• KIEAE Journal
• /
• v.10 no.4
• /
• pp.75-80
• /
• 2010

Generally, ground-source heat pump (GSHP) systems have a higher performance than conventional air-source systems. However, the major fault of GSHP systems is their expensive boring costs. Therefore, it is important issue that to reduce initial cost and ensure stability of system through accurate prediction of the heat extraction and injection rates of the ground heat exchanger. Conventional analysis methods employed by line source theory are used to predict heat transfer rate between ground heat exchanger and soil. Shape of ground heat exchanger was simplified by equivalent diameter model, but these methods do not accurately reflect the heat transfer characteristics according to the heat exchanger geometry. In this study, a numerical model that combines a user subroutine module that calculates circulation water conditions in the ground heat exchanger and FEFLOW program which can simulate heat/moisture transfer in the soil, is developed. Heat transfer performance was evaluated for 3 different types ground heat exchanger(U-tube, Double U-tube, Coaxial).

• Proceedings of the KIPE Conference
• /
• 2016.11a
• /
• pp.206-207
• /
• 2016

The intermittent characteristics of wind power (WP) may have negative effect on grid stability, especially in weak grid. WP fluctuation rate can be reduced by using energy storage system (ESS) through charging and discharging. The operation of ESS will decide its losses and lifetime of batteries. From this point, this paper proposes WP smoothing control by using short-term average of WP. In this case, the ESS will only operate at high WP fluctuation rate. Then, the output power of ESS will be estimated by short-term average value. The effectiveness of proposed method will be verified by comparing with conventional method. The simulation results will be carried out by using Matlab program.

• Journal of Biosystems Engineering
• /
• v.35 no.1
• /
• pp.53-63
• /
• 2010

The performance of two serial completely stirred tank reactors (CSTRs) for treatment of swine manure (SM) with Chinese cabbage silage (CCS) was studied. The two CSTRs of 41 liters each were connected in series and first reactor was fed swine manure with Chinese cabbage silage in 3:1 proportion by VS basis. The FOS/TAC, methane content (%) and pH were utilized as the parameters for the digester stability control. The FOS/TAC value was found to be effective indicator for instant digester condition. The stability of reactors can be obtained with the FOS/TAC value up to 1.0 with accumulation of FOS value below 10,000 mg/L. Material exchange method was effective in transferring the excess volatile fatty acids (VFA) from the first reactor to the second one and maintaining stability in both the reactors. The biogas yield and the methane yield was 0.55-0.61 and 0.41-0.42 L/g VS fed, respectively, at organic loading rate (OLR) of 2.2-2.6 g VS/L with total HRT of 32 days.

• The KSFM Journal of Fluid Machinery
• /
• v.9 no.6 s.39
• /
• pp.45-53
• /
• 2006

Turbo-blower as an air supply system is one of the most important BOP (Balance of Plant) systems for FCV(Fuel Cell Vehicle). For generating and blowing compressed air, the motor of air blower consumes maximum 25% of net power, and fuel cell demands a clean air. In this study, turbo-blower supported by air foil bearings is introduced as the air supply system used by 80kW proton exchange membrane fuel systems. The turbo-blower is a turbo machine which operates at high speed, so air foil bearings suit their purpose as bearing elements. Analysis for confirming the stability and endurance is conducted. The rotordynamic stability was predicted using the numerical analysis of air foil bearings and it is verified through experimental works. In spite of various transient dynamic situation, the turbo-blower had stable performances. After the performance test, results are presented. The normal power of driving motor has about 1.6 kW with the 30,000 rpm operating range and the flow rate of air has maximum 160 SCFM. The test results show that the aerodymic performance and stability of turbo-blower are satisfied to the primary goals.

• Journal of Navigation and Port Research
• /
• v.34 no.9
• /
• pp.711-718
• /
• 2010

Redevelopment of the domestic small fishing ports is being started in earnest by applying the environmentally friendly technology in order to attract tourists. For the purpose of improving water quality in the harbor, selection of breakwater type might have the priority to secure calmness and stability. Therefore, this study is to determine the hydraulic characteristics of reflective ratio, installation efficiency and stability of the special type of blocks through the hydraulic model experiment. The results were introduced to analyze for the effect of infield construction work through numerical analysis. Gujora, a small fishing port in southern Korea, is affected by the waves of SSE, S, SSW direction and strong tidal currents. The results of applying cylindrical slit block show that stability of the blocks and harbor calmness were secured. Considering that the pass rate of a long period wave is still excellent, the primary objective of wave control and the secondary objective of improving water exchange are satisfied simultaneously.

• Journal of Electrochemical Science and Technology
• /
• v.8 no.4
• /
• pp.265-273
• /
• 2017

Solid-state alkaline water electrolysis is a promising method for producing hydrogen using renewable energy sources such as wind and solar power. Despite active investigations of component development for anion exchange membrane water electrolysis (AEMWE), understanding of the device performance remains insufficient for the commercialization of AEMWE. The study of assembled AEMWE devices is essential to validate the activity and stability of developed catalysts and electrolyte membranes, as well as the dependence of the performance on the device operating conditions. Herein, we review the development of catalysts and membranes reported by different AEMWE companies such as ACTA S.p.A. and Proton OnSite and device operating conditions that significantly affect the AEMWE performance. For example, $CuCoO_x$ and $LiCoO_2$ have been studied as oxygen evolution catalysts by Acta S.p.A and Proton OnSite, respectively. Anion exchange membranes based on polyethylene and polysulfone are also investigated for use as electrolyte membranes in AEMWE devices. In addition, operation factors, including temperature, electrolyte concentration and acidity, and solution feed methods, are reviewed in terms of their influence on the AEMWE performance. The reaction rate of water splitting generally increases with increase in operating temperature because of the facilitated kinetics and higher ion conductivity. The effect of solution feeding configuration on the AEMWE performance is explained, with a brief discussion on current AEMWE performance and device durability.

• Journal of Life Science
• /
• v.23 no.11
• /
• pp.1365-1370
• /
• 2013

Immobilized cellulase on weak ion exchange resin showed a typical Langmuir adsorption isotherm. Immobilized cellulase had better stability with respect to pH and temperature than free cellulase. Kinetics of thermal inactivation on free and immobilized cellulase followed first order rate, and immobilized cellulase had a longer half-life than free cellulase. The initial rate method was used to characterize the kinetic parameters of free and immobilized enzyme. The Michaelis-Menten constant $K_m$ was higher for the immobilized enzyme than it was for the free enzyme. The effect of the recirculation rate on cellulose degradation was studied in a recycling packed-bed reactor. In a continuous packed-bed reactor, the increasing flow rate of cellulose decreased the conversion efficiency of cellulose at different input lactose concentrations. Continuous operation for five days was conducted to investigate the stability of long term operation. The retained activity of the immobilized enzymes was 48% after seven days of operation.

• THE INTERNATIONAL COMMERCE & LAW REVIEW
• /
• v.55
• /
• pp.185-208
• /
• 2012

Before and after the Capital Market Integration Act in 2007 is implemented in South Korea, many of small-and mid sized exporting companies in South Korea has been bankrupted or filed for lawsuit claiming mis-selling(KIKO) by the banks. The basic economic structure of KIKO in Korea are part of a business model based on the use or misuse of exotic derivatives whose results are anything but imaginary. 571 mid sized exporting companies have been damaged about $28 billion. KIKO is a currency option product that sells foreign currencies at higher foreign exchange rate when the rate moves within a certain range, but sells foreign currencies at two or three times lower rate than the market price when the rate exceeds the designated upper limit. KIKO, Therefore, is hard to know whether the non financial firms intended to hedge against further strengthening of their currency or merely to speculate. It is also hard to know how thoroughly they understood the risk-return profile of these transactions. It is similarly hard to ascertain whether the derivatives dealers offering these transactions were meeting the demands of their clients or taking advantage of them. These exotic derivatives were inappropriate for either hedging or speculating, and no knowledgeable investor would be likely to enter into these contracts intentionally.

• 한국신재생에너지학회:학술대회논문집
• /
• 2011.11a
• /
• pp.85.1-85.1
• /
• 2011

In this study, Grafoil$^{TM}$ which has comparable electric resistance and chemical stability but is flexible, fragile, and cheap material was adopted as bipolar plates for proton exchange membrane fuel cell(PEMFC) having only one straight line flow channel. Because of its flexibility, pressurizations of cell with various pressures showed different operating characteristics compared to ordinary graphite-used PEMFC. While performances of both cells decreased as these were pressurized, investigation of ohmic and faradaic resistance by electrochemical impedance measurement indicated different tendency of change. Ohmic resistance of graphite-used cell increased with increasing pressure, which is reversed in Grafoil$^{TM}$-used cell. It is speculated that effective chemical reaction area is decreased with increasing pressure in case of graphite-used one, but because of flexible property of Grafoil$^{TM}$, gas diffusion layer in Grafoil$^{TM}$-used cell was well-activated. Different rate of change of faradaic resistances in both cells support this supposition. However, although optimum point of pressurization is found, it is required to investigate other operating conditions because of low performance compared to graphite-used cell.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1995.04a
• /
• pp.26-27
• /
• 1995

Most of synthetic polymeric membranes used in ultrafiltration, reverse osmosis and microfiltration processes are prepared by phase inversion(or phase separation) technique. In this technique, a homogeneous polymer solution is cast into thin film or hollow fiber shape and then immersed into a nonsolvent coagulant bath. The exchange of solvent and nonsolvent across the interface between casting solution and coagu!ant can make the casting solution phase-separate and form a membrane with a symmetric or asymmetric structure. Because of importance of this technique in membrane field, many investigations have been dedicated to elucidate the mechanism of membrane formation by phase inversion technique.[1-10] These investigation have suggested that the structure formation and permeation properties of phase inversion membrane depend on the variables such as the nature and content of casting solution and coagulant, temperature of casting solution and coagulant, and the diffusional exchange rate of solvent and nonsolvent etc. which can be related to the thermodynamic and kinetic properties of the casting system. The variables such as the nature and content of casting solution can also be the important factor affecting the structure formation and permeation property of the phase inversion membrane.