3.5kt's of towing speed, net width of the full-scale trawl net was 2.5% smaller than that of simulation and 8.2% larger than that of model experiment. On the fishing experiment of the full-scale trawl net for the 3.5kt's of average towing speed, average net height of A group(same direction with external force) was 423.5% higher than that of model experiment and 457.1% higher than that of simulation and that of B group(opposite direction with external force) were 283.8% and 306.3% higher than in case of model experiment and Simulation respectively. Net mouth of the full-scale trawl net was 338.1-504.6% higher than those of model experiment and simulation in A group, and 525.2-745.3% higher in B group.

• Computers and Concrete
• /
• 제31권1호
• /
• pp.9-21
• /
• 2023

The published studies usually used analytical method, numerical methods or experimental method to determine the stress-strain state and displacement of the single-layer or multi-layer curved shell types, but with a small scale model. However, a full scale multi-layer doubly curved concrete shell roof model should be researched. This paper presents the results of the experiment and simulation analysis involving stress-strain state, sliding between layers, the formation and development of the full scale double-layer doubly curved concrete shell roof when this shell begins to crack. The results of the this study have constructed the load-sliding strain relationship; strain diagram; stress diagram in the shell layers; the N_x, N_y membrane force diagram and deflection of shell. Thisresults by experimental method on a full scale model of concrete have clarified the working of multi-layer doubly curved concrete shell roof. The experimental and simulation results are compared with each other and compared with the Sap2000 software.

• 설비공학논문집
• /
• 제15권11호
• /
• pp.970-978
• /
• 2003

This paper aims at suggesting design guidelines for a perimeter-less HVAC system that contributes energy savings. Perimeter-less HVAC system is one that relieves difficulties such as handling mixing loss, uneven radiative environment, and maintenance and repair. It prevents heat load gained through window and outdoor wall without modifying a previously equipped building skin system. In this paper, we conducted a large-scale model experiment to see how the push-pull air flow would handle indoor heat to obtain an optimized perimeter-less design, and then we plan to perform several kinds of CFD (computational fluid dynamics) cases through numerical simulation